On the recovery of surface wave by pressure transfer function

Except the commonly selected pressure transfer function derived from the linear wave theory, a previous study on the pressure transfer function for recovering surface wave from underwater pressure transducer suggested that the pressure transfer function is a function of frequency parameter only. With careful analysis, this study showed that the pressure transfer function should include a transducer submergence parameter as that given by the linear theory. It was found that the previously suggested empirical formula should be restricted to measurements with the pressure transducer close to the surface; otherwise overestimation of wave height would result. Field measurements were carried out with an acoustic wave gauge and a synchronized pressure transducer located at various depths with submergence parameter close to 1 (near the sea floor). It was shown that the previous one-parameter empirical formula might overestimate the significant wave height by more than 30%. This study found that with deep-water wave bursts excluded, the transfer function based on the linear wave theory provided a fairly good estimation on the significant wave heights, with an average deviation of 3.6%.     

Three-dimensional Layer-integrated Modelling of Estuarine Flows with Flooding and Drying

Details are given of the refinement and application of a thee-dimensional (3-D) layer-integrated numerical model of tidal circulation, with the aim of simulating severe tidal conditions for practical engineering applications. The mode splitting strategy has been used in the model. A set of depth-integrated 2-D equations are first solved to give the pressure gradient, and the layer-integrated 3-D equations are then solved to obtain the vertical distributions of the flow velocities. Attention has been given to maintaining consistency of the physical quantities derived from the 2-D and 3-D equations. A TWO=layer mixing length turbulence model for the vertical shear stress distribution has been included in the model. Emphasis has been focused on applying the model to a real estuary, which is geometrically complicated and has large tidal ranges giving rise to extensive flooding and drying. The model has been applied to three examples, including: wind-driven flow in a rectangular lake, tidal circulation in a model rectangular harbour, and tidal circulation in a large estuary. Favourable results have been obtained for both the simple and complex flow beds.     

Numerical and simplified methods for the calculation of the total horizontal wave force on a perforated caisson with a top cover

The VOF method and the k–ε model, combined with the equation of state of air at constant temperature, have been used to calculate the total horizontal wave force caused by monochromatic waves acting on a perforated caisson with a top cover. From comparison of various parameters, such as the total horizontal force, the pressure difference on the front wall, the pressure on the back wall and the pressure on the top cover, between the numerical results and test data, it can be seen that the numerical results agree well with the test data. It is concluded that the method described in this paper can be utilized to calculate wave forces acting on perforated caissons with a top cover in the case of nonovertopping, nonbreaking waves. A simplified method to calculate the total horizontal force has been developed, based on test data, using a least-squares method. A comparison between the numerical results and the values calculated from the simplified equations shows good agreement. Therefore the simplified equations can be used in engineering applications to evaluate the total horizontal force on a perforated caisson with a top cover.     

薛家岛湾沉积动力学特征及海港开发研究

于１９９０年秋对胶州湾内的薛家岛湾进行海洋水动力条件及积动力学特征,泥沙运动规律研究,为开发建设港口提供科学依据。结果表明,湾内深大于１ｍ的海底泥沙发生“全面移动”的时间,一年内仅有１－２ｄ,其余处于稳定状态或“表面移动”状态。湾内泥沙来源很少,预计建港后,港池和航道年平均回淤量分别小于１６ｃｍ,１０ｃｍ对于开发中小型港口十分有利。     

动荷载作用下海底粉土的孔压响应及其动强度

本文选用近海分布较广的粉土为研究对象 ,利用室内动三轴试验结果 ,找出动荷载作用下粉土的动应力应变关系 ,分析模拟波浪荷载作用下粉土中的孔压响应、临界循环次数 ,确定波浪作用下粉土的应力状态、破坏临界循环次数 ,判断不同深度处的粉土发生液化的可能性及发生液化所需要的时间 ;研究粉土在动荷载作用下的强度降低 ,为海上工程设计和施工提供科学依据。     

Measurement of nuclides of uranium and thorium series of disequilibrium using γ-spectroscopy

ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｒａｄｉｏｎｕｃｌｉｄｅｓｏｆｎａｔｕｒａｌｕｒａｎｉｕｍａｎｄｔｈｏｒｉｕｍｓｅｒｉｅｓｃａｎｂｅｕｓｅｄｔｏｔｒａｃｅｍａｒｉｎｅｐｒｏ ｃｅｓｓｏｆｖａｒｉｏｕｓｔｅｍｐｏｒａｌａｎｄｓｐａｔｉａｌｓｃａｌｅａｎｄｐｒｏｐｅｒｔｉｅｓｔｈａｔｐｒｏｖｉｄｅｐｌｅｎｔｉｆｕｌｉｎｆｏｒｍａｔｉｏｎａｂｏｕｔｐｈｙｓｉｃｓ,ｃｈｅｍｉｓｔｒｙ ,ｇｅｏｓｃｉｅｎｃｅａｎｄｂｉｏｌｏｇｙｏｆｏｃｅａｎｂｅｃａｕｓｅｔｈｅｙｈａｖｅｄｉｆｆｅｒｅｎｔｃｈｅｍｉｃａｌｐｒｏ…     

Numerical simulation of the hydrodynamic behaviour of submerged plane nets in current

The aim of this paper is to investigate the shape and tension distribution of fishing nets in current. A numerical model is developed, based on lumped mass method to simplify the net. The motion equation is set up for each lumped mass. The Runge–Kutta–Verner fifth-order and sixth-order method is used to solve these simultaneous equations, and then the displacement and tension of each lumped mass are obtained. In order to verify the validity of the numerical method, model tests have been carried out. The results by the numerical simulation agree well with the experimental data.     

X60钢在CO2饱和盐水中缓蚀作用的研究

本文采用动电位极化、线性极化、电偶电流和高压釜挂片失重等法,研究了含氮、硫有机缓蚀剂和/或Me~(2+)对X60钢在CO_2饱和的盐水溶液中的缓蚀作用。结果表明,含氮、硫的有机缓蚀剂在缓蚀过程中,开始是以抑制阳极过程为主,随后是以抑制阴极过程为主的混合型缓蚀剂。如与Me~(2+)复配使用,能明显地提高缓蚀效能。     

全球船舶压载水管理项目在我国启动

为了防止全球船舶压舱水中的有害水生物在海洋中传播,危害海洋生态环境,造成海洋污染,2000年9月20日～21日,我国召开了关于制定船舶压载水管理国家项目工作计划和宣传项目研讨会。据悉,国际海事组织近年来一直在努力采取措施,制订有关法规,并将在2002年召开大会予以通过。届时,关于船舶压载水的管理规定将成为全球强制性要求。     

诊断台风异常路径的三层权重控制点方案

本方案采用850、700、500hPa三个层次的环境平均流场作控制点法。综合考虑这些层次上的引导气流在不同时、空域中的相对重要性。试验结果表明,其效果比单一取某层作引导为佳。且对用来预测台风的未来24小时路径是否异常具有一定的参考价值。