Trace metals in suspended particulate matter and in sediment trap material from a permanently anoxic fjord — Framvaren, South Norway

Geochemical studies of the trace metal concentrations in suspended particulate matter (SPM) and sediment trap material from a permanently anoxic fjord, Framvaren, South Norway in 1989 and 1993 indicate that extremely high concentrations of zinc (max = 183920 mg/kg), copper (max = 4130 mg/kg), lead (max = 2752 mg/kg), and cadmium (max= 8.1 mg/kg) sometimes (1993) occur in the SPM collected in the anoxic water layer. The highest concentrations of Zn occur just below the redoxcline at 22 m water depth (in 1993), and copper, lead and cadmium have maximum concentrations between 30 and 80 m depth, where the amount of total SPM is at a minimum (about 0.3 mg/L). On a mass per volume (g/L) basis, the maximum concentrations of Cd, Cu and Fe occur at the interface (21m) and those of Zn occur just below the redoxcline (22 m depth). The SPM and sediment trap data suggest that the metals are precipitated as sulfide minerals in the anoxic water. The presence of particulate sulfides was confirmed by SEM studies that show the occurrence of discrete metal (Cu, Fe, Pb, and Zn) sulfide particles in size from 10–20 m as well as framboidal pyrites (1–5 m in size). Higher levels of metal sulfides at intermediate depths rather than in the deep water of Framvaren (> 100 m), may be due to input of trace metals by water exchange over the sill in the upper part of the water column. In the deep water, less metal sulfide precipitation takes place due to depletion of trace metals, and the dilution of particulate metal concentrations by organic matter and by the chemogenic formation of calcite.     

The contact binary system YY Eri

Relatively new and unanalysed photometric data-sets of the contact binary system YY Eri are presented. The light curves have been analysed using information limit optimization techniques, and the Binary Maker program of Bradstreet (1992).Comparison of the results allows insight into determinacy questions affecting the W UMa type of light curve, which relates to our general understanding of contact binaries. A limiting contact configuration cannot be ruled out on the basis of empirical data-analysis alone.Very careful analysis of the photospheric flux distribution over the surface of the Sun may help establish appropriate values of the gravity brightening parameter for cool dwarf stars. At present, however, empirical photometric information on contact binaries is non-discriminatory: i.e. alternative cosmogonies can find alternative support from available evidence. The implication is then for more and better observational data to allow better real independent parameter determination.     

The GEM project: An international collaboration to survey galactic radiation emission

The GEM (Galactic Emission Mapping) project is an international collaboration established with the aim of surveying the full sky at long wavelengths with a multi-frequency radio telescope. A total of 745 hours of observation at 408 MHz were completed from an Equatorial site in Colombia. The observations cover the celestial band 0 ^h <<24 ^h , and –24° 22<<+35° 37. Preliminary results of this partial survey will be discussed. A review of the instrumental setup and a 10° resolution sky map at 408 MHz is presented.Presented by S. Torres at the UN/ESA Workshop on Basic Space Sciences: From Small Telescopes to Space Missions, Colombo, Sri Lanka 11–14 January 1996     

Joint radio and soft x-ray imaging of an ‘anemone’ active region

The Very Large Array and the Soft X-ray Telescope (SXT) aboard the Yohkoh satellite jointly observed the rapid growth and decay of a so-called anemone active region on 3–6 April, 1992 (AR 7124). The VLA obtained maps of the AR 7124 at 1.5, 4.7, and 8.4 GHz. In general, discrete coronal loop systems are rarely resolved at 1.5 GHz wavelengths because of limited brightness contrast due to optical depth effects and wave scattering. Due to its unusual anemone-like morphology, however, several discrete loops or loop systems are resolved by both the VLA at 1.5 GHz and the SXT in AR 7124.Using extrapolations of the photospheric field and the radio observations at 4.7 and 8.4 GHz, we find that the microwave emission is the result of gyroresonance emission from a hot, rarefied plasma, at the second and/or third harmonic. The decimetric source is complex -1.5 GHz emission from the leading part of AR 7124 is due to free-free emission, while that in the trailing part of the active region is dominated by gyroresonance emission. We also examine an interesting case of a discrete radio loop with no soft X-ray (SXR) emission adjacent to a hot SXR loop. This observation clearly shows the multithermal nature of the solar corona.     

Propagation of MHD body and surface waves in magnetically structured regions of the solar atmosphere

The fact that magnetically structured regions exist in the solar atmosphere has been known for a number of years. It has been suggested that different kinds of magnetohydrodynamic (MHD) waves can be efficiently damped in these regions and that the dissipated wave energy may be responsible for the observed enhancement in radiative losses. From a theoretical point of view, an important task would be to investigate the propagation and dissipation of MHD waves in these highly structured regions of the solar atmosphere. In this paper, we study the behavior of MHD body and surface waves in a medium with either a single or double (slab) magnetic interface by use of a nonlinear, two-dimensional, time-dependent, ideal MHD numerical model constructed on the basis of a Lagrangean grid and semi-implicit scheme. The processes of wave confinement and wave energy leakage are discussed in detail. It is shown that the obtained results depend strongly on the type of perturbations imposed on the interface or slab and on the plasma parameter, . The relevance of the obtained results to the heating problem of the upper parts of the solar atmosphere is also discussed.     

Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

Turbulent flows over mountainous terrain modelled by the Reynolds equations

A numerical model based upon fundamental principles, a standard (k, ) turbulence closure and a finite element integration technique, is applied to separated flows over hills. Predictions are compared to experimental data from a wind tunnel. Although few-equation turbulence closures have been shown to have obvious deficiencies with respect to comparable flows, the model predicts remarkably accurately, without coefficient adjustments of any kind. Even the turbulent intensity is predicted quite realistically.     

Dynamics of the plasmasphere in the dusk sector as observed in the outer ionosphere

Summary Direct measurements of the thermal plasma parameters in the topside ionosphere reveal variations of the plasmasphere boundary in the dusk sector. The ACTIVE satellite's near-polar orbits at altitudes of 500 – 1800 km around winter solstice 1989 were used to study the bulge region of the plasmasphere during intervals with different levels of geomagnetic agitation. The narrow, sharply defined trough in electron concentration corresponding to the plasmapause under quiet conditions situated at L = 6 – 7 moved to lower L-values with increasing geomagnetic activity. This narrow trough can be found in all main ion constituents. During periods of moderate geomagnetic activity, following the onset of a weak magnetic storm, a portion of the plasmaspheric bulge region was separated from the main plasmaspheric body. This can be seen in the outer ionosphere as an inner narrow trough at lower L-value. Troughs in light ions need no longer coincide with this in electron concentration. He⁺ is the most sensitive constituent reflecting the dusk sector plasmaspheric situation at this altitude.Dedicated to the Memory of Professor Karel P     

About the specification of erosion flux for soft stratified cohesive sediments

The present paper deals with the specification of bed erosion flux that accounts for the effects of sediment-induced stratification in the water column. Owing to difficulties in measuring the bed shear stress _b and the erosive shear strength _s, we suggest a series of methods that combine laboratory and numerical experiments. A simplified turbulent transport model that includes these effects helps to quantify _b and _s. Focusing on soft stratified beds, the present study considers erosion rate formulas of the form =_f exp {[T_b-T_s]} where is a model constant (=1 for Gularte's (1978) formula and =1/2 for Parchure's (1984) formula). First, the bed erosive strength profile _s(Z) is adjusted by forcing the turbulent transport model with measured erosion rates. Second, three procedures are suggested to determine the erosion rate formula coefficients _f and : a global procedure and two different layer-by-layer procedures. Each procedure is applied to an erosion experiment conducted in a rotating annular flume by Villaret and Paulic (1986). The use of the layer-by-layer procedure based on a least squares fitting technique provides a closer fit than the global procedure. The present study points out the complementarity of experimental and numerical approaches and also suggests possible improvements in laboratory test procedures.     

Pb−Sr−Nd−O isotopic constraints on the origin of rhyolites from the Taupo Volcanic Zone of New Zealand: evidence for assimilation followed by fractionation from basalt

A comprehensive Sr–Nd–Pb–O isotopic study is reported for rhyolites from the Maroa Volcanic Centre in the Taupo Volcanic Zone (TVZ) of New Zealand. The Sr–Nd isotopic compositions of the rhyolites (⁸⁷Sr/⁸⁶Sr=0.705236 to 0.705660 and _Nd = 2.0 to 0.2) are intermediate between those of primitive basalts (⁸⁷Sr/⁸⁶Sr=0.70387 and _Nd = 5.3) and the Torlesse basement (⁸⁷Sr/⁸⁶Sr=0.709 and _Nd = -4.5). The relatively low mantle-like oxygen isotopic compositions of ¹⁸ O = 7 ± 0.5 are consistent with the Nd-Sr isotopic constraints in that they can be accounted for by 15% to 25% crustal contamination of a basaltic parent by relatively ¹⁸ O-rich Torlesse metasediment. High precision Pb isotopic analyses of plagioclase separates from the Maroa rhyolites show that they have essentially the same compositions as the Torlesse metasedimentary terrane which is itself distinctive from the Western or Waipapa metasediments. Due to the high concentration of Pb in the Torlesse metasediments (>20 ppm) compared to the basalts (<2 ppm), the Pb isotopic composition of the volcanics may be controlled by relatively small amounts (>10%) of crustal contamination. All these results are shown to be consistent with derivation of the rhyolites by 15% to 25% contamination of relatively primitive basaltic magmas with Torlesse metasedimentary crust, followed by extensive, essentially closed system fractionation of the basalt to a magma of rhyolite composition. It is argued that the processes of assimilation and fractionation are separated in both space and time. The voluminous high silica rhyolites, which make up >97% of the exposed volcanism in the continental margin back-are basin environment of the TVZ, therefore appear to be a product of predominantly new additions to the crust with assimilation-recycling of pre-existing crust being of secondary importance.