Design of stable drainage networks in upland forestry plantations

Erosion of man-made, forestry drainage channels occurs when the plough cuts through the surface peat layer into the underlying erodible mineral soil. A procedure is developed, based on hydraulic considerations, which will allow the drainage engineer to design stable drainage networks in upland forestry plantations. An example design chart is given for an erodible sandy loam type soil.     

A simulation tool for high data-rate acoustic communication in ashallow-water, time-varying channel

The paper discusses the development of a simulation tool to model high data-rate acoustic communication in shallow water. The simulation tool is able to generate synthetic time series of signals received at a transducer array after transmission across a shallow-water communication channel. The simulation tool is suitable for testing advanced signal processing techniques for message recovery. A channel model has been developed based on the physical aspects of the acoustic channel. Special emphasis has been given to fluctuations of the signal transmission caused by time-varying multipath effects. At shorter ranges, the temporal variations are dominated by acoustic scattering from the moving sea surface. Therefore, the channel model produces a coherence function which may be interpreted as a time-varying reflection coefficient for the surface scattered acoustical path. A static, range-independent ray model identifies the significant multipaths, and the surface path is modulated with the time-varying reflection coefficient. The advantages and limitations of the channel model are discussed and assumptions necessary to overcome the limitations are emphasised. Based on the assumptions, an algorithm has been developed and implemented to model how a binary message will be modulated when transmitted by a transducer, is distorted in the channel and finally is received by a transducer array     

OSCR wave measurements-some preliminary results

OSCR is an HF radar system that has been developed for high spatial resolution coastal surface current measurement. This paper describes preliminary results that demonstrate that wave measurement can be successfully obtained from suitably processed OSCR data. Comparisons with data from a WAVEC directional buoy are presented and show encouraging agreement. Some of the limitations to the measurement process are discussed and indicate a maximum range of about 20 km. Surface current variability on short time scales presents the most serious obstacle to wave measurement. This appears to be more of a problem when the mean currents are large, in that in these circumstances the data fail initial quality control criteria. However, in lower mean currents, the effect is often still present and leads to errors in long wave measurement     

The variability of Mercury's exosphere by particle and radiation induced surface release processes

Mercury's close orbit around the Sun, its weak intrinsic magnetic field and the absence of an atmosphere (P_surface<1×10⁻⁸ Pa) results in a strong direct exposure of the surface to energetic ions, electrons and UV radiation. Thermal processes and particle-surface-collisions dominate the surface interaction processes leading to surface chemistry and physics, including the formation of an exosphere (N?10¹⁴ cm⁻²) in which gravity is the dominant force affecting the trajectories of exospheric atoms. NASA's Mariner 10 spacecraft observed the existence of H, He, and O in Mercury's exosphere. In addition, the volatile components Na, K, and Ca have been observed by ground based instrumentation in the exosphere. We study the efficiency of several particle surface release processes by calculating stopping cross-sections, sputter yields and exospheric source rates. Our study indicates surface sputter yields for Na between values of about 0.27 and 0.35 in an energy range from 500 eV up to 2 keV if Na⁺ ions are the sputter agents, and about 0.037 and 0.082 at an energy range between 500 eV up to 2 keV when H⁺ are the sputter agents and a surface binding energy of about 2 eV to 2.65 eV. The sputter yields for Ca are about 0.032 to 0.06 and for K atoms between 0.054 to 0.1 in the same energy range. We found a sputter yield for O atoms between 0.025 and 0.04 for a particle energy range between 500 eV up to 2 keV protons. By taking the average solar wind proton surface flux at the open magnetic field line area of about 4×10⁸ cm⁻² s⁻¹ calculated by Massetti et al. (2003, Icarus, in press) the resulting average sputtering flux for O is about 0.8-1.0×10⁷ cm⁻² s⁻¹ and for Na approximately 1.3-1.6×10⁵ cm⁻² s⁻¹ depending on the assumed Na binding energies, regolith content, sputtering agents and solar activity. By using lunar regolith values for K we obtain a sputtering flux of about 1.0-1.4×10⁴ cm⁻² s⁻¹. By taking an average open magnetic field line area of about 2.8×10¹⁶ cm² modelled by Massetti et al. (2003, Icarus, in press) we derive an average surface sputter rate for Na of about 4.2×10²¹ s⁻¹ and for O of about 2.5×10²³ s⁻¹. The particle sputter rate for K atoms is about 3.0×10²⁰ s⁻¹ assuming lunar regolith composition for K. The sputter rates depend on the particle content in the regolith and the open magnetic field line area on Mercury's surface. Further, the surface layer could be depleted in alkali. A UV model has been developed to yield the surface UV irradiance at any time and latitude over a Mercury year. Seasonal and diurnal variations are calculated, and Photon Stimulated Desorption (PSD) fluxes along Mercury's orbit are evaluated. A solar UV hotspot is created towards perihelion, with significant average PSD particle release rates and Na fluxes of about 3.0×10⁶ cm⁻² s⁻¹. The average source rates for Na particles released by PSD are about 1×10²⁴ s⁻¹. By using the laboratory obtained data of Madey et al. (1998, J. Geophys. Res. 103, 5873-5887) for the calculation of the PSD flux of K atoms we get fluxes in the order of about 10⁴ cm⁻² s⁻¹ along Mercury's orbit. However, these values may be to high since they are based on idealized smooth surface conditions in the laboratory and do not include the roughness and porosity of Mercury's regolith. Further, the lack of an ionosphere and Mercury's small, temporally and spatially highly variable magnetosphere can result in a large and rapid increase of exospheric particles, especially Na in Mercury's exosphere. Our study suggests that the average total source rates for the exosphere from solar particle and radiation induced surface processes during quiet solar conditions may be of the same order as particles produced by micrometeoroid vaporization. We also discuss the capability of in situ measurements of Mercury's highly variable particle environment by the proposed NPA-SERENA instrument package on board ESA's BepiColombo Mercury Planetary Orbiter (MPO).