A comparison between analytical aerial photogrammetry,laser scanning,total station and global positioning system surveys for generation of digital terrain model

The present paper compares between four data sources for creating digital terrain models (DTMs), based on analytical aerial photogrammetry, laser scanning, total station (TS) and global positioning system surveys. The case study presents the comparative results obtained using the methods listed above. After obtaining the ground coordinates of points using each method, DTMs were created using Surfer Software to establish comparison consistency. To check accuracy of each method used, a series of 100 independent points were collected at random positions over the case study area using the TS for horizontal position and a digital level for elevation. The comparison of the results of the methods was performed based on accuracy and efficiency aspects. The results have shown that TS and terrestrial laser scanners (TLSs) could represent precise, effective and rapid solutions to produce economical and accurate DTMs. Also, using TLSs allow more various possibilities of data representation.     

A laboratory investigation of bed-load transport of gravel sediments under dam break flow

Dam break flows and resulting river bed erosion can have disastrous impacts on human safety,infrastructure,and environmental quality.However,there is a lack of research on the mobility of non-uniform sediment mixtures resulting from dam break flows and how these differ from uniform sized sediment.In this paper,laboratory flume experiments revealed that coarse and fine fractions in non-uniform sediment had a higher and a lower bed-load parameter,respectively,than uniform sediments of the same size.Thus,the finer fractions were more stable and the coarser fractions were more erodible in a nonuniform bed compared to a uniform-grained bed.These differences can be explained by the hiding and protrusion of these fractions,respectively.By investigating changes in mobility of the mixed-size fractions with reservoir water levels,the results revealed that at low water levels,when the coarser fractions were only just mobile,the bed-load parameter of the finer fractions was higher than the coarser fractions.The opposite was observed at a higher water level,when a significant proportion of the coarsest fractions was mobilized.The higher protrusion of these grains had an important effect on their mobility relative to the finer grains.The transported sediment on these mixed-sized beds was coarser than the initial bed sediment,and became coarser with an increase in reservoir water level.     

Metal fluxes to the sediments of the Moulay Bousselham lagoon,Morocco

The metal content in surface sediments (0–2 cm, 26 samples), in a sediment core (120, 1 cm slices), taken from Moulay Bousselham (Morocco) was investigated. Concentrations of Al, Fe, Mn, Pb, Zn, Cu, Ni, Cr, Cd, As, and Hg were evaluated in surface and cored sediments of Moulay Bousselham lagoon. Significantly high concentrations in μg g⁻¹ dw of Pb (31.7–6.2), Zn (758.9–167), Cu (310.7–22), Ni (96–10.5), Cr (113–18.9), Cd (0.84–0.02), As (1–0.1), and Hg (0.61–0.02) were found in sediment samples from Moulay Bousselham lagoon. Calculated enrichment factors [EF_Me = (Me/Al)_sample/(Me/Al)_background], using Al as a normalizer, and correlation matrices showed that metal pollution in Merja Zerga of Moulay Bousselham lagoon was the product of anthropogenic sources, while the metal content in Merja Kehla was of natural origins. The results suggest that a major change in the sedimentary regime of the lagoon, associated with internal trapping and re-distribution of heavy metal, has been occurring in the past few decades. The cause would appear to be the construction of a Nador Canal at the lagoon. Probable effects concentrations (PEC) were often exceeded for heavy metals in the lagoon sediments, especially for Zn, Cu, Ni, and Cr, and four stations, stations MZ-11, MZ-12, MZ-13, MZ-14, MZ-16, and MZ-17, had multiple metals at presumptively toxic levels. These comparisons suggest that sediment metal levels in the river are clearly high and probably pose an environmental risk at some stations. The levels of most of the metals were not greatly enriched, a consideration that is of the utmost importance when contamination issues are at stake. Metal concentrations found in Moulay Bousselham lagoon were comparable to aquatic systems classified as contaminated from other regions of the world.     

The CERES‐Rice Model‐Based Estimates of Potential Monsoon Season Rainfed Rice Productivity in Bangladesh*

Agricultural practices in Bangladesh are largely dependent on the monsoonal rainfall. Historically, Bangladesh often experiences severe droughts and floods during the monsoon months, with significant crop losses during both extreme conditions. This article provides a quantitative assessment of potential monsoon‐season aman rice for four transplanting dates: 1 June, 1 July, 15 July, and 15 August. A crop‐growth simulation model, the CERES‐Rice, is applied to sixteen locations representing major rice‐growing regions of Bangladesh to determine baseline yield estimates for four transplanting dates. The applications were conducted for 1975 through 1987. Average potential yield in Bangladesh is 6,907, 5,039, 3,637, and 1,762 kg ha^?1 for the above transplanting dates, respectively. In other words, Bangladesh would obtain 27 percent, 48 percent, and 75 percent less yield for 1 July, 15 July, and 15 August transplanting, respectively, than for 1 June transplanting. Potential yield vulnerability is the least for 1 June transplanting (up to 5 percent) and the highest (up to 66 percent) for 15 July transplanting date. The model applications show that regional variations exist for potential yield and yield vulnerability for a particular transplanting date. In addition, response of yield and vulnerability for a region changes with transplanting dates.     

Lithologic mapping of a forested montane terrain from Landsat 5 TM image

Thick forest cover and poor infrastructures are the major hindrances for detailed lithologic mapping in an inaccessible montane landscape. To overcome these limitations, we utilize a Landsat 5 TM image to map lithology using vegetation and drainage pattern as an indicator of underlying rock types in a heavily forested region of the Chittagong Hill Tracts area located in southeastern Bangladesh. We use supervised and unsupervised classifiers for a vegetation-based approach while on-screen digitization is used for drainage patterns-based mapping. Field observations were used for mapping lithology and evaluating accuracy. Overall, our results agree well with the current geologic map and improve it by providing a more spatially detailed distribution of the sandstone and shale. The performances of all approaches are good at the inner and outer flanks of anticlines located in the study area while the drainage pattern mapping performs best at the mid-flank area.     

Tigris River Sediments as Abrasive for Polishing Marble

Natural Resources Research - This study aims to evaluate the use of Tigris River sediments as abrasives for polishing marble surfaces to achieve a usable form as floor tiles, facing stones and...     

Composition and structure of species along altitude gradient in Moghan-Sabalan rangelands,Iran

This study provides a checklist of species distributed at the altitude gradient of Moghan-Sabalan rangelands in Ardabili province, Northwest Iran. We evaluated the changes in species composition, growth types of species, Raunkiaer’s life forms, geographical distribution, threat and endemicity status, and palatability of species along two altitudinal gradients in the sampling plots, which were conducted in eleven sites/habitats with 300 meters above sea level (masl) altitude intervals (from 100 to 3300 masl). We assessed the plant species composition with special reference to the gradient analysis, and identified overall 396 species, which was comprising 44 families and 194 genera. Results showed that Asteraceae family is by far the most species-rich family, followed by Poaceae, Fabaceae, Caryophyllaceae and Brassicaceae. Among the genera, Astragalus is the most diverse genus, followed by Allium, Veronica and Bromus, Galium, Silene and Ranunculus. Results indicated that the number of species increased as the altitude increased to 1200–1500 masl, but then starts to decline to 3300 masl. Family-to-genera ratio was 1:4.4, the family-tospecies ratio was 1:9, and the genera-to-species ratio was 1:2.04. Growth type of species analysis shows that the frequency of perennial plants was higher in the study area followed by annual species while the lower group was biennial species. The number of annuals showed a decreasing trend towards higher altitude. Hemicryptophytes and therophytes were the most frequent life forms constituted each with (41.9%). Hemicryptophytes showed an increasing trend with altitude, while therophytes showed a decreasing trend with altitude increase, followed by geophytes, chamaephytes, and phanerophytes. Results showed more than half of the species of the study area belonged to Iran-Turanian region and these species showed an increasing trend with altitude. In contrast, Sahara-Sindian species comprise a minor component of the spectrum, with decreasing trend with altitude. The rare and endangered species out of the surveyed taxonomic groups comprised 53 species in total which 29 of them are considered lower risk (LR), 13 data deficient (DD), 5 vulnerable (Vu) and with 3 rare (R) and identified endemic plants comprised 24 species. Some 56.6% species were identified as class III, 22.6% were class I and 20.8% were class II as the palatability variation. Moghan-Sabalan rangelands require strong conservation management policies in case of species loss and changing natural communities due to the occurrence of conversion into cropland, over-grazing and other anthropogenic effects.