Palaeovariations in the East-Asian Monsoon Regime Geochemically Recorded in Varved Sediments of Lake Sihailongwan (Northeast China, Jilin Province). Part 1: Hydrological Conditions and Dust Flux

The varved sediments of the dimictic Lake Sihailongwan (Long Gang mountain area, Jilin Province, Northeast China) represent a palaeoclimatic archive which documents the local precipitation frequency during the summer monsoon, and variations in the aeolian flux of dust with their remote sources in the arid and semi-arid regions of inner Asia. Based on a detailed discussion of sediment genesis in Lake SHL, dust flux rates and palaeohydrological conditions were reconstructed on a decadal scale over the past 220 years. The aeolian influx by dry and wet deposition was quantified and characterised in its chemical composition. Photosynthetic production in the lake is positively correlated with the inflow of nutrient-rich groundwater. The groundwater discharge largely reflects the strength of the summer monsoon. Net accumulation rates for biogenic silica were determined for annually laminated sediments from the centre of the U-shaped lake basin based on sediment data. In a Si-balance model of the modern lake, the depositional flux of biogenic silica could be independently quantified on the base of hydrochemical monitoring data. Comparison of the both estimates allowed to asses the focussing of the particle flux in the lake. Though water retention in Lake SHL is rather high (ca. 30 years), changes in the hydrological conditions are sensitively recorded in the sediments because (i) nutrient-rich groundwater discharges into the productive zone of the lake, (ii) a substantial proportion of the total dissolved Si-inventory of the mixed lake (ca. 30%) is annually consumed by diatom growth, and (3) sediment accumulation is substantially focussed towards the flat bottom of the lake basin. The bulk siliciclastic sediment fraction (ca. 75 wt.%) largely originates from influx of dust of remote provenance. In sediment thin-sections, the dry-deposited dust fraction is microscopically identifiable as seasonal silt layer. Aeolian input by wet-deposition shows a distinctly higher variability than the influx of dust by dry-deposition. As diatom production, wet-deposition of dust is positively correlated with the rainfall during the summer monsoon. The inferred positive correlation between rainfall and dust flux during the summer monsoon implies that dust deposition is determined by the out-wash efficiency of mineral particles for a permanent high atmospheric dust concentration over Northeast China in the last 220 years.     

Variscan ore formation and metamorphism at the Felbertal scheelite deposit (Austria): constraining tungsten mineralisation from Re–Os dating of molybdenite

The Felbertal scheelite deposit in the Eastern Alps has been regarded as the type locality for stratabound scheelite deposits. It is hosted by a Cambro-Ordovician metavolcanic arc sequence with minor Variscan granitoids (∼ 340 Ma) in the central Tauern Window. Re–Os model ages for molybdenite from the Felbertal tungsten deposit range between ∼ 358 and ∼ 336 Ma and record several pulses of magmatic-hydrothermal-metamorphic molybdenite formation. Molybdenite ages from the K2 orebody, a scheelite-rich quartz mylonite in the Western ore field, indicate that both mineralisation and mylonite are Variscan in age and suggest that the shear zone was active for ∼ 20 million years. Early stage tungsten mineralisation (Scheelite 1) in quartzitic ores in the Eastern ore field, which is free of molybdenite, yielded very low to near blank levels of Re and Os and thus could not be dated. However, molybdenite from scheelite–quartz stringers, previously interpreted as a feeder stockwork to quartzitic scheelite ore of presumed Cambrian age, yielded Variscan Re–Os ages of ∼ 342 and ∼ 337 Ma. Dating of molybdenite contained in scheelite ores thus far provides no indication of a Cambrian component to the tungsten mineralisation. Our data are consistent with a model of either granite intrusion-related ore formation and coeval metamorphic overprint during the Early Carboniferous or, alternatively, molybdenite formation may be exclusively attributed to Variscan metamorphism (see Stein 2006).     

Single frequency processing of Ørsted GPS radio occultation measurements

The Global Positioning System (GPS) radio occultation measurements obtained using the TurboRogue GPS receiver on the Danish satellite Ørsted have been processed using the single frequency method. Atmospheric profiles of refractivity and temperature are derived and validated against numerical weather prediction data from the European Centre for Medium-Range Weather Forecast (ECMWF). Results from the Ørsted GPS measurement campaign in February 2000 indicate that the single frequency method can provide retrievals with accuracy comparable to that of using two frequencies. From comparisons between measured dry temperature profiles and corresponding dry temperature profiles derived from ECMWF analysis fields, we find a mean difference of less than 0.5 K and a standard deviation of 2–4 K between 500 and 30 hPa in height. Above 30 hPa the impact of the ionosphere becomes more dominant and more difficult to eliminate using the single frequency method, and the results show degraded accuracy when compared to previous analysis results of occultation data from other missions using the dual frequency method. At latitudes less than 40° (denoted low latitudes), the standard deviation is generally smaller than at latitudes higher than 40° (denoted high latitudes). A small temperature bias is observed centered at 200 hPa for low latitudes and at 300 hPa for high latitudes. This indicates that the ECMWF analyses do not adequately resolve the tropopause temperature minimum. In the lowest part of the troposphere an observed warm bias is thought to be due to erroneous tracking of the GPS signal in cases of atmospheric multipath propagation.     

The onset of Pleistocene glaciation in the Barents Sea: implications for glacial isostatic adjustment

In this paper the effect of a delayed onset of glaciation in the Barents Sea on glacial isostatic adjustment is investigated. The model calculations solve the sea-level equation governing the total mass redistributions associated with the last glaciation cycle on a spherically symmetric, linear, Maxwell viscoelastic earth for two different scenarios for the growth phase of the Barents Sea ice sheet. In the first ice model a linear growing history is used for the Barents Sea ice sheet, which closely relates its development to the build-up of other major Late Pleistocene ice sheets. In the second ice model the accumulation of the Barents Sea ice sheet is restricted to the last 6 ka prior to the last glacial maximum.
The calculations predict relative sea levels, present-day radial velocities, and gravity anomalies for the area formerly covered by the Weichselian ice sheet. The results show that observed relative sea levels in the Barents Sea are appropriate for distinguishing between the different glaciation histories. In particular, present-day observables such as the free-air gravity anomaly over the Barents Sea, and the present-day radial velocities are sensitive to changes in the glaciation history on this scale.
A palaeobathymetry derived from relative sea-level predictions before the last glacial maximum based on the second ice model essentially agrees with a palaeobathymetry derived by Lambeck (1995). The additional emerged areas provide centres for the build-up of an ice sheet and thus support the theory of Hald, Danielsen & Lorentzen (1990) and Mangerud et al. (1992) that the Barents Sea was an essentially marine environment shortly before the last glacial maximum.     

Life cycle of Agapetus fuscipes (Trichoptera, Glossosomatidae) in a first-order upland stream in central Germany

The number of immature stages and the seasonal patterns of development are basic life history features of a stream dwelling species and knowledge about these important components are essential for understanding its adaptations to its dynamic environment. The life cycle of Agapetus fuscipes (Trichoptera, Glossosomatidae), one of the dominant scrapers in the upper and middle reaches of the Breitenbach, a first-order upland stream in central Germany, was analysed. The pronotum length and the relationship between pronotum length, larval biomass and case length showed seven distinct larval instars, contrary to earlier findings from the Breitenbach. In addition to a few trichopteran species from other functional feeding groups, A. fuscipes is the only scraping caddis fly reported to have more than five larval instars. The moult increments of pronotum length and larval biomass were distinctly lower than in glossosomatid species with five larval instars. A. fuscipes is clearly univoltine in the Breitenbach. First-instar larvae were found from July to the beginning of December, and second-instar larvae from July to January. At the beginning of December the population consisted of the instars I to V, and development did not cease during winter. The sixth-instar larvae occurred mostly in January, and the seventh-instar larvae were never present before January. The prepupae and pupae occurred in April. The last pupae were found at the beginning of September, although most of the emergence took place in June and July. At least five different immature stages with different ecological demands were present at any time throughout the year. The ecological advantage having two additional larval instars compared to other glossosomatid species may be to compensate for the high rate of mouthpart wear that occurs while the larvae feed on the rough Bunter Sandstone substratum. A further advantage may be to spread the risk of high mortality under unfavourable environmental conditions.     

Discrete element model for crack propagation in brittle materials

We propose a discrete element model for brittle rupture. The material consists of a bidimensional set of closed‐packed particles in contact. We explore the isotropic elastic behavior of this regular structure to derive a rupture criterion compatible to continuum mechanics. We introduce a classical criterion of mixed mode crack propagation based on the value of the stress intensity factors, obtained by the analysis of two adjacent contacts near a crack tip. Hence, the toughness becomes a direct parameter of the model, without any calibration procedure. We verify the consistency of the formulation as well as its convergence by comparison with theoretical solutions of tensile cracks, a pre‐cracked beam, and an inclined crack under biaxial stress. Copyright © 2015 John Wiley & Sons, Ltd.     

Assessment of small-diameter shallow wells for managed aquifer recharge at a site in southern Styria,Austria

An approach to establish the recharge component of managed aquifer recharge (MAR) has recently been proposed that uses small-diameter shallow wells installed using relatively inexpensive drilling methods such as direct push. As part of further development of that approach, a generalized procedure is presented for a technical and economic assessment of the approach’s potential in comparison to other systems. Following this procedure, the use of small-diameter wells was evaluated both experimentally and numerically for a site located in southern Styria, Austria. MAR is currently done at the site using a horizontal pipe infiltration system, and system expansion has been proposed with a target rate of 12 l/s using small-diameter wells as one possible option. A short-duration single-well field recharge experiment (recharge rate 1.3–3.5 l/s) was performed (recharge by gravity only). Numerical modeling of the injection test was used to estimate hydraulic conductivity (K). Quasi-steady-state, single-well recharge simulations for different locations, as well as a long-term transient simulation, were performed using the K value calibrated from the field injection test. Results indicate that a recharge capacity of 4.1 l/s was achievable with a maximum head rise of 0.2 m at the injection well. Finally, simulations were performed for three different well fields (4, 6 and 8 wells, respectively) designed to infiltrate a target rate of 12 l/s. The experimental and numerical assessments, supported by a cost analysis of the small-diameter wells, indicate that the small-diameter wells are a viable, cost-effective recharge approach at this and other similar sites.