Verification and mitigation of the power-induced measurement errors for airport pseudolites in LAAS

Certain GPS receivers exhibit a power-induced measurement error when the input signal power exceeds a certain threshold that is a function of the receiver architecture. The characterization of this error is important in the case of airport pseudolites (APLs) due to receiver saturation at ranges close to the transmission antenna. This paper details an effort using laboratory test to characterize the power-induced measurement error in NovAtel Millennium and Beeline receivers that are widely used for APL development. The results from the laboratory tests show that this effect can lead to errors as large as 3 m on pseudorange measurement for the dynamic range typical for APLs. The carrier-phase error however is seen to be limited to 5 cm. On the verification and characterization of the error, a cost-effective mitigation technique for LAAS is proposed. A solution for the ground subsystem is sought by employing power-control measures to limit the amount of APL power that LGF GPS/APL receivers are exposed to. In order to keep the integration cost low, the solution for the airborne subsystem does not involve hardware modifications or additions, but rather relies on the transition to a differential carrier-phase positioning algorithm prior to the onset of the power-induced error along the approach path. The proposed architecture was flight-tested to verify successful mitigation of the power-induced error on both the ground and air, and the results from these tests are presented in the paper.     

Reliability checking for GNSS baseline and network processing

Reliability analysis is inseparably connected with the formulation of failure scenarios, and common test statistics are based on specific assumptions. This is easily overlooked when processing observation differences. Poor failure identification performance and misleading pre-analysis results, mainly meaningless minimum detectable biases and external reliability measures, are the consequence. A reasonable failure scenario for use with differenced GNSS observations is formulated which takes into account that individual outliers in the original data affect more than one processed observation. The proper test statistics and reliability indicators are given for use with correlated observations and both batch processing and Kalman filtering. It is also shown that standardized residuals and redundancy numbers fail completely when used with double differenced observations.

Analysis of temporal sar and optical data for rice mapping

This study investigates the potential of multi-temporal signature analysis of satellite imagery to map rice area in South 24 Paraganas district of West Bengal. Two optical data (IRS ID LISS III) and three RADARSAT SAR data of different dates were acquired during 2001. Multi-temporal SAR backscatter signatures of different landcovers were incorporated into knowledge based decision rules and kharif landcover map was generated. Based on the spectral variation in signature, the optical data acquired during rabi (January) and summer (March) season were classified using supervised maximum likelihood classifier. A co-incidence matrix was generated using logical approach for a combined “rabi-summer” and “kharif-rabi-summer” landcover mapping. The major landcovers obtained in South 24 Paraganas using remote sensing data are rice, water, aquaculture ponds, homestead, mangrove, and urban area. The classification accuracy of rice area was 98.2% using SAR data. However, while generating combined “kharif-rabi-summer” landcovers, the classification accuracy of rice area was improved from 81.6% (optical data) to 96.6% (combined SAR-Optical). The primary aim of the study is to achieve better accuracy in classifying rice area using the synergy between the two kinds of remotely sensed data.     

Micro- and nano-textural evidence of Ti(–Ca–Fe) mobility during fluid–rock interactions in carbonaceous lawsonite-bearing rocks from New Zealand

Understanding the mobility of chemical elements during fluid–rock interactions is critical to assess the geochemical evolution of a rock undergoing burial and metamorphism and, more generally, to constrain the geochemical budget of the subduction factory. In particular, determining the behavior and mobility of Ti in aqueous fluids constitutes a great challenge that is still under scrutiny. Here, we study plant fossils preserved in blueschist metasedimentary rocks from the Marybank Formation (New Zealand). Using scanning and transmission electron microscopies (SEM and TEM), we show that the carbonaceous material (CM) composing the fossils contains abundant nano-inclusions of Ti- and Fe-oxides. These nanocrystals are mainly anatase, rutile, and Fe–Ti oxides. The mineral composition observed within the fossils is significantly different from that detected in the surrounding rock matrix. We propose that Ti and Fe might have been mobilized by the alteration of a detrital Ti–Fe-rich protolith during an early diagenetic event under acidic and reducing conditions. Aqueous fluids rich in organic ligands released by the degradation of organic matter may have been involved. Moreover, using mass balance and petrological observations, we show that the contrasted mineralogy between the rock matrix and the fossil CM might be the consequence of the chemical isolation of fossil CM during the prograde path of the rock. Such an isolation results from the early formation of quartz and Fe-rich phyllosilicate layers enclosing the fossil as characterized by SEM and TEM investigations. Overall, this study shows that investigating minerals associated with CM down to the nanometer scale in metamorphic rocks can provide a precious record of early prograde geochemical conditions.     

Comparison of near-fault and far-fault ground motion effects on geometrically nonlinear earthquake behavior of suspension bridges

This paper presents a comparison of near-fault and far-fault ground motion effects on geometrically nonlinear earthquake behavior of suspension bridges. Bo?azi?i (The First Bosporus) and Fatih Sultan Mehmet (Second Bosporus) suspension bridges built in Istanbul, Turkey, are selected as numerical examples. Both bridges have almost the same span. While Bo?azi?i Suspension Bridge has inclined hangers, Fatih Sultan Mehmet Suspension Bridge has vertical hangers. Geometric nonlinearity including P-delta effects from self-weight of the bridges is taken into account in the determination of the dynamic behavior of the suspension bridges for near-fault and far-fault ground motions. Near-fault and far-fault strong ground motion records, which have approximately identical peak ground accelerations, of 1999 Chi-Chi, 1999 Kocaeli, and 1979 Imperial Valley earthquakes are selected for the analyses. Displacements and internal forces of the bridges are determined using the finite element method including geometric nonlinearity. The displacements and internal forces obtained from the dynamic analyses of suspension bridges subjected to each fault effect are compared with each other. It is clearly seen that near-fault ground motions are more effective than far-fault ground motion on the displacements and internal forces such as bending moment, shear force and axial forces of the suspension bridges.     

A Raman spectroscopic study on the structural disorder of monazite–(Ce)

This study addresses whether Raman spectra can be used to estimate the degree of accumulated radiation damage in monazite-(Ce) samples whose chemical composition was previously determined. Our results indicate that the degree of disorder in monazite–(Ce), as observed from increasing Raman band broadening, generally depends on both the structural state (i.e., radiation damage) and the chemical composition (i.e., incorporation of non-formula elements). The chemical effects were studied on synthetic orthophosphates grown using the Li-Mo flux method, and non radiation-damaged analogues of the naturally radiation-damaged monazite–(Ce) samples, produced by dry annealing. We found that the “chemical” Raman-band broadening of natural monazite–(Ce) can be predicted by the empirical formula, $$ {\hbox{FWHM}} {\hbox{[c}}{{\hbox{m}}^{ - {1}}}{]} = {3}{.95} + {26}{.66} \times {\hbox{(Th}} + {\hbox{U}} + {\hbox{Ca}} + {\hbox{Pb)}} {\hbox{[apfu]}} $$ where, FWHM = full width at half maximum of the main Raman band of monazite–(Ce) (i.e., the symmetric PO₄ stretching near 970?cm^?1), and (Th+U+Ca+Pb) = sum of the four elements in apfu (atoms per formula unit). Provided the chemical composition of a natural monazite–(Ce) is known, this “chemical band broadening” can be used to estimate the degree of structural radiation damage from the observed FWHM of the ν₁(PO₄) band of that particular sample using Raman spectroscopy. Our annealing studies on a wide range of monazite–(Ce) reference materials and other monazite–(Ce) samples confirmed that this mineral virtually never becomes highly radiation damaged. Potential advantages and the practical use of the proposed method in the Earth sciences are discussed.     

Deciphering the Variscan tectonothermal overprint and deformation partitioning in the Cadomian basement of the Teplá–Barrandian unit, Bohemian Massif

The Teplá–Barrandian unit (TBU) has long been considered as a simply bivergent supracrustal ‘median massif’ above the Saxothuringian subduction zone in the Variscan orogenic belt. This contribution reveals a much more complex style of the Variscan tectonometamorphic overprint and resulting architecture of the Neoproterozoic basement of the TBU. For the first time, we describe the crustal-scale NE–SW-trending dextral transpressional Krakovec shear zone (KSZ) that intersects the TBU and thrusts its higher grade northwestern portion severely reworked by Variscan deformation over a southeastern very low grade portion with well-preserved Cadomian structures and only brittle Variscan deformation. The age of movements along the KSZ is inferred as Late Devonian (~380–370?Ma). On the basis of structural, microstructural, and anisotropy of magnetic susceptibility data from the KSZ, we propose a new synthetic model for the deformation partitioning in the Teplá–Barrandian upper crust in response to the Late Devonian to early Carboniferous subduction and underthrusting of the Saxothuringan lithosphere. We conclude that the Saxothuringian/Teplá–Barrandian convergence was nearly frontal during ~380–346?Ma and was partitioned into pure shear dominated domains that accommodated orogen-perpendicular shortening alternating with orogen-parallel high-strain domains that accommodated dextral transpression or bilateral extrusion. The synconvergent shortening of the TBU was terminated by a rapid gravity-driven collapse of the thickened lithosphere at ~346–337?Ma followed by, or partly simultaneous with, dextral strike-slip along the Baltica margin-parallel zones, driven by the westward movement of Gondwana from approximately 345?Ma onwards.     

Evolution of geochemistry and depositional settings of Early Palaeozoic siliciclastics of the Barrandian (Teplá-Barrandian Unit,Bohemian Massif,Czech Republic)

Cambrian and Ordovician-Middle Devonian sequences of two successive Early Palaeozoic basins of the Barrandian unconformably overlie Cadomian basement in the Bohemian Massif NW interior (Teplá-Barrandian unit) which is the easternmost peri-Gondwanan remnant within the Variscides. Correlation of stratigraphy and geochemistry of the Early Palaeozoic siliciclastic rocks elucidated sediment provenances. Sandstones of the Middle Cambrian Píbram-Jince Basin were derived from a Cadomian Neoproterozoic island arc. The source area of the Ordovician shallow-marine siliciclastics of the successor Prague Basin is a dissected Cadomian orogen. Late Cambrian acid volcanics of the Barrandian and Cambrian (meta)granitoids emplaced in the W part of the Teplá-Barrandian Cadomian basement are also discernible in these sediments. Old sedimentary component increased during the Ordovician. Early Llandovery siliciclastic rocks show characteristics of an abruptly weakened supply of terrigenous material and an elevated proportion of synsedimentary basic volcanics as a result of Silurian transgression. Emsian siliciclastics (intercalated in the Late Silurian to Early Devonian limestone suite) presumably comprise an addition of coeval basic/ultrabasic volcaniclastics. Middle Devonian flysch-like siliciclastics indicate reappearance of Cadomian source near the Barrandian during early Variscan convergences of Armorican microplates that preceeded accretion of the Teplá-Barrandian unit within the Bohemian Massif terrane mosaic.Dr. Patoka deceased in July 2004.     

Building and Testing an <Emphasis Type="Italic">a priori</Emphasis> Geophysical Model for Western Eurasia and North Africa

We construct and evaluate a new three-dimensional model of crust and upper mantle structure in Western Eurasia and North Africa (WENA) extending to 700 km depth and having 1° parameterization. The model is compiled in an a priori fashion entirely from existing geophysical literature, specifically, combining two regionalized crustal models with a high-resolution global sediment model and a global upper mantle model. The resulting WENA1.0 model consists of 24 layers: water, three sediment layers, upper, middle, and lower crust, uppermost mantle, and 16 additional upper mantle layers. Each of the layers is specified by its depth, compressional and shear velocity, density, and attenuation (quality factors, Q _P and Q _S ). The model is tested by comparing the model predictions with geophysical observations including: crustal thickness, surface wave group and phase velocities, upper mantle _n velocities, receiver functions, P-wave travel times, waveform characteristics, regional 1-D velocities, and Bouguer gravity. We find generally good agreement between WENA1.0 model predictions and empirical observations for a wide variety of independent data sets. We believe this model is representative of our current knowledge of crust and upper mantle structure in the WENA region and can successfully be used to model the propagation characteristics of regional seismic waveform data. The WENA1.0 model will continue to evolve as new data are incorporated into future validations and any new deficiencies in the model are identified. Eventually this a priori model will serve as the initial starting model for a multiple data set tomographic inversion for structure of the Eurasian continent.     

Fast and direct nonparametric procedures in the L-moment homogeneity test

Regional frequency analysis is an important tool to properly estimate hydrological characteristics at ungauged or partially gauged sites in order to prevent hydrological disasters. The delineation of homogeneous groups of sites is an important first step in order to transfer information and obtain accurate quantile estimates at the target site. The Hosking–Wallis homogeneity test is usually used to test the homogeneity of the selected sites. Despite its usefulness and good power, it presents some drawbacks including the subjective choice of a parametric distribution for the data and a poorly justified rejection threshold. The present paper addresses these drawbacks by integrating nonparametric procedures in the L-moment homogeneity test. To assess the rejection threshold, three resampling methods (permutation, bootstrap and Pólya resampling) are considered. Results indicate that permutation and bootstrap methods perform better than the parametric Hosking–Wallis test in terms of power as well as in time and procedure simplicity. A real-world case study shows that the nonparametric tests agree with the HW test concerning the homogeneity of the volume and the bivariate case while they disagree for the peak case, but that the assumptions of the HW test are not well respected.