钻井利器的故事之“铝合金钻杆”

地球科学的发展对地球深部数据的依赖程度越来越高,作为“入地”重要手段的科学超深井工程是研究深部地质学的重要方法,被誉为是“伸入地壳的望远镜”。与钢钻杆相比,铝合金钻杆以其独特的优越性(质量轻、比强度高、钻进深度深、所需能耗少),已成为难进入地区、大位移井、超深井等钻柱设计的优选方案。本文从科普的角度介绍了钻柱与钻杆的区别、钻柱的使用极限长度、铝合金钻杆的技术优势及其现存的不足之处,以此提高对铝合金钻杆的认识,促进铝合金钻杆的研究和发展。     

Occurrence and conceptual sedimentary model of Cambrian gypsum-bearing evaporites in the Sichuan Basin,SW China

During the Cambrian, gypsum-bearing evaporites formed in the Sichuan Basin, SW China. These rocks are important for oil and gas sealing, but details of their distribution and origin are not well established. This study examines the regional distribution and origin of the gypsum-bearing evaporites using a comprehensive analysis of drilling data from 34 wells, 5 measured cross-sections in the basin and surrounding area, and 96 maps of area-survey data. Results show that in the stratigraphic succession, the gypsum-bearing evaporites occur mainly in the Lower Cambrian Longwangmiao Formation, the Middle Cambrian Douposi Formation, and the Middle-Upper Cambrian Xixiangchi Group. Geographically, the rocks are found mainly in the southeastern part of the basin, and the distribution of deposits shows an overall SW-NE trend. The sedimentary environments for evaporite formation were evaporative lagoon and inter-platform basin in a platform setting. Gypsum was generated by the underwater concentration of sea water in a strongly evaporative environment. Both an evaporative restricted platform and a mixeddeposition restricted platform model appear to be applicable to the development of gypsum in the Sichuan Basin. The gypsum-bearing evaporites with the best sealing capacity are located mostly in the southeastern part of the basin. These constraints can be applied directly to regional exploration, and have implications for the regional paleogeography and paleoclimate.     

Impacts of hydrous manganese oxide on the retention and lability of dissolved organic matter

Minerals constitute a primary ecosystem control on organic C decomposition in soils, and therefore on greenhouse gas fluxes to the atmosphere. Secondary minerals, in particular, Fe and Al (oxyhydr)oxides—collectively referred to as “oxides” hereafter—are prominent protectors of organic C against microbial decomposition through sorption and complexation reactions. However, the impacts of Mn oxides on organic C retention and lability in soils are poorly understood. Here we show that hydrous Mn oxide (HMO), a poorly crystalline δ-MnO₂, has a greater maximum sorption capacity for dissolved organic matter (DOM) derived from a deciduous forest composite O_i, O_e, and O_a horizon leachate (“O horizon leachate” hereafter) than does goethite under acidic (pH 5) conditions. Nonetheless, goethite has a stronger sorption capacity for DOM at low initial C:(Mn or Fe) molar ratios compared to HMO, probably due to ligand exchange with carboxylate groups as revealed by attenuated total reflectance-Fourier transform infrared spectroscopy. X-ray photoelectron spectroscopy and scanning transmission X-ray microscopy–near-edge X-ray absorption fine structure spectroscopy coupled with Mn mass balance calculations reveal that DOM sorption onto HMO induces partial Mn reductive dissolution and Mn reduction of the residual HMO. X-ray photoelectron spectroscopy further shows increasing Mn(II) concentrations are correlated with increasing oxidized C (C=O) content (r = 0.78, P < 0.0006) on the DOM–HMO complexes. We posit that DOM is the more probable reductant of HMO, as Mn(II)-induced HMO dissolution does not alter the Mn speciation of the residual HMO at pH 5. At a lower C loading (2 × 10² μg C m^?2), DOM desorption—assessed by 0.1 M NaH₂PO₄ extraction—is lower for HMO than for goethite, whereas the extent of desorption is the same at a higher C loading (4 × 10² μg C m^?2). No significant differences are observed in the impacts of HMO and goethite on the biodegradability of the DOM remaining in solution after DOM sorption reaches steady state. Overall, HMO shows a relatively strong capacity to sorb DOM and resist phosphate-induced desorption, but DOM–HMO complexes may be more vulnerable to reductive dissolution than DOM–goethite complexes.     

冻融循环对不同孔隙率页岩相似材料影响的试验研究

基于地质力学模型试验的相似理论,针对寒区岩体工程,分别制作了5种不同孔隙率的页岩相似材料,进行冻融循环试验,探究不同孔隙率的页岩相似材料在冻融前后,其主要物理力学参数的变化规律。试验研究表明：在冻融循环后,页岩相似材料的单轴抗压强度、三轴抗压强度、弹性模量、粘聚力、内摩擦角有不同程度的减小,孔隙率、泊松比有不同程度的增大。页岩相似材料的物理力学参数受冻融循环的影响随孔隙率的增大先增大后减小,孔隙率处于9.4%~13.6%时,受冻融循环影响最大;孔隙率处于5.8%~9.4%时,受冻融循环的影响随孔隙率的增大有增大的趋势;孔隙率处于13.9%~19.1%时,受冻融循环的影响随孔隙率的增大有减小的趋势。研究结果可以为西部寒区的岩土工程建设和减灾提供相关的科学依据。     

基于面向对象分类的稀土开采区遥感信息提取方法研究

离子吸附型稀土矿是我国宝贵的矿产资源,运用遥感影像分类技术提取稀土开采区可以准确地实现对稀土开采状况的监测,但仅利用光谱信息往往难以保证分类精度。本文以江西寻乌稀土矿区为研究区,以IKONOS影像为数据源,应用面向对象分类方法提取了稀土开采区的遥感信息。针对稀土开采区的分布特点,选择基于边缘的分割算法进行影像分割;结合地形信息、光谱信息及几何信息建立规则集,进行特征提取;最后采用隶属度函数法实现面向对象分类,并与传统的光谱角填图分类进行对比分析。研究结果表明,面向对象分类法提取稀土开采区的总体精度为92.49%,Kappa系数为0.857 6,与传统监督分类方法相比有了很大的提高。     

页岩压裂影响因素三维模型数值分析

不同影响因素对页岩水力压裂效果有不同的影响。基于三维数值计算模型介绍了水力压裂的典型过程,针对水平最小主应力、页岩的弹性模量和渗透系数对压裂的影响进行了分析。结果表明:随着水平最小主应力的增加,裂缝高度也随之增加;随着页岩的弹性模量增加,裂缝的高度随之降低;随着渗透系数的增加,裂缝高度也随之增加;随着压裂液的黏度系数提高,裂缝的高度降低。     

几内亚福雷卡里亚YML铁矿区的富铁矿床地质特征及找矿前景探讨

YML铁矿区位于几内亚福雷卡里亚省,富铁矿以条带状赤铁矿和铁角砾岩矿为主。矿区内共发育7条矿体,条带状赤铁矿体6条,铁角砾岩矿体1条。条带状赤铁矿体赋存部位多为向形地段,次级紧密褶皱发育,沿走向和倾向有逐渐变薄和尖灭的趋势;铁角砾岩矿体覆盖于地表,以风化壳的形式出现。矿床类型属复合类型,即海底热液喷气沉积叠加后期构造变质型+风化淋滤型。该区具备铁矿形成和保存的地质条件,且已发现具一定储量、品位较高的条带状赤铁矿和大面积的铁角砾岩分布区,区内铁矿找矿远景较好。     

菲律宾迪纳加特岛30#矿权区红土型镍矿床地质特征及成矿作用探讨

30~#矿权区位于菲律宾迪纳加特岛北部,区内发育有红土型镍矿床。本次勘查圈定4处矿(化)体,其中以Ⅰ、Ⅱ、Ⅲ矿(化)体的矿化范围较大,厚度变化系数为45%~50%(相对稳定),经济价值较高。红土型镍矿体平面上呈地毯状展布于地表,厚度受地形控制,富镍矿体分布于矿权区东部的5、6、11、12小区;剖面上从地表向深部矿体为铁质红土层、松散红土层及高岭土化蛇纹石化橄榄岩层。30~#矿权区红土镍矿矿床的形成经历了从普通矿到富矿两个阶段,红土镍矿石属于酸性矿石。     

川西南荥经坳陷川荥页1井奥陶系沉积相与古生物特征及地层厘定

对川西南荥经坳陷内三口页岩气井尤其是川荥页1井奥陶系开展了系统的岩心观察和分析。三口钻井在梁山组之下均发育十余米厚的灰黑色泥岩,其中川荥页1井灰黑色泥岩厚近16m。沉积相分析认为灰黑色泥岩为浅水陆棚相,泥岩之下发育的大套砂岩为滨岸近滨亚相,总体向上海水逐渐变深。砂岩中发育丰富的沉积软变形构造及波状交错层理、浪成沙纹层理、平行层理、斜层理等构造。川荥页1井上部泥岩中见大量三叶虫、笔石和腕足等化石及其碎片,鉴定表明含有代表中下奥陶统的常见生物分子,如对笔石(Didymograotus sp.)、大洪山虫(Taihungshania sp.)等。该套砂泥岩组合在沉积相及古生物化石等方面明显区别于荥经坳陷周缘奥陶系五峰组—志留系龙马溪组,与研究区及邻区中下奥陶统红石崖组、湄潭组、大湾组、大官山组中段等层位相当。     

机载北斗差分定位系统的测量船应用

针对测量船测控设备传统精度检测方法的局限性,该文提出了使用搭载北斗差分定位系统的无人机检测测控设备测量精度的方案。在充分分析北斗系统应用于精度检测可行性的基础上,研制了一套适用于码头和海上的无人机差分定位系统,并通过该系统的单站静态和双站动态差分实验,验证了基于北斗系统的无人机精度检测系统的性能与精度指标。最后通过测控设备跟踪测量无人机实验,检测了标校经纬仪和脉冲雷达设备的测距、测角精度。