Isotope variations in a Sierra Nevada snowpack and their relation to meltwater

Isotopic variations in melting snow are poorly understood. We made weekly measurements at the Central Sierra Snow Laboratory, California, of snow temperature, density, water equivalent and liquid water volume to examine how physical changes within the snowpack govern meltwater δ¹⁸O. Snowpack samples were extracted at 0.1 m intervals from ground level to the top of the snowpack profile between December 1991 and April 1992. Approximately 800 mm of precipitation fell during the study period with δ¹⁸O values between −21.35 and −4.25‰. Corresponding snowpack δ¹⁸O ranged from −22.25 to −6.25‰. The coefficient of variation of δ¹⁸O in snowpack levels decreased from −0.37 to −0.07 from winter to spring, indicating isotopic snowpack homogenization. Meltwater δ¹⁸O ranged from −15.30 to −8.05‰, with variations of up to 2.95‰ observed within a single snowmelt episode, highlighting the need for frequent sampling. Early snowmelt originated in the lower snowpack with higher δ¹⁸O through ground heat flux and rainfall. After the snowpack became isothermal, infiltrating snowmelt displaced the higher δ¹⁸O liquid in the lower snowpack through a piston flow process. Fractionation analysis using a two-component mixing model on the isothermal snowpack indicated that δ¹⁸O in the initial and final half of major snowmelt was 1.30‰ lower and 1.45‰ higher, respectively, than the value from simple mixing. Mean snowpack δ¹⁸O on individual profiling days showed a steady increase from −15.15 to −12.05‰ due to removal of lower δ¹⁸O snowmelt and addition of higher δ¹⁸O rainfall. Results suggest that direct sampling of snowmelt and snow cores should be undertaken to quantify tracer input compositions adequately. The snowmelt sequence also suggests that regimes of early lower δ¹⁸O and later higher δ¹⁸O melt may be modeled and used in catchment tracing studies.     

Lithium and lithium isotope profiles through the upper oceanic crust: a study of seawater-basalt exchange at ODP Sites 504B and 896A

Ocean Drilling Program (ODP) Hole 504B near the Costa Rica Rift is the deepest hole drilled in the ocean crust, penetrating a volcanic section, a transition zone and a sheeted dike complex. The distribution of Li and its isotopes through this 1.8-km section of oceanic crust reflects the varying conditions of seawater alteration with depth. The upper volcanic rocks, altered at low temperatures, are enriched in Li (5.6-27.3 ppm) and have heavier isotopic compositions (δ⁷Li=6.6-20.8‰) relative to fresh mid-ocean ridge basalt (MORB) due to uptake of seawater Li into alteration clays. The Li content and isotopic compositions of the deeper volcanic rocks are similar to MORB, reflecting restricted seawater circulation in this section. The transition zone is a region of mixing of seawater with upwelling hydrothermal fluids and sulfide mineralization. Li enrichment in this zone is accompanied by relatively light isotopic compositions (−0.8-2.1‰) which signify influence of basalt-derived Li during mineralization and alteration. Li decreases with depth to 0.6 ppm in the sheeted dike complex as a result of increasing hydrothermal extraction in the high-temperature reaction zone. Rocks in the dike complex have variable isotopic values that range from −1.7 to 7.9‰, depending on the extent of hydrothermal recrystallization and off-axis low-temperature alteration. Hydrothermally altered rocks are isotopically light because ⁶Li is preferentially retained in greenschist and amphibolite facies minerals. The δ⁷Li values of the highly altered rocks of the dike complex are complementary to those of high-temperature mid-ocean ridge vent fluids and compatible to equilibrium control by the alteration mineral assemblage. The inventory of Li in basement rocks permits a reevaluation of the role of oceanic crust in the budget of Li in the ocean. On balance, the upper 1.8 km of oceanic crusts remains a sink for oceanic Li. The observations at 504B and an estimated flux from the underlying 0.5 km of gabbro suggest that the global hydrothermal flux is at most 8×10⁹ mol/yr, compatible with geophysical thermal models. This work defines the distribution of Li and its isotopes in the upper ocean crust and provides a basis to interpret the contribution of subducted lithosphere to arc magmas and cycling of crustal material in the deep mantle.     

The Triassic age for oceanic eclogites in the Dabie orogen: Entrainment of oceanic fragments in the continental subduction

Low-temperature and high-pressure eclogites with an oceanic affinity in the western part of the Dabie orogen have been investigated with combined Lu–Hf and U–Pb geochronology. These eclogites formed over a range of temperatures (482–565 °C and 1.9–2.2 GPa). Three eclogites, which were sampled from the Gaoqiao country, yielded Lu–Hf ages of 240.7 ± 1.2 Ma, 243.3 ± 4.1 Ma and 238.3 ± 1.2 Ma, with a corresponding lower-intercept U–Pb zircon age of 232 ± 26 Ma. Despite the well-preserved prograde major- and trace-element zoning in garnets, these Lu–Hf ages mostly reflect the high-pressure eclogite-facies metamorphism instead of representing the early phase of garnet growth due to the occurrence of omphacite inclusions from core to rim and the shell effect. An upper-intercept zircon U–Pb age of 765 ± 24 Ma is defined for the Gaoqiao eclogite, which is consistent with the weighted-mean age of 768 ± 21 Ma for the country gneiss. However, the gneiss has not been subjected to successive high-pressure metamorphism. The new Triassic ages are likely an estimate of the involvement of oceanic fragments in the continental subduction.     

Using Diurnal Temperature Signals to Infer Vertical Groundwater‐Surface Water Exchange

Heat is a powerful tracer to quantify fluid exchange between surface water and groundwater. Temperature time series can be used to estimate pore water fluid flux, and techniques can be employed to extend these estimates to produce detailed plan‐view flux maps. Key advantages of heat tracing include cost‐effective sensors and ease of data collection and interpretation, without the need for expensive and time‐consuming laboratory analyses or induced tracers. While the collection of temperature data in saturated sediments is relatively straightforward, several factors influence the reliability of flux estimates that are based on time series analysis (diurnal signals) of recorded temperatures. Sensor resolution and deployment are particularly important in obtaining robust flux estimates in upwelling conditions. Also, processing temperature time series data involves a sequence of complex steps, including filtering temperature signals, selection of appropriate thermal parameters, and selection of the optimal analytical solution for modeling. This review provides a synthesis of heat tracing using diurnal temperature oscillations, including details on optimal sensor selection and deployment, data processing, model parameterization, and an overview of computing tools available. Recent advances in diurnal temperature methods also provide the opportunity to determine local saturated thermal diffusivity, which can improve the accuracy of fluid flux modeling and sensor spacing, which is related to streambed scour and deposition. These parameters can also be used to determine the reliability of flux estimates from the use of heat as a tracer.     

Submerged cylinder wave energy device: theory and experiment

Linearized water wave theory is used to show that a submerged long circular cylinder suitably constrained by springs and dampers to make small harmonic oscillations, can be extremely efficient in absorbing the energy in an incident regular wave whose crests are parallel to the axis of the cylinder. Experimental results are described which confirm the theory for small amplitude waves and which suggest that the device can still be fairly efficient in waves of moderate amplitude.     

Contaminant concentrations and toxicity of sea-surface microlayer near Los Angeles, California

Sea-surface microlayer samples were collected from six nearshore areas receiving different amounts of anthropogenic inputs. The samples were analyzed for selected trace metals, chlorinated hydrocarbons, and polycyclic aromatic hydrocarbons. The relative toxicities of the samples were determined with fish embryo bioassays.Contaminant concentrations generally increased from offshore to the inshore stations. Contaminant concentrations were several orders of magnitude higher in microlayer samples from the highly industrialized Los Angeles and Long Beach harbors compared to samples from a site 15km offshore. Microlayer samples from the inshore stations were significantly more toxic, and induced significantly more developmental abnormalities and chromosome aberrations, than samples from the offshore stations.     

Climate change affecting temperature and aridity zones: a case study in Eastern Inner Mongolia, China from 1960–2008

Recent climate change is substantially affecting the spatial pattern of geographical zones, and the temporal and spatial inconsistency of climatic warming and drying patterns contributes to the complexity of the shifting of temperature and aridity zones. Eastern Inner Mongolia, China, located in the interface region of different biomes and ecogeographic zones, has experienced dramatic drying and warming over the past several decades. In this study, the annual accumulated temperature above 10 °C (AAT10) and the aridity index, two key indicators in geographical regionalization, are used to assess warming and drying processes and track the movements of temperature and aridity zones from 1960 to 2008. The results show a significant warming at the regional level from 1960 to 2008 with an AAT10 increase rate of 7.89 °C·d/year (p?<?0.001) in Eastern Inner Mongolia, while the drying trend was not significant during this period. Spatial heterogeneity of warming and drying distributions was also evident. Analysis of warming and drying via piecewise regression revealed two separate, specific trends between the first 31 years (1960–1990) and the subsequent 18 years (1991–2008). Generally, mild warming and very slight wetting occurred prior to 1990, while after 1991 both warming and drying were significant and enhanced. Continuous warming drove a northward shift of temperature zones from the 1960s to 2000s, while aridity zones displayed enhanced temporal and spatial variability. Climate change effects on temperature and aridity zones imply that the patterns of cropping systems, macro-ecosystems, and human land use modes are potentially undergoing migration and modification due to climate change.