Discussion on the dynamic mechanism of Great North China area based on the observed stress data

Introduction The Great North China, located at longitude 106E to 124E and latitude 31N to 42N, in-cludes three secondary active tectonic blocks, Ordos, Yanshan and North China plain (Figure 1). The geological tectonics of these three secondary blocks is much different from each other. As a stable block with high rigidity, the Ordos block is mostly surrounded by down-faulted basins with an inactive interior since Cenozoic, although the fault zones along its boundary are strongly active wi…     

Paleo-earthquake studies on the eastern section of the Kunlun fault

Introduction East Kunlun active fault is one of the largest sinistral slip fault zones in northern Tibetan Pla-teau. The fault tails primarily after the ancient eastern Kunlun suture zone, which was reactivatedby the northward subduction of the Indian plate beneath the Eurasian plate. The western end of thefault starts near the western flank of the Buxedaban peak in Qinghai Province. The fault then ex-tends eastwards through the Kusai Lake, Xidatan, Dongdatan, Alag Lake, Tuosuo Lak…     

The method of design for seismic data database system based on tree structure

Introduction In recent years, with the development of earthquake observation technology, increasing ofobservation stations and improvement of observation instruments which are digitalized and con-nected by network, a great deal of data is recorded, to some extend, which brings difficulty for usto manage and store them. It leads to traditional methods, which use the file system to managemass data, could not satisfy our requirement, and it is necessary to find a new method in place oftradit…     

The dependence of response spectrum on the tectonic ambient shear stress field

Introduction The acceleration response spectrum and peak ground acceleration are the necessary and im-portant parameters in earthquake-resistant design at present. They are still active research field. With the increase of digital high accurate strong motion observation data, especially the earth-quakes of Loma Prieta (M=7.0) in 1989; Landers (M=7.3) in 1992; Big Bear (M=6.4) in 1994 and Northridge (M=6.7) in 1994 in USA; Kozani (M=6.6) earthquake and afteshocks in 1995 in Greece; Dinar…     

On the applicability of KirchofPs law and the principle of heat balance in thermal infrared remote sensing:A non-isothermal system

This paper proposes a basic equation of thermal radiation interaction between surface objects on the basis of the principle of heat balance in the interface. The solution of this equation takes account of the contribution of sensible heat flux and latent heat flux more completely, compared with traditional solution for surface cooling and heating processes. By the aid of the experimental data conducted in the Xiaotangshan experimental site, Beijing, both the non-applicability of Kirchoff's law and the measurability of surface emissivity in a non-isothermal system have been highlighted. Two methods called ventilation and time-delay compensations have been proposed to reduce the error induced by change of surface temperatures of non-isothermal objects during the measurement of emissivity. Based on the solution of the basic equation, this paper has analyzed and pointed out the misunderstanding in comprehension and application of Kirchoff's law published in literature.     

Source time-function as discriminant using empirical Green’s function

Since the sign up of CTBT (Comprehensive Test Ban Treaty), the nuclear monitoring and distinguishing has gained great attention by the treaty countries. Seismology is one of the primary technical means available for monitoring compliance to a CTBT. However, there does not exist a single criterion, so far, that can effectively distinguish explorations from earthquakes. It has been known that source time function (abbreviated to STF) of an underground nuclear explosion contains important p…     

A study on the focal parameters of Shidian M =5.9 earthquake sequences in 2001

On the basis of about 300 earthquake wave forms observed in the Shidian M _S=5.9 sequences on April 12, 2001 recorded in Kunming Digital Seismic Network, the spectra of shear wave have been used to estimate the focal parameters of these earthquake sequences. The results show that within the magnitude range of 1.5–5.3, the seismic moments are 10¹⁰–10¹⁶ N·m, the corner frequencies are 0.2–0.8 Hz, radii of the focal rupture are 200–2 500 m and the stress drops are 0.1×10⁵–20×10⁵Pa. Through the statistical analyses of variation of corner frequency f _c and stress drop Δσ with time, it is discovered that the average corner frequency of the foreshock sequences is obviously lower than that of the aftershock sequences. Contrarily, the average stress drops Δσ of the foreshock sequences are clearly higher than that of the aftershocks. It is considered that these variation characteristics of average corner frequency and stress drops before and after the main shock have index significance to the precursory information before a strong earthquake. The higher stress drops for the foreshock sequences show that the higher shear stresses have been stored in the area of main shock. After the main shock, most of the stresses have been released, so the aftershock sequences show a rupture process of lower stresses. Foundation item: Scientific and Technological Key Project of Yunnan Province (2001NG46)     

Observed Evolution of Linear and Nonlinear Effects at the Dahan Downhole Array,Taiwan: Analysis of the September 21, 1999 M 7.3 Chi-Chi Earthquake Sequence

— In this paper, the site characteristics of the Dahan downhole array are studied by analyzing the September 21, 1999 M 7.3 Chi-Chi earthquake sequence including the main shock and some aftershocks. The four-level array (0 m, 50 m, 100 m and 200 m) is located to the north of Hualien City in eastern Taiwan. Polarization analysis is used to check the orientation errors of the seismometers at different levels of depth. If the surface instrument is chosen as reference, the angle between the major polarization axes of the surface and any downhole records is the orientation error that must be corrected for the downhole accelerographs. The orientation errors at depths of 50 m, 100 m and 200 m are 32°, 120° and –84°. After the corrections, the coherency between the surface and downhole records is substantially improved. Spectral ratio analysis shows that the predominant frequency of the Chi-Chi main shock shifts to a lower frequency. We also simulate ground motions at different depths by using the Haskell method with a linear velocity structure model. The record at surface is chosen as the input motion. Compared with the observed data, ground acceleration can be well reproduced for the aftershocks (weak-motion events) of the September 21, 1999 M 7.3 Chi-Chi earthquake. However, for the Chi-Chi main shock, the synthetic waveform cannot match well with the observation neither in amplitude nor in phase. This indicates that large ground shaking probably induced the nonlinear site effect at that time, and the model used cannot support it.Acknowledgement. The authors would like to express their thanks to Dr. L.F. Bonilla and one anonymous reviewer for their valuable suggestions. This research was supported by the National Science Council under grant number NSC 89-2921-M-194-007. The Institute of Earth Sciences, Academia Sinica supplied the strong-motion data. The support of these organizations is gratefully acknowledged.     

2-D crustal Poisson’s ratio from seismic travel time inversion in Changbaishan Tianchi volcanic region

Based on the inversion method of 2D velocity structure and interface, the crustal velocity structures of P-wave and S-wave along the profile L ₁ are determined simultaneously with deep seismic sounding data in Changbaishan Tianchi volcanic region, and then its Poisson’s ratio is obtained. Calculated results show that this technique overcomes some defects of traditional forward calculation method, and it is also very effective to determine Poisson’s ratio distribution of deep seismic sounding profile, especially useful for study on volcanic magma and crustal fault zone. Study result indicates that there is an abnormally high Poisson’s ratio body that is about 30 km wide and 12 km high in the low velocity region under Tianchi crater. Its value of Poisson’s ratio is 8% higher than that of surrounding medium and it should be the magma chamber formed from melted rock with high temperature. There is a high Poisson’s ratio zone ranging from magma chamber to the top of crust, which may be the uprise passage of hot substance. The lower part with high Poisson’s ratio, which stretches downward to Moho, is possibly the extrusion way of hot substance from the uppermost mantle. The conclusions above are consistent with the study results of both tomographic determination of 3D crustal structure and magnetotelluric survey in this region. Foundation item: Key Project from China Earthquake Administration and the Project (95-11-02-01) from Ministry of Science and Technology (2001DIA10003). Contribution No. RCEG200401, Geophysical Exploration Center, China Earthquake Administration.