Sediment source apportionment in Laurel Hill Creek,PA, using Bayesian chemical mass balance and isotope fingerprinting

A Bayesian chemical mass balance (CMB) approach was used to assess the contribution of potential sources for fluvial samples from Laurel Hill Creek in southwest Pennsylvania. The Bayesian approach provides joint probability density functions of the sources' contributions considering the uncertainties due to source and fluvial sample heterogeneity and measurement error. Both elemental profiles of sources and fluvial samples and ¹³C and ¹⁵N isotopes were used for source apportionment. The sources considered include stream bank erosion, forest, roads and agriculture (pasture and cropland). Agriculture was found to have the largest contribution, followed by stream bank erosion. Also, road erosion was found to have a significant contribution in three of the samples collected during lower‐intensity rain events. The source apportionment was performed with and without isotopes. The results were largely consistent; however, the use of isotopes was found to slightly increase the uncertainty in most of the cases. The correlation analysis between the contributions of sources shows strong correlations between stream bank and agriculture, whereas roads and forest seem to be less correlated to other sources. Thus, the method was better able to estimate road and forest contributions independently. The hypothesis that the contributions of sources are not seasonally changing was tested by assuming that all ten fluvial samples had the same source contributions. This hypothesis was rejected, demonstrating a significant seasonal variation in the sources of sediments in the stream. Copyright © 2014 John Wiley & Sons, Ltd.     

Arsenic incorporation into authigenic pyrite, Bengal Basin sediment, Bangladesh

Sediment from two deep boreholes (∼400 m) approximately 90 km apart in southern Bangladesh was analyzed by X-ray absorption spectroscopy (XAS), total chemical analyses, chemical extractions, and electron probe microanalysis to establish the importance of authigenic pyrite as a sink for arsenic in the Bengal Basin. Authigenic framboidal and massive pyrite (median values 1500 and 3200 ppm As, respectively), is the principal arsenic residence in sediment from both boreholes. Although pyrite is dominant, ferric oxyhydroxides and secondary iron phases contain a large fraction of the sediment-bound arsenic between approximately 20 and 100 m, which is the depth range of wells containing the greatest amount of dissolved arsenic. The lack of pyrite in this interval is attributed to rapid sediment deposition and a low sulfur flux from riverine and atmospheric sources. The ability of deeper aquifers (>150 m) to produce ground water with low dissolved arsenic in southern Bangladesh reflects adequate sulfur supplies and sufficient time to redistribute the arsenic into pyrite during diagenesis.     

Hormone loads exported by a tile‐drained agroecosystem receiving animal wastes

Little is known regarding hormone export from tile‐drained agricultural fields despite the widespread presence of tile drains in the Midwestern United States. By intensively measuring water flow rates and hormone concentrations in four subsurface tile drains and three receiving ditches at a working Midwest farm, hormone fluxes and loads from the tile‐drained fields were quantified. Before and during the 17‐month study period (January 2009 – May 2010), the associated farm fields received various animal waste applications (beef, dairy, poultry, sheep, and swine). Hormones monitored included the estrogens17β‐ and 17α‐estradiol, estrone, and estriol; the natural androgens testosterone, and androstenedione; and the synthetic androgens 17β‐ and 17α‐trenbolone, and trendione. Hormone loads measured in the ditches for three drainage areas during the entire 17‐month study period were in ranges of 16–58 mg/ha for total estrogens, 6.8–19 mg/ha for natural androgens, and 4.2–44 mg/ha for synthetic androgens. Because higher hormone concentrations generally occurred during discrete periods of increased flow, high flow rates often were associated with a disproportionately high hormone flux. For example, 80% of total estrogens and natural androgens exported into the ditches occurred during only 9–26% of the study period, coinciding with the most significant storm events. In addition, hormone fluxes were highest during storm events that occurred shortly after animal waste applications. Therefore, to effectively reduce hormone loads exported to downstream aquatic ecosystems in the absence of any application reduction, the short periods during which high‐flow events occur must be targeted. Copyright © 2012 John Wiley & Sons, Ltd.     

Constraining the Late Wisconsinan retreat of the Laurentide ice sheet from western Canada using luminescence ages from postglacial aeolian dunes

Optically stimulated luminescence (OSL) dating of quartz extracts from postglacial aeolian dunes from central Alberta in western Canada points to a landscape that was free of ice as early as 15 ka. Data from profiles where multiple ages have been obtained indicate an increase in depositional age with depth, suggesting that older aeolian sands underlie the dated sequences. The OSL ages present plausible minimum age constraints for the retreat of the Laurentide Ice Sheet (LIS) towards the end of the Late Wisconsinan glaciation. Previous reconstructions of the LIS recession have relied on radiocarbon chronologies, despite the scarcity of contemporaneous radiocarbon-bearing material for large parts of western Canada. While the OSL chronology may be deemed concordant with ice sheet margin retreat models determined using radiocarbon data, there appears to be a systematic lag in the radiocarbon ages which may reflect that aeolian activity is initiated prior to the proliferation of organic material. The OSL chronology reported in this study does not preclude the emergence of a wide deglacial corridor between the LIS and the Cordilleran Ice Sheet by 15 ka or earlier. The possibility of such a passage would resuscitate the notion of an ice-free corridor that appeared early enough to afford the first peoples of the Americas a navigable inland migratory passage from Beringia to south of the North American ice sheets. More broadly, the corridor would also have allowed genetic exchanges between the Beringian refugium and the American middle and low latitudes.     

Columnar jointing in vapor-phase-altered,non-welded Cerro Galán Ignimbrite,Paycuqui, Argentina

Columnar jointing is thought to occur primarily in lavas and welded pyroclastic flow deposits. However, the non-welded Cerro Galán Ignimbrite at Paycuqui, Argentina, contains well-developed columnar joints that are instead due to high-temperature vapor-phase alteration of the deposit, where devitrification and vapor-phase crystallization have increased the density and cohesion of the upper half of the section. Thermal remanent magnetization analyses of entrained lithic clasts indicate high emplacement temperatures, above 630°C, but the lack of welding textures indicates temperatures below the glass transition temperature. In order to remain below the glass transition at 630°C, the minimum cooling rate prior to deposition was 3.0 × 10⁻³–8.5 × 10⁻²°C/min (depending on the experimental data used for comparison). Alternatively, if the deposit was emplaced above the glass transition temperature, conductive cooling alone was insufficient to prevent welding. Crack patterns (average, 4.5 sides to each polygon) and column diameters (average, 75 cm) are consistent with relatively rapid cooling, where advective heat loss due to vapor fluxing increases cooling over simple conductive heat transfer. The presence of regularly spaced, complex radiating joint patterns is consistent with fumarolic gas rise, where volatiles originated in the valley-confined drainage system below. Joint spacing is a proxy for cooling rates and is controlled by depositional thickness/valley width. We suggest that the formation of joints in high-temperature, non-welded deposits is aided by the presence of underlying external water, where vapor transfer causes crystallization in pore spaces, densifies the deposit, and helps prevent welding.     

A re-appraisal of the stratigraphy and volcanology of the Cerro Galán volcanic system,NW Argentina

From detailed fieldwork and biotite ⁴⁰Ar/³⁹Ar dating correlated with paleomagnetic analyses of lithic clasts, we present a revision of the stratigraphy, areal extent and volume estimates of ignimbrites in the Cerro Galán volcanic complex. We find evidence for nine distinct outflow ignimbrites, including two newly identified ignimbrites in the Toconquis Group (the Pitas and Vega Ignimbrites). Toconquis Group Ignimbrites (~5.60–4.51 Ma biotite ages) have been discovered to the southwest and north of the caldera, increasing their spatial extents from previous estimates. Previously thought to be contemporaneous, we distinguish the Real Grande Ignimbrite (4.68 ± 0.07 Ma biotite age) from the Cueva Negra Ignimbrite (3.77 ± 0.08 Ma biotite age). The form and collapse processes of the Cerro Galán caldera are also reassessed. Based on re-interpretation of the margins of the caldera, we find evidence for a fault-bounded trapdoor collapse hinged along a regional N-S fault on the eastern side of the caldera and accommodated on a N-S fault on the western caldera margin. The collapsed area defines a roughly isosceles trapezoid shape elongated E-W and with maximum dimensions 27 × 16 km. The Cerro Galán Ignimbrite (CGI; 2.08 ± 0.02 Ma sanidine age) outflow sheet extends to 40 km in all directions from the inferred structural margins, with a maximum runout distance of ~80 km to the north of the caldera. New deposit volume estimates confirm an increase in eruptive volume through time, wherein the Toconquis Group Ignimbrites increase in volume from the ~10 km³ Lower Merihuaca Ignimbrite to a maximum of ~390 km³ (Dense Rock Equivalent; DRE) with the Real Grande Ignimbrite. The climactic CGI has a revised volume of ~630 km³ (DRE), approximately two thirds of the commonly quoted value.     

Perception of the rip current hazard on Galveston Island and North Padre Island,Texas, USA

The hazard posed by a rip current depends in part on the ability of beach users to identify a rip current and to associate surf conditions with the potential for rip currents. Understanding which visual features beach users associated with rip currents is an important step in the development of appropriate programs and educational materials aimed at improving the ability of beach users to identify a rip current. A face-to-face survey (n = 392) was conducted to assess the ability of beach users to identify a rip current using five near eye-level photographs that simulate the view of the beach and surf zone as the respondent approached the beach. The survey was conducted on three heavily used public beaches in Texas (Galveston, Port Aransas, and Corpus Christi) at the height of the summer beach season in 2012. Only 13 % of respondents correctly selected the photograph showing the most hazardous conditions and correctly identified the precise location of the rip current on the photograph. The majority of beach users (87 %) incorrectly indicated that the photograph with the heaviest surf represented the most hazardous surf conditions and greatest potential for the development of rip currents, or failed to identify rip currents in photographs. Respondents who were able to correctly identify the rip current tended to recognize the breaking wave pattern, areas of darker water, or the proximity to structures as key visual characteristics of rip currents and also had higher self-reported abilities to swim in rough water and escape a rip current.