The future of the western Baltic Sea: two possible scenarios

Globally coupled climate models are generally capable of reproducing the observed trends in the globally averaged atmospheric temperature. However, the global models do not perform as well on regional scales. Here, we present results from four 100-year, high-resolution ocean model experiments (resolution less than 1 km) for the western Baltic Sea. The forcing is taken from a regional atmospheric model and a regional ocean model, imbedded into two global greenhouse gas emission scenarios, A1B and B1, for the period of 2000 to 2100 with each two realisations. Two control runs from 1960 to 2000 are used for validation. For both scenarios, the results show a warming with an increase of 0.5–2.5 K at the sea surface and 0.7–2.8 K below 40 m. The simulations further indicate a decrease in salinity by 1.5–2 practical salinity units. The increase in water temperature leads to a prolongation of heat waves based on present-day thresholds. This amounts to a doubling or even tripling of the heat wave duration. The simulations show a decrease in inflow events (barotropic/baroclinic), which will affect the deepwater generation and ventilation of the central Baltic Sea. The high spatial resolution allows us to diagnose the inflow events and the mechanism that will cause future changes. The reduction in barotropic inflow events correlates well with the increase in westerly winds. The changes in the baroclinic inflows can be consistently explained by the reduction of calm wind periods and thus a weakening of the necessary stratification in the western Baltic Sea and the Danish Straits.     

Methods for locating the proper position of a planned fishway entrance near a hydropower tailrace

The spatial distribution of upstream migrating Atlantic salmon (Salmo salar) spawners was studied in 2008 and 2009 in the surroundings of the tailrace from a hydropower station in the River Umeälven. This area is problematic because the fish have difficulties finding their way into the original riverbed, which prompted an investigation on the feasibility of adding a fishway in the area. Echo sounding was used in 2008 to investigate the spatial use of fish in the tailrace channel during the time of salmon migration. Presence of other fish species was so low that all echo sounding detections were assumed to be salmon. In 2009, data on wild radio-tagged salmon (n = 94) was collected in the same tailrace by an array of underwater antennas with a detection radius of approximately 10 m, to validate the results from the echo sounding. Both types of surveys showed aggregations of fish in one part of the tailrace. As a final step, Computational Fluid Dynamics (CFD) modeling was performed to analyze hydrodynamics. This CFD modeling showed a coincidence of fish detections in areas with turbulence intensities between 0.6 and 0.8, which may be an indication that the fish are holding in these areas to reduce energy expenditure during migration. A high proportion of the radio-tagged salmon were observed in the tailrace area (a median of 21 days between their first and last detection), indicating that the salmon are delayed in their upstream migration by the attraction to the tailrace in this area. The overall data on fish behavior in the tailrace led us to suggest a location for a new fishway where the fish aggregation was most pronounced. The number of detections from either technology had similar distributions over the tailrace, suggesting that the results are comparable. Thus, the split beam echo sounder can preferably be used to investigate which location is most appropriate for locations of entrances to new fishways since many more individual fishes are covered by this method compared to telemetry. Furthermore, there is no need to handle the fish in the echo sounding studies as is required in telemetry studies.     

ON THE DETERMINATION OF THE ROUGHNESS COEFFICIENT IN NATURAL AND ARTIFICIAL WATERWAYS

SYNOPSIS

It has always been a problem for the hydraulic engineer to obtain reasonable values for the roughness in a waterway. The writer feels that the idea put forward in this essay could help the parcticing engineer to obtain a roughness value without complicated procedure.     

Pesticides Removal by Filtration over Cactus Pear Leaves: A Cheap and Natural Method for Small‐Scale Water Purification in Semi‐Arid Regions

This study aims to examine the efficiency of Opuntia ficus‐indica for removing organochlorine pesticides from surface waters. Adsorption properties such as size, dose, and time of O. ficus‐indica for aldrin, dieldrin, and dichlorodiphenyltrichloroethane (DDT) were studied through stirring and column methods. Because of their high affinity and swelling characteristics, dried O. ficus‐indica was studied in stirring while fresh unpeeled O. ficus‐indica was applied in both stirring and column experiments and proved to be well‐suited to column application. Before removing pesticides, the column was flashed with distilled water eliminate the turbidity and smell from fresh unpeeled cactus. The removal of pesticides increased with an increasing adsorbent dose and decreased with adsorbent particle sizes. The optimum adsorbent dose is 10 g for dried and 15 g for fresh unpeeled O. ficus‐indica. The experimental results show that O. ficus‐indica possesses strong adsorption ability for aldrin, dieldrin, and DDT, and the adsorption isotherm data obeyed the Freundlich model. The results of our small‐scale experiments suggest a strong potential to develop local small‐scale water treatment units that can be used at the level of individual households or local communities, using a widely available adsorbent.     

Automated approaches for displaying spatially oriented time‐series data through image processing techniques

This study demonstrated the cartographic implications of automated image processing and computer graphics for the study of time‐series data. Automated statistical and image processing techniques were applied to a case study data set consisting of weekly Crop Moisture Index (CMI) values summarized at 174 state cooperative weather stations within Oklahoma for the time period between February and October, 1980. Computer generated isoline maps of the CMI values were interpolated and rescaled into a series of 32 grid matrices for input into a raster‐based ERDAS image processing software system. Principal Components Analysis (PCA) was used to develop graphic models that synthesized the multi‐temporal data into statistical dimensions that represented the most significant elements of CMI variability. Graphic models of the PCA statistical vectors were displayed individually, in conjunction with eigenvector loadings, and as composite images. Resultant images were analyzed statistically and graphically through the generated CMI grid matrices to ascertain the location, severity, and progression of drought represented in the CMI values. Traditional image processing techniques and devices were combined with the ERDAS software system to transform the multi‐temporal CMI data into multi‐dimensional images that represented the drought's spatial and temporal signature unobscured by redundant information.     

Electrical conductivity of orthopyroxene and plagioclase in the lower crust

The electrical conductivities of lower crustal orthopyroxene and plagioclase, as well as their dependence on water content, were measured at 6–12 kbar and 300–1,000°C on both natural and pre-annealed samples prepared from fresh mafic xenolith granulites. The complex impedance was determined in an end-loaded piston cylinder apparatus by a Solarton-1260 Impedance/Gain Phase analyzer in the frequency range of 0.1–10⁶ Hz. The spectra usually show an arc over the whole frequency range at low temperature and an arc plus a tail in the high and low frequency range, respectively, at high temperature. The arc is due to conduction in the sample interior, while the tails are probably due to electrode effects. Different conduction mechanisms have been identified under dry and hydrous conditions. For the dry orthopyroxene, the activation enthalpy is ~105 kJ/mol, and the conduction is likely due to small polarons, e.g., electrons hopping between Fe²⁺ and Fe³⁺. For the dry plagioclase, the activation enthalpy is ~161 kJ/mol, and the conduction may be related to the mobility of Na⁺. For the hydrous samples, the activation enthalpy is ~81 kJ/mol for orthopyroxene and ~77 kJ/mol for plagioclase, and the electrical conductivity is markedly enhanced, probably due to proton conduction. For each mineral, the conductivity increases with increasing water content, with an exponent of ~1, and the activation enthalpies are nearly independent of water content. Combining these data with our previous work on the conductivity of lower crustal clinopyroxene, the bulk conductivity of lower crustal granulites is modeled, which is usually >~10⁻⁴ S/m in the range of 600–1,000°C. We suggest that the high electrical conductivity in most regions of the lower crust, especially where it consists mostly of granulites, can be explained by the main constitutive minerals, particularly if they contain some water. Contributions from other highly conducting materials such as hydrous fluids, melts, or graphite films are not strictly necessary to explain the observed conductivities.     

Chemical characteristics (REE,etc.) of Paleozoic and Mesozoic graywackes and sandstones from Central Europe

During the Variscan orogeny in Central Europe, partial melting in the lower continental crust formed granitic magmas, which intruded into the upper crust and left compounds of Ca (plus Eu²⁺), Mg, etc. in the lower crust. From the late Paleozoic decomposition of the tonalitic upper crust, sedimentary graywackes were produced reflecting the composition of this crust. The repeated reworking of the sedimentary cover caused the formation of sands. Sandstones as their products of consolidation contain increasing fractions of quartz and decreasing feldspar from Carboniferous and Triassic to Cretaceous age. A distinct negative Eu anomaly characterizes the majority of these rocks. The latter is imprinted by the Variscan magmatism. Quartz as used for numerous Medieval wood ash glasses is marked for its Central European origin by a distinct negative Eu anomaly in contrast to many soda glasses produced outside Germany mostly with a small or none Eu anomaly.     

From Fish to Jellyfish in the Eutrophicated Limfjorden (Denmark)

The heavily eutrophicated Limfjorden (Denmark) provides a good illustration of the value of long-term monitoring, especially if this is combined with an experimental, interdisciplinary research approach. Here, we first give a short overview of the environmental status of Limfjorden, including the historical development of nutrient overloading and subsequent oxygen depletion in near-bottom water, and how the annual landings of edible bottom-dwelling fish species (plaice, flounder, eel and others) caught in Limfjorden have decreased from about 2,500 t in the early 1920s to only about 20 t in recent years where the fish have been replaced by an increasing number of especially the moon jellyfish, Aurelia aurita, which mainly preys on zooplankton. Next, we evaluate the ecological consequences of the present high number of jellyfish, based on data from recent years’ research on the abundance of jellyfish, their population dynamics and predation impact. In Limfjorden, the benthic polyp stage of A. aurita ensures a large number of small ephyrae in the early spring and subsequently a large population of adult medusae that control the zooplankton during summer and autumn. The holopelagic invasive ctenophore Mnemiopsis leidyi, which was observed in Limfjorden for the first time in 2007, is a second carnivore adding additional predation pressure of the indigenous A. aurita so that copepods and other mesozooplankton organisms may be virtually absent, as observed in 2008 and 2009 where ciliates made up a substantial part of the zooplankton biomass. Marine environmental management programmes should be aware of the increasing importance of both indigenous and new invasive jellyfish species that may show mass occurrence in especially eutrophicated and over-fished areas.     

Non-monotonic Responses of Phytoplankton Biomass Accumulation to Hydrologic Variability: A Comparison of Two Coastal Plain North Carolina Estuaries

Freshwater inputs often play a more direct role in estuarine phytoplankton biomass (chlorophyll a) accumulation than nitrogen (N) inputs, since discharge simultaneously controls both phytoplankton residence time and N loading. Understanding this link is critical, given potential changes in climate and human activities that may affect discharge and watershed N supply. Chlorophyll a (chla) relationships with hydrologic variability were examined in 3-year time series from two neighboring, shallow (<5?m), microtidal estuaries (New and Neuse River estuaries, NC, USA) influenced by the same climatic conditions and events. Under conditions ranging from drought to floods, N concentration and salinity showed direct positive and negative responses, respectively, to discharge for both estuaries. The response of chla to discharge was more complex, but was elucidated through conversion of discharge to freshwater flushing time, an estimate of transport time scale. Non-linear fits of chla to flushing time revealed non-monotonic, unimodal relationships that reflected the changing balance between intrinsic growth and losses through time and along the axis of each estuary. Maximum biomass occurred at approximately 10-day flushing times for both systems. Residual analysis of the fitted data revealed positive relationships between chla and temperature, suggesting enhanced growth rates at higher temperatures. N loading and system-wide, volume-weighted chla were positively correlated, and biomass yields per N load were greater than other marine systems. When combined with information on loss processes, these results on the hydrologic control of phytoplankton biomass will help formulate mechanistic models necessary to predict ecosystem responses to future climate and anthropogenic changes.