Boundary-layer observations over water and arctic sea-ice during on-ice air flow

Observations made on 8 and 9 May 1988 by aircraft and two ships in and around the marginal ice zone of the Fram Strait during on-ice air flow under cloudy and cloud-free conditions are presented.The thermodynamic modification of the air mass moving from the open water to the ice over horizontal distances of 100–300 km is only a few tenth of a degree for temperature and a few tenth of a gram per kilogram for specific humidity. This is due to the small temperature differences between sea and ice surfaces. During the day, the ice surface is even warmer than the sea surface. The stably stratified 200–400 m deep boundary layer is often topped by a moisture inversion leading to downward fluxes of sensible as well as latent heat.The radiation and energy balance at the surface are measured as functions of ice cover, cloud cover and sun elevation angle. The net radiationR _Nis the dominating term of the energy budget. During the day, the difference ofR _Nbetween clear and overcast sky is only a few W/m² over ice, but 100–200 W/m² over water. During the night,R _Nover ice is more sensitive to cloud cover.The kinematic structure is characterized by strong shears of the longitudinal and the transversal wind component. The profile of the latter one shows an inflection point near the top of the boundary layer. Dynamically-driven roll circulations are numerically separated from the mean flow. The secondary flow patterns have wavelengths of about 1 km and contribute substantially to the total variances and covariances.     

Theoretical aspects of coal washer performance

This paper presents a theoretical analysis of the performance of ideal float-and-sink type coal washing devices. Included are studies of single washer performance, single washer with bypass, multiple washers in parallel and multiple washers in series. A maximum yield principle is developed for the cases of a single washer with bypass and multiple washers in parallel. The results of numerical calculations for actual washers are also presented and compared with the theoretical predictions for multiple washers in parallel and multiple washers in series.     

A generalization of distribution data for characterizing the performance of float-sink coal cleaning devices

The performance of float-sink coal cleaning devices customarily is characterized by a distribution curve, in which the percent of feed reporting to clean coal is plotted against specific gravity. For a given vessel and a given feed a family of distribution curves can be obtained, each having its own specific gravity of separation.This paper presents a method for combining these distribution curves at different specific gravities of separation, for a given coal cleaning vessel and a given feed, into a single, generalized distribution curve which is independent of the specific gravity of separation. This curve can be expressed in tabular form or it can be represented mathematically by an exponential type equation, known as a Weibull function.A different generalized distribution curve will be obtained for each of several different size fractions. A method is presented for utilizing these curves with feeds which encompass a broad spectrum of sizes.The well-known concepts of error area and probable error are extended to the generalized distribution curve. It is shown that the conventional probable error, and — under certain conditions — the conventional error area, are directly proportional to the specific gravity of separation for a given vessel and a given feed size.     

Glaukonitkörner in rezenten Sedimenten des Persischen Golfs

The field-name “glauconite” is applicable to a great variety of green grains, particularly mud clasts, which are found in the fraction >63μ in surface sediments from the Persian Gulf. These grains occur in areas of low sedimentation rates in all water depths to 110 m, the shelf break in the Gulf of Oman (Fig. 1). Glauconite grains coarser than 250,μ were magnetically separated from 15 samples and then handpicked. Their carbonate fractions (75->90%, predominantly aragonite) are basically different from those of the corresponding total samples (50–65%, predominantly calcite). The clay minerals in the glauconite grains fall into two groups. The samples away from the shore contain abundant montmorillonite, compared to the small amount in the 2μ (fractions of the total samples; the near shore samples are predominantly amorphous material and illite. Because of these and other differences from the remaining parts of the samples (Tab. 1) the glauconite grains are considered to be parautochthonous relicts from the underlying late Pleistocene. They were apparently formed under the special conditions of a transgressing shallow marine environment.     

Surface-active substances on rainwater and atmospheric particles

The surface tension lowering by surface-active substances has been measured on rainwater, melted snow, and dispersions of atmospheric particles in water, with a film balance and a tensiometer. The precipitation water was sampled during 1979, 1980, and 1981 in the city of Frankfurt/Main. From measurements with the film balance technique, normalized concentrations of insoluble and weakly soluble surface-active substances have been estimated. Soluble surface-active substances were determined from measurements with a tensiometer. It was found that the normalized concentration of theinsoluble and weakly soluble surface-active material on rainwater or melted snow shows a maximum during late spring of about 2.5 · 10⁻⁷ moles/l and a minimum during wintertime of about 5 · 10⁻⁸ moles/l. These concentrations are too low to influence significantly the condensation of water vapour on cloud droplets or the evaporation of water from them. Thesoluble surface-active material on rainwater or melted snow was found to have concentrations of the order of 2 · 10⁻⁶ moles/l. These concentrations are also too small to have a significant influence on cloud physical processes.     

Indirect crustal contamination: evidence from isotopic and chemical disequilibria in minerals from alkali basalts and nephelinites from northern Tanzania

 Alkali basalts and nephelinites from the volcanic province of northern Tanzania contain pyroxene and nepheline that show evidence for chemical and/or isotopic disequilibria with their host magmas. Olivine, pyroxene, nepheline and plagioclase all appear to be partially xenocrystic in origin. Five whole rock/mineral separate pairs have been analyzed for Sr, Nd, and Pb isotopic compositions. The ²⁰⁶Pb/²⁰⁴Pb ratios are distinct by as much as 20.94 (whole rock) vs. 19.10 (clinopyroxene separate). The Sr and Nd isotopic disequilibria vary from insignificant in the case of nepheline, to Δ ⁸⁷Sr/⁸⁶Sr of 0.0002 and Δɛ_Nd of 0.7 in the case of clinopyroxene. The mineral chemistry of 25 samples indicates the ubiquitous presence of minerals that did not crystallize from a liquid represented by the host rock. The northern Tanzanian magmas are peralkaline and exhibit none of the xenocrystic phases expected from crustal assimilation. The disequilibria cannot be the result of mantle source variations. Rather the xenocrystic phases present appear to have been derived from earlier alkali basaltic rocks or magmas that were contaminated by the crust. Material from this earlier magma was then mixed with batches of magma that subsequently erupted on the surface. Disequilibrium in volcanic rocks has potentially serious consequences for the use of whole rock data to identify source reservoirs. However, mass balance calculations reveal that the ²⁰⁶Pb/²⁰⁴Pb isotopic compositions of the erupted lavas were changed by less than 0.25% as a result of this indirect crustal contamination. Received: 15 February 1995 / Accepted: 4 May 1996     

Seismic hazard assessment for low-seismicity areas — Case study: Northern Germany

The problem of assessing seismic hazard in low-seismicity areas becomes obvious in many practical applications. A typical low-seismicity area, which experienced damaging earthquakes in historical times, is the North German Plain, for which a case study is presented. It is shown how seismic hazard assessments are influenced by different interpretations of historical key earthquakes, changes in b-value as well as variations of the upper bound magnitude assumed for the seismic source regions. The latter strongly influences the hazard results in the case of very low b-values for long return periods.