深圳湾公路大桥设计风速的推算

从资料的完整性和合理性、方法的规范性等几方面着手，对深圳湾公路大桥设计风速进行推算。利用深圳市气象站1954～2001年逐年年最大风速资料，通过时距、高度、地形等订正后得到相当于开阔平地上方10 m高度10 min年最大风速48年序列，使之符合建筑抗风指南或规范的要求。再利用极值Ⅰ型计算出不同重现期的基本风速，同时用耿贝尔的参数估算法和修正后的矩法参数估计法计算出不同重现期（200、120、100、60、50、30、10年）的基本风速。研究发现桥位区自动气象站与深圳市气象站最大风速正相关显著，前者是后者的1.1倍，从而可将基本风速外推到桥位区，进一步根据规范将该值放大1.11/2（1.049）倍至海面上，最终得到设计风速。还利用近地层风的指数和对数曲线推算出150 m内每10 m高度层的最大风速。     

国家级气象资料存储检索系统的建立

对国家级气象资料存储检索系统的需求进行了分析，进而对系统进行了功能设计，并在技术调研和分析的基础上确定了功能实现的技术路线:在数据管理方面采用数据库和文件系统相结合的方式；在存储管理方面采用分级存储管理模式，并解决了数据库的分级存储管理技术；在检索应用方面提供了程序调用式检索方式，并通过采用中间件技术实现了基于B/S结构的程序调用式检索；通过选用HPSS技术解决了由异种机型构成的高性能计算机群存储池问题；通过分别建立实时数据库和综合数据库解决了气象资料的规范化存储和实时业务使用需求之间的矛盾；在应用软件开发方面严格按照有关规范进行。     

载荷试验确定基床系数修正方法的讨论

Winkler地基模型是目前工程界应用最广的一种地基模型，但对其关键参数——基床系数k的确定，许多文献的表述并不一致。该文在大量试验资料的基础上，通过对该问题的深入研究，阐明了通过载荷试验确定基床系数修正方法的有关概念。对于砂性土地基，载荷板试验得出的基准基床系数仅需要进行基础大小修正，而对于粘性土地基，则需要进行基础大小和基础形状两项修正。     

Accurate U-Pb Age and Trace Element Determinations of Zircon by Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry

Various zircons of Proterozoic to Oligocene ages (1060-31 Ma) were analysed by laser ablation-inductively coupled plasma-mass spectrometry. Calibration was performed using Harvard reference zircon 91500 or Australian National University reference zircon TEMORA 1 as external calibrant. The results agree with those obtained by SIMS within 2s error. Twenty-four trace and rare earth elements (P, Ti, Cr, Y, Nb, fourteen REE, Hf, Ta, Pb, Th and U) were analysed on four fragments of zircon 91500. NIST SRM 610 was used as the reference material and ²⁹Si was used as internal calibrant. Based on determinations of four fragments, this zircon shows significant intra-and inter-fragment variations in the range from 10% to 85% on a scale of 120 μm, with the variation of REE concentrations up to 38.7%, although the chondrite-normalised REE distributions are very similar. In contrast, the determined age values for zircon 91500 agree with TIMS data and are homogeneous within 8.7 Ma (2 s ). A two-stage ablation strategy was developed for optimising U-Pb age determinations with satisfactory trace element and REE results. The first cycle of ablation was used to collect data for age determination only, which was followed by continuous ablation on the same spot to determine REE and trace element concentrations. Based on this procedure, it was possible to measure zircon ages as low as 30.37 0.39 Ma (MSWD = 1.4; 2 s ). Other examples for older zircons are also given.     

Crustal structure of the southern Dabie ultrahigh-pressure orogen and Yangtze foreland from deep seismic reflection profiling

A new 140‐km‐long seismic reflection profile provides a high‐resolution crustal‐scale image of the southern Dabieshan high‐pressure (HP) metamorphic belt and the Yangtze foreland fold‐and‐thrust belt. The seismic image of the stacked section shows that the southern Dabieshan metamorphic terrane and Yangtze foreland belt are separated by a large north‐dipping fault. In the foreland the upper crust is dominated by a series of folds and thrusts formed during the collisional stage in the mid‐Triassic; it was reworked by crustal extension resulting in the formation of a late Jurassic and Cretaceous red‐bed basin. The southern Dabieshan profile shows stacked crustal slabs developed along the margin of the collisional orogenic belt. The Moho reflectors at 10–11 s (～30–33 km) are seismically prominent and segmented by a number of south‐verging thrusts that were probably developed by foreland‐directed thrusting of the deeply subducted continental crust during exhumation. The seismic reflection profile suggests that structures related to the Triassic–Jurassic subduction and exhumation of the Yangtze plate are preserved despite the severe crustal extension superimposed during the late Mesozoic and Cenozoic.     

The method of design for seismic data database system based on tree structure

Introduction In recent years, with the development of earthquake observation technology, increasing ofobservation stations and improvement of observation instruments which are digitalized and con-nected by network, a great deal of data is recorded, to some extend, which brings difficulty for usto manage and store them. It leads to traditional methods, which use the file system to managemass data, could not satisfy our requirement, and it is necessary to find a new method in place oftradit…     

挤扩支盘桩极限承载力的预测

用双曲线方法对110根挤扩支盘桩的极限承载力进行预测,并与直杆桩预测结果进行对比。结果表明由于支盘桩受力性状复杂,加载前期和中期预测精度较高,后期较低,误差超过15%;支盘桩的沉降曲线出现台阶时预测值与实测值误差较大;支盘桩极限承载力的预测精度与工程地质条件和桩本身的参数密切相关,桩身参数和地质条件相同条件下各桩预测精度比较接近。总体上直杆桩的预测结果优于支盘桩。     

Grassland productivity in an alpine environment in response to climate change

Situated in a climatically stressful environment, alpine grassland is sensitive to subtle climate changes in its productivity. We remedy the current deficiency in studying grassland productivity by taking the integrated effect of all relevant factors into consideration. The relative importance of temperature, rainfall and evaporation to the alpine grassland productivity in western China was determined through analysis of their relationship with the normalized difference vegetation index (NDVI) between 1981 and 2000. Climate warming stimulated grassland productivity in the 1980s, but hampered it in the 1990s. Temperature is more important than rainfall to grassland productivity early in the growing season. However, their relative importance is reversed late in the growing season. Monthly summer month rainfall modified by maximum monthly temperature is a good predictor of alpine grassland productivity at 62.0 per cent. However, the best predictor is water deficiency, which is able to improve the estimation accuracy to 78.3 per cent. Hence, the impact of temperature on grassland productivity is better studied indirectly through evaporation.     

Sedimentation rates in the Wanggang salt marshes, Jiangsu

1 IntroductionLand-ocean interaction in coastalzone is one of the key m atters of the International G eosphereand Biosphere Program (IG BP). The key problem s of the second phase in the next decadeinclude the m aterial cycle, the system evolution process …     

Karst database development in Minnesota: design and data assembly

The Karst Feature Database (KFD) of Minnesota is a relational GIS-based Database Management System (DBMS). Previous karst feature datasets used inconsistent attributes to describe karst features in different areas of Minnesota. Existing metadata were modified and standardized to represent a comprehensive metadata for all the karst features in Minnesota. Microsoft Access 2000 and ArcView 3.2 were used to develop this working database. Existing county and sub-county karst feature datasets have been assembled into the KFD, which is capable of visualizing and analyzing the entire data set. By November 17 2002, 11,682 karst features were stored in the KFD of Minnesota. Data tables are stored in a Microsoft Access 2000 DBMS and linked to corresponding ArcView applications. The current KFD of Minnesota has been moved from a Windows NT server to a Windows 2000 Citrix server accessible to researchers and planners through networked interfaces.