The early Caledonian (Finnmarkian) event reassessed in Finnmark: Ar/Ar cleavage age data from NW Varangerhalvøya, N. Norway

The relative significance of early (Finnmarkian) and late (Scandian) Caledonian deformation in N. Norway is uncertain. Early studies suggested pervasive Finnmarkian deformation whilst later results indicated a restricted Finnmarkian domain. The present work suggests it was more widespread than accepted and that inter Finnmarkian–Scandian deformation occurred. ⁴⁰Ar/³⁹Ar dating of 2–6 and 6–11 μm pelitic fractions from the lower to mid-greenschist facies Tanahorn Nappe (five samples; base Middle Allochthon) and the epizone Løkvikfjellet and Barents Sea Groups (three samples; North Varanger Region) in the north Scandinavian Caledonides show slightly discordant spectra. Most spectra from the Tanahorn Nappe preserve possible evidence of an early Caledonian event in the high temperature steps, with recoil/excess Ar effects in the low temperature steps; no pre-Caledonian relict component has been recorded. The results indicate Finnmarkian deformation continued to 460 Ma, with Scandian reactivation at 425–415 Ma. From the North Varanger Region, a strongly crenulated sample yielded plateau ages (444–442 Ma); means of combined young steps from weakly to uncrenulated samples gave 470–450 Ma, suggesting penetrative strike-slip deformation occurred in the late Finnmarkian to inter-Finnmarkian–Scandian period. No Scandian ages were recorded in the North Varanger Region. Reassessment of published data from the Laksefjord Nappe and Gaissa Thrust Belt suggests they were affected by Finnmarkian deformation.     

Characteristics of the atmospheric heat source and moisture sink over the Qinghai-Tibetan Plateau during the second TIPEX of summer 1998 and their impact on surrounding monsoon

Summary ?Using the data of 6 automatic heat balance observation (AWS) stations and a data set of 52 surface observation stations over the Qinghai-Tibetan Plateau (“the Plateau”) and surroundings, the horizontal distribution is studied of “apparent atmospheric heat sources” 〈Q ₁〉 and of “apparent atmospheric moisture sinks” 〈Q ₂〉. The AWS stations were established during the period May to August 1998 of the Tibetan Plateau Meteorological Experiment (second TIPEX) by a cooperation of China and Japan. For this period the Plateau mean of 〈Q ₁〉 is positive. Its value of 74 W/m² is a little greater than a climate value and than values from MONEX and the first TIPEX in 1979, respectively. Also the corresponding 〈Q ₂〉 is positive. Hence during that time the Plateau is a heat source and a moisture sink. A day-to-day change of 〈Q ₁〉 and 〈Q ₂〉 is more pronounced over the middle and east part of the Plateau than over the west part. Diagnostics accompanied by numerical simulations are used to study the daily relationship between 〈Q ₁〉 over the Plateau and the weather over China and Asia for this summer. The results suggest that 〈Q ₁〉 may affect precipitation over northern China and position of the west Pacific subtropical high. Abnormal southward retreat of this Pacific high seems to have caused the second flood over the middle and lower Yangtse river basin in July. Received May 20, 2001; revised February 2, 2002     

New palaeomagnetic data from Central Iran and a Triassic palaeoreconstruction

New pole positions for Triassic and Cretaceous times have been obtained from volcanic and sedimentary sequences in Central Iran. These new results confirm the general trend of the Apparent Polar Wander Path (APWP) of the Central-East-Iran microplate (CEIM) from the Triassic through the Tertiary as published by Soffel and Förster (1983, 1984). Two new palaeopoles for the Triassic of the CEIM have been obtained; limestones and tuffs from the Nakhlak region yield a mean direction of 094.0°/25.0°, N=12, k=4.1,α ₉₅=24.7°, after bedding correction, corresponding to a palaeopole position of 310.8°E; 3.9°S, and volcanic rocks from the Sirjan regions yield a mean direction of 114.5°/35.1°, N=44, k=45.9,α ₉₅=3.2° after bedding correction and a palaeopole position of 295.8°E; 10.3°N. Combining these with the two previously published results yields a new palaeopole position of 317.5°E; 12.7°N, for the Triassic of the CEIM, thus confirming that large counterclockwise rotations of the CEIM have occurred since the Triassic time. New results have also been obtained from Cretaceous limestones from the Saghand region of the CEIM. The mean direction of 340.7°/26.3°, N=33, k=44.3,α ₉₅=3.8°, and the corresponding palaeopole position of 283.1°E; 64.4°N, is in agreement with previously determined Cretaceous palaeopole positions of the CEIM. Furthermore, results have also been obtained from Triassic dolomite, limestone, sandstone and siltstone from the Natanz region, which is located to the west of the CEIM. A total of 161 specimens from 44 cores taken at five sites gave a mean direction of the five sites at 033.3°/25.1°, N=5, k=69.0,α ₉₅=9.3° and a palaeopole position of 167.2°E; 53.7°N. They pass the positive fold test of McElhinny (1964) on the level of 99% confidence. This pole position is in fairly good agreement with the mean Triassic pole position of the Turan Plate (149°E; 49°N). It indicates that the area of Natanz has not undergone the large counterclockwise rotation relative to the Turan plate since the Triassic, which has been shown for the CEIM. A Triassic palaeogeographic reconstruction of Iran, Arabia (Gondwana) and the Turan Plate (Eurasia) is also presented.     

Geostatistical regionalization of glacial aquitard thickness in northwestern Germany, based on fuzzy kriging

In many instances hydrogeological parameters obtained by conventional methods for selected localities within an aquifer or an aquitard are not sufficient for adequate regionalization at the scale of the entire layer. Here, we demonstrate an application of the fuzzy kriging method in regionalization of hydrogeological data, in which the set of conventional, crisp values is supplemented by imprecise information subjectively estimated by an expert. It is believed that such an approach eventually may reflect the real-world conditions more closely than a traditional crisp-value approach, because the former does not impose exactness artificially on phenomena which are diffuse by their nature. Spatial interpolation was done for the thickness of one of the major aquitards (till and glaciolacustrine clay) in northwestern Germany. The dataset consists of 329 crisp values from boreholes supplemented by 172 imprecise values defined as fuzzy numbers. It is demonstrated that the reliability of regionalization was higher, compared to regionalization performed with the crisp dataset only. Fuzzy kriging was performed with FUZZEKS (Fuzzy Evaluation and Kriging System) developed at the Ecosystem Research Center at the University of Kiel.     

Thorium and uranium isotopes in a manganese nodule from the Peru basin determined by alpha spectrometry and thermal ionization mass spectrometry (TIMS): Are manganese supply and growth related to climate?

Thorium- and uranium isotopes were measured in a diagenetic manganese nodule from the Peru basin applying alpha- and thermal ionization mass spectrometry (TIMS). Alpha-counting of 62 samples was carried out with a depth resolution of 0.4 mm to gain a high-resolution²³⁰Th_excess profile. In addition, 17 samples were measured with TIMS to obtain precise isotope concentrations and isotope ratios. We got values of 0.06–0.59 ppb (²³⁰Th), 0.43–1.40 ppm (²³²Th), 0.09–0.49 ppb (²³⁴U) and 1.66–8.24 ppm (²³⁸U). The uranium activity ratio in the uppermost samples (1–6 mm) and in two further sections in the nodule at 12.5±1.0 mm and 27.3–33.5 mm comes close to the present ocean water value of 1.144±0.004. In two other sections of the nodule, this ratio is significantly higher, probably reflecting incorporation of diagenetic uranium. The upper 25 mm section of the Mn nodule shows a relatively smooth exponential decrease in the²³⁰Th_excess concentration (TIMS). The slope of the best fit yields a growth rate of 110 mm/Ma up to 24.5 mm depth. The section from 25 to 30.3 mm depth shows constant²³⁰Th_excess concentrations probably due to growth rates even faster than those in the top section of the nodule. From 33 to 50 mm depth, the growth rate is approximately 60 mm/Ma. Two layers in the nodule with distinct laminations (11–15 and 28–33 mm depth) probably formed during the transition from isotopic stage 8 to 7 and in stage 5e, respectively. The Mn/Fe ratio shows higher values during interglacials 5 and 7, and lower ones during glacials 4 and 6. A comparison of our data with data from adjacent sediment cores suggests (a) a variable supply of hydrothermal Mn to sediments and Mn nodules of the Peru basin or (b) suboxic conditions at the water sediment interface during periods with lower Mn/Fe ratios.     

Gravity reduction with three-dimensional atmospheric pressure data for precise ground gravity measurements

The redistribution of air masses induces gravity variations (atmospheric pressure effect) up to about 20 μgal. These variations are disturbing signals in gravity records and they must be removed very carefully for detecting weak gravity signals. In the past, different methods have been developed for modelling of the atmospheric pressure effect. These methods use local or two-dimensional (2D) surface atmospheric pressure data and a standard height-dependent air density distribution. The atmospheric pressure effect is consisting of the elastic deformation and attraction term. The deformation term can be well modelled with 2D surface atmospheric pressure data, for instance with the Green's function method. For modelling of the attraction term, three-dimensional (3D) data are required. Results with 2D data are insufficient.From European Centre for Medium-Range Weather Forecasts (ECMWF) 3D atmospheric pressure data are now available. The ECMWF data used here are characterised by a spacing of Δ and Δλ = 0.5°, 60 pressure levels up to a height of 60 km and an interval of 6 h. These data are used for modelling of the atmospheric attraction term. Two attraction models have been developed based on the point mass attraction of air segments and the gravity potential of the air masses. The modelling shows a surface pressure-independent part of gravity variations induced by mass redistribution of the atmosphere in the order of some μgal. This part can only be determined by using 3D atmospheric pressure data. It has been calculated for the Vienna Superconducting Gravimeter site.From this follows that the gravity reduction can be improved by applying the 3D atmospheric attraction model for analysing long-periodic tidal waves including the polar tide. The same improvement is expected for reduction of long-term absolute gravity measurements or comparison of gravity measurements at different seasonal times. By using 3D atmospheric pressure data, the gravity correction can be improved up to some μgal.     

Sampling Fauna in Stream Sediments as well as Groundwater Using One Net Sampler

Groundwater bores act as traps. Net samplers are regularly used for sampling this type of trap for fauna. To enable direct comparisons of faunal communities in groundwater bores and stream sediments, stream sediment tubes were built similar to groundwater bores and were sampled with net samplers for fauna. These stream sediment tubes consisted of a tube anchored in the stream sediment, also called interstitial space. To test the efficacy of this trap method in stream sediments, it was compared to another type of trap, Hahn's trap. Faunal communities sampled by a net in the stream sediment tubes did not differ hugely from fauna in Hahn's trap samples. Physical and chemical factors of sampled water in both the stream sediment tubes, the surrounding interstitial sediments and the second type of traps, Hahn's traps, showed that water in both the tubes and Hahn's traps was closely related to interstitial water. The net sampler is inexpensive and easy to handle. It is suggested that sampling stream tubes with nets may be an appropriate method for long‐term monitoring studies.     

A Reflection on Mg, Cd, Ca, Li and Si Isotopic Measurements and Related Reference Materials

This contribution aims to report the reflections we had with the scientific community during two international workshops on reference materials for stable isotopes in Davos (2002) and Nice (2003). After evaluating the isotopic homogeneity of some existing reference materials, based on either certificates, literature data or specific inter-laboratory rounds, we confirm these as primary reference materials or propose new ones relative to which stable isotope compositions should be reported. We propose DSM-3 for Mg, NIST SRM 915a for Ca, L-SVEC for Li and NBS28 for Si. Cadmium does not yet have a well identified delta zero material, although three commercial mono-elemental Cd solutions have yielded the same isotopic composition relative to one another. In order to scale the linearity of any mass spectrometer, some secondary reference materials are also proposed: Cambridge-1 solution for Mg, the "Münster-Cd" and JEPPIM Cd solutions for Cd and the "Big Batch" silicate for Si. The team from Nancy propose to prepare a mixed spike solution for Li isotopes. Well-characterised natural samples such as ocean or continental waters, diatoms, sponges, rocks and minerals are needed to validate the entire analytical procedure, particularly to take into account the effect of sample mineralisation and of chemical manipulations for elemental separation prior to analysis.