Thorium and uranium isotopes in a manganese nodule from the Peru basin determined by alpha spectrometry and thermal ionization mass spectrometry (TIMS): Are manganese supply and growth related to climate?

Thorium- and uranium isotopes were measured in a diagenetic manganese nodule from the Peru basin applying alpha- and thermal ionization mass spectrometry (TIMS). Alpha-counting of 62 samples was carried out with a depth resolution of 0.4 mm to gain a high-resolution²³⁰Th_excess profile. In addition, 17 samples were measured with TIMS to obtain precise isotope concentrations and isotope ratios. We got values of 0.06–0.59 ppb (²³⁰Th), 0.43–1.40 ppm (²³²Th), 0.09–0.49 ppb (²³⁴U) and 1.66–8.24 ppm (²³⁸U). The uranium activity ratio in the uppermost samples (1–6 mm) and in two further sections in the nodule at 12.5±1.0 mm and 27.3–33.5 mm comes close to the present ocean water value of 1.144±0.004. In two other sections of the nodule, this ratio is significantly higher, probably reflecting incorporation of diagenetic uranium. The upper 25 mm section of the Mn nodule shows a relatively smooth exponential decrease in the²³⁰Th_excess concentration (TIMS). The slope of the best fit yields a growth rate of 110 mm/Ma up to 24.5 mm depth. The section from 25 to 30.3 mm depth shows constant²³⁰Th_excess concentrations probably due to growth rates even faster than those in the top section of the nodule. From 33 to 50 mm depth, the growth rate is approximately 60 mm/Ma. Two layers in the nodule with distinct laminations (11–15 and 28–33 mm depth) probably formed during the transition from isotopic stage 8 to 7 and in stage 5e, respectively. The Mn/Fe ratio shows higher values during interglacials 5 and 7, and lower ones during glacials 4 and 6. A comparison of our data with data from adjacent sediment cores suggests (a) a variable supply of hydrothermal Mn to sediments and Mn nodules of the Peru basin or (b) suboxic conditions at the water sediment interface during periods with lower Mn/Fe ratios.     

A Reflection on Mg, Cd, Ca, Li and Si Isotopic Measurements and Related Reference Materials

This contribution aims to report the reflections we had with the scientific community during two international workshops on reference materials for stable isotopes in Davos (2002) and Nice (2003). After evaluating the isotopic homogeneity of some existing reference materials, based on either certificates, literature data or specific inter-laboratory rounds, we confirm these as primary reference materials or propose new ones relative to which stable isotope compositions should be reported. We propose DSM-3 for Mg, NIST SRM 915a for Ca, L-SVEC for Li and NBS28 for Si. Cadmium does not yet have a well identified delta zero material, although three commercial mono-elemental Cd solutions have yielded the same isotopic composition relative to one another. In order to scale the linearity of any mass spectrometer, some secondary reference materials are also proposed: Cambridge-1 solution for Mg, the "Münster-Cd" and JEPPIM Cd solutions for Cd and the "Big Batch" silicate for Si. The team from Nancy propose to prepare a mixed spike solution for Li isotopes. Well-characterised natural samples such as ocean or continental waters, diatoms, sponges, rocks and minerals are needed to validate the entire analytical procedure, particularly to take into account the effect of sample mineralisation and of chemical manipulations for elemental separation prior to analysis.     

MTBE in Drinking Water Production – Occurrence and Efficiency of Treatment Technologies

In Germany, the gasoline additive methyl tert‐butyl ether (MTBE) is almost constantly detected in measurable concentrations in surface waters and is not significantly removed during riverbank filtration. The removal of MTBE from water has been the focus of many studies that mostly were performed at high concentration levels and centred in understanding the mechanisms of elimination. In order to assess the performance of conventional and advanced water treatment technologies for MTBE removal in the low concentration range further studies were undertaken. Laboratory experiments included aeration, granulated activated carbon (GAC) adsorption, ozonation and advanced oxidation processes (AOP). The results show that the removal of MTBE by conventional technologies is not easily achieved. MTBE is only removed by aeration at high expense. Ozonation at neutral pH values did not prove to be effective in eliminating MTBE at all. The use of ozone/H₂O₂ (AOP) may lead to a partly elimination of MTBE. However, the ozone/H₂O₂ concentrations required for a complete removal of MTBE from natural waters is much higher than the ozone levels applied nowadays in waterworks. MTBE is only poorly adsorbed on activated carbon, thus GAC filtration is not efficient in eliminating MTBE. A comparison with real‐life data from German waterworks reveals that if MTBE is detected in the raw water it is most often found in the corresponding drinking water as well due to the poor removal efficiency of conventional treatment steps.     

‘Committing to Place’ at the Local Scale: the potential of youth education programs for promoting community participation in regional natural resource management

Emerging approaches to environmental governance require a greater level of community participation than did previous approaches in which these responsibilities largely rested with government agencies. There is consequently a need for increased engagement with NRM among a broad community sector. This paper examines initiatives by two prominent government agencies, the Murray–Darling Basin Commission (MDBC) and the National Museum of Australia (NMA), to engage school children from regional communities using education programs that focus on place and environmental health. We focus on the MDBC's International Riverhealth Conference held in Mildura in 2003 and the associated Murray–Darling Basin TalkBack Classroom sponsored by the NMA and the Parliamentary Education Office (PEO). We explore how key themes of local scale, place-based identities, youth voice and critical engagement are developed in these programs and consider how they relate to the environmental agency of children. We then reflect on the potential for the kinds of environmental agency promoted through these programs to help build the capacity of local communities to progress larger goals of environmental restoration and sustainability in the Murray–Darling Basin. The evaluation research reported here forms part of the Committing to Place research project, an Australian Research Council Linkage grant involving the University of Tasmania, the National Museum of Australia and the Murray–Darling Basin Commission.     

Vegetation changes in the Jornada Basin from 1858 to 1998

Notes made by land surveyors in 1858 were utilized to estimate cover of grasses and shrubs on the Jornada Experimental Range (JER) and the Chihuahuan Desert Range Research Center (CDRRC) in the northern Chihuahuan Desert in southern New Mexico, USA. Portions of these areas have been previously assessed for historical vegetation dynamics but the entire 84,271 ha assessed in the 19th century has not been examined in total. In 1858, fair to very good grass cover occurred on 98% and 67% of the JER and CDRRC, respectively. Shrubs were present throughout both properties but 45% of the JER and 18% of the CDRRC were shrub free. Reconnaissance surveys, made to determine carrying capacity for livestock were made in 1915–1916 and 1928–1929 on the JER and in 1938 on the CDRRC, show that shrubs had made large increases in area occupied at the time of the surveys. Vegetation type maps were made of both properties in 1998. Mesquite (Prosopis glandulosa) was the primary dominant on 59% of the JER in 1998 and creosotebush (Larrea tridentata) was the primary dominant on 27% of the area. On the CDRRC mesquite and creosotebush were primary dominants on 37% and 46% of the area, respectively. Grass cover has decreased greatly with the increase in shrubs and only shrub control efforts have maintained the once abundant black grama (Bouteloua eriopoda) as a primary dominant on 1% or less of the area on both properties.     

Gold partitioning in melt-vapor-brine systems

We used laser-ablation inductively coupled plasma mass spectrometry to measure the solubility of gold in synthetic sulfur-free vapor and brine fluid inclusions in a vapor + brine + haplogranite + magnetite + gold metal assemblage. Experiments were conducted at 800°C, oxygen fugacity buffered at Ni-NiO (NNO), and pressures ranging from 110 to 145 MPa. The wt% NaCl eq. of vapor increases from 2.3 to 19 and that of brine decreases from 57 to 35 with increasing pressure. The composition of the vapors and brines are dominated by NaCl + KCl + FeCl₂ + H₂O. Gold concentrations in vapor and brine decrease from 36 to 5 and 50 to 28 μg/g, respectively, and the calculated vapor:brine partition coefficients for gold decrease from 0.72 to 0.17 as pressure decreases from 145 to 110 MPa. These data are consistent with the thermodynamic boundary condition that the concentration of gold in the vapor and brine must approach a common value as the critical pressure is approached along the 800°C isotherm in the NaCl-KCl-FeCl₂-HCl-H₂O system.We use the equilibrium constant for gold dissolution as AuOH⁰, extrapolated from lower temperature and overlapping pressure range, to calculate expected concentrations of AuOH⁰ in our experimental vapors. These calculations suggest that a significant quantity of gold in our experimental vapors is present as a non-hydroxide species. Possible chloridogold(I) species are hypothesized based on the positively correlated gold and chloride concentrations in our experimental vapors. The absolute concentration of gold in our synthetic vapor, brine, and melt and calculated mass partition coefficients for gold between these physicochemically distinct magmatic phases suggests that gold solubility in aqueous fluids is a function of aqueous phase salinity, specifically total chloride concentration, at magmatic conditions. However, though we highlight here the effect of salinity, the combination of our data with data sets from lower temperatures evinces a significant decrease in gold solubility as temperature drops from 800°C to 600°C. This decrease in solubility has implications for gold deposition from ascending magmatic fluids.