Quantitative high resolution cathodoluminescence spectroscopy of diagenetic and hydrothermal dolomites

A combination of high resolution cathodoluminescence-spectroscopy (HRS-CL=high resolution spectroscopy of cathodoluminescence emission) with spatial resolving trace element analyses (PIXE=proton induced X-ray emission) is used to establish a method for the quantitative determination of the Mn-content of diagenetic and hydrothermal dolomites using the measurements of peak areas of Mn-activated CL emission bands. This method takes into account the overlap of the CL broad bands of Mn²⁺ in the Mg- and the Ca-lattice-position of dolomite. There is a linear correlation between the peak areas and Mn concentration up to approx. 1000–1500 ppm. Thus, CL spectroscopy allows a determination of Mn concentrations below the abilities of PIXE (10–15 ppm) to less than 1 ppm by extrapolation of this linear relation.

Up to an Fe-content of approx. 2000 ppm, no quenching effect of Fe on this linear relationship occurs. However, Fe-contents above 2000 ppm result in a decrease of Mn-induced luminescence. Even at Fe-concentration >25,000 ppm spectroscopy reveals that Mn-activated CL of dolomite is not entirely extinguished.     

Optically stimulated luminescence dating of sublittoral and intertidal sediments from Dubai, UAE: Radioactive disequilibria in the uranium decay series

Shallow marine and intertidal shell rich sediments from the low coastal plain of Dubai were dated by optically stimulated luminescence. Combined high-resolution gamma spectrometry and ICP–MS analyses revealed significant disequilibria in the ²³⁸U decay series. Time dependent dose rates were modelled for two scenarios including a closed system and an open system with linear U and Ra uptake. OSL ages that were calculated using the linear uptake model are in good agreement with archaeological evidence and radiocarbon datings on shells and wood. The presented results illustrate that luminescence-dating techniques are suitable to set up a chronostratigraphic frame for calcareous coastal environments if an appropriate model is applied to consider the influence of radioactive disequilibria and time dependent dose rates. A comprehensive radionuclide analysis of the sediments is thought necessary to perform geochemically supported dose rate simulations.     

Comparing precipitation bias correction methods for high-resolution regional climate simulations using COSMO-CLM

A new parametric bias correction method for precipitation with an extension for extreme values is compared to an empirical and an existing parametric method. The bias corrections are applied to the regional climate model COSMO-CLM (consortium for small-scale modelling – climate limited area modelling) with a resolution of 4.5 km for the time periods 1991–2000 and 2091–2100. In addition to a comparison in a cross-validation framework, a focus is laid on the investigation of extreme value correction and the effect of the bias correction on the climate change signal. According to the statistical methods used in this study, it was found that the empirical method outperforms both parametric alternatives. However, due to the limited length of the available time series, some outliers occurred, and all methods had problems correcting extreme values. The climate change signal is moderately influenced by all three methods, and the power of climate change detection is reduced. The largest effect was found for the number of dry days and the mean daily intensity, which are considerably altered after correction.     

Heavy mineral-based provenance analysis of Mesozoic continental-marine sediments at the western edge of the Bohemian Massif,SE Germany: with special reference to Fe–Ti minerals and the crystal morphology of heavy minerals

During the Mesozoic, the epicontinental Germanic Basin and the Regensburg Strait the latter being an embayment of the Tethys Ocean that had subsided into the Moldanubian Zone of the Central European Variscides were filled with terrigenous continental-marine sediments. Both sediments’ heavy mineral (HM) grains and aggregates have been studied in a drill section in the Wackersdorf area, SE Germany. The majority of them belong to the (semi)opaque group of Fe–Ti minerals. In Wackersdorf, the entire stratigraphy of the basin fill, which occurred between the Triassic and the Late Cretaceous, is well exposed. In addition to the chemical composition of HM, the morphology and texture of zircon, apatite and Fe–Ti compounds have been studied in a provenance-related mineral classification. Provenance analysis has yielded five discrete source rock lithologies: (1) Moldanubian H-T-metamorphics, (2) late Paleozoic (sub)volcanic rocks, (3) gneisses of the Tepla-Barrandian unit, (4) ophiolites of the Tepla-Barrandian unit, (5) silicified shear zones and quartz cores of pegmatites. The detrital minerals include zircon, tourmaline (dravite-schoerl), apatite, monazite (Ce–Th–La–Nd), xenotime, biotite, rutile, ilmenite, “nigrine” (ilmenite-rutile intergrowth), sphene, amphibole, staurolite, garnet and spinel (Cr–Mg–Al). Based on the allogenic Ti and Fe minerals, a magnetite-type source area (Eh > 0, near-surface felsic to intermediate (sub)volcanic rocks) was distinguished from an ilmenite-type source area (Eh < 0), deeply eroded crystalline basement rocks (gneiss, granite, shear zones). The latter may be subdivided into “nigrine –I” (deep) and “nigrine-II” (intermediate) subtypes, according to the level of erosion in the source area. At the Jurassic–Cretaceous transition, extrabasinal erosion provoked a noticeable variation of allogenic heavy minerals with the incisions of rivers into source rock lithologies (4) and (5). Uplift and erosion along the western edge of the Bohemian Massif took place contemporaneously with spreading and closure in the central parts of the adjacent Tethys Ocean.     

Vertical hydraulic exchange and the contribution of hyporheic community respiration to whole ecosystem respiration in the River Lahn (Germany)

To quantify the contribution of hyporheic community respiration to whole running-water ecosystem respiration in a cultural landscape setting, we studied the vertical hydraulic exchange in riffle–pool sequences of the River Lahn (Germany). We used flow through curves from four tracer experiments to estimate flow velocities in the surface and subsurface water. Generally, vertical exchange velocities were higher in riffle sections and a high temporal variability was observed (range of values 0.11–1.08 m day⁻¹). We then used (1) the exchange velocities and (2) time series of dissolved oxygen concentration in surface and subsurface water to calculate hyporheic respiration. Hyporheic respiration was estimated in a range of 10–50 mg O₂ m⁻³ day⁻¹ for the upper sediment layer (first 20 cm). It was much lower in the deeper sediment layer (20–40 cm), ranging from 0 to 10 mg O₂ m⁻³ day⁻¹ (volumes are volumes of interstitial water; the average porosity was 20%). We determined primary production and respiration of the biofilm growing on the sediment by modelling dissolved oxygen concentration time series for a 2,450 m long stream reach (dissolved oxygen concentrations with diurnal variations from 8 to 16 mg L⁻¹). Modelled respiration rates ranged from 2 to 21 g O₂ m² day⁻¹. All information was integrated in a system analysis with numerical simulations of respiration with and without sediments. Results indicated that hyporheic respiration accounted for 6 to 14% of whole ecosystem respiration. These values are much lower than in other whole system respiration studies on more oligotrophic river systems.     

The “Donauplatin”: source rock analysis and origin of a distal fluvial Au-PGE placer in Central Europe

The mineral assemblage and the sedimentological characteristics of the “Donauplatin” (Danubian fluvial placer containing platinum-group elements (PGE) and gold (Au)) are described for the first time in connection with upstream reference placer deposits near the potential source area in tributaries of the River Danube/Donau. Granulometric and morphometric data have been obtained using the CCD-based CAMSIZER technique. The platinum-group minerals (PGM; iridium, osmium, unknown iridium-osmium-sulfide, ruthenium-osmium-iridium alloys, platinum-iron alloys, iridium-bearing platinum, sperrylite) have been derived from ultramafic magmatic rocks, probably belonging to the ophiolitic series in the Tepla Barrandian unit of the Bohemian Massif. The Au-Pd-Cu compounds in the placer originated from dynamo-metamorphogenic processes in a sulfur-deficient environment at the SW edge of the Bavarian Basement. Gold in the “Donauplatin” has been reworked from a “secondary” or intermediate repository of lateritic gold (Boddington-type). Its primary source is supposed to be of orogenic origin. Provenance analyses of the associated non-heavy minerals point to high-pressure metamorphic rocks, igneous rocks (monazite) and high-temperature metamorphic rocks (750° to 850°C, zircon morphology). Garnet compositions indicate that meta(ultra)basic igneous rocks, calc-silicate rocks and skarns prevailed over paragneisses in the provenance area. Extraterrestrial processes creating the well-known Ries impact crater in the environs of Nördlingen during the Miocene have a minor share in the PGE budget by delivering molybdenum-ruthenium-osmium-iridium alloys and iridium solid-solution series (s.s.s.) minerals. Judging by the heavy mineral suites, Saxothuringian source rocks of the NE Bavarian Basement connected with the Donau River via the Naab River drainage system have not contributed to the element budget of the “Donauplatin” under study. Stream sediments which have been derived from this provenance area are characterized by low-temperature (LT) crystalline rocks and a considerable proportion of pegmatitic and metabauxitic material lacking in the Holocene sediments of the “Donauplatin”.