Potential environmental issues of CO2 storage in deep saline aquifers: Geochemical results from the Frio-I Brine Pilot test,Texas, USA

Sedimentary basins in general, and deep saline aquifers in particular, are being investigated as possible repositories for large volumes of anthropogenic CO₂ that must be sequestered to mitigate global warming and related climate changes. To investigate the potential for the long-term storage of CO₂ in such aquifers, 1600 t of CO₂ were injected at 1500 m depth into a 24-m-thick “C” sandstone unit of the Frio Formation, a regional aquifer in the US Gulf Coast. Fluid samples obtained before CO₂ injection from the injection well and an observation well 30 m updip showed a Na–Ca–Cl type brine with ∼93,000 mg/L TDS at saturation with CH₄ at reservoir conditions; gas analyses showed that CH₄ comprised ∼95% of dissolved gas, but CO₂ was low at 0.3%. Following CO₂ breakthrough, 51 h after injection, samples showed sharp drops in pH (6.5–5.7), pronounced increases in alkalinity (100–3000 mg/L as HCO₃) and in Fe (30–1100 mg/L), a slug of very high DOC values, and significant shifts in the isotopic compositions of H₂O, DIC, and CH₄. These data, coupled with geochemical modeling, indicate corrosion of pipe and well casing as well as rapid dissolution of minerals, especially calcite and iron oxyhydroxides, both caused by lowered pH (initially ∼3.0 at subsurface conditions) of the brine in contact with supercritical CO₂.     

西藏恰功铁矿岩浆演化序列及斑岩出溶流体特征

冈底斯成矿带是碰撞造山过程形成的最重要的成矿带,恰功矽卡岩铁(铜)矿床即位于冈底斯成矿带中部.本文在详细的野外地质填图和室内研究基础上确定了恰功铁矿与成矿有关的斑岩体为二长花岗斑岩,锆石的U-Pb定年结果为68.8±2.2 Ma,明显早于冈底斯东部与后碰撞伸展有关的斑岩型矿床和主碰撞期形成的矽卡岩型矿床,其应代表了冈底斯一次尚未被充分认识到的成矿事件.通过对成矿斑岩的岩石学、岩石化学、岩浆出溶流体的包裹体岩相学、显微测温分析及包裹体成分的LRM、LA-ICP-MS和PIXE分析,本文探讨了与该矽卡岩矿床有关的斑岩的岩浆起源、斑岩侵位机制及出溶流体特征.结果表明,成矿斑岩为矿区最早的侵入岩单元,具有壳幔源混源特征,其常量元素组成与冈底斯东部斑岩铜矿带的埃达克质岩相近,但稀土和微量元素组成与东部斑岩明显不同,为地幔物质上涌并诱发角闪岩相下地壳熔融的产物,岩体侵位深度大(>7 km)、剥蚀程度高.早期岩浆出溶的流体为高温、高压、高盐度流体,其中富含Fe、Pb、Zn、Cu等成矿金属,与世界其他斑岩铜矿床相比,相对富铁、铅而贫铜.流体的沸腾作用发生于钾硅化阶段,形成了一套富气、高盐、高固相和气液包裹体组合,不同于早期出溶流体的包裹体组合.从岩浆起源和出溶流体性质可以看出,该斑岩具有形成与斑岩有关的铁铅多金属矿床的成矿潜力,但从该矿区地表出露的蚀变和包裹体测压结果可以看出,该斑岩体目前剥蚀深度较大,对斑岩型矿床保存不利,对该斑岩体及与成矿关系的认识对理解该区内的矿床成因和指导区域找矿具有重要的指示意义.     

Minimum Bedrock Exposure Ages and Their Implications: Larsemann Hills and Neighboring Bolingen Islands, East Antarctica

<正>Considerable controversy exists over whether or not extensive glaciation occurred during the global Last Glacial Maximum(LGM) in the Larsemann Hills.In this study we use the in situ produced cosmogenic nuclide ~(10)Be(half life 1.51 Ma) to provide minimum exposure ages for six bedrock samples and one erratic boulder in order to determine the last period of deglaciation in the Larsemann Hills and on the neighboring Bolingen Islands.Three bedrock samples taken from Friendship Mountain(the highest peak on the Mirror Peninsula,Larsemann Hills;～2 km from the ice sheet) have minimum exposure ages ranging from 40.0 to 44.7 ka.The erratic boulder from Peak 106(just at the edge of the ice sheet) has a younger minimum exposure age of only 8.8 ka.The minimum exposure ages for two bedrock samples from Blundell Peak(the highest peak on Stornes Peninsula,Larsemann Hills;～2 km from the ice sheet) are about 17 and 18 ka.On the Bolingen Islands(southwest to the Larsemann Hills;～10 km from the ice sheet),the minimum exposure age for one bedrock sample is similar to that at Friendship Mountain(i.e.,44 ka).Our results indicate that the bedrock exposure in the Larsemann Hills and on the neighboring Bolingen Islands commenced obviously before the global LGM(i.e.,20-22 ka),and the bedrock erosion rates at the Antarctic coast areas may be obviously higher than in the interior land.     

Recent morphological evolution of the Lower Mississippi River

This study documents slope and stream power changes in the Lower Mississippi River during the pre-cutoff (1880s–1930s), and post-cutoff (1943–1992) periods. The study reach extends from New Madrid, MO, to Natchez, MS, a distance of about 900 km. Analyses for six major reaches and 13 sub-reaches for the pre- and post-cutoff periods indicate that the river presently has a much larger slope and stream power than prior to the cutoffs. The largest increases have occurred between Fulton, TN, and Lake Providence, LA, where slope and stream power increases range from about 27% to 36% and 20% to 38%, respectively. Increases in slope and stream power in reaches upstream and downstream have also occurred, but to a lesser degree. Previous investigations have shown that no coarsening of the bed material has occurred since 1932, and that the bed material may actually be somewhat finer overall. As the Lower Mississippi River is not a sediment-starved system, an increase in stream power with no change in D₅₀ would be expected to be offset by an increase in the bed material load as the river adjusts towards equilibrium. Previous investigators have inferred a reduction in the sediment loads on the Mississippi River this century based on analyses of total measured suspended loads. However, these results should be viewed as primarily representing the changes in wash load and should not be taken to imply that bed material loads have also decreased. Therefore, the bed material loads in the study reach should be greater than in the pre-cutoff period. Excess stream power in the sub-reaches directly affected by cutoffs resulted in scour that increased downstream bed material load. These elevated sediment loads play a key role in driving morphological adjustments towards equilibrium in the post-cutoff channel. The stability status of the channel in the study reach currently ranges from dynamic equilibrium in the farthest upstream reaches through severe degradation to dynamic equilibrium in the middle reaches, and aggradation in the lowest reaches. These evolutionary trends cannot be explained by consideration of changes in slope and stream power alone. Changes in the incoming bed material load to each reach generated by upstream channel evolution must also be considered.     

Interpretation of magnetic and gravity gradient tensor data using normalized source strength – A case study from McFaulds Lake,Northern Ontario,Canada

In this paper, we present a case study on the use of the normalized source strength (NSS) for interpretation of magnetic and gravity gradient tensors data. This application arises in exploration of nickel, copper and platinum group element (Ni‐Cu‐PGE) deposits in the McFaulds Lake area, Northern Ontario, Canada. In this study, we have used the normalized source strength function derived from recent high resolution aeromagnetic and gravity gradiometry data for locating geological bodies. In our algorithm, we use maxima of the normalized source strength for estimating the horizontal location of the causative body. Then we estimate depth to the source and structural index at that point using the ratio between the normalized source strength and its vertical derivative calculated at two levels; the measurement level and a height h above the measurement level. To discriminate more reliable solutions from spurious ones, we reject solutions with unreasonable estimated structural indices. This method uses an upward continuation filter which reduces the effect of high frequency noise. In the magnetic case, the advantage is that, in general, the normalized magnetic source strength is relatively insensitive to magnetization direction, thus it provides more reliable information than standard techniques when geologic bodies carry remanent magnetization. For dipping gravity sources, the calculated normalized source strength yields a reliable estimate of the source location by peaking right above the top surface. Application of the method on aeromagnetic and gravity gradient tensor data sets from McFaulds Lake area indicates that most of the gravity and magnetic sources are located just beneath a 20 m thick (on average) overburden and delineated magnetic and gravity sources which can be probably approximated by geological contacts and thin dikes, come up to the overburden.     

Evidence for high-pressure core-mantle differentiation from the metal-silicate partitioning of lithophile and weakly-siderophile elements

Liquid Fe metal-liquid silicate partition coefficients for the lithophile and weakly-siderophile elements Ta, Nb, V, Cr, Si, Mn, Ga, In and Zn have been measured in multianvil experiments performed from 2 to 24 GPa, 2023-2873 K and at oxygen fugacities of −1.3 to −4.2 log units relative to the iron-wüstite buffer. Compositional effects of light elements dissolved in the metal liquid (S, C) have been examined and experiments were performed in both graphite and MgO capsules, specifically to address the effect of C solubility in Fe-metal on siderophile element partitioning. The results were used to examine whether there is categorical evidence that a significant portion of metal-silicate equilibration occurred under very high pressures during core-mantle fractionation on Earth. Although the depletion of V from the mantle due to core formation is significantly greater than that of Nb, our results indicate that both elements have similar siderophile tendencies under reducing conditions at low pressures. With increasing pressure, however, Nb becomes less siderophile than V, implying that average metal-silicate equilibration pressures of at least 10-40 GPa are required to explain the Nb/V ratio of the mantle. Similarly the moderately-siderophile, volatile element ratios Ga/Mn and In/Zn are chondritic in the mantle but both volatility and core-mantle equilibration at low pressure would render these ratios strongly sub-chondritic. Our results indicate that pressures of metal-silicate partitioning exceeding 30-60 GPa would be required to render these element ratios chondritic in the mantle. These observations strongly indicate that metal-silicate equilibration must have occurred at high pressures, and therefore support core-formation models that involve deep magma oceans. Moreover, our results allow us to exclude models that envisage primarily low-pressure (<1 GPa) equilibration in relatively small planetary bodies. We also argue that the core cannot contain significant U as this would require metal-silicate equilibration at oxygen fugacities low enough for significant amounts of Ta to have also been extracted from the mantle. Likewise, as In is more siderophile than Pb but similarly volatile and also quite chalcophile it would have been difficult for Pb to enter the core without reversing the relative depletions of these elements in the mantle unless metal-silicate equilibration occurred at high pressures >20 GPa.     

A Method for Installing Piezometers in Large Cobble Bed Rivers

An impact drive point method is described for emplacing piezometers in a cobble river bottom where this has previously been difficult without the use of drilling rigs. To force the drive point piezometers through coble, the vibrational impact of an air-powered hammer was carried directly to the drive point by the use of an internal drive rod. After insertion to depth, the drive rod was removed from the lower portion of the piezometer and a standpipe was added to extend the piezometer above the river level. Piezometers installed in this way have permitted water quality analysis and dynamic measurement of vertical potentials in cobble sediments ranging in size from 2.5 to >30 cm and the method has been successfully used in the Columbia River, USA, and Töss River, Switzerland. This innovative method provides information on the hydrodynamics of pore water in highly permeable, cobble deposits that are common in high-energy river and lake bottoms. Piezometers installed using the internal drive rod method facilitate the assessment of the temporal and spatial dynamics of recharge and discharge at the ground water/surface water interface and analyses of the ecological connectivity between the hyporheic zone and surface water of rivers and streams. This information will lead to improved management decisions related to our nation's ground water and surface water supplies.     

Amino acid racemization dating of fossil bones,I. inter-laboratory comparison of racemization measurements

Enantiomeric measurements for aspartic acid, glutamic acid, and alanine in twenty-one different fossil bone samples have been carried out by three different laboratories using different analytical methods. These inter-laboratory comparisons demonstrate that D/L aspartic acid measurements are highly reproducible, whereas the enantiomeric measurements for the other amino acids show a wide variation between the three laboratories. At present, aspartic acid measurements are the most suitable for racemization dating of bone because of their superior analytical precision.