Monitoring and prediction of land use/land cover changes using CA-Markov model: a case study of Ravansar County in Iran

Human‐induced land use/land cover (LULC) changes are among the most important processes that shape the dynamics of the earth’s surface. This phenomenon, which is occurring at an astonishing rate, and its consequential environmental impacts have become an important area of research for scientists.Therefore, a wide range of methods and models have been developed to detect and predict these alterations, among which cellular automata (CA) models such as the CA‐Markov model, due to their affinity to geographic information system (GIS) and remote sensing (RS), are appropriate for detailed resolution modelling and simulating dynamic spatial processes. In Iran, the district of Ravansar has undergone severe LULC changes recently, thus to take the necessary precautions, decision‐makers need to predict and determine the extent of these changes. In this study, using spatial analysis methods the LULC changes in Ravansar were investigated from 1992 to 2015. Subsequently, the CA‐Markov model was applied to simulate the spatial pattern changes of LULC until 2030. Our results indicated that from 1992 to 2015, this region has witnessed a noticeable increase in the areas of the built‐up and agricultural lands (both aquatic and non‐aquatic), resulting in the decrease of the gardens, range, and bare lands. The simulated LULC map showed that this trend will continue due to more urbanization and development of agricultural areas.     

Radioactive anomalies associated with the graphite-bearing metasediments,Wadi Umm Gheig area,Central Eastern Desert,Egypt

The study area is located in the central part of the Eastern Desert of Egypt and is mainly covered by different varieties of Precambrian basement rocks represented mainly by younger and older granites, metadiorite, metavolcanics, and metasediments. The analysis and interpretation of airborne gamma-ray spectrometric survey data are essentially based on the computation of the three radioelements (U, Th, and K) favorability indices, estimation of uranium migration rate percentage, variation of eU with eTh and eU/eTh ratio, and the construction of the contour map of the (eU-eTh/3.5) in the different rock units. The highest percent of uranium migration- out or leaching rate is connected with the red and pink granites of Gebel Kadabora El-hamra, metadiorite, and red and pink granites of G. Umm Rakham (??20.8%, ??18.57%, and ??8.45% respectively), which indicates that they could represent a major U-source bodies in the area. It was observed that the metasediments and associated graphite-bearing schists west and northwest of G. Kadabora El-hamra reflect more precipitation than the other locations around the pluton (the uranium migration rates varies between 2.59 and 30%) which mean that the graphite may have acted as a reducing agent for uranium carried in oxidizing fluids (surface meteoric water) and resulted in its precipitation. In the light of the availability of uranium source, its mobility, and graphite-bearing metasediments, the area has a good potential for the possible occurrence of uranium mineralization.     

Estimated volume of water in shallow wells of Ekiti State,Southwestern Nigeria: implications on groundwater sustainability

Volumes of water in shallow wells of Ekiti State Southwestern Nigeria was estimated during the rainy and dry seasons of 2017 to categorize the area into different groundwater potential zones and to scrutinize it for groundwater sustainability and development. Locations of the wells were measured using etrex 12 Channel GPS while dip meter was employed for the water levels and depths of wells. The volume of water in a well was estimated employing V = πr²h (r and h are radius and water column of well, respectively). The wells in the area have low water storage (av. 6.91m³ and 2.70m³ in rainy and dry seasons, respectively). The study area had sufficient quantity of water in the rainy season to meet domestic, agricultural, and industrial requirements as deficiency was met from rainfall replenishment. Groundwater potential evaluation revealed that majority of the study area fell into very poor to poor water categories. Groundwater sustainability and development in the study area is a herculean task due to uncoordinated sitting of wells, low storage of water in the aquifers, and erratic occurrence of the groundwater. Hygiene education should be intensified in the area to forestall the risks post by the principal elements of fecal oral disease transmission.     

Geomorphic characteristics of a bedrock river inferred from drainage quantification,longitudinal profile,knickzone identification and concavity analysis: a DEM-based study

An examination of river channels has ability to provide substantial information regarding the geomorphic characteristics, control of lithology, tectonic uplift and geomorphic evolution during the geological past of an area. In this paper, a detailed study of geomorphic and structural investigation has been carried out for Pravara basin, Maharashtra, with the help of 90-m resolution SRTM DEM and geospatial techniques. Drainage network analysis performed in this paper demonstrates the general geomorphic characteristics, while the analysis of longitudinal profile synthesises lithological control over Pravara basin. Pravara is a 6th order drainage basin, encompassing an area of 2637 km². Bifurcation ratio reveals low to moderate structural control. Due to the hard rock lithology, the drainage density and stream frequency are low, and it indicates higher permeability in the sub-surface layers. The shape parameters denote that Pravara is highly elongated and it is easier to control floods in this basin. Relief parameters show very steep slope and higher vulnerability to the slope failure in some areas. Upstream of Pravara river has shown that series of breaks and knickzones indicate active erosion and acute lithological control on the channel. Major breaks are observed only in the main channel whereas in two major tributaries, no such breaks found, instead these tributaries are characterised by several knickzones which indicate regional variation in the lithological physiognomies. Different lithological stages on knickpoint and channel incision substantiate rejuvenation of Pravara river in several phases during geological past. The geospatial methodology carried out in this study can be pragmatic elsewhere around this world to recognise the geomorphic appearances and lithological control of a drainage basin.     

Effects of biochar and bio-fertilizer on yield and qualitative properties of soybean and some chemical properties of soil

This study attempted to examine the effects of biochar amendment together with bio-fertilizer on soybean yield and its qualitative properties, as well as a few chemical properties of soil through a factorial randomized complete block design at three replications in east of Golestan Province (Iran) during 2014. The two factors under study included the following: (1) biochar amendment (in four levels of 0, 2.5, 8, and 16 tons per hectare), (2) bio-fertilizer containing phosphorus and sulfur growth-promoting rhizobacteria (in two levels of inoculation and non-inoculation) applied through foliar feeding. The results of analysis of variance indicated that interactions of biochar amendment and bio-fertilizer on harvest index and grain yield were significant (p ≤?0.01). According to the results of this study, the highest harvest index and oil content were 56.9, and 17.7%, respectively, in the treatment of 8 tons per hectare biochar and inoculation with bio-fertilizer. The lowest harvest index and the lowest oil content were in the control treatment. The interaction of biochar and bio-fertilizer on bulk density and cation exchange capacity was significant (p ≤?0.01). The results of this study demonstrated that biochar affected the amount of residual nitrogen in the soil after harvest, cation exchange capacity (CEC), acidity (pH), and electrical conductivity (EC). The highest grain yield (3440 kg/ha) was in the 8-ton biochar treatment with inoculated bio-fertilizer. Our study concludes that the biochar and bio-fertilizers can improve grain yield of soybean till 51% relative to the control.     

Effect of heat treatment on dynamic properties of selected rock types taken from the Salt Range in Pakistan

Temperature is one of the variables that influence the elasto-plastic behavior and integrity of rock outcrops. Fluctuations in temperature can trigger alteration of some of the mineral properties and impact the brittle-plastic transition. Initiation and propagation of thermally induced tension cracks tend to weaken most rock types. The principal goal of this study was to anticipate impacts of thermal stress-strain cycles on the dynamic response of representative rock units exposed in the Khewra Gorge of the Salt Range Punjab of Pakistan. Ten types of sedimentary rock units were sampled, including marl, dolomite, three types of limestone, and five different sandstones exhibiting varying characteristics in outcrop. Boulder specimens were collected from the field and transported to the laboratory to prepare 50 drill cores that could be subjected to thermal cycling between 50 and 200 °C in increments of 50 °C. Room temperature core samples were tested using an Erudite resonance frequency meter to measure their Q-factors and the resonance frequency (F_r) at an applied loading frequency of 7 KHz with 0.01 V output voltage. Results suggest that thermal cycling tends to reduce the dynamic Young’s modulus (E_d) and Q-factor. Other parameters, such as damping ratio (ξ), specific damping capacity (Ψ), and loss factor (?) appeared to increase with increasing temperature cycles, likely as a result of developing thermally induced tensile fractures. The resultant values of the null hypothesis (t-critical and t-stats) suggests that the null hypothesis can be discarded because there was no observable difference between the measured and expected values for the cores tested. The observations and data emanating from this study might be useful in designing low-level radioactive waste landfills, nuclear waste repositories, and deep underground excavations where the increased temperature could alter the mechanical behavior of the parent rock mass.     

Geotechnical design parameter evaluation using the alluvial plain characteristics in southeastern Iraq

Geotechnical construction is responsible for the overall stability of superstructures, and if there are design errors, the structure will be exposed to potential problems. Geotechnical design starts with the correct interpretation of the target ground. Southeastern Iraq is mainly comprised of an alluvial plain with diverse geological features, and, therefore, geotechnical design requires a detailed interpretation and understanding of the area. This paper reports on laboratory and field tests and in-depth analyses conducted on these alluvial plains. The results reveal that the upper layer of this area is highly over-consolidated. This may have been caused by the removal of overburden pressure as a result of glaciation and desiccation. The highly over-consolidated soils caused considerable sample disturbance by swelling the bored sample; this provided less reliable results. However, the cone penetration test was regarded as the most appropriate field assessment method for deriving sensible geotechnical design parameters. Despite its limitations in clayey soils, the standard penetration test provided results that matched well with previous observations due to the high penetration resistance of the highly over-consolidated ground. Down-hole tests and plate load tests were considered less reliable methods due to their limited applicability in this area. This study considers geographical features, laboratory methods, and empirical correlations from in situ tests, and, therefore, provides a well-summarized guideline to evaluate special geotechnical characteristics of the alluvial plain in southeastern Iraq.     

A practical approach for the interpretation of flowing well tests

Flowing well test is one of the tools employed to identify transmissivity and storage coefficient of a confined aquifer where the potentiometric surface is located above the ground surface, so that the groundwater flows naturally from the well without pumping. During a flowing well test, constant hydraulic head is preserved at the well while the discharge from the well decreases with time and the temporal variation of discharge provides significant information about aquifer characteristics. In this study, a simple and straightforward approach is presented as an alternative to a number of graphical or error minimization-based techniques available in the literature for analyzing data from flowing well tests. The proposed method employs a polynomial regression equation to establish a link between observed discharge and the theoretical dimensionless discharge that is introduced in the analytical solution, so as to retrieve the aquifer parameters. The method is tested with a vast number of synthetically generated data sets as well as a real data set reported in the literature. Besides its simplicity, the present method is seen to produce highly accurate and reliable estimations.     

Structural properties of Urfa stone doped with erbium oxide

In this study, we investigated the structural properties of Urfa stone (US) doped with erbium oxide (Er₂O₃). Solid US was powdered by using an agate mortar, and its elemental composition was determined using inductive coupling plasma (ICP) methods. Varying amounts of Er₂O₃ (5, 10, 20, 30, and 40%) were added as a dopant to the US powder using mechanical alloying methods. The resultant samples were sintered at 1000 °C for 1 h. The structural properties of the Er₂O₃-doped US samples were subsequently investigated using X-ray diffraction (XRD), Fourier-transform infrared spectrometry (FTIR), and photoluminescence methods. Results from the XRD analysis of the Er₂O₃-doped US powder indicated two crystalline phases: (1) calcium oxide (CaO) or lime and (2) Er₂O₃. After the samples were sintered at 1000 °C, CaO, Er₂O₃, calcium carbonate (CaCO₃), and mixed crystalline phases were observed. Results from the FTIR analysis of the Er₂O₃-doped US samples indicated absorption bands at 711.91, 872.08, and 1396.87 cm^?1 in the spectra. Finally, photoluminescence analysis results indicated a shift in the emission and excitation bands to longer and shorter wavelengths, respectively, in the solid state (non-aqueous media) US-Er complex.     

Teleseismic finite-fault inversion of two <Emphasis Type="Italic">M</Emphasis><Subscript>w</Subscript> = 6.4 earthquakes along the East Anatolian Fault Zone in Turkey: the 1998 Adana and 2003 Bingöl earthquakes

The East Anatolian Fault Zone is a continental transform fault accommodating westward motion of the Anatolian fault. This study aims to investigate the source properties of two moderately large and damaging earthquakes which occurred along the transform fault in the last two decades using the teleseismic broadband P and SH body waveforms. The first earthquake, the 27 June 1998 Adana earthquake, occurred beneath the Adana basin, located close to the eastern extreme of Turkey’s Mediterranean coast. The faulting associated with the 1998 Adana earthquake is unilateral to the NE and confined to depths below 15 km with a length of 30 km along the strike (53°) and a dipping of 81° SE. The fixed-rake models fit the data less well than the variable-rake model. The main slip area centered at depth of about 27 km and to the NE of the hypocenter, covering a circular area of 10 km in diameter with a peak slip of about 60 cm. The slip model yields a seismic moment of 3.5?×?10¹⁸ N-m (M_w???6.4). The second earthquake, the 1 May 2003 Bingöl earthquake, occurred along a dextral conjugate fault of the East Anatolian Fault Zone. The preferred slip model with a seismic moment of 4.1?×?10¹⁸ N-m (M_w???6.4) suggests that the rupture was unilateral toward SE and was controlled by a failure of large asperity roughly circular in shape and centered at a depth of 5 km with peak displacement of about 55 cm. Our results suggest that the 1998 Adana earthquake did not occur on the mapped Göksun Yakap?nar Fault Zone but rather on a SE dipping unmapped fault that may be a split fault of it and buried under the thick (about 6 km) deposits of the Adana basin. For the 2003 Bingöl earthquake, the final slip model requires a rupture plane having 15° different strike than the most possible mapped fault.