Modelling of turbidity currents on Navy Submarine Fan, California Continental Borderland

Several Holocene turbidites can be correlated across much of Navy Fan through more than 100 sediment core localities. The uppermost muddy turbidite unit is mapped throughout the northern half of the fan; its volume, grain-size distribution and the maximum height of deposition on the basin slopes are known. These parameters can be related to the precise channel morphology and mesotopography revealed by deep-tow surveys. Thus there is sufficient information to estimate detailed flow characteristics for this turbidity current as it moved from fan valley to distal basin plain. On the upper fan, the gradient and the increasing downstream width of the channel and only limited flow overspill suggest that the flow had a Froude number close to 1.0. The sediment associated with the channel indicates friction velocities of about 0.06 m s^?1 and flow velocities of about 0.75 m s^?1. Using this flow velocity and channel dimensions, sediment concentration (～2×10^?3) and discharge are estimated, and from a knowledge of the total volume of sediment deposited, the flow duration is estimated to be from 2 to 9 days. It is shown that the estimates of Froude number, drag coefficient, and sediment concentration are not likely to vary by more than a factor of 2. On the mid-fan, the flow was much thicker than the height of the surface relief of the fan and it spread rapidly. The cross-flow slope, determined from the horizontal extent of turbidite sediment, is used to estimate flow velocity, which is confirmed by consideration of both sediment grain size and rate of deposition. This again allows sediment concentration and discharge to be estimated. The requirements of flow continuity, entrainment of water during flow expansion, and observed sediment deposition provide checks on all these estimates, and provide an integrated picture of the evolution of the flow. The flow characteristics of this muddy turbidity current are well constrained compared to those for more sand-rich late Pleistocene and early Holocene turbidity currents on the fan.     

Sedimentation in ice-covered Lake Hoare, Antarctica

The sedimentation mechanisms that occur in ice-covered Lake Hoare, Antarctica are examined, to determine how sediment enters the lake, and how the sedimentation pattern affects blue-green algal growth at the lake bottom. The 3 m-thick ice cover contains pebbly sand as much as 2 m below the surface. Sediment with similar texture and mineralogy is found at the lake bottom. This evidence, together with the lack of sediment in the inflowing stream and the markedly different texture of sediment from the other terrains around the lake suggest that most of the sediment at the lake bottom comes in through the ice cover. Sand grains intermittently migrate through porous ice on the surface, water-filled vertical gas-channels penetrating two-thirds of the ice cover, and possibly through cracks in the ice that act as conduits. The algae at the lake bottom are able to survive in part because sediment that comes through the ice cover does not obliterate them.     

Turbidite depositional patterns and flow characteristics, Navy Submarine Fan, California Borderland

The late Pleistocene and Holocene stratigraphy of Navy Fan is mapped in detail from more than 100 cores. Thirteen ¹⁴C dates of plant detritus and of organic-rich mud beds show that a marked change in sediment supply from sandy to muddy turbidites occurred between 9000 and 12,000 years ago. They also confirm the correlation of several individual depositional units. The sediment dispersal pattern is primarily controlled by basin configuration and fan morphology, particularly the geometry of distributary channels, which show abrupt 60° bends related to the Pleistocene history of lobe progradation. The Holocene turbidity currents are depositing on, and modifying only slightly, a relict Pleistocene morphology. The uppermost turbidite is a thin sand to mud bed on the upper-fan valley levées and on parts of the mid-fan. Most of its sediment volume is in a mud bed on the lower fan and basin plain downslope from a sharp bend in the mid-fan distributary system. Little sediment occurs farther downstream within this distributary system. It appears that most of the turbidity current overtopped the levée at the channel bend, a process referred to as flow stripping. The muddy upper part of the flow continued straight down to the basin plain. The residual more sandy base of the flow in the distributary channel was not thick enough to maintain itself as gradient decreased and the channel opened out on to the mid-fan lobe. Flow stripping may occur in any turbidity current that is thick relative to channel depth and that flows in a channel with sharp bends. Where thick sandy currents are stripped, levée and mid-fan erosion may occur, but the residual current in the channel will lose much of its power and deposit rapidly. In thick muddy currents, progressive overflow of mud will cause less declaration of the residual channelised current. Thus both size and sand-to-mud ratio of turbidity currents feeding a fan are important factors controlling morphologic features and depositional areas on fans. The size-frequency variation for different types of turbidity currents is estimated from the literature and related to the evolution of fan morphology.     

Geomorphology of the Ablation Point massif, Alexander Island, Antarctica

A coloured geomorphological map at the approximate scale of 1:50,000 is presented for the Ablation Point massif area. The main gcomorphological features have been described, such as ice and snow cover, glacial landforms and deposits (and chronology), ice marginal lakes, melt pools, gelifluction landforms and patterned ground and valley-slope landforms. The area is thought to be a good analogue for glacial-age maritime northwest Europe.     

Lateral fluctuations in pelagic sedimentation during the Pleistocene glaciations

Boström, K., & Fisher, D. E.: Lateral fluctuations in pelagic sedimentation during the Pleistocene glaciations. Boreas, Vol. 1, pp. 275–288. Oslo, 1st December, 1972.
A total of 308 sediment samples of dated cores from 7 different locations have been analyzed for several major and trace elements. Our results, as well as previously published ones, show that during the Pleistocene the pelagic sediments have high concentrations of Mn, Cu, Co, REE, etc., in deposits of glacial age and low concentrations in corresponding interglacial ones; for hemipelagic sediments the situation is reversed. This shows that the boundary between reducing hemipelagic sediments and well-oxidized pelagic sediments has been migrating laterally back and forth due to climatic variations. Such sediment sequences may be easily confused with deposits where postdepositional migration of Mn and other elements has taken place.     

Properties of Synthetic Triclinic KFeSi3O8, Iron-microcline, with some Observations on the Iron-microcline{rightleftharpoons}Iron-sanidine Transition

Triclinic KFeSi₃O₈, iron-microcline, has been synthesized fromoxide mixes and by complete conversion of monoclinic KFeSi₃O₈,iron-sanidine. Iron-microcline is triclinic, C, a=8?68?0?01?, b=13?10?0?01, c=7?34?0?01, =90? 45'?10', ß=116?03'?10', =86?14'?10'. The optical properties (Na light) are:=1?585?0?002, ß=1?596?0?002, =1?605?0?002, 2V=85?(calc.), Xb, Z c=20??5?. A reversible phase transition betweentriclinic and monoclinic KFeSi₃O₈ occurs at 704??6? C at 2000bars total pressure. Iron-microcline is the low-temperaturepolymorph; no intermediate polymorphs were observed in eitherhydrothermal or dry heating experiments.     

TECHNIQUES FOR REMOVING INTERSTITIAL WATER FROM COARSEGRAINED SEDIMENTS FOR CHEMICAL ANALYSES

Three methods, (a)dessication, (b)gas extraction and (c)immiscible-liquid extraction, are described and evaluated for removing interstitial water from coarse-grained sedi- ments for semi-quantitative and quantitative chemical analyses. The dessication method is useful for chlorinity or chlorosity determinations and (with a correction of 5%) gives results probably accurate to within about ± 2O% Extraction of interstitial water with gas of high relative humidity gives results which are correct to within an error of ± l.O% The chlorosity of interstitial water extracted by forcing a high- viscosity epoxy plasticizer (immiscible with water) through the sediment falls within about ± 0.1% of the correct value. The immiscible-extraction method is therefore recommended for work requiring quantitative knowledge of interstitial water chemistry.     

Surface textures of turbidite sand grains, Laurentian Fan and Sohm Abyssal Plain

Surface textures of quartz grains have been examined from five samples from the Laurentian Fan and Sohm Abyssal Plain, representing varied transport distances and power of the depositing turbidity current. The grains retain their primary irregular shape derived from glacial erosion, and glacial surface textures are preserved in dish-shaped depressions. These features have been superimposed by a slight rounding of edges and an abundance of collision-induced markings, particularly mechanical V-forms. The most intense current modification of this sort occurs in mid-Wisconsinan or earlier sands that have been transported over 1000 km to the distal Sohm Abyssal Plain by turbidity currents. Collision textures probably develop during grain flow on the steep continental slope: delicate resedimented shelf foraminifera are preserved in the same turbidites and most have been transported exclusively in suspension.     

The visualization of socio-economic GIS data using virtual reality tools

This paper addresses two issues: the use of 'realistic' environments for the visualization of socio-economic data, and the use of virtual reality tools for the exploration of data from existing GIS databases. 'Realistic' is here used in a narrow sense to imply the reconstruction of real-world scenes in which major components of the physical environment are reconstructed to facilitate geographical visualization. A review of visualization techniques for geographically-referenced 3-D data is presented, and the translation of an existing urban GIS database into virtual reality modelling language (VRML) demonstrated for a study area in Cardiff, UK. This work shows that the export of conventional 2-D GIS data into virtual reality toolkits can be relatively straightforward, and offers exciting new avenues for visualization and exploration. We argue that some of the parameters of the true scene such as colour, building shape, and texture may be directly modified in order to represent otherwise unobservable socio-economic characteristics, in the spirit of exploratory data analysis. These issues are of particular importance in the context of current advances towards the dynamic linkage of GIS and virtual reality modelling.     

Decision makers' perspectives on European geographic information policy issues

The proposals for a European policy framework for Geographic Information (GI) recently put forward by Directorate General XIII raise three sets of issues about measures required to facilitate the dissemination of GI in the European Union: (1)'hot topics' such as privacy and the legal protection of databases that apply to information generally; (2) GI issues such as reference data and metadata services that may require action by the European Commission; and (3) perceived barriers to the development of a European GI market. This paper examines the views of 20 experts responsible for the provision and management of GI in key organizations throughout Europe. A Delphi-style strategy was used to identify the relative importance of the issues raised by the proposals and to ascertain the level of agreement as to the importance of these issues between the experts. The results show that issues relating to copyright, the protection of intellectual property rights, data quality, and data access policies were ranked highly by most of the respondents. A lack of awareness, education, and training (as opposed to the lack of public domain data and metadata services) were viewed as the main barriers to the deveiopment of the GI market in Europe.