吉尼系数的计算及正态分布的吉尼系数

本文给出了吉尼系数的一般计算公式 ,推导出正态分布的吉尼系数渐进无偏估计 ,并以实例对比了传统的吉尼系数的算法——万分法与本文中提出的估计方法。     

Experimental study of reflection coefficient and wave forces acting on perforated caisson

The reflection coefficient and the total horizontal forces of regular waves acting on theperforated caisson are experimentally investigated. The empirical relationship between reflection coefficient and the ratio of the total horizontal forces acting on the perforated caisson to those on solid vertical walls with the relative chamber width, relative water depth and porosity of perforated wall, etc. are given. Moreover, the results of the ratio of the total horizontal forces are also compared with formulas given by Chinese Harbour Design Criteria and Takahashi, which may be useful for the practical engineering application.     

长江河口硼的测定及分布规律研究

采用ＨＰＴＡ方法对长江口水中硼进行分析，并与姜黄素法进行比较，方法的标准偏差为０．００５，变动系数小于５％，对长江口水样分析结果与姜黄素法相比较，其相对误差为－０．４％。     

北仑港区宁波组晚大理冰期气候特征

以往认为宁波组沉积时期的古气候为寒冷干燥或冷凉干燥。本文依据北仑B_(12)孔的孢粉资料,阐明在这一冷期中曾有一次相对较暖的气候波动,据此又可分冷凉—温和—温凉三个阶段,湿度以略湿为主。此外,还讨论了本区在晚大理冰期温度、湿度的变化特点。     

高纯河豚毒素对蛙坐骨神经动作电位的影响

用电生理学方法观察了4种不同浓度的高纯河豚毒素(tetrodotoxin,TTX)对蛙离体坐骨神经动作电位的影响.实验结果表明:1μmol/dm3TTX在给药后7 min能显著抑制动作电位的上相幅度(P<0.05),但在给药后10 min才显著抑制动作电位的下相幅度(P<0.01);20μmol/dm3TTX在给药后3 min内能完全抑制动作电位的形成.1μmol/dm3TTX在给药后1~5min对动作电位传导速度的影响没有统计学意义,5μmol/dm3TTX在5min时可显著抑制传导速度(P<0.05),而10μmol/dm3TTX在2min时便显著抑制传导速度(P<0.05).实验结果提示高纯河豚毒素对蛙离体坐骨神经动作电位的影响存在剂量效应关系.     

Numerical and simplified methods for the calculation of the total horizontal wave force on a perforated caisson with a top cover

The VOF method and the k–ε model, combined with the equation of state of air at constant temperature, have been used to calculate the total horizontal wave force caused by monochromatic waves acting on a perforated caisson with a top cover. From comparison of various parameters, such as the total horizontal force, the pressure difference on the front wall, the pressure on the back wall and the pressure on the top cover, between the numerical results and test data, it can be seen that the numerical results agree well with the test data. It is concluded that the method described in this paper can be utilized to calculate wave forces acting on perforated caissons with a top cover in the case of nonovertopping, nonbreaking waves. A simplified method to calculate the total horizontal force has been developed, based on test data, using a least-squares method. A comparison between the numerical results and the values calculated from the simplified equations shows good agreement. Therefore the simplified equations can be used in engineering applications to evaluate the total horizontal force on a perforated caisson with a top cover.     

Research on Characteristics of Density Current Under the Action of Waves

In this paper,the characteristics of density current under the action of waves are describedwith the help of flume experiment and theoretical analysis.The study shows that turbid water under the ac-tion of the waves can present three types of motion,i.e.significant stratification,fragile stratification andstrong mixing.The motion of turbid water presents significant stratification when(H/D)/△ρ/ρ~(1/2)≤4.5,generally this state is known as density current.The formulas of motionvelocity,thickness,and discharge of density current moving on horizontal bottom are derived by use of ba-sic equations such as momemtum equation,equation of energy conservation and continuity equation offluid.The time-average velocity and the thickness of density current under the action of waves have a rela-tionship with such parameters as relative density(△ρ/ρ),wave height(H),and water depth(D).Whenthese parameters are determined,the time-average thickness and motion velocity of density current are al-so determined.The relat     

Static Analysis of Collision Strength of Offshore Platform

In this paper a numerical analysis method combining FEM incemental technique with limit analysis concept is proposed for the study of the static strength of offshore platform in collision. Large deformation and plasticity are accounted for and the limit yield surface expressed by generalized stress for a tubular section is derived. The modified stiffness matrix of space beam element is formulated by Plastic Node Method. The buckling behavior of beam columns can also be taken into account. It can trace the generation of plastic hinges during loading and finally the ultimate strength of offshore platform against collision is obtained.     

Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.     

An alternative approach to the structural motion analysis of wedge-beam offshore structures supporting a load

For convenience of dynamic analysis, some offshore structures such as fixed-type platforms are often modeled as the wedge beams supporting tip lumped masses. It is well-known that, due to the effect of the surrounding water, the natural frequencies of a beam in air (or dry beam) are different from those of the same beam immersed in water (or wet beam). However, if the natural frequencies and the associated mode shapes of a dry beam are calculated by taking account of the “added mass” for the immersed beam, then the last natural frequencies and mode shapes will be equal to the corresponding ones of the wet beam. Based on the last concept, the closed form solutions for natural frequencies and the associated mode shapes of the dry beam were determined first, then the partial differential equation of motion for the wet beam was transformed into a matrix equation by using the expansion theorem and the foregoing closed form solutions of free vibration responses for the dry beam. Solving the last matrix equation will give the required natural frequencies and the associated mode shapes of the wet beam. The formulation of this paper is available for the fully or partially immersed double tapered beams with either circular, square or rectangular cross-sections. The taper ratio for width and that for depth may be equal or unequal. The numerical results of this paper were compared with the existing results or the finite-element-method results and good agreement was achieved.