雨水入渗对非饱和土坡稳定性影响的参数研究

很多国家和地区的斜坡失稳与雨水入渗有密切关系。通过参数分析研究可以深化对这种关系的认识和理解,因而对滑坡灾害的预测和预防有重要意义。针对香港地区一种典型非饱和土斜坡,用有限元法模拟雨水入渗引起的暂态渗流场,然后将计算得到的暂态孔隙水压力分布用于斜坡的极限平衡分析。计算中采用延伸的摩尔－库伦破坏准则以便考虑基质吸力对抗剪强度的贡献,研究了降雨特征、水文地质条件及坡面防渗处理等因素对暂态渗流场和斜坡安全因数的影响。数值模拟结果表明：降雨强度、降雨历时和雨型对暂态渗流场及斜坡稳定性有明显的影响;土体的渗透系数,尤其是渗透系数各向异性的影响特别显著;斜坡中相对隔水层的存在以及斜坡防渗护面的效果等因素的影响均不容忽视。     

Effects of rainfall on oil droplet size and the dispersion of spilled oil with application to Douglas Channel,British Columbia,Canada

Raindrops falling on the sea surface produce turbulence. The present study examined the influence of rain-induced turbulence on oil droplet size and dispersion of oil spills in Douglas Channel in British Columbia, Canada using hourly atmospheric data in 2011–2013. We examined three types of oils: a light oil (Cold Lake Diluent - CLD), and two heavy oils (Cold Lake Blend - CLB and Access Western Blend - AWB). We found that the turbulent energy dissipation rate produced by rainfalls is comparable to what is produced by wind-induced wave breaking in our study area. With the use of chemical dispersants, our results indicate that a heavy rainfall (rain rate > 20 mm h^? 1) can produce the maximum droplet size of 300 μm for light oil and 1000 μm for heavy oils, and it can disperse the light oil with fraction of 22–45% and the heavy oils of 8–13%, respectively. Heavy rainfalls could be a factor for the fate of oil spills in Douglas Channel, especially for a spill of light oil and the use of chemical dispersants.     

Effects of variation in loading protocol on the strength and deformation capacity of ductile reinforced concrete beams

Understanding the impact of prior earthquake damage on residual capacity is important for postearthquake damage assessment of buildings; however, interpretation of such impact is challenging when based on tests using traditional reversed‐cyclic loading protocols. A new loading protocol, consisting of a dynamic earthquake displacement history followed by quasi‐static reversed‐cyclic loading to failure, is presented as an alternative to traditional simulated seismic loading protocols. Data are analyzed from a set of 12 nominally identical ductile reinforced concrete beams that were tested by using variations of this protocol and traditional reversed‐cyclic and monotonic protocols. Differences in the cycle content of the earthquake displacement histories applied to the test specimens allowed for the effects of load history variation below 2.2% drift to be isolated. It is found that such variation had no effect on the beam deformation capacities. The effects of dynamic loading rates are also analyzed and compared against control quasi‐static specimens. Relative strength increases due to dynamic loading are found to be more significant at yield than at ultimate. Dynamic loading rates led to modest reductions in the beam deformation capacities, but the presence of causality between these variables remains uncertain.     

Using the Newly‐created ILE DBMS to Better Represent Temporal and Historical GIS Data

This article introduces a type of DBMS called the Intentionally‐Linked Entities (ILE) DBMS for use as the basis for temporal and historical Geographical Information Systems. ILE represents each entity in a database only once, thereby mostly eliminating redundancy and fragmentation, two major problems in Relational and other database systems. These advantages of ILE are realized by using relationship objects and pointers to implement all of the relationships among data entities in a native fashion using dynamically‐allocated linked data structures. ILE can be considered to be a modern and extended implementation of the E/R data model. ILE also facilitates storage of things that are more faithful to the historical records, such as gazetteer entries of places with imprecisely known or unknown locations. This is difficult in Relational database systems but is a routine task using ILE because ILE is implemented using modern memory allocation techniques. We use the China Historical GIS (CHGIS) and other databases to illustrate the advantages of ILE. This is accomplished by modeling these databases in ILE and comparing them to the existing Relational implementations.     

Facies and sequence stratigraphic architecture of the Mural Limestone (Albian), Arizona: Carbonate response to global and local factors and implications for reservoir characterization

This study documents the detailed facies and sequence stratigraphic architecture of a multi-cyclic patch-reef and its associated ramp interior facies that formed during Oceanic Anoxic Event 1b in the Mural Limestone, Arizona, USA. Ramp interior facies are comprised of bedded wackestone/packstone, rudist build-up and coral–algal patch-reef facies located north of Bisbee, Arizona, at the Grassy Hill locality. The larger multi-cyclic patch-reef that developed coevally ca 5 km to the south of Grassy Hill consists of a high-angle windward margin with a narrow ca 70 m long reef frame containing vertically zonated Microsolena, Actinastrea, diverse branching coral and rudist assemblages, and an 870 m long low-angle leeward margin comprised of reef debris rudstone and grainstone shoal facies. Similar reef geomorphology and orientation is documented across the Gulf of Mexico and reflects the shelf-wide north to north-east-trending prevailing wind and current energies. Controls affecting reef formation and growth patterns include changes in accommodation space associated with low-amplitude global sea-level rise and regional thermotectonic subsidence, local accommodation space and nutrient fluctuations associated with the inner shelf depositional setting within a humid and siliciclastic-rich environment. Four aggradational to retrogradational high-frequency sequences are documented in Arizona: High-frequency sequences 1 and 2 represent the first pulse of patch-reef development in an overall second-order marine transgression over the Sonora/Bisbee Shelf. These sequences correlate to δ¹³C signatures associated with Oceanic Anoxic Event 1b across the Gulf of Mexico and suggest that carbonate reefs persisted on the ramp interior during this time. High-frequency sequences 3 and 4 record a second brief transgression and backstepping of reef facies followed by the final regression of shallow shelf carbonates that correlates to more robust patch-reef development in Sonora, Mexico. The patch-reef at Paul Spur is an excellent outcrop analogue for productive patch-reefs in the Maverick Basin (Comanche Shelf) of Texas. Detailed facies mapping of this outcrop analogue shows that the greatest reservoir potential is contained within the backreef grainstone shoals where primary porosity of up to 15% is observed.     

An analysis of soil crust strength in relation to potential abrasion by saltating particles

Wind erosion depends on the ease with which particles can be detached from the soil surface, but suitable tests to characterize this property are not available. Two possible methods to determine surface soil strength in the field were therefore compared on a range of artificially ‘crusted’ surfaces. These were made by spraying or tension wetting aggregates (10–2, 2–0.5 and <0.5 mm) from a structurally unstable sandy loam, followed by drying. Each test involved measuring the force exerted on a probe driven at a steady rate into the surface, using either a flat-tipped 0.6 mm diameter penetrometer or a flat-ended cylindrical punch with inner and outer diameters of 5 and 6 mm, respectively. Both probes showed that crusts could be produced reproducibly. Depending on the probe and aggregate size, penetration mainly occurred either as a result of aggregates being deflected out of the pathway of the probe or by genuine rupture of aggregates or of the crusted surface. The penetrometer, because it was comparable to the size of sand grains, gave results that can be used to characterize surface erodibility to saltating particles. The punch gave results that would be unsuitable for this purpose, as would other strength tests that are on too large a scale. Penetrometer results were analyzed to calculate the energy required for penetration. It was thus possible to demonstrate that only the spray-wetted fine aggregates had a surface that could undergo large-scale rupture by saltating sand grains. For all other surfaces, saltating particles would be unable to supply sufficient energy to rupture aggregates or the crusted surface. Erosion could only occur by a slower process of abrasion in which smaller particles or aggregates are chipped away from the surface. However, it is shown that saltating particles could rupture the interaggregate bonding in the 2–0.5 mm aggregate surfaces, thus permitting creep. An alternative and potentially simpler way of characterizing surface erodibility by using a surface modulus of elasticity is also discussed. Our results demonstrate that the small diameter penetrometer is a promising technique for characterizing erodibility of aggregated and crusted surfaces. © 1997 by John Wiley & Sons, Ltd.     

A GIS-based multi-proxy analysis of the evolution of subglacial dynamics of the Quebec–Labrador ice dome,northeastern Quebec,Canada

The glacial records of the inner-core regions of the Laurentide Ice Sheet (LIS) document complex yet coherent patterns reflecting ice-sheet change (e.g. ice-divide migration), providing unique insights into past glacial conditions. This study develops a conceptual model of subglacial dynamics evolution within a major ice-dispersal centre of the LIS in northeastern Quebec, Canada using a GIS-based analysis of the surficial geologic record. Multiple proxies of subglacial conditions (subglacial streamlined landforms, lake density and lake area over thin drift/bedrock) were analysed through grid-overlay techniques and then classified based on different proxy variables ranging from highly mobile warm-based to immobile cold-based conditions. An additional proxy (till blanket) was used to identify areas of thick till deposition, but with few proxies (few lake or landform metrics). Based on local ice-flow reconstructions, the most ‘relict’ glacial terrain zone (GTZ1) has warm-based conditions over 66% of its area and is remarkably well preserved, suggesting laterally extensive warm-based conditions during the oldest identified ice-flow phase. This relict glacial terrain is partially overprinted by two subsequent ice-flow phases in spatially restricted zones in the northeast (73% warm-based), east-central (41% warm-based), and northwest (33% warm-based) of the study area. A zone of more sluggish conditions (only 3% warm-based) was identified in the highlands at the centre of the study area, characterized by thin till cover, few landforms, yet with large patches of relatively abundant small lakes, indicative of areal scouring. No clear evidence of sustained cold-based conditions (i.e. high chemical index of alteration values or high ¹⁰Be abundances) was found in the study area. These results suggest that warm-based conditions (active erosion and/or deposition) were uniformly widespread during the earliest ice-flow phase, later becoming more spatially restricted with broader sluggish ice conditions. These spatially restricted regions of warm-based subglacial regimes were likely controlled by surrounding and down-flow ice streaming. © 2020 The Authors. Earth Surface Processes and Landforms published by John Wiley & Sons Ltd     

Morphology and dynamics of the intertidal floodplain along the Amazon tidal river

Depositional environments along the tidal river downstream of Óbidos have been proposed as important sinks for up to one third of the sediment discharge from the Amazon River. However, the morphology of the intertidal floodplain and the dynamics of sediment exchange along this reach have yet to be described. River-bank surveys in five regions along the Amazon tidal river reveal a distinct transition in bank morphology between the upper, central and lower reaches of the tidal river. The upper tidal-river floodplain is defined by prominent natural levees that control the transfer of water and sediment between the mainstem Amazon River and its floodplain. Greater tidal influence in the central tidal river suppresses levee development, and tidal currents increase sediment transport into the distal parts of the floodplain. In the lower tidal river, the floodplain morphology closely resembles marine intertidal environments (e.g. mud flats, salt marshes), with dendritic tidal channels incising elevated vegetated flats. Theory, morphology and geochronology suggest that the dynamics of sediment delivery to the intertidal floodplain of the Amazon tidal river vary along its length due to the relative influence and coupling of fluvial and tidal dynamics. © 2018 John Wiley & Sons, Ltd.