Tensile stresses around boreholes due to transient fluid flow

We present solutions for the effective stress induced by gas flow through a porous solid into a borehole resulting from sudden pressure reduction. Tensile effective stress that exceeds the strength of the solid will lead to borehole failure. This has applications to the intentional creation of cavities, relevant to the efficient recovery of coalbed methane, and the avoidance of borehole stability problems in conventional gas production.     

Speciation of trace metals in sediments of a tropical estuary

Axial surveys were performed in the two river tributaries of the Cochin estuary, SW India during November 1988. Surficial sediments were subjected to sequential chemical extractions to delineate five metal fractions, namely, exchangeable, carbonate bound, easily reducible, organic/sulfide bound, and residual. The results indicated selective accumulation of Mn and Ni in carbonate bound and organic/sulfide forms, along with marginal amounts of Co in the exchangeable fraction. Large portions of Fe and Cr occurred in the residual fraction, whereas composite fractionation of Zn species was noticed. The exchangeable fractions of Fe and Cr as well as of easily reducible cobalt were below detection limits. The levels of Cr and Zn indicate anthropogenic inputs in this estuary, whereas Co and Ni show regional contamination exceeding natural levels. The analytical speciation procedure helps to deduce the sedimental diagenetic processes in the estuarine environment.     

40Ar/39Ar and oxygen isotope studies of polymetamorphism from Tinos Island, Cycladic blueschist belt, Greece

Abstract Petrological, oxygen isotope and ⁴⁰Ar/³⁹Ar studies were used to constrain the Tertiary metamorphic evolution of the lower tectonic unit of the Cyclades on Tinos. Polyphase high-pressure metamorphism reached pressures in excess of 15 kbar, based on measurements of the Si content in potassic white mica. Temperatures of 450–500° C at the thermal peak of high-pressure metamorphism were estimated from critical metamorphic assemblages, the validity of which is confirmed by a quartz–magnetite oxygen isotope temperature of 470° C. Some ⁴⁰Ar/³⁹Ar spectra of white mica give plateau ages of 44–40 Ma that are considered to represent dynamic recrystallization under peak or slightly post-peak high-pressure metamorphic conditions. Early stages in the prograde high-pressure evolution may be documented by older apparent ages in the high-temperature steps of some spectra. Eclogite to epidote blueschist facies mineralogies were partially or totally replaced by retrograde greenschist facies assemblages during exhumation. Oxygen isotope thermometry of four quartz–magnetite pairs from greenschist samples gives temperatures of 440–470° C which cannot be distinguished from those deduced for the high-pressure event. The exhumation and overprint is documented by decreasing ages of 32–28 Ma in some greenschists and late-stage blueschist rocks, and ages of 30–20 Ma in the lower temperature steps of the Ar release patterns of blueschist micas. Almost flat parts of Ar–Ar release spectra of some greenschist micas gave ages of 23–21 Ma which are assumed to represent incomplete resetting caused by a renewed prograde phase of greenschist metamorphism. Oxygen isotope compositions of blueschist and greenschist facies minerals show no evidence for the infiltration of a δ¹⁸O-enriched fluid. Rather, the compositions indicate that fluid to rock ratios were very low, the isotopic compositions being primarily controlled by those of the protolith rocks. We assume that the fundamental control catalysing the transformation of blueschists into greenschists and the associated resetting of their isotopic systems was the selective infiltration of metamorphic fluid. A quartz–magnetite sample from a contact metamorphic skarn, taken near the Miocene monzogranite of Tinos, gave an oxygen isotope temperature of 555° C and calculated water composition of 9.1%. The value of δ¹⁸O obtained from this water is consistent with a primary magmatic fluid, but is lower than that of fluids associated with the greenschist overprint, which indicates that the latter event cannot be directly related to the monozogranite intrusion.     

Sonar acoustic facies and sediment distribution on an area of the deep ocean floor

Long-range sidescan sonar can be used to map sediment distributions over wide expanses of deep ocean floor. Seven acoustic facies that arise from differing sediment or rock types have been mapped over the low-relief Saharan continental rise and Madeira abyssal plain. These have been calibrated with sampling, profiling and camera studies and the facies can be traced confidently on a regional scale using the sidescan data. The mapping of the sediment distribution shows that a complex interplay of turbidity current and debris flow processes can occur at a continental rise/abysaal plain transition over 1000 km from the nearest continental slope.     

Properties of the motion of the isolated body of the problem of three bodies

We investigate the condition for the third body of the problem of three bodies to be an “isolated body”, and the properties of its motion, particularly in the case where the system has a negative total angular momentum. We give the permitted regions for the acceleration and radius vector of the isolated body, the law of variation of its velocity and the region of escape of the isolated body.     

Geometry and kinematics of recent deformation in the Mondy–Tunka area (south-westernmost Baikal rift zone, Mongolia–Siberia)

We used satellite imagery and field data to investigate the south‐westernmost Baikal rift zone. We focus our study in the Mondy and Ikhe Ukhgun valleys, site of an Mw = 6.9 seismic event in 1950. Surface deformations are observed along the E–W‐trending Mondy strike‐slip fault and along the Ikhe Ukhgun thrust. The Mondy fault system is 80 km long and is composed of four segments 10–15 km long. These segments are characterized by subvertical planes with left‐lateral movements. The Ikhe Ukhgun thrust is 20 km long, dips 40° to the south and shows reverse movement with a left‐lateral component. These observations are consistent with the present‐day regional NNE–SSW compression and with the focal mechanism of the 1950 Mondy earthquake that was recently re‐evaluated. These features, like those observed in the Tunka basin, demonstrate a recent change of regional strain regime from transtension to transpression that we place before the Late Pleistocene.     

Cokriging nonstationary data

Universal cokriging is used to obtain predictions when dealing with multivariate random functions. An important type of nonstationarity is defined in terms of multivariate random functions with increments which are stationary of orderk. The covariance between increments of different variables is modeled by means of the pseudo-cross-covariance function. Criteria are formulated to which the parameters of pseudo-cross-covariance functions must comply so as to ensure positive-definiteness. Cokriging equations and the induced cokriging equations are given. The study is illustrated by an example from soil science.     

Long-term seismicity of Istanbul and of the Marmara Sea region

We examine the long-term seismicity of the Marmara Sea region in Turkey over a period of twenty centuries to attempt to answer two questions: (1) how well recorded in history is the earthquake activity of this region? and (2) does seismicity over this long period of time differ from that over the present century? We study this densely-populated and fast-developing region because it is one of the most tectonically active regions on the continents that appears today to be relatively quiescent.     

Seismotectonic significance of the 29 January 1989 Etne earthquake, SW Norway

The integrated analysis of geological, seismological and field observations with lineament data derived from satellite images allows the identification of a possible seismogenic fault zone for an earthquake which occurred near Etne in southwestern Norway, on 29 February 1989. The hypocentre of the earthquake was located at the mid-crust at a depth of 13.8±0.9 km which is typical of small intraplate earthquakes. The Etne earthquake occurred as a result of normal faulting with a dextral strike-slip component on a NW–SE trending fault. Available geological and lineament data indicate correlation of the inferred seismogenic fault with the NW–SE trending Etne fault zone. An aeromagnetic anomaly related to the Etne fault zone forms a regional feature intersecting both Precambrian basement and allochthonous Caledonian rocks. Based on these associations the occurrence of the Etne event is ascribed to the reactivation of a zone of weakness along the Etne fault zone. Slope-instabilities developed in the superficial deposits during the Etne event demonstrate the existence of potentially hazardous secondary-effects of such earthquakes even in low seismicity areas such as southwestern Norway.