Kara-Bogaz-Gol Bay: Physical and Chemical Evolution

Kara-Bogaz-Gol Bay is a large (around 18,000 km²) and shallow (few meters deep) lagoon located east of the Caspian Sea. Its water surface was several meters to several dozens cm lower than in the Caspian Sea, so water flows from the Caspian Sea through a narrow strait into the bay, where it evaporates. Kara-Bogaz-Gol Bay is one of the saltiest bodies of water in the world; its water salinity amounts to 270–300 g/l. Different kinds of salts available in this natural evaporative basin has been used commercially since at least the 1920s. In March 1980, in order to decelerate a continuous fall of the Caspian Sea level, which in 1977 was the lowest over the last 400 years (?29 m), the Kara-Bogaz-Gol Strait was dammed. In response to this human intervention, the bay had already dried up completely by November 1983. In 1992, the dam was destroyed, and Kara-Bogaz-Gol Bay had been filling up with the Caspian Sea water at a rate of about 1.7 m/year up to 1996 as observed by the TOPEX/Poseidon satellite altimetry mission. Since then, Kara-Bogaz-Gol Bay level evolution with characteristic seasonal and interannual oscillations has been similar to that of the Caspian Sea. Physical and chemical evolution of the bay in the twentieth and twenty-first centuries is traced in detail in the paper.     

Turbulent measurements in the stable atmospheric boundary layer during SHEBA: ten years after

This paper surveys results of the comprehensive turbulent measurements in the stable boundary layer (SBL) made over the Arctic pack ice during the Surface Heat Budget of the Arctic Ocean experiment (SHEBA) in the Beaufort Gyre from October 1997 through September 1998. Turbulent fluxes and mean meteorological data were continuously measured and reported hourly at five levels on a 20-m main SHEBA tower. Eleven months of measurements during SHEBA cover a wide range of stability conditions, from the weakly unstable regime to very stable stratification, and allow studying the SBL in detail. A brief overview of the SBL regimes, the flux-profile relationships, the turbulent Prandtl number, and other parameters obtained during SHEBA is given. The traditional Monin—Obukhov approach, z-less scaling, and gradient-based scaling are evaluated and discussed based on the data from SHEBA.     

Moderately compact helix antennas with cutoff patterns for millimeter RTK positioning

GPS Solutions - Helical antennas have been developed that feature a cutoff pattern and are suitable for practical positioning at millimeter level. The antennas are in the form of a tube with...     

The updated version of SPONSOR land surface scheme: PILPS-influenced improvements

The parameterization scheme SPONSOR (Semi-distributed ParameterizatiON Scheme of the ORography-induced hydrology) participating in PILPS (Project for Intercomparison of Land-surface Parameterization Schemes) experiments since 1993 is described in more detail than before, taking into account a range of recent modifications. Improvement of the scheme in several aspects (e.g., soil water movement) resulted in significantly improved results for the Cabauw site (used for PILPS (2a) experiments). Then, parameterization of cold seasons/regions processes (water phase transformations within soil and snow cover) was developed for PILPS (2d) experiments carried out with Valdai data. Testing of the scheme against the data of Kolyma water balance station shows that it is able to reproduce the main features of heat and water exchange at the land surface in the permafrost zone quite satisfactorily. It was found that the scheme results are rather sensitive to the soil heat conductivity, especially in the cold seasons. The original method for the calculation of this parameter was developed using a square root function. The surface temperature and dates of crossing the 0°C temperature threshold for Kolyma station were reproduced with satisfactory accuracy. The temporal variation of the deep soil layers' temperatures was modelled satisfactorily too, but the seasonal amplitude of deep soil temperatures was overestimated by the scheme. This disadvantage can possibly be improved by inclusion of vertical inhomogeneity of soil thermal and hydraulic properties in the model.     

The Project for Intercomparison of Land-surface Parameterization Schemes (PILPS) phase 2(c) Red-Arkansas River basin experiment:: 2. Spatial and temporal analysis of energy fluxes

The energy components of sixteen Soil-Vegetation Atmospheric Transfer (SVAT) schemes were analyzed and intercompared using 10 years of surface meteorological and radiative forcing data from the Red-Arkansas River basin in the Southern Great Plains of the United States. Comparisons of simulated surface energy fluxes among models showed that the net radiation and surface temperature generally had the best agreement among the schemes. On an average (annual and monthly) basis, the estimated latent heat fluxes agreed (to within approximate estimation errors) with the latent heat fluxes derived from a radiosonde-based atmospheric budget method for slightly more than half of the schemes. The sensible heat fluxes had larger differences among the schemes than did the latent heat fluxes, and the model-simulated ground heat fluxes had large variations among the schemes. The spatial patterns of the model-computed net radiation and surface temperature were generally similar among the schemes, and appear reasonable and consistent with observations of related variables, such as surface air temperature. The spatial mean patterns of latent and sensible heat fluxes were less similar than for net radiation, and the spatial patterns of the ground heat flux vary greatly among the 16 schemes. Generally, there is less similarity among the models in the temporal (interannual) variability of surface fluxes and temperature than there is in the mean fields, even for schemes with similar mean fields.     

Atmospheric Turbulence Measurements at a Coastal Zone with and without Fog

Boundary-Layer Meteorology - Measurements of atmospheric turbulence at a site in Ferryland (Newfoundland) during the C-FOG (Coastal-Fog) field campaign in September–October 2018 are used to...     

Numerical analysis of flux footprints for different landscapes

Summary A model for the canopy – planetary boundary layer flow and scalar transport based on E- closure was applied to estimate footprint for CO₂ fluxes over different inhomogeneous landscapes. Hypothetical heterogeneous vegetation patterns – forest with clear-cuts as well as hypothetical heterogeneous relief – a bell-shaped valley and a ridge covered by forest were considered. The distortions of airflow caused by these heterogeneities are shown – the upwind deceleration of the flow at the ridge foot and above valley, acceleration at the crest and the flow separation with the reversed flow pattern at lee slopes of ridge and valley. The disturbances induce changes in scalar flux fields within the atmospheric surface layer comparing to fluxes for homogeneous conditions: at a fixed height the fluxes vary as a function of distance to disturbance. Correspondingly, the flux footprint estimated from model data depends on the location of the point of interest (flux measurement point) and may significantly deviate from that for a flat terrain. It is shown that proposed method could be used for the choice of optimal sensor position for flux measurements over complex terrain as well as for the interpretation of data for existing measurement sites. To illustrate the latter the method was applied for experimental site in Solling, Germany, taking into account the complex topography and vegetation heterogeneities. Results show that in certain situations (summer, neutral stratification, south or north wind) and for a certain sensor location the assumptions of idealized air flow structure could be used for measurement interpretation at this site, though in general, extreme caution should be applied when analytical footprint models are used in the interpretation of flux measurements over complex sites.     

Transient simulation of the last glacial inception. Part I: glacial inception as a bifurcation in the climate system

We study the mechanisms of glacial inception by using the Earth system model of intermediate complexity, CLIMBER-2, which encompasses dynamic modules of the atmosphere, ocean, biosphere and ice sheets. Ice-sheet dynamics are described by the three-dimensional polythermal ice-sheet model SICOPOLIS. We have performed transient experiments starting at the Eemiam interglacial, at 126 ky BP (126,000 years before present). The model runs for 26 kyr with time-dependent orbital and CO₂ forcings. The model simulates a rapid expansion of the area covered by inland ice in the Northern Hemisphere, predominantly over Northern America, starting at about 117 kyr BP. During the next 7 kyr, the ice volume grows gradually in the model at a rate which corresponds to a change in sea level of 10 m per millennium. We have shown that the simulated glacial inception represents a bifurcation transition in the climate system from an interglacial to a glacial state caused by the strong snow-albedo feedback. This transition occurs when summer insolation at high latitudes of the Northern Hemisphere drops below a threshold value, which is only slightly lower than modern summer insolation. By performing long-term equilibrium runs, we find that for the present-day orbital parameters at least two different equilibrium states of the climate system exist—the glacial and the interglacial; however, for the low summer insolation corresponding to 115 kyr BP, we find only one, glacial, equilibrium state, while for the high summer insolation corresponding to 126 kyr BP only an interglacial state exists in the model.

---

Synergy of satellite remote sensing and numerical modeling for monitoring of suspended particulate matter

Monitoring and modeling of the distribution of suspended particulate matter (SPM) is an important task, especially in coastal environments. Several SPM models have been developed for the North Sea. However, due to waves in shallow water and strong tidal currents in the southern part of the North Sea, this is still a challenging task. In general there is a lack of measurements to determine initial distributions of SPM in the bottom sediment and essential model parameters, e.g., appropriate exchange coefficients. In many satellite-borne ocean color images of the North Sea a plume is visible, which is caused by the scattering of light at SPM in the upper ocean layer. The intensity and length of the plume depends on the wave and current climate. It is well known that the SPM plume is especially obvious shortly after strong storm events. In this paper a quasi-3-D and a 3-D SPM transport model are presented. Utilizing the synergy of satellite-borne ocean color data with numerical models, the vertical exchange coefficients due to currents and waves are derived. This results in models that for the first time are able to reproduce the temporal and spatial evolution of the plume intensity. The SPM models consist of several modules to compute ocean dynamics, the vertical and horizontal exchange of SPM in the water column, and exchange processes with the seabed such as erosion, sedimentation, and resuspension. In the bottom layer, bioturbation via benthos and diffusion processes is taken into account.Responsible Editor: Jörg-Olaf Wolff