Evaluation of soil collapse potential in regional scale

Collapsible soils have considerable strength and stiffness in their dry natural state but settle dramatically when they become wet. This paper documents a low-cost, qualitative evaluation scheme using fuzzy set analysis to determine site collapsibility based on subjective knowledge of the geological, geotechnical, and environmental conditions and their uncertainty. For each category, factors or subcategories were defined in a decision tree based on relevant literature. Each category and subcategory was then weighted or rated using linguistic terms developed from expert assessment. The linguistic data or information obtained from the assessments was represented and processed using fuzzy sets. To calibrate the criteria, 87 collapse potential tests were performed on undisturbed soil samples gathered from 27 different locations throughout Iran, leading to the definition of a standard collapse potential fuzzy set. Finally, on the basis of the established criteria, a collapse potential map was prepared for a suburban area in the western part of the city of Kerman, Iran.     

A new approach to use AHP in landslide susceptibility mapping: a case study at Yenice (Karabuk, NW Turkey)

This study aimed to investigate the parameter effects in preparing landslide susceptibility maps with a data-driven approach and to adapt this approach to analytical hierarchy process (AHP). For this purpose, at the first stage, landslide inventory of an area located in the Western Black Sea region of Turkey covering approximately 567?km² was prepared, and a total of 101 landslides were mapped. In order to assess the landslide susceptibility, a total of 13 parameters were considered as the input parameters: slope, aspect, plan curvature, topographical elevation, vegetation cover index, land use, distance to drainage, distance to roads, distance to structural elements, distance to ridges, stream power index, sediment transport capacity index, and wetness index. AHP was selected as the major assessment methodology since the adapted approach and AHP work in data pairs. Adapted to AHP, a similarity relation?Cbased approach, namely landslide relation indicator (LRI) for parameter selection method, was also proposed. AHP and parametric effect analyses were performed by the proposed approach, and seven landslide susceptibility maps were produced. Among these maps, the best performance was gathered from the landslide susceptibility map produced by 9 parameter combinations using area under curve (AUC) approach. For this map, the AUC value was calculated as 0.797, while the others ranged between 0.686 and 0.771. According to this map, 38.3?% of the study area was classified as having very low, 8.5?% as low, 15.0?% as moderate, 20.3?% as high, and 17.9?% as very high landslide susceptibility, respectively. Based on the overall assessments, the proposed approach in this study was concluded as objective and applicable and yielded reasonable results.     

Robust attenuation relations for peak time-domain parameters of strong ground motions

This study presents new attenuation models for the estimation of peak ground acceleration (PGA), peak ground velocity (PGV), and peak ground displacement (PGD) using a hybrid method coupling genetic programming and simulated annealing, called GP/SA. The PGA, PGV, and PGD were formulated in terms of earthquake magnitude, earthquake source to site distance, average shear-wave velocity, and faulting mechanisms. A worldwide database of strong ground motions released by Pacific Earthquake Engineering Research Center (PEER) was employed to establish the models. A traditional genetic programming analysis was performed to benchmark the proposed models. For more validity verification, the GP/SA models were employed to predict the ground-motion parameters of the Iranian plateau earthquakes. Sensitivity and parametric analyses were carried out and discussed. The results show that the GP/SA attenuation models can offer precise and efficient solutions for the prediction of estimates of the peak time-domain characteristics of strong ground motions. The performance of the proposed models is better than or comparable with the attenuation relationships found in the literature.     

Durability assessment of the Ala?at? tuff (Izmir) in western Turkey

Ala?at? tuff has been used extensively as a source of building stone for outdoor and indoor decorations since the historical times in and around the tourist town of Ala?at? (western Turkey). The use of the Alacati tuff in buildings has been made compulsory by the Ala?at? municipality, for preserving the historical appearance of the buildings, after 2005 in Ala?at?. It has been noticed that, evident deteriorations developed in tuff surfaces of the stone buildings and garden walls within 5?C6?years of their emplacement. Durability properties of the Ala?at? tuff are evaluated by determining the mineralogical, chemical, and physico-mechanical properties of the fresh tuff samples obtained from the only operative quarry in the area. Ageing tests such as Na₂SO₄ and MgSO₄ salt crystallization, freezing?Cthawing, and wetting?Cdrying were conducted on the fresh tuff samples to assess their durability. Additionally, the durability of the tuff is also evaluated by determining its average pore diameter, saturation coefficient, wet-to-dry strength ratio, static rock and slake-durability indices. Fresh Ala?at? tuff has high porosity and low unit weight and strengths and are classified to be very poor to moderately durable stone based on the test results of different durability assessment methods. Mineralogical and geochemical analyses have also been carried out on the deteriorated tuff samples collected from the surfaces of the stone buildings to determine the effect of weathering on tuff and the test results have been compared with those of the fresh tuff samples. There is no major difference observed between the mineralogy and chemistry of the fresh and weathered tuff samples thus, it has been concluded that physical weathering has been dominant in the area in deterioration of tuff.     

The mineralogy and petrology of the Pahnavar Fe skarn, In the Eastern Azarbaijan, NW Iran

The Pahnavar calcic Fe-bearing skarn zone is located in the Eastern Azarbaijan (NW Iran). This skarn zone occurs along the contact between Upper Cretaceous impure carbonates and an Oligocene granodioritic batholith. The skarnification process can be categorized into two discrete stages: prograde and retrograde. The prograde stage began immediately after the initial emplacement of the granodioritic magma into the enclosing impure carbonate rocks. The effect of heat flow from the batholith caused the enclosing rocks to become isochemically marmorized in the pure limestone layers and bimetasomatized (skarnoids) in the impure clay-rich carbonates. Segregation and evolution of an aqueous phase from the magma that infiltrated to the marbles and skarnoids through fractures and micro-fractures took place during the emplacement of magma. The influx of Fe, Si and Mg from the granodiorite to the skarnoids and marbles led to the crystallization of anhydrous calc-silicates (garnet and pyroxene). The retrograde stage can be divided, in turn, into two distinct sub-stages. During earliest sub-stage, the previously formed skarn assemblages were affected by intense hydro-fracturing; in addition, Cu, Pb, Zn, along with H₂S and CO₂ were added. Consequently, hydrous calc-silicates (epidote and tremolite-actinolite), sulfides (pyrite, chalcopyrite, galena and sphalerite), oxides (magnetite and hematite) and carbonates (calcite) deposited the anhydrous calc-silicates. The late-retrograde sub-stage was due the incursion of colder oxidizing fluids into the skarn system, causing the alteration of the previously formed calc-silicate assemblages and the development of fine-grained aggregates of chlorite, illite, kaolinite, hematite and calcite. The lack of wollastonite in the mineral assemblage, along with the garnet-clinopyroxene paragenesis, suggests that the prograde stage formed under temperature and fO₂ conditions of 430?C550°C and 10^?26?C10^?23, respectively.     

Computation of the structure of a magnetized strange quark star

We have calculated some properties of spin polarized strange quark matter(SQM) in a strong magnetic field at zero temperature using the MIT bag model.We showed that the equation of state of spin polarized SQM is stiffer than that for unpolarized cases.We have also computed the structural properties of a spin polarized strange quark star(SQS) and found that the presence of a magnetic field leads to a more stable SQS when compared to the structural properties of an unpolarized SQS.     

Carbonate diagenesis of the upper Jurassic successions in the west of Binalud — Eastern Alborz (NE Iran)

The upper Jurassic carbonate settings in Iran are widely exposed in north and northeastern parts. Five stratigraphic columns were selected in the north eastern Iran. Their thickness ranges from 330 to 500 m. The various diagenetic processes identified include, micritization, cementation, compaction (physical and chemical), dissolution, neomorphism, pyritization, hematitization, silicification and dolomitization, which affected these carbonates. Elemental and stable isotopes analysis indicated that these deposits have undergone both meteoric and burial diagenesis in a relatively open system with moderate water-rock interaction. The positive trend between trace elements and oxygen isotope depletion also support these burial conditions. Lighter δ^l8O values of the dolomite samples may be related to an increase in temperature during the burial, which correspond to coarser euhedral crystals. Relatively higher δ¹⁸O values in finer dolomite crystals indicate their formation at lower burial depths relative to coarser crystals. Petrographic evidences such as coarse euhedral crystals with bright and dull zonation prove this interpretation. Chert nodules also have lighter ¹⁸O values relative to carbonate host rock, thus indicating the influence of burial diagenetic processes in their formation. The average environmental palaeotemperature was estimated to be 26°C on the basis of oxygen isotope values of less altered lime-mudstones.     

Geochemical peculiarities of the formation of the Novoshirokinskii gold-polymetallic deposit,Eastern Transbaikalia,Russia

The fluid inclusions in minerals and isotope composition of sulfur in sulfides and carbon and oxygen in carbonates are studied for the Novoshirokinskii gold-polymetallic deposit. The ore-forming fluids are characterized by the following physico-chemical and isotope-geochemical parameters: temperature of 290–100°C, salinity of 13–2.5 wt % NaCl-equiv., δ¹⁸O from +8 to 0‰, δ¹³C of 2.5 ± 0.5‰, and δ³⁴S of 10.5 ± 1.0‰. It is concluded that the Late Proterozoic-Early Cambrian carbonaceous-terrigenous and carbonate rocks were involved in the Late Jurassic ore-magmatic system.     

Analytical solutions for one-dimensional advection–dispersion equation of the pollutant concentration

We present simple analytical solutions for the unsteady advection–dispersion equations describing the pollutant concentration C(x, t) in one dimension. The solutions are obtained by using Laplace transformation technique. In this study we divided the river into two regions x ≤ 0 and x≥0 and the origin at x = 0. The variation of C(x, t) with the time t from t = 0 up to t → ∞ (the steady state case) is taken into account in our study. The special case for which the dispersion coefficient D = 0 is studied in detail. The parameters controlling the pollutant concentration along the river are determined.