Evidence of Younger Dryas and Neoglacial cooling in a Late Quaternary palaeotemperature record from a speleothem in eastern Victoria,Australia

A calcitic stalagmite collected from a limestone cave in the Buchan area of eastern Victoria has been dated by three mass-spectrometric uranium series analyses. Two growth phases are represented: the older from 13.4 to 10.6 ka and the younger from 3.2 to 2.1 ka. Oxygen isotope analysis reveals that temperatures were below present-day values at all times, but particularly cool conditions are indicated between 12.3 and 11.4 ka, and Neoglacial conditions occurred at about 3 ka. The older cold climate event is clearly synchronous with the Younger Dryas in Europe and this is the first time that strong evidence for this event has been found in Australia. Carbon isotope variations are interpreted as indicating changes in plant productivity on the surface and are most likely controlled by variations in summer rainfall. They indicate particularly high levels of plant productivity from 11.5 to 11.0 ka. © 1996 John Wiley & Sons, Ltd.     

Dependence of sediment sorting on bedload transport phase in a river meander

It is widely recognized nowadays that there are at least two different phases of bedload sediment transport in gravel‐bed rivers. However, the transition between these phases is still poorly or subjectively defined, especially at bends in rivers, where cross‐stream sediment transport can strongly influence changes in the texture of the transported sediment. In this paper, we use piecewise models to identify objectively, at two points in the cross‐section of a river bend, the discharge at which the transition between bedload transport phases occurs. Piecewise models were applied to a new bedload data set collected during a wide range of discharges while analysing the associated changes in sediment texture. Results allowed the identification of two well‐differentiated phases of sediment transport (phase I and phase II), with a breakpoint located around bankfull discharge. Associated with each phase there was a change in bedload texture. In phase I there was non‐dominance in the transport of fine or coarse fractions at a particular sampling point; but in phase II bedload texture was strongly linked to the position of the sampling point across the channel. In this phase, fine particles tended to be transported to the inner bank, while coarse sizes were transferred throughout the middle parts of the channel. Moreover, bedload texture at the inner sampling point became bimodal while the transport of pebble‐sized particles was increasing in the central parts of the river channel. It is suggested that this general pattern may be related both to secondary currents, which transfer finer particles from the outer to the inner bank, and to the progressive dismantling of the riverbed surface layer. Copyright © 2018 John Wiley & Sons, Ltd.     

Flux-Corrected Transport with MT3DMS for Positive Solution of Transport with Full-Tensor Dispersion

Solute transport is usually modeled by the advection-dispersion-reaction equation. In the standard approach, mechanical dispersion is a tensor with principal directions parallel and perpendicular to the flow vector. Since realistic scenarios include nonuniform and unsteady flow fields, the governing equation has full tensor mechanical dispersion. When conventional grid-based numerical methods are used, approximation of the cross terms arising from the off-diagonal terms cause nonphysical solution with oscillations. As an example, for the common scenario of contaminant input into a domain with zero initial concentration, the cross-dispersion terms can result in negative concentrations that can wreak havoc in reactive transport applications. To address this issue, we use the well-known flux-corrected-transport (FCT) technique for a standard finite volume method. Although FCT has most often been used to eliminate oscillations resulting from discretization of the advection term for explicit time stepping, we show that it can be adapted for full-tensor dispersion and implicit time stepping. Unlike other approaches based on new discretization techniques (e.g., mimetic finite difference, nonlinear finite volume), FCT has the advantage of being flexible and widely applicable. Implementation of FCT requires solving an additional system of equations at each time step, using a modified “low order” matrix and a modified right-hand-side vector. To demonstrate the flexibility of FCT, we have modified the well-known and widely used groundwater solute transport simulator, MT3DMS. We apply the new simulator, MT3DMS-FCT, to several benchmark problems that suffer from negative concentrations when using MT3DMS. The new results are mass conservative and strictly nonnegative.     

Sediment characteristics and internal architecture of offshore sand ridges on a tideless continental shelf (western Mediterranean)

An integrated approach combining swath bathymetry, an extensive dataset of vibrocores and high-resolution seismic reflection data was used to assess the origin and evolution of offshore sand ridges on a tideless continental shelf (Gulf of Valencia, western Mediterranean). The sand ridges are located in the mid-outer shelf at 55–85 m water depth, obliquely oriented to the shoreline. They are 1.5 to 7 m high, with a wavelength between 600 and 1,100 m and a mean height-to-wavelength ratio of 0.004. The sand ridges are composed of well-sorted medium sand and are partially covered by a mud layer, evidencing a moribund stage. They overlie an erosion surface that locally crops out at the seafloor and is interpreted as the Holocene wave-ravinement surface. In the sediment cores, this surface corresponds to an erosional lag composed of coarse sand and gravel with pebbles. Small topographic irregularities on this surface are interpreted as shoreline-associated features that may act as the precursor for ridge development. Their preservation within the sand ridges could be related to the hardness of these features. Internally, the sand ridges display high-angle dipping reflections, indicating ridge migration towards the southeast in the direction of the present-day sediment transport direction. The presence of interbedded mud layers, associated with these reflections, indicates intermittent episodes of mud deposition when active. The internal architecture of some small ridges also provides new insights into their transition from an active to moribund state, as evidenced by a change in the geometry of the internal units from progradational to aggradational, finally being overlain by onlapping finer deposits over the flanks and in the troughs. The Gulf of Valencia sand ridge field constitutes a valuable potential sand resource of 22 million m³ of well-sorted medium and coarse sand with limited mud content, which must be preserved as a strategic sand reservoir. © 2020 John Wiley & Sons, Ltd.     

Simulated perturbation in the sea-to-air flux of dimethylsulfi de and the impact on polar climate

Marine biogenic emission of dimethylsulfi de(DMS)has been well recognized as the main natural source of reduced sulfur to the remote marine atmosphere and has the potential to aff ect climate,especially in the polar regions.We used a global climate model(GCM)to investigate the impact on atmospheric chemistry from a change to the contemporary DMS fl ux to that which has been projected for the late 21 st century.The perturbed simulation corresponded to conditions that pertained to a tripling of equivalent CO 2,which was estimated to occur by year 2090 based on current worst-case greenhouse gas emission scenarios.The changes in zonal mean DMS fl ux were applied to 50°S–70°S Antarctic(ANT)and 65°N–80°N Arctic(ARC)regions.The results indicate that there are clearly diff erent impacts after perturbation in the southern and northern polar regions.Most quantities related to the sulfur cycle show a higher increase in ANT.However,most sulfur compounds have higher peaks in ARC.The perturbation in DMS fl ux leads to an increase of atmospheric DMS of about 45%in ANT and 33.6%in ARC.The sulfur dioxide(SO 2)vertical integral increases around 43%in ANT and 7.5%in ARC.Sulfate(SO 4)vertical integral increases by 17%in ANT and increases around 6%in ARC.Sulfur emissions increases by 21%in ANT and increases by 9.7%in ARC.However,oxidation of DMS by OH increases by 38.2%in ARC and by 15.17%in ANT.Aerosol optical depth(AOD)increases by 4%in the ARC and by 17.5%in the ANT,and increases by 22.8%in austral summer.The importance of the perturbation of the biogenic source to future aerosol burden in polar regions leads to a cooling in surface temperature of 1 K in the ANT and 0.8 K in the ARC.Generally,polar regions in the Antarctic Ocean will have a higher off setting eff ect on warming after DMS fl ux perturbation.     

Thermal history and evolution of Mars

A theoretical thermal evolution model of Mars is constructed, utilizing as constraints the available geophysical and geological data, including those provided by the Viking missions. The calculation includes conduction and subsolidus mantle convection. Calculated models indicate that Martian evolution can be roughly characterized by four different stages. (1) Core formation and crust differentiation: this stage starts from the planet formation to about 1 by thereafter. During this period, Martian core is separated and the initial crust is differentiated. (2) Heating, expansion, and mantle differentiation: this stage begins after the core separation and extends to about 3 by. First, mantle temperatures rise and reach partial melting. Between 2 and 3 by, extensive melting, differentiation, and outgassing occur. Planetary radius increases and extensional features observed at the surface are most likely generated at this stage. (3) Mature phase: after 3 by, the planet reaches maturity. Between 3 and 4 by slow and sustained evolution continues. Lithosphere thickens and partial melt zone deepens. (4) Cooling period: this stage represents the last phase of Martian history. The planet is cooling slowly. The partial melting zone shrinks and volcanic activity tapers off. At present, Martian lithosphere is about 200 km thick and the mantle is convecting slowly. The models suggest that the core is molten, and the calculated surface heat flux is 35 erg cm^?2 sec^?1.     

Home range and habitat: Using platial characteristics to define urban areas from the bottom up

The spatial representation of a city is typically formed by top‐down jurisdictional boundaries. A parallel approach would be to consider representing a city based on platial characteristics, that is, a bottom‐up landscape created through individual and collectively derived representations. This study contributes to this discourse through the exploratory examination of the ecology notions of home range and habitat applied to humans in an urban context. Using spatial data collected through a WebGIS platform, we employ a spatial definition of sense of place and social capital to understand the platial nature of the city and, simultaneously, defining home range and habitat as platial notions. We found spatial variability among individual home range and habitat and the difficulty of traditional administrative boundaries to represent these areas. This research defines and presents home range and habitat to partially describe the emergent nature of platial theory and explores their operationalization at the urban level.     

Assessing socio-economic impacts of wave overtopping: An institutional perspective

One way to address the assessment of strategies to control wave overtopping at seawalls and related coastal defence structures is to make use of Cost-Benefit Analysis. The institutional context in which Cost-Benefit Analysis takes place influences decisions on the types of values that are taken into consideration and the subsequent selection of valuation methods. We suggest to consider Cost-Benefit Analysis in a broad institutional framework when decisions are to be made on coastal defence strategies. It is argued that the institutional context provides the rules of the game on how a balance can be found between social, economic and ecologic functions of projects that protect societies against overtopping.     

Effectiveness of Neural Kriging for Three-Dimensional Modeling of Sparse and Strongly Biased Distribution of Geological Data with Application to Seafloor Hydrothermal Mineralization

Mathematical Geosciences - Three-dimensional modeling of geoscientific data of limited amounts and strongly biased locations is difficult and impractical using almost any method. To obtain a...