Composition of brines in halite‐hosted fluid inclusions in the Upper Ordovician,Canning Basin,Western Australia: new data on seawater chemistry

Analyses of primary and early diagenetic fluid inclusions in the halite from the Late Ordovician Mallowa Salt, Canning Basin, Western Australia indicate a Ca‐rich composition and high concentration of parent brines in the basin which were close to sylvite and carnallite precipitation. The salt‐bearing series in the sampled interval was overheated up to 62 °C. The recorded differences in gas compositions result from the input of several gas sources including dispersed organic matter in the salt series and hydrocarbon deposits in the underlying rocks. The high concentration of the brines in fluid inclusions does not allow quantitative reconstruction of the chemical composition of Late Ordovician parent seawater. Using the information from Early Cambrian and Late Silurian basins as a proxy, however, the new data indicate that Late Ordovician seawater was undoubtedly Ca‐rich and, in comparison with modern seawater, had a similar K content, considerably lower Mg content (c. 30%), approximately three times the Ca content and one‐third the SO₄ content.     

Screening of polymers on selected Hawaii soils for erosion reduction and particle settling

In recent years, high‐molecular‐weight anionic polyacrylamides (PAMs) have been tested on a variety of soils, primarily in temperate climates. However, little information is available regarding the effectiveness of PAM for preventing soil loss through runoff in tropical settings. Screening tests were performed using three negatively charged PAMs and one positively charged PAM on five Hawaii soils (two Oxisols, one Vertisol, and two Aridisols) to determine erosion loss, sediment settling, and aggregate stability. A laboratory‐scale rainfall simulator was used to apply erosive rainfall at intensities from 5 to 8·5 cm h^?1 at various PAM doses applied in both dry and solution forms. Soil detachment due to splash and runoff, as well as the runoff and percolate water volumes, were measured for initial and successive storms. The impact of PAM on particle settling and aggregate stability was also evaluated for selected soil‐treatment combinations. Among the PAMs, Superfloc A‐836 was most effective, and significantly reduced runoff and splash sediment loss for the Wahiawa Oxisol and Pakini Andisol at rates varying between 10 and 50 kg ha^?1. Reduced runoff and splash sediment loss were also noted for PAM Aerotil‐D when applied in solution form to the Wahiawa Oxisol. Significant reductions in soil loss were not noted for either the Lualualei Vertisol or the Holomua Oxisol. It is believed that the high montmorillonite content of the Lualualei Vertisol and the low cation‐exchange capacity of the Holomua Oxisol diminished the effectiveness of the various PAMs tested. The polymers were also found to enhance sediment settling of all soils and helped improve their aggregate stability. This screening study shows the potential use of PAM for tropical soils for applications such as infiltration enhancement, runoff reduction, and enhanced sedimentation of detention ponds. Copyright © 2005 John Wiley & Sons, Ltd.     

Intercomparison of the seasonal cycle of tropical surface stress in 17 AMIP atmospheric general circulation models

 The mean state of the tropical atmosphere is important as the nature of the coupling between the ocean and the atmosphere depends nonlinearly on the basic state of the coupled system. The simulation of the annual cycle of the tropical surface wind stress by 17 atmospheric general circulation models (AGCMs) is examined and intercompared. The models considered were part of the Atmospheric Model Intercomparison Project (AMIP) and were integrated with observed sea surface temperature (SST) for the decade 1979–1988. Several measures have been devised to intercompare the performance of the 17 models on global tropical as well as regional scales. Within the limits of observational uncertainties, the models under examination simulate realistic tropical area-averaged zonal and meridional annual mean stresses. This is a noteworthy improvement over older generation low resolution models which were noted for their simulation of surface stresses considerably weaker than the observations. The models also simulate realistic magnitudes of the spatial distribution of the annual mean surface stress field and are seen to reproduce realistically its observed spatial pattern. Similar features are observed in the simulations of the annual variance field. The models perform well over almost all the tropical regions apart from a few. Of these, the simulations over Somali are interesting. Over this region, the models are seen to underestimate the annual mean zonal and meridional stresses. There is also wide variance between the different models in simulating these quantities. Large model-to-model variations were also seen in the simulations of the annual mean meridional stress field over equatorial Indian Ocean, south central Pacific, north east Pacific and equatorial eastern Pacific oceans. It is shown that the systematic errors in simulating the surface winds are related to the systematic errors in simulating the Inter-Tropical Convergence Zone (ITCZ) in its location and intensity. Weaker than observed annual mean southwesterlies simulated by most models over Somali is due to weaker than observed southwesterlies during the Northern Hemisphere summer. This is related to the weaker than observed land precipitation simulated by most models during the Northern Hemisphere summer. The diversity in simulation of the surface wind over Somali and equatorial Indian ocean is related to the diversity of AGCMs in simulating the precipitation zones in these regions. Received: 2 August 1996 / Accepted: 7 February 1997     

Radon variations in a Hungarian village

 A steady radon exhalation is assumed in most publications. In a village of North-East Hungary, however, high radon concentrations have been measured, differing strongly in neighbouring houses and varying in time, due to the interplay of geochemical phenomena. Received: 20 November 1995 · Accepted: 18 June 1996     

A technique for calibration of monostatic echosounder systems

A calibration technique has been adapted to render complete system calibrations of high-frequency acoustical instrumentation. This is based on standard targets; specifically, precisely manufactured spheres composed of tungsten carbide with 6% cobalt binder. The use of multiple sphere sizes was found to be advantageous, both as an independent check of the calibrations, and so that resonances in the sphere responses at certain frequencies could be avoided. Complete system gains and beam patterns, which include effects of bandpass filters and finite-pulse lengths, were determined by moving the spheres individually in the transducer far-fields. Use of this procedure ensures control over the acoustical characteristics of transducers, which may change from the time of manufacture and first testing due, for example, to platform mounting. It also provides a direct means of measuring the sampling volume at relatively high and constant signal-to-noise ratios. Implementation of this technique is discussed using a multifrequency sonar system as an example     

Signal processing strategies for a bathymetric sidescan sonar

A dominant source of errors in swath bathymetry is acoustic interference. In 1989 the author published an analysis of these errors and predicted depth accuracies for a system which reduced their effect by averaging. This present paper shows how a considerable improvement in performance may be obtained by a variety of signal processing strategies that include the use of several widely spaced receivers and the elimination of the most unsatisfactory measurements before averaging. Simulations show how impressive sea bed profiles can be produced with a single ping, even at low signal-to-interference ratios     

Reliability assessment of serviceability performance of braced retaining walls using a neural network approach

In urban environments, one major concern with deep excavations in soft clay is the potentially large ground deformations in and around the excavation. Excessive movements can damage adjacent buildings and utilities. There are many uncertainties associated with the calculation of the ultimate or serviceability performance of a braced excavation system. These include the variabilities of the loadings, geotechnical soil properties, and engineering and geometrical properties of the wall. A risk‐based approach to serviceability performance failure is necessary to incorporate systematically the uncertainties associated with the various design parameters. This paper demonstrates the use of an integrated neural network–reliability method to assess the risk of serviceability failure through the calculation of the reliability index. By first performing a series of parametric studies using the finite element method and then approximating the non‐linear limit state surface (the boundary separating the safe and ‘failure’ domains) through a neural network model, the reliability index can be determined with the aid of a spreadsheet. Two illustrative examples are presented to show how the serviceability performance for braced excavation problems can be assessed using the reliability index. Copyright © 2005 John Wiley & Sons, Ltd.     

A 20‐ka climate record from Central Himalayan loess deposits

The southwest monsoon that dominated Central Himalaya has preserved loessic silt deposits preserved in patches that are proximal to periglacial areas. The occurrence of such silts suggests contemporary prevalence of cold and dry northwesterly winds. Field stratigraphy, geochemistry, mineral magnetism, infrared stimulated luminescence (IRSL) and radiocarbon dating has enabled reconstruction of an event chronology during the past 20 ka. Three events of loess accretion could be identified. The first two events of loess deposition occurred betweem 20 and 9 ka and were separated by a phase of moderate weathering. Pedogenesis at the end of this event gave rise to a well‐developed soil that was bracketed around 9 to > 4 ka. This was followed by the third phase of loess accretion that occurred around 4 to > 1 ka. Episodes of loess deposition and soil formation are interpreted in terms of changes in the strength of the Indian southwest monsoon. Copyright © 2005 John Wiley & Sons, Ltd.