Experimental study on the deterioration and natural remediation of the Ariake Sea tidal mud caused by the sea laver treatment acid practice and the upward seepage of pore water liquid

This study presents a laboratory study of the following two aspects: (1) the influence of sea laver treatment acid on the geoenvironmental properties of Ariake Sea tidal mud, and (2) the natural remediation effect on the sea laver treatment acid contaminated Ariake Sea tidal mud caused by the upward seepage of pore water liquid in the mud. Firstly, the mechanisms of the transport of sea laver treatment acid in the Ariake Sea tidal mud and the generation mechanisms of the upward seepage flow in the Ariake Sea tidal mud are discussed. Secondly, a series of one-dimensional laboratory infiltration tests were carried out to investigate the deterioration of the Ariake Sea tidal mud caused by the sea laver acid treatment practice. Test results reveal that the acid treatment practice caused considerable change in the geochemical properties of the mud in terms of increase in sulfide content and decrease in pH value. After the treatment by the sea laver treatment acid, the sulfide content of the mud even exceeded the safe limit value for the benthos, which represents undesirable living condition for benthos. Thirdly, series of laboratory fresh seawater infiltration tests for the deteriorated Iida site mud were conducted to illustrate this natural remediation efficiency. It is found that with the infiltration of the fresh seawater, the sulfide content of the Iida site mud was considerably reduced and pH value increased to an acceptable range for benthos living in the tidal flat mud. With the increase in the infiltration time and the hydraulic gradient, the remediation efficiency could be increased.     

Atomistic simulation of the mechanisms of noble gas incorporation in minerals

Atomistic simulations have been carried out to investigate the mechanisms of noble gas incorporation in minerals using both the traditional two-region approach and the “supercell” method. The traditional two-region approach has been used to calculate defect energies for Ne, Ar, Kr and Xe incorporation in MgO, CaO, diopside and forsterite in the static limit and at one atmosphere pressure. The possibilities of noble gas incorporation via both substitution and interstitial mechanisms are studied. The favored mechanism varies from mineral to mineral and from noble gas to noble gas. In all minerals studied, the variation of the solution energies of noble gas substitution with atomic radius appears approximately parabolic, analogous to those for 1⁺, 2⁺, 3⁺ and 4⁺ trace element incorporation on crystal lattice sites. Noble gas solution energies thus also fall on a curve, similar to those previously observed for cations with different charges, but with much lower curvature.The “supercell” method has been used to investigate the pressure dependence of noble gas incorporation in the same systems. Results indicate a large variation of the solubility of the larger noble gases, Kr and Xe with pressure. In addition, explicit simulation of incorporation at the (0 0 1) surface of MgO shows that the solubility of the heavier noble gases may be considerably enhanced by the presence of interfaces.     

Comparison of arsenic concentrations in simultaneously-collected groundwater and aquifer particles from Bangladesh,India, Vietnam,and Nepal

One of the reasons the processes resulting in As release to groundwater in southern Asia remain poorly understood is the high degree of spatial variability of physical and chemical properties in shallow aquifers. In an attempt to overcome this difficulty, a simple device that collects groundwater and sediment as a slurry from precisely the same interval was developed in Bangladesh. Recently published results from Bangladesh and India relying on the needle-sampler are augmented here with new data from 37 intervals of grey aquifer material of likely Holocene age in Vietnam and Nepal. A total of 145 samples of filtered groundwater ranging in depth from 3 to 36 m that were analyzed for As (1–1000 μg/L), Fe (0.01–40 mg/L), Mn (0.2–4 mg/L) and S (0.04–14 mg/L) are compared. The P-extractable (0.01–36 mg/kg) and HCl-extractable As (0.04–36 mg/kg) content of the particulate phase was determined in the same suite of samples, in addition to Fe(II)/Fe ratios (0.2–1.0) in the acid-leachable fraction of the particulate phase. Needle-sampler data from Bangladesh indicated a relationship between dissolved As in groundwater and P-extractable As in the particulate phase that was interpreted as an indication of adsorptive equilibrium, under sufficiently reducing conditions, across 3 orders of magnitude in concentrations according to a distribution coefficient of 4 mL/g. The more recent observations from India, Vietnam and Nepal show groundwater As concentrations that are often an order of magnitude lower at a given level of P-extractable As compared to Bangladesh, even if only the subset of particularly reducing intervals characterized by leachable Fe(II)/Fe >0.5 and dissolved Fe >0.2 mg/L are considered. Without attempting to explain why As appears to be particularly mobile in reducing aquifers of Bangladesh compared to the other regions, the consequences of increasing the distribution coefficient for As between the particulate and dissolved phase to 40 mL/g for the flushing of shallow aquifers of their initial As content are explored.     

Considerations for conducting incubations to study the mechanisms of As release in reducing groundwater aquifers

Microbial Fe reduction is widely believed to be the primary mechanism of As release from aquifer sands in Bangladesh, but alternative explanations have been proposed. Long-term incubation studies using natural aquifer material are one way to address such divergent views. This study addresses two issues related to this approach: (1) the need for suitable abiotic controls and (2) the spatial variability of the composition of aquifer sands. Four sterilization techniques were examined using orange-colored Pleistocene sediment from Bangladesh and artificial groundwater over 8 months. Acetate (10 mM) was added to sacrificial vials before sterilization using either (1) 25 kGy of gamma irradiation, (2) three 1-h autoclave cycles, (3) a single addition of an antibiotic mixture at 1× or (4) 10× the typical dose, and (5) a 10 mM addition of azide. The effectiveness of sterilization was evaluated using two indicators of microbial Fe reduction, changes in diffuse spectral reflectance and leachable Fe(II)/Fe ratios, as well as changes in P-extractable As concentrations in the solid phase. A low dose of antibiotics was ineffective after 70 days, whereas autoclaving significantly altered groundwater composition. Gamma irradiation, a high dose of antibiotics, and azide were effective for the duration of the experiment.     

Numerical estimation of REV and permeability tensor for fractured rock masses by composite element method

The Monte Carlo method is used to generate parent stochastic discrete fracture network, from which a series of fractured rock samples of different sizes and orientations are extracted. The fracture network combined with a regular grid forms composite element mesh of the fractured rock sample, in which each composite element is composed of sub‐elements incised by fracture segments. The composite element method (CEM) for the seepage is implemented to obtain the nodal hydraulic potential as well as the seepage flow rates through the fractured rock samples. The application of CEM enables a large quantity of stochastic tests for the fractured rock samples because the pre‐process is facilitated greatly. By changing the sizes and orientations of the samples, the analysis of the seepage characteristics is realized to evaluate the variation of the permeability components, the existence of the permeability tensor and the representative element volume. The feasibility and effectiveness are illustrated in a numerical example. Copyright © 2008 John Wiley & Sons, Ltd.     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

利用MC-ICPMS对水样中硼同位素比值的测定

采用Amberlite IRA-743硼特效树脂进行水溶液中硼的分离,对洗脱液温度、体积以及树脂动态交换容量等进行了实验.它的动态交换容量为4.2 mg/g,在室温条件下,用5 mL 2%HNO3可定量从树脂柱上洗脱被吸附的硼.采用Neptune型MC-ICPMS进行硼同位素组成的测定,1 μg/g浓度的硼标准溶液获得放大的信号强度约为0.7V,硼的化学分离过程有效避免了质量歧视效应.实验结果表明,MC-ICPMS对硼存在严重的记忆效应,通过采用5%HNO3-(1%HNO3 0.1%HF)-H2O-20%NH3H2O-H2O的交替清洗方法,可在约1 h内消除硼的记忆效应.在最佳仪器条件下,对含有250 ng硼的水样,可以快速测定硼的同位素组成,占δ11B测定的绝对偏差为0.4‰-0.5‰(SD).     

Flexural isostatic response of the Alps to increased Quaternary erosion recorded by foreland basin remnants,SE France

We test the hypothesis that flexural isostatic compensation of the mass removed by enhanced Quaternary erosion is responsible for uplift of the Western European Alps and their forelands. We use two well‐preserved and well‐dated (1.8 Ma) abandonment surfaces of foreland basin remnants in SE France (the Chambaran and Valensole plateaux) as passive benchmarks for tilting of the foreland. Estimating their initial slope from morphometric scaling relationships, we determine bulk post‐depositional tilting of 0.5–0.8% for these surfaces. The calculated isostatic response of the Alpine lithosphere to erosional unloading, using the method recently proposed by Champagnac et al. [Geology 35 (2007) 195–198] , yields a predicted tilting of 0.3–0.4% in the considered areas, explaining approximately half of the determined post‐depositional tilting. Such long‐term deformation being insensitive to cyclic loading/unloading because of glaciations, we suspect the other half to be related to as yet undetermined long‐wavelength and long‐lived tectonic process(es).