Nitric oxide profiles measured in situ during the Globus '85 campaign

Nitric oxide profiles obtained from three flights of chemiluminescent instruments during the Globus '85 campaign held in France in the autumn of 1985 are reported. When the profile obtained in the early morning of 20 September is compared with the flight made the previous afternoon, an average morning to midday NO ratio of 0.7 for the region between 26 and 33 km is obtained. This value is in good agreement with theoretical studies involving the photolysis of N₂O₅ and the establishment of the NO₂–NO equilibrium.     

Intercomparison of NO column measurements during MAP/GLOBUS 1985

Column measurements of nitric oxide were made using several techniques during the MAP/GLOBUS campaign in France in September 1985. The data sets are nearly co-located and simultaneous, therefore allowing a valid intercomparison of the various measurement methods. The range of altitudes sampled differs from instrument to instrument. This complicates the comparison because the data sets are to some extent complementary. The NO distributions apparently vary significantly from day to day, and possibly over shorter timescales. Changes in dynamics may be responsible for these variations. The results from the instruments which measure in the infrared and the ultraviolet are self-consistent, and show good agreement with photochemical predictions. On 19 September, when the intercomparison was made, the profile measured by the in-situ chemiluminescent instrument differed significantly from the predicted profile, and the measured columns were generally higher.     

A simple model of drainage flow in a valley

A model of the drainage flow in a valley under calm conditions has been developed on the basis of the conservation laws of mass, momentum, and heat. The inflow of mass and heat from side-slopes is incorporated, and the momentum and sensible heat exchanges between valley drainage flow and valley floor are parameterized.The characteristic velocity of valley drainage flow is expressed in terms of the following parameters: three potential temperature differences representing the temperature field in the valey; topographic parameters of the valley; mean bulk coefficients representing the aerodynamic conditions of the valley floor; and the stability of the ambient atmosphere. The characteristic thickness includes additional parameters of side-slope flow.That the model satisfactorily predicts the characteristic thickness and velocity is shown from comparison with observations from valleys several hundred meters to a few hundred kilometers long.     

The effect of the Mt St Helens eruption on tropospheric and stratospheric ions

Balloon-borne observations of electrical conductivity in the troposphere and stratosphere were performed using conductivity sondes at Garmisch-Partenkirchen, West Germany, from June to November, 1980, after the Mt St Helens eruption. A significant decrease of atmospheric ions in the altitudes from the troposphere to lower stratosphere has been detected until several months after the eruption in comparison with the observational results obtained before the eruption. Simulteneous ruby lidar observation a month after the eruption indicates an increased amount of aerosol at nearly the same altitude as that of conductivity decrease. Several months after the eruption it appears that aerosols detected by lidar and those effective in reducing ion concentration have different profiles.     

Heterogeneous shock-induced thermal radiation in minerals

A 500 channel optical imaging intensifying and spectral digital recording system is used to record the shock-induced radiation emitted from 406 to 821 nm from transparent minerals during the time interval that a shock wave propagates through the sample. Initial results obtained for single crystals of gypsum, calcite and halite in the 30 to 40 GPa (300 to 400 kbar) pressure range demonstrate greybody emission spectra corresponding to temperatures in the 3,000 to 4,000 K range and emissivities ranging from 0.003 to 0.02. In the case of gypsum and calcite, distinctive line spectra, are superimposed on the thermal radiation. The observed color temperatures are a factor of 2 to 10 greater than the Hugoniot temperature, calculable on the basis of continuum thermodynamics and equation of state models for the shock states achieved in the three minerals. These observed high temperatures are believed to be real. We conclude that we are detecting a large number of closed spaced high temperature shear-band regions immediately behind the shock front. A shear instability model, such as proposed independently by Grady (1977, 1980), Ananin et al. (1974), and Horie (1980), in which small zones of highly deforming and melted material are produced which are the source of the detected thermal radiation and have a fractional effective area approximately numerically equal to the measured emissivity, can be used to predict an effective emissivity of 0.0065 directly behind the shock front. If shear band instability arises from viscous flow processes, Grady's model and mineral thermal properties yield for the shocked mineral viscosities values in the range of 10⁹ to 10¹⁵ P immediately behind the shock front.     

Structural and fabric analyses of basal slip zone of the Jin’nosuke-dani landslide, northern central Japan: its application to the slip mechanism of decollement

We describe in detail the deformation structures and textures of a large-scale landslide body that developed in the Betto-dani Valley in northern central Japan. We studied the shape-preferred orientation of clasts and clay flakes and the development of internal shear planes within the slip zone of the landslide. The slip has an average rate of 5–10 cm/year under the overburden pressure of approximately 1.6 MPa; these values are similar to those of the proto-decollement zone of the Nankai accretionary prism in SW Japan. The anisotropy of magnetic susceptibility of samples obtained from the slip zone reveals that the long axes of clay flakes define an imbricate structure. The slip was due to a long-term periodical creep, which occurs during the thaw seasons with an average slip rate of 0.16–0.32 μm/min. During the creep, the long axes of grains including clay flakes in the slip zone are developed from parallel to perpendicular to the slip direction. The observed textures provide a clue to elucidate the deformation textures and process in the decollement zone of the Nankai prism.     

A new fault rupture scenario for the 2003 Mw 6.6 Bam earthquake, SE Iran: Insights from the high-resolution QuickBird imagery and field observations

The December 26, 2003 M_w 6.6 Bam earthquake is one of the most disastrous earthquakes in Iran. QuickBird panchromatic and multispectral satellite imagery with 61 cm and 2.4 m ground resolution, respectively provide new insights into the surface rupturing process associated with this earthquake. The results indicate that this earthquake produced a 2–5 km-wide surface rupture zone with a complex geometric pattern. A 10-km-long surface rupture zone developed along the pre-existing Bam fault trace. Two additional surface rupture zones, each 2–5 km long, are oblique to the pre-existing Bam fault in angles of 20–35°. An analysis of geometric and geomorphic features also shows that movement on the Bam fault is mainly right-lateral motion with some compressional component. This interpretation is consistent with field investigations, analysis of aftershocks as well as teleseismic inversion. Therefore, we suggest that the 2003 Bam earthquake occurred on the Bam fault, and that the surface ruptures oblique to the Bam fault are caused by secondary faulting such as synthetic shears (Reidel shears). Our fault model for the Bam earthquake provides a new tectonic scenario for explaining complex surface deformations associated with the Bam earthquake.     

The use of sintered diamond anvils in the MA8 type high-pressure apparatus

A new multi-anvil type high-presure apparatus has been developed using sintered diamond anvils to generate pressures over 30 GPa and temperatures up to about 2000°C. A maximum sample volume of about 1 mm³ is available in this system. The pressure was confirmed by dissociation of forsterite into Mg-perovskite and periclase. The basic techniques and problems in utilizing sintered diamond in the MA8 type high-pressure apparatus are discussed with an emphasis on the future prospect of incorporating simultancous X-ray diffraction observation.     

Assessment of the Uncertainties in the NO2 and O3 Measurements by Visible Spectrometers

The column amounts of nitrogen dioxide (NO2) and ozone (O3) were measured using a visible spectrometer based on the twilight zenith-sky technique at two observatories located at similar latitudes in the northern part of Japan separated by a distance of 150 km. The measurements began in April 1991 at the Moshiri Observatory (44.4°N, 142.3°E) and in April 1994 at the Rikubetsu Observatory (43.5°N, 143.8°E). Since weather conditions and the possible influence from tropospheric pollution were not always identical at these two observatories, the overall accuracy of the measurements was studied comparing these data sets. The first year data obtained at a solar zenith angle of 90 degrees indicated that the NO2 slant column values at sunrise and sunset agreed within 0.36 and 0.54 × 1016 cm-2, respectively, corresponding to 5 % (June) and to 12 % (December) of the columns. The O3 values agreed within 0.76 × 1019 cm-2, corresponding to 4 % (March) 6 % (August) of the columns, although a part of the difference was systematic. The O3 column amounts were also compared to those obtained by the Dobson spectrometer at Sapporo (43.5°N, 143.8°E), whose latitude is similar to these observatories. When an air mass factor of 17.5 was used, the two-year Moshiri vertical column values agreed with the Dobson direct sun values to within 15 Dobson Units, or 3 6 % of the column. The difference between the two values was found to be due partly to the change in the air mass factor caused by seasonal and day-to-day changes in the shape of the O3 vertical profiles. These results confirm the reliability of the NO2 and O3 measurements by visible spectrometers at these sites for the Network for the Detection of Stratospheric Change (NDSC).