A modified light transmission visualization method for DNAPL saturation measurements in 2-D models

In this research, a light transmission visualization (LTV) method was used to quantify dense non-aqueous phase liquids (DNAPL) saturation in two-dimensional (2-D), two fluid phase systems. The method is an expansion of earlier LTV methods and takes into account both absorption and refraction light theories. Based on this method, DNAPL and water saturations can rapidly be obtained point wise across sand-packed 2-D flow chambers without the need to develop a calibration curve. A single point calibration step is, however, needed when dyed DNAPL is used to account for the change in the transmission factor at the dyed DNAPL–water interface. The method was applied to measure, for the first time, undyed DNAPL saturation in small 2-D chambers. Known amounts of DNAPL, modeled by tetrachloroethylene (PCE), were added to the chamber and these amounts were compared to results obtained by this LTV method. Strong correlation existed between results obtained based on this method and the known PCE amounts with an R² value of 0.993. Similar experiments conducted using dyed PCE showed a stronger correlation between results obtained by this LTV method and the known amounts of dyed PCE added to the chamber with an R² value of 0.999. The method was also used to measure dyed PCE saturation in a large 2-D model following sparging experiments. Results obtained from image analyses following each sparging event were compared to results obtained by two independent techniques, namely gas chromatography–mass spectrometry (GC/MS) analyses and carbon column extraction. There was a good agreement between the results obtained by this LTV method and those obtained by the two independent techniques when experiments were carried out under stable light source conditions and errors in mass balance were minor. The method presented here can be expanded to measure fluid contents in three fluid phase systems and provide a non-destructive, non-intrusive tool to investigate changes in DNAPL architecture and flow characteristics in laboratory experiments.     

Biomarkers and environmental risk assessment: guiding principles from the human health field

Although the potential use of biomarkers within environmental risk assessment (ERA) has long been recognised their routine use is less advanced compared with clinical human health risk assessment, where a number of familiar biomarkers (such as blood pressure and serum cholesterol) are in common usage. We have examined how biomarkers are incorporated into human health risk assessment and have identified several 'required elements'. These include identification of the (clinical) assessment endpoint at the outset, rational selection of the biomarker(s) (the measurement endpoint), biomarker 'validation' (e.g. QA/QC) and biomarker 'qualification' (evidence linking the measurement and assessment endpoints). We discuss these elements in detail and propose that their adoption will facilitate the routine use of biomarkers in environmental risk assessment. Furthermore, our analysis highlights the need for cooperation between those working with biomarkers within human and environmental risk assessment to exchange best practice between common disciplines for mutual advantage.     

Seagrass meadows globally as a coupled social–ecological system: Implications for human wellbeing

Seagrass ecosystems are diminishing worldwide and repeated studies confirm a lack of appreciation for the value of these systems. In order to highlight their value we provide the first discussion of seagrass meadows as a coupled social–ecological system on a global scale. We consider the impact of a declining resource on people, including those for whom seagrass meadows are utilised for income generation and a source of food security through fisheries support. Case studies from across the globe are used to demonstrate the intricate relationship between seagrass meadows and people that highlight the multi-functional role of seagrasses in human wellbeing. While each case underscores unique issues, these examples simultaneously reveal social–ecological coupling that transcends cultural and geographical boundaries. We conclude that understanding seagrass meadows as a coupled social–ecological system is crucial in carving pathways for social and ecological resilience in light of current patterns of local to global environmental change.     

Regional effects of climate change on reindeer: a case study of the Muotkatunturi region in Finnish Lapland

Few studies have investigated current climate changes for high latitude regions, and the impact of such changes on reindeer and indigenous people. Previous work by other authors has identified snow and ice conditions in winter as being critical in determining the availability of forage for reindeer. Deep snow makes it difficult to access food. Lack of food weakens the herd and can reduce the allocation of nutrients to the development of the foetus in the female deer. Climate data for Lapland, northern Finland, and Karasjok, northern Norway, are examined, together with reindeer calf numbers for the period 1977 to 1994 for the Muotkatunturi region (68°N 25°30'E). Between 1883 and 1993, precipitation increased but temperatures showed no clear warming or cooling trend. However, since the late 1980s, temperatures have increased. A regression analysis on the climate and reindeer data found that the warmer the winter prior to the rut, the fewer the live calves recorded the following year (r = 0.529, p < 0.05). Also, the wetter the winter prior to the rut, the fewer the calves recorded (r = 0.427, p < 0.10). In contrast, the warmer the autumn prior to their birth, the greater the number of calves recorded (r = 0.474, p < 0.10). These results suggest that as climate changes and winters become warmer and wetter with increased snowfall, calf numbers will decline. These findings have important implications for the Saami people who are heavily dependent on the reindeer for their livelihood.     

Debris-flow release processes investigated through the analysis of multi-temporal LiDAR datasets in north-western Iceland

Debris flows are fast-moving gravity flows of poorly sorted rock and soil, mixed and saturated with water. Debris-flow initiation has been studied using empirical and experimental modelling, but the geomorphic changes, indicative of different triggering processes, are difficult to constrain with field observations only. We identify signatures to distinguish two different debris-flow release styles by integrating high-resolution multi-temporal remote sensing datasets and morphometric analysis. We analyse debris flows sourced above the town of Ísafjörður (Iceland). Two debris-flow triggering processes were previously hypothesised for this site: (i) slope failure, characterised by landslides evolving into debris flows; and (ii) the fire-hose effect, in which debris accumulated in pre-existing, steep-sided bedrock passages is transported by a surge of water. It is unknown which process dominates and determines the local risk. To investigate this question, we compare airborne LiDAR elevation models and aerial photographs collected in 2007 with similar data from 2013. We find that two new debris-flow tracks were created by slope failures. These are characterised by steep sliding surfaces and lateral leveed channels. Slope failure also occurred in two large, recently active tracks, creating the preparatory conditions for the fire-hose effect to mobilise existing debris. These tracks show alternating zones of fill and scour along their length, and debris stored below the source-area at rest angles >35°. Our approach allows us to identify and quantify the morphological changes produced by slope failure release process, which generated the preparatory conditions for the fire-hose effect. As debris flows are rarely observed in action and morphological changes induced by them are difficult to detect and monitor, the same approach could be applied to other landscapes to understand debris-flow initiation in the absence of other monitoring information, and can improve the identification of zones at risk in inhabited areas near hillslopes with potential for debris flows. © 2018 The Authors. Earth Surface Processes and Landforms published by John Wiley & Sons Ltd.     

Syringe‐Tip Filters May Contain the Artificial Sweetener Saccharin

The presence of artificial sweeteners in environmental samples is increasingly used to detect wastewater (and recently landfill leachate) in rivers, lakes and groundwater. Through routine laboratory quality assurance/quality control procedures, it was discovered that some syringe‐tip filters leach saccharin when used to process water samples. We subsequently tested several brands of filters to determine if they leached any of the four common artificial sweeteners analyzed in environmental samples, acesulfame, saccharin, cyclamate, and sucralose. Of the six types of filters tested, only one brand was a source of artificial sweeteners and the only artificial sweetener found was saccharin. The source of the saccharin in the filters is unknown but it is likely the result of some step in the manufacturing process. The saccharin was typically removed from these filters using a distilled water rinse of 13 mL or less. As a precaution, filters should be pre‐tested for the presence of saccharin and/or filters should be flushed with distilled water or sample prior to the collection of water samples for artificial sweetener analyses.     

Carbonate melting and peperite formation at the intrusive contact between large mafic dykes and clastic sediments of the upper Palaeozoic Saint‐Jules Formation,New‐Carlisle,Quebec

The base of an upper Palaeozoic graben‐fill in eastern Canada was affected by mafic dyke intrusions shortly after deposition, resulting in the formation of peperite. Complex magma–sediment interactions occurred as the melts mingled with the wet and poorly consolidated clastic material of this sedimentary basin, which is separated from underlying rocks by the Acadian unconformity (Middle Devonian). As a result of these interactions, the mafic rocks are strongly oxidized, albitized and autobrecciated near and above the unconformity, where blocky juvenile clasts of mafic glass and porphyritic basalt have mingled with molten or fluidized sediments of the upper Palaeozoic Saint‐Jules Formation, forming a peperite zone several metres thick. In contrast to most peperite occurrences, the New‐Carlisle peperites are associated with the tip of dykes rather than with the sides of sills or dykes. We argue that more heat can be concentrated above a dyke than above a sill, as the former provides a more efficient and focused pathway for heated waters to invade the poorly consolidated host sediments. Superheated groundwaters that issued from the sides of the dykes appear to have promoted melting of carbonate components in calcareous sedimentary rock clasts of the Saint‐Jules Formation, locally generating carbonate melts that contributed to the mingling of juvenile and sedimentary clasts in the peperite. Copyright © 2005 John Wiley & Sons, Ltd.     

Sagged phosphatic Nantgarw porcelain (ca. 1813–1820): Casualty of overfiring or a fertile paste?

Nantgarw phosphatic (bone-ash) porcelain (ca. 1813–1820) is renowned for its translucency and the high quality of its enamel decoration. However, only a small proportion of its wares (perhaps 10%) were successfully fired due to sagging (body distortion) and other problems. This indicates that: (1) In terms of its potential for generating a minimum melt, the Nantgarw paste had an unusually fertile composition, or (2) Nantgarw's staff had difficulties in controlling kiln temperatures, so that its wares tended to be overfired. This issue has been addressed using analytical data for sherds excavated from the factory site. Detailed modal, petrographic, and geochemical data demonstrate that extensively sagged wasters contain a high proportion (∼43–63 vol %) of a former melt phase but are surprisingly porous (7–25 vol % pores). In terms of minimum melt generation, the sagged samples have a more fertile bulk composition than their successfully fired counterparts. Most of the wasters contain subsolidus anorthite (∼An₉₅) enclosed by a melt phase with (once corrected for entrained silica polymorph crystallites) a eutectic (minimum melt) composition. The anorthite, however, was completely resorbed by the melt in some of the sagged samples, which subsequently crystallized liquidus anorthite that displays a quenched morphology. These samples were therefore fired above (T_max <1430°C, as estimated from melt compositions) the eutectic (T∼1290°C) in the anorthite–tricalcium phosphate–silica system. The fact that other wasters contain subsolidus anorthite and a minimum melt shows that firing at the eutectic did not guarantee a successful firing, regardless of the melt fertility of the paste. It is likely that the duration of firing near T_max and character of the object (i.e., flatware vs. hollow-ware) were also important variables in this regard. In addition to producing their well-known phosphatic wares, Nantgarw's proprietors apparently also experimented with silicious pastes with compositions akin to true porcelain. Some of silicious sherds found at the site have a lead-bearing (∼15 wt % PbO) glaze, indicating that they survived an early, high temperature biscuit firing, after which they were fired at lower temperature in the glost kiln (i.e., a “soft-paste type” firing sequence). Evidence that the Nantgarw kiln could achieve temperatures in the order of 1400°C further suggests that these silicious sherds are b.f. wasters. © 1999 John Wiley & Sons, Inc.     

Conditions for generation of fire‐related debris flows,Capulin Canyon,New Mexico

Comparison of the responses of three drainage basins burned by the Dome fire of 1996 in New Mexico is used to identify the hillslope, channel and fire characteristics that indicate a susceptibility specifically to wildfire‐related debris flow. Summer thunderstorms generated three distinct erosive responses from each of three basins. The Capulin Canyon basin showed widespread erosive sheetwash and rilling from hillslopes, and severe flooding occurred in the channel; the North Tributary basin exhibited extensive erosion of the mineral soil to a depth of 5 cm and downslope movement of up to boulder‐sized material, and at least one debris flow occurred in the channel; negligible surface runoff was observed in the South Tributary basin. The negligible surface runoff observed in the South Tributary basin is attributed to the limited extent and severity of the fire in that basin. The factors that best distinguish between debris‐flow producing and flood‐producing drainages are drainage basin morphology and lithology. A rugged drainage basin morphology, an average 12 per cent channel gradient, and steep, rough hillslopes coupled with colluvium and soil weathered from volcaniclastic and volcanic rocks promoted the generation of debris flows. A less rugged basin morphology, an average gradient of 5 per cent, and long, smooth slopes mantled with pumice promoted flooding. Flood and debris‐flow responses were produced without the presence of water‐repellent soils. The continuity and severity of the burn mosaic, the condition of the riparian vegetation, the condition of the fibrous root mat, accumulations of dry ravel and colluvial material in the channel and on hillslopes, and past debris‐flow activity, appeared to have little bearing on the distinctive responses of the basins. Published in 2000 by John Wiley & Sons, Ltd.