Hurricanes Frances and Jeanne remove blooms of the invasive green algaCaulerpa brachypus formaparvifolia (Harvey) cribb from coral reefs off Northern Palm Beach County, Florida

Coral reefs worldwide are under stress from a variety of anthropogenic activities that can alter or inhibit recovery from catastrophic physical disturbances such as hurricanes. On coral reefs off southeast Florida, land-based nutrient pollution contributed to a successful invasion ofCaulerpa brachypus fornaparvifolia that dominated (up to 90% cover) reefs between January 2003 and August 2004. In September 2004, physical effects from Hurricanes Frances and Jeanne removed virtually all of theC. brachypus from the affected reefs. In July 2005, small patches ofC. brachypus began to re-emerge and the area was affected again by Hurricane Wilma in October 2005. Although these hurricanes provided temporary relief from theC. brachypus invasion, the future of these reefs is uncertain because of competition with other opportunistic macroalgae and biota that may respond to the combination of newly created space and continued nutrient stress.     

An ephemeral turbidity maximum generated by resuspension of organic-rich matter in a macrotidal estuary, S.W. Wales

An ephemeral estuarine turbidity maximum (ETM) occurs at high water in the macrotidal Taf estuary (SW Wales, United Kingdom). A new mechanism of ETM formation, due to resuspension and advection of material by flood tidal currents, is observed that differs from classical mechanisms of gravitational circulation and tidal pumping. The flood tide advances across intertidal sand flats in the main body of the estuary, progressively entraining material from the rippled sands. Resuspension creates, a turbid front that has suspended sediment concentrations (SSC) of about 4,000 mg I⁻¹ by the time it reaches its landward limit which is also the landward limit of salt penetration. This turbid body constitutes the ETM. Deposition occurs at high slack water but the ETM retains SSC values up to 800 mg I⁻¹, 1–2 orders of magnitude greater than ambient SSC values in the river and estuarine waters on either side. The ETM retreats down the estuary during the ebb; some material is deposited thinly across emergent intertidal flats and some is flushed out of the estuary. A new ETM is generated by the next flood tide. Both location and SSC of the ETM scale on Q/R³ where Q is tidal range and R is river discharge. The greatest expression of the ETM occurs when a spring tide coincides with low river discharge. It does not form during high river discharge conditions and is poorly developed on neap tides. Particles in the ETM have effective densities (120–160 kg m⁻³) that are 3–4 times less than those in the main part of the estuary at high water. High chlorophyll concentrations in the ETM suggest that flocs probably originate from biological production in the estuary, including production on the intertidal sand flats.     

Relative effects of physical and biological processes on nutrient and phytoplankton dynamics in a shallow estuary after a storm event

The effects of advection, dispersion, and biological processes on nitrogen and phytoplankton dynamics after a storm event in December 2002 are investigated in an estuary located on the northern New South Wales coast, Australia. Salinity observations for 16 d after the storm are used to estimate hydrodynamic transports for a one-dimensional box model. A biological model with nitrogen limited phytoplankton growth, mussel grazing, and a phytoplankton mortality term is forced by the calculated transports. The model captured important aspects of the temporal and spatial dynamics of the bloom. A quantitative analysis of hydrodynamic and biological processes shows that increased phytoplankton biomass due to elevated nitrogen loads after the storm was not primarily regulated by advection or dispersion in spite of an increase in river flow from <1 to 928×10³ m³ d⁻¹. Of the dissolved nitrogen that entered the surface layer of the estuary in the 16 d following the storm event, the model estimated that 28% was lost through exchange with the ocean or bottom layers, while 15% was removed by the grazing of just one mussel species,Xenostrobus securis, on phytoplankton, and 50% was lost through other biological phytoplankton loss processes.X. securis grazing remained an important loss process even when the estimated biological parameters in the model were varied by factors of ± 2. The intertidal mangrove pneumatophore habitat ofX. securis allows filtering of the upper water column from the lateral boundaries when the water column is vertically stratified, exerting top-down control on phytoplankton biomass.     

Statistical evaluation of methods for the calculation of static formation temperatures in geothermal and oil wells using an extension of the error propagation theory

The feasibility of using the more sophisticated weighted least-squares (WLS) model, as opposed to the traditional ordinary least-squares (OLS), in linear regressions of BHT data to estimate the static formation temperatures (SFT) was investigated. The most commonly used analytical methods (line-source; spherical and radial heat flow; and cylindrical heat source) were applied. Error propagation equations were derived to calculate errors in the time function of each method. These errors were combined with the BHT measurement errors to compute weighting factors for applying the WLS. Intercept uncertainties were estimated for all regressions using sets of synthetic and actual borehole logs taken from geothermal and oil applications. SFT computed with the spherical and radial heat flow method were generally greater than those from the other two methods.     

Tectonically driven fluid flow and associated low-grade metamorphism during the Alpine compression in the eastern Iberian Chain (Spain)

Fluid inclusions and clay mineralogy of the Permo-Triassic rocks from the Espina and Espadà Ranges (SE Iberian Chain, Spain) have been investigated to establish their relationship with hydrothermal fluid circulation during the Alpine Orogeny. Primary fluid inclusions in quartz-filled tension gashes in Permo-Triassic sandstones reveal maximum temperatures around 230 °C and very constant salinities of 8.5% wt. eq. NaCl. Secondary fluid inclusions found in quartz from the Santonian Ba–Cu–Hg deposits show similar compositional and thermodynamic characteristics, denoting an Alpine recrystallization. Clay mineral composition of Permo-Triassic mudrocks is characterized by pyrophyillite, indicating low-grade metamorphic conditions. Field observations and experimental data suggest that the crystallization of quartz in tension gashes, the formation of secondary fluid inclusions and the development of the metamorphism are contemporaneous and related to fluid circulation during the Alpine compression. Fluid flow took place along the Hercynian fault system that was reactivated during the Mesozoic rift stage and inverted during the Alpine deformation.     

Lower Eocene carbonate-cemented “chimney” structures (Varna, Bulgaria) — Control of seepage rates on their formation and stable isotopic signature

The genesis of Lower Eocene calcite-cemented columns, “pisoid”-covered structures and horizontal interbeds, clustered in dispersed outcrops in the Pobiti Kamani area (Varna, Bulgaria) is related to fossil processes of hydrocarbon migration. Field observations, petrography and stable isotope geochemistry of the cemented structures and associated early-diagenetic veins, revealed that varying seepage rates of a single, warm hydrocarbon-bearing fluid, probably ascending along active faults, controlled the type of structure formed and its geochemical signature. Slow seepage allowed methane to oxidize within the sediment under ambient seafloor conditions (δ¹⁸O = − 1 ± 0.5‰ V-PDB), explaining columns' depleted δ¹³C ratios of − 43‰. Increasing seepage rates caused methane to emanate into the water column (δ¹³C = − 8‰) and raised precipitation temperatures (δ¹⁸O = − 8‰). Calcite-cemented conduits formed and upward migrating fluids also affected interbed cementation. Even higher-energy fluid flow and temperatures likely controlled the formation of “pisoids”, whereby sediment was whirled up and cemented.     

Comparative study of sampling methods and in situ and laboratory analysis for shallow-water submarine hydrothermal systems

A primary aim for sampling of submarine hydrothermal vents is to minimize inclusion of ambient seawater. Here, we compare the results of three different sampling methods (air displacement, two-valve bottle, and syringes) for shallow submarine systems. Mixing of hydrothermal fluid with seawater is unavoidable; however, calculations based on linear mixing models allow estimation of the hydrothermal fluid end-member composition. The results show that sampling with a two-valve bottle and syringes are the best options because they allow collection of samples with a large proportion of hydrothermal fluid. Additionally, we compare the results of in situ and laboratory analyses of the fluid samples, and demonstrate that determination of chemical composition in situ is the best option for some components, as re-equilibration affects some component concentrations (i.e. bicarbonate). Conversely, silica determination in situ usually underestimates the concentration in the fluid, as it does not account for polymeric silica. Other components can be measured either in the field or in the laboratory.     

Composition and applied sedimentology of salt from brines of the Mamfe Basin, Cameroon

Salts produced using brines of the Mamfe Basin were analysed by XRD for their mineral composition and ICP-MS for minor element composition. Halite (NaCl) and dolomite (CaMg (CO₃)₂) constitute the major minerals with minor impurities from Mo and Cd in the chlorides and Sc and Cu in the carbonates. The mineral composition is evidence of dissolution of evaporites with parent brine of marine origin. Other elements analysed are suggested to be adsorbed to these salts and result from water–rock interaction. The elements partitioned based on their correlation to other elements are suggested to derive from sulphates including barite for Ba, sulphides for Pb, Zn, silicates for Zr, Mn and oxides for V, Cr. The electrical conductance of the brines is related to the salt yield by the equation; M = 9 × 10^− 4E− 3.27, and it can be used to estimate salt yield throughout the year. Over 1200 tons of salt consisting dominantly of grade I halite are lost annually as brines across the basin. Purification is required for some minor elements including Ba, Pb, Hg and Cd for use as a condiment. A genetic relation between the parent brine, sulphide minerals and organic matter-rich sediments is proposed.     

Comparison of soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters

The choice of sampling method for soil solution is of great importance. In this paper soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters have been studied with the purpose of investigating systematic differences between them. The samples were taken at 4 depths from an acidified forest soil as well as from adjacent lime and ash treated soils. A centrifugation drainage method was compared with two types of suction lysimeters (‘Rhizon’ and ‘Prenart’) and zero-tension lysimeters. About half of the 27 variables measured showed a significant difference between the sampling methods used. Typically the centrifuged samples had lower pH (4.0 vs. 4.4), Ca (21 μM vs. 30 μM) and Mg (25 μM vs. 34 μM) concentrations and higher Cl (330 μM vs. 230 μM) and DOC (4.4 mM vs. 3.2 mM) concentrations than the Rhizon lysimeters. Also the other lysimeters showed significant differences compared to the centrifuged samples for about half the number of analytes. Centrifuged samples had higher concentrations of all analytes except NO₃ and PO₄ compared to zero-tension lysimeters and also for all analytes except NO₃ and Al compared to Prenart lysimeters. Among the environmental factors considered depth showed an influence to some extent, while sampling occasion had a great significant impact on the difference between the centrifugation method and the Rhizon lysimeters. Factors like individual pits or soil treatment did not show any influence on the difference between the methods.