A novel method for synthesis of aluminium hematites, based upon the homogeneous precipitation of Fe and Al oxinates in various proportions, is presented. The precursor precipitates are heated in air at 700?°C. X-ray diffraction, thermal analyses, BET, FTIR, optical reflection analysis, TEM and Mössbauer spectroscopy at room temperature and 80?K of the resulting products indicate that single-phase hematites are formed with structural Al substitution of up to 10 at%. Interestingly, the particle size (>100?nm) is not substantially reduced by the Al content. Although it remains difficult to obtain a homogeneously distributed Al substitution in the final hematite, this processing line offers a unique opportunity to separate the effects of grain size and Al substitution on the Morin transition temperature (TM) of Al hematite. From the comparison between the present hematites and a series of Al-substituted hematites with lepidocrocite as precursor, it could be shown that the effect on TM, associated with a change of a factor 10 in grain size, is about 1/3 of the effect caused by a change of 10 in the degree of substitution. Finally, it is suggested that proper thermal treatments under different conditions of the same precursors are likely to produce spinel phases. 相似文献
This study focused on chemical weathering and bacterial ecology in the hyporheic zone of Green Creek, a McMurdo Dry Valley (Antarctica) stream. An in situ microcosm approach was used to observe dissolution features on the basal-plane surface of muscovite mica. Four mica chips were buried in December 1999 and dug up 39 d later. Atomic force microscopy (AFM) of the basal-plane surfaces revealed small, anhedral ∼10-Å-deep etch pits covering ∼4% of the surfaces, from which an approximate basal-plane dissolution rate of 8.3 × 10−18 mol muscovite cm−2 s−1 was calculated (on the basis of the geometric surface area) for the study period. This is an integrated initial dissolution rate on a fresh surface exposed for a relatively brief period over the austral summer and should not be compared directly to other long-term field rates. The observation of weathering features on mica agrees with previous stream- and watershed-scale studies in the Dry Valleys, which have demonstrated that weathering occurs where liquid water is present, despite the cold temperatures.AFM imaging of mica surfaces revealed biofilms including numerous small (<1 μm long), rounded, oblong bacteria. The AFM observations agreed well with X-ray photoelectron microscopy results showing increased organic C and N. Bacteriologic analysis of the hyporheic zone sediments also revealed <1-μm-long bacteria. α-Proteobacteria were observed, consistent with the oligotrophic conditions of the hyporheic zone. Nitrate-reducing bacteria were found, in agreement with a previous tracer test at Green Creek that suggested nitrate reduction occurs in the hyporheic zone. The results of this study thus provide direct evidence of dynamic geochemical and microbial processes in the hyporheic zone of a Dry Valley stream despite the extreme conditions; such processes were inferred previously from stream-scale hydrogeochemical studies. 相似文献
This paper presents results recently obtained for generating site-specific ground motions needed for design of critical facilities. The general approach followed in developing these ground motions using either deterministic or probabilistic criteria is specification of motions for rock outcrop or very firm soil conditions followed by adjustments for site-specific conditions. Central issues in this process include development of appropriate attenuation relations and their uncertainties, differences in expected motions between Western and Eastern North America, and incorporation of site-specific adjustments that maintain the same hazard level as the control motions, while incorporating uncertainties in local dynamic material properties. For tectonically active regions, such as the Western United States (WUS), sufficient strong motion data exist to constrain empirical attenuation relations for M up to about 7 and for distances greater than about 10–15 km. Motions for larger magnitudes and closer distances are largely driven by extrapolations of empirical relations and uncertainties need to be substantially increased for these cases.
For the Eastern United States (CEUS), due to the paucity of strong motion data for cratonic regions worldwide, estimation of strong ground motions for engineering design is based entirely on calibrated models. The models are usually calibrated and validated in the WUS where sufficient strong motion data are available and then recalibrated for applications to the CEUS. Recalibration generally entails revising parameters based on available CEUS ground motion data as well as indirect inferences through intensity observations. Known differences in model parameters such as crustal structure between WUS and CEUS are generally accommodated as well. These procedures are examined and discussed. 相似文献
High spatial resolution U–Pb dates of zircons from two consanguineous ignimbrites of contrasting composition, the high-silica rhyolitic Toconao and the overlying dacitic Atana ignimbrites, erupted from La Pacana caldera, north Chile, are presented in this study. Zircons from Atana and Toconao pumice clasts yield apparent 238U/206Pb ages of 4.11±0.20 Ma and 4.65±0.13 Ma (2σ), respectively. These data combined with previously published geochemical and stratigraphic data, reveal that the two ignimbrites were erupted from a stratified magma chamber. The Atana zircon U–Pb ages closely agree with the eruption age of Atana previously determined by K–Ar dating (4.0±0.1 Ma) and do not support long (>1 Ma) residence times. Xenocrystic zircons were found only in the Toconao bulk ignimbrite, which were probably entrained during eruption and transport. Apparent 238U/206Pb zircon ages of 13 Ma in these xenocrysts provide the first evidence that the onset of felsic magmatism within the Altiplano–Puna ignimbrite province occurred approximately 3 Myr earlier than previously documented. 相似文献
Oxygen isotope studies were carried out across units of a Neoproterozoic nappe system, south of São Francisco Craton. A temperature decrease toward the base of the system is found, consistent with a previously recognized inverted metamorphic pattern. The tectonic contact of the basal unit and the reworked southern São Francisco craton show a steep temperature gradient, suggesting that low temperature thrusting acted as the dominant tectonic process. The contrasts between the δ18O values of the Três Pontas-Varginha and Carmo da Cachoeira nappes and the differences among the samples and minerals are consistent with the preservation of sedimentary isotopic composition during metamorphism. The small differences in the δ18O values between the undeformed and the deformed calc-silicate samples (1.6‰) suggest that the δ18O value of mylonitization fluids was close to that which equilibrated with the metamorphic assemblage. The distinct δ18O values of metapelitic and calc-silicate samples and the great temperature difference from one type to the other indicate that no large-scale fluid interaction processes occurred during metamorphism. Oxygen isotopic estimations of both Três Pontas-Varginha undeformed rocks and Carmo da Cachoeira unaltered equivalents indicate δ18O values of up to 18‰. Comparison between these values and those from the ‘basement’ orthogneisses (8.3–8.5‰) indicates the latter are not sources for the metapelites. 相似文献
This paper deals with the taxonomic revision of the Early Cretaceous large, many-chambered planispiral planktonic foraminifera, historically assigned to the genus Globigerinelloides or alternatively assigned in the 1990s to the genera Globigerinelloides Cushman and ten Dam, Biglobigerinella Lalicker, Blowiella Krechmar and Gorbachik and Alanlordella BouDagher-Fadel. In a previous paper we demonstrated that the morphological and microstructural features used in the literature for distinguishing Blowiella from Globigerinelloides have value only at species level, and the former genus was thus invalidated (being the junior synonym). Moreover, the Late Aptian specimens assigned to Biglobigerinella by some authors, based on the presence of twin last chamber(s), are also included in Globigerinelloides because individuals sharing the same features (number of chambers, growth rate, size of umbilicus, and a finely perforate wall) may or may not possess twin last chamber(s). Meanwhile, Moullade et al. questioned the taxonomic value of Alanlordella, erected by BouDagher-Fadel to accommodate planispiral taxa possessing a macroperforate wall. All the species analysed here possess a finely perforate wall and consequently cannot be assigned to this taxon.The large species of Globigerinelloides retained here, with six or more chambers in the outer whorl, are G. algerianus Cushman and ten Dam, G. aptiensis Longoria, G. barri (Bolli, Loeblich and Tappan) and G. ferreolensis (Moullade).In the sections studied, Globigerinelloides aptiensis was first found close to the Barremian/Aptian boundary, even though this species was recorded in Spain (Rio Argos) in the mid Upper Barremian; very rare, small, seven-chambered individuals here assigned to Globigerinelloides ferreolensis are recorded in the Lower Aptian (just below and within the Selli Level, OAE1a), while a few specimens belonging to Globigerinelloides barri occur in the Globigerinelloides ferreolensis Zone (Upper Aptian). Globigerinelloides aptiensis and G. ferreolensis range up to the Ticinella bejaouaensis Zone while Globigerinelloides barri disappears at the top of the Globigerinelloides algerianus Zone; finally, Globigerinelloides algerianus obviously spans the eponymous total range zone.From an evolutionary point of view, two lineages within the many-chambered Globigerinelloides have been recognized. In the first, already known in the literature, Globigerinelloides aptiensis gave rise to G. ferreolensis, which evolved into G. algerianus; the latter in turn gave rise to Pseudoplanomalina cheniourensis as the final evolutionary member. In the second lineage Globigerinelloides barri originated from G. blowi. 相似文献
The polyphase evolution of the Seridó Belt (NE-Brazil) includes D1 crust formation at 2.3–2.1 Ga, D2 thrust tectonics at 1.9 Ga and crustal reworking by D3 strike-slip shear zones at 600 Ma. Microstructural investigations within mylonites associated with D2 and D3 events were used to constrain the tectono-thermal evolution of the belt. D2 shear zones commenced at deeper crustal levels and high amphibolite facies conditions (600–650 °C) through grain boundary migration, subgrain rotation and operation of quartz c-prism slip. Continued shearing and exhumation of the terrain forced the re-equilibration of high-T fabrics and the switching of slip systems from c-prism to positive and negative a-rhombs. During D3, enhancement of ductility by dissipation of heat that came from syn-D3 granites developed wide belts of amphibolite facies mylonites. Continued shearing, uplift and cooling of the region induced D3 shear zones to act in ductile-brittle regimes, marked by fracturing and development of thinner belts of greenschist facies mylonites. During this event, switching from a-prism to a-basal slip indicates a thermal path from 600 to 350 °C. Therefore, microstructures and quartz c-axis fabrics in polydeformed rocks from the Seridó Belt preserve the record of two major events, which includes contrasting deformation mechanisms and thermal paths. 相似文献