华北克拉通北缘东段“开原岩群”的解体及重新认识

根据近年来的同位素年代学资料,对分布于辽北地区的一套构造变质岩系（"开原岩群"或"清河镇岩群"）进行了重新认识和划分,并将其重新定义为清河构造混杂岩,由中太古代、新太古代、中元古代、新元古代、二叠纪等不同时代、不同构造环境的地质体组成.其中,中太古代、新太古代、中元古代岩石来自华北克拉通,而新元古代、二叠纪岩石则来自兴蒙造山带.将原沈家堡子岩组重新划分为新太古代变质表壳岩和中-新太古代变质深成岩,原板石沟岩组（或芦家堡子岩组）厘定为中元古代石门岩组,原照北山岩组重新划分为新元古代南平岩片和晚二叠世照北山岩组,将原佟家屯岩组和尖山子火山岩合并为晚二叠世佟家屯岩组.最后,提出了清河构造混杂岩带为华北克拉通与兴蒙造山带的界线以及古亚洲洋在华北板块北缘东段的最终闭合时间为中三叠世早期（约245Ma）的认识.     

基于数值模拟的再生水对地下水质影响实例

为了探讨在再生水地表回灌条件下,再生水对地下水中氨素和主要盐分浓度变化的影响,选取现实存在的清河再生水湿地公园为例,以氨氮、Cl-离子为主要研究对象,利用Hydrus-1D溶质运移模型和Modflow、MT3DMSD耦合地下水模型,模拟了再生水长期利用后的地下水氨氮和Cl-指标变化情况。研究结果显示,再生水到达包气带底部时,水中氮氨、Cl-离子含量高于研究区潜水地下水中的相应指标含量,氨氮超出地下水质量Ⅲ类标准。预测5~20年后,潜水中氨氮超标面积不断扩展,20年后将达14km2,氨氮超标垂向延伸至第一层弱透水层;Cl-离子在潜水中不超标,但在湿地公园周边浓度有所增加。湿地公园再生水的长期地表回灌将给当地地下水质量带来负面影响。     

塔里木陆块西北缘萨热克砂岩型铜矿床构造-流体演化对成矿的制约

塔里木陆块西北缘萨热克砂岩型铜矿床构造演化、流体演化与成矿之间具有密切关系,处于一个统一系统中。矿床成岩期方解石中包裹体水的δD值为-65.3‰~-99.2‰,改造成矿期石英包裹体水的δD值为-77.7‰~-96.3‰,成岩成矿期成矿流体δ~(18)OH_2O变化范围为-3.22‰~1.84‰,改造成矿期成矿流体δ~(18)OH_2O变化范围为-4.26‰~5.14‰,指示萨热克铜矿成岩期、改造期成矿流体主要为中生代大气降水及其经水岩作用而成的盆地卤水。矿石中辉铜矿δ~(34)S值为-24.7‰~-15.4‰,指示硫主要源自硫酸盐细菌与有机质还原,部分源于有机硫。构造与成矿流体演化对砂岩铜矿成矿起关键制约作用。盆地发展早期强烈的抬升运动使盆地周缘基底与古生界剥蚀,为富铜矿源层的形成提供了丰富物源,至晚侏罗世盆地发展晚期,长期演化积聚的巨量含矿流体在库孜贡苏组砾岩胶结物及裂隙中富集,在萨热克巴依盆地内形成具有经济意义的砂岩型铜矿床。     

四川西昌盆地白垩纪恐龙足迹群的新发现

四川西昌盆地白垩系小坝组尚未发现骨骼化石记录,其白垩系恐龙动物群的信息全赖于足迹化石。2017年,在喜德县洛甘发现小坝组迄今最大型的恐龙足迹群。该足迹点保存了大量的兽脚类足迹。足迹保存条件较差,但具备了基本的形态学特征。总体来看,兽脚类足迹具有尺寸较小(8~13cm),中等中趾前凹(0.5~0.6)和第Ⅱ趾和第Ⅳ趾间较宽趾间角(70°~100°)的特征;少量足迹保存了跖骨垫。初步分析认为,洛甘兽脚类足迹与四川盆地夹关组的兽脚类足迹Eubrontes和Grallator形态类型相似,为两地在白垩纪中期具有类似的恐龙动物群的观点提供了新的证据。该发现对于西昌盆地的古气候、古地理和地层对比都具有重要的意义,足迹详细分类还有待进一步研究。     

Development and verification of the comprehensive model for physical properties of hydrate sediment

Natural gas hydrate is widely distributed all over the world and may be a potential resource in the near future, whereas hydrate dissociation during the development affects wellbore stability and drilling safety. However, the present modeling of hydrate reservoir parameters ignored the influence of effective stress and only considered the hydrate saturation. In this paper, a series of stress sensitivity experiments for the unconsolidated sandstone were carried out, and the influence of mean effective stress on physical parameters was obtained; a comprehensive model for the physical parameters of hydrate reservoir was developed subsequently. With the help of ABAQUS finite element software, the established comprehensive model was verified by the use of the wellbore stability numerical model of hydrate reservoir. The verification results show that ignoring the effect of mean effective stress on the parameters of hydrate formation aggravates the invasion of drilling fluid into the hydrate formation. Besides, ignoring the stress sensitivity of reservoir physical parameters will underestimate the wellbore instability during hydrate drilling, which will be a threat to the safety of gas hydrate drilling. At the end of the drilling operation, the maximum plastic strain of the model for considering and not considering stress sensitivity was 0.0145 and 0.0138, respectively. Therefore, the established comprehensive model will provide a theoretical support for accurately predicting the engineering geological disasters in hydrate development process.     

Evolution of the shape parameter in the Weibull distribution for brittle rocks under uniaxial compression

Applying the statistical damage theory based on the Weibull distribution to describe rock deformation and failure processes is an important development in rock mechanics. The shape parameter of the Weibull distribution, m, determines the basic shape of the distribution curve; additionally, it also represents a physical characteristic which can be applied when constructing rock constitutive models. To study the evolution of m during rock failure when applying the Weibull distribution to rock mechanics, uniaxial cyclic loading tests of shale specimens were conducted and previous rock mechanics experiments under different temperatures and loading rates were reviewed. The results indicate that m varied with the accumulation of damage but was almost constant between the volume expansion point and the peak strength point of each specimen. Combined with previous studies about the accelerated failure behavior of rocks, we conclude that between the volume expansion point and the peak strength point, the mechanical behavior of the rock fracture process did not change significantly. Based on the characteristics of m at different damage stages during the rock failure process, ranges of m values at different damage stages are proposed. The conclusions reached in this study may be used as an important reference for theoretical research on rock mechanics.     

Porosity and wave velocity evolution of granite after high-temperature treatment: a review

The evolution of porosity and changes in wave velocity in granite after high-temperature treatment has been experimentally investigated in different studies. Statistical analysis of the test results shows that there is a temperature threshold value that leads to variations in porosity and wave velocity. At a temperature that is less than 200 °C, the porosity of granite slowly increases with increases in temperature, while the wave velocity decreases. When the temperature is greater than 200 °C (especially between 400 and 600 °C), the porosity quickly increases, while the wave velocity substantially decreases. The temperature ranges of room temperature to 200 and 200–400 °C correspond to the undamaged state and the micro-damage state, respectively. The results confirm that there is an important link between the variations of physical and mechanical properties in response to thermal treatment. By studying the relationships among rock porosity, wave velocity and temperature, this provides the basis for solving multi-variable coupling problems under high temperatures for the thermal exploitation of petroleum and safe disposal of nuclear waste.     

A GIS-based method of risk assessment on no. 11 coal-floor water inrush from Ordovician limestone in Hancheng mining area,China

The no. 11 coal seam in the deep area of Hancheng mining area is mining in recent years, which is threatened by the water inrush from the Ordovician limestone aquifer. Coal-floor water inrush is governed by the water abundance of coal-floor aquifer, the water-resisting performance of coal-floor aquitard, and the pathway connecting the water source and the working face. To make an accuracy risk assessment of water inrush from the no. 11 coal seam floor, a GIS-based vulnerability index method (VIM) is adopted for its superior comprehensive consideration of more controlling factors, powerful spatial analysis, and intuitively display functions. This study firstly established an index system including the water pressure of the coal-floor aquifer, the unit water inflow, the thickness, the core recovery percentage, the thickness ratio of brittle rocks to ductile rocks, the thickness of effective aquitard, and the accumulated length of faults and folds, of which the former six indexes governed the water abundance of the coal-floor aquifer which was combined with the last two factors to determine the risk of coal-floor water inrush. Secondly, the thematic map of each controlling factor is established by GIS using the geological prospecting data, and the weight of each factor is determined by the analytic hierarchy process (AHP) after consulting the expert review panel. At last, a vulnerability index is obtained and used to assess the risk of coal-floor water inrush of the no. 11 coal seam. The risk of water inrush of the no. 11 coal seam of the study area was ranked to three zones: the southeastern shallow area in red color is the dangerous zone, the wide northwestern area in green color is the safe zone, and the transition area in yellow color is the moderate-risk zone. Compared with the actual water-inrush incidents, the risk assessment result was verified to achieve an accuracy of 82.35%, which is proved to be a dependable reference for the prevention and controlling of coal-floor water inrush of the no. 11 coal seam in Hancheng mining area.     

Stability study on the northern batter of MBC Open Pit using Plaxis 3D

Cracks appeared on the northern batter at Maddingley Brown Coal Open Pit Mine, Victoria, Australia, on 8 November 2013 and a 2-day rainfall event happened 5 days later. This study models the stability of the northern batter considering the effect of the rainfall event and an emergency buttress using finite element method (FEM) encoded in Plaxis 3D. It is found that the batter tended to lead to block sliding after overburden removal. The observed vertical crack would be a combined action of the overburden removal and groundwater flow. The simulated location of cracks agrees well with the actual location, and the simulated heave of the coal seam is in good agreement with the experience in Victoria brown coal open pit mining. The rainfall accelerated the development of the cracks. With the construction of the emergency buttress, the batter became stable that is in good agreement with the monitored data.     

湘西-黔东下寒武统清虚洞组藻灰岩沉积特征及其找矿意义

铅锌矿是湘西-黔东地区的优势矿种,资源丰富,开发历史悠久,找矿潜力巨大。综合分析前人有关湘西-黔东生物礁的资料,介绍了藻灰岩的沉积特征,并结合大量实际地质资料,对藻灰岩控矿进行了论述。结果表明: 成矿物质主要来源于藻类及碳酸盐泥对Pb²⁺、Zn²⁺离子的吸取,矿床成因属于沉积成岩矿床类型,兼有成岩期后矿床性质; 藻礁灰岩与不同岩性的接合部位及其附近等微地球化学障区,往往就是铅锌富矿体产出部位; 藻礁灰岩与礁间通道的薄层泥质白云质灰岩呈指状交叉接触处,也常有铅锌富矿体产出; 铅锌富矿体基本上产于清虚洞组灰岩段中,且明显受该段藻礁灰岩控制。为满足国内外对铅锌矿日益增长的消费需要,深入研究区内铅锌矿的地层岩相岩石控矿因素及其富集规律,指导该地区藻灰岩中铅锌矿找矿工作,具有重要的现实意义。