Effects of bottom topography and density stratification on variations of western boundary currents caused by periodic change in wind stress

Variations of the western boundary currents induced by a periodic change in wind stress are studied in a two-layer model with a continental slope along the western boundary. The variation of the total transport of the western boundary current over the continental slope shows a considerable phase lag with the wind stress and a decrease in amplitude compared with for the flat bottom ocean, though the interior barotropic response is to adjust almost instantaneously to the wind stress. The total transport variation of the western boundary current is well approximated by the upper layer transport variation. That is, almost complete separation of the upper- and lower-layer flows takes place over the slope, and only the upper layer flow contributes to the change in total transport of the western boundary current. Contributions of the interior barotropic and baroclinic responses to the upper layer transport variation depend on the forcing period. With decrease in the forcing period, the barotropic response becomes relatively important for determining the upper layer transport variation although the amplitude of the variation is smaller.     

大气气溶胶的垂直非均一对向上亮度和卫星遥感地表反射率的效应

均一模式和两层模式是两个忽略气溶胶垂直非均一、并广泛用于卫星遥感的辐射模式。通过两个模式的数值模拟，分析了气溶胶的垂直非均一对向上天空亮度和卫星遥感地面反射率的效应。数值模拟选用了２４个有代表性的气溶胶模式。对于具有强分子散射的卫星短波通道，由于分子和气溶胶散射性的明显不同，应用均一和两层模式计算的向上亮度往往存在较大误差。对长波通道，如果气溶胶的光学特性随高度变化不大，该亮度误差较小，但如果存在不同散射相函数和一次散射反照率的气溶胶层，该误差仍可能较大。对于干净的大气，由均一和两层模式计算的亮度误差可分别高达３１．４％和３１．５％，而对于混浊的大气，该误差可分别高达６７．８％和５９．２％。该亮度误差可以引起地表反射率解存在大的不确定性，特别是对于短波通道和强吸收的气溶胶。对于包含强吸收气溶胶的混浊大气，均一和两层模式不适合于大气订正应用。     

Formation mechanism of pigeonite lamellae in skaergaard augite

Fine textures of exsolution lamellae and interface boundaries between augite and pigeonite in augite crystals from Skaergaard ferrogabbro 4430 have been studied by high resolution electron microscopy and X-ray methods. Thick pigeonite lamellae have higher densities of (100) stacking faults than thin lamellae. The displacement vector of the faults has been determined as 5/6c from the measured density of faults and the relative rotation of the augite and pigeonite lattices. The augite and pigeonite lattices are apparently coherent, and no growth ledges were observed at the interfaces. The stacking faults are often combined with the antiphase boundary of pigeonite resulting in a total displacement vector of 1/2(a+b)+5/6c. The observation of thick and thin pigeonite lamellae indicated that the thickening of (001) pigeonite lamellae was controlled by coherency strains accumulated at the interfaces between augite and pigeonite.     

Correlation study between suspended particulate matter and DOAS data

Continuous data of aerosol optical thickness monitored using differential optical absorption spectroscopy (DOAS) are correlated with the concentration of ground-measured suspended particulate matter (SPM). A high correlation is found between the DOAS and the ground SPM data, making it possible to calculate the mass extinction efficiency of the aerosols in the atmosphere. It is found that the value of mean mass extinction efficiency (MEE) varies over a range of 2.6–13.7m2 g?1, with smaller and larger values occurring for size distributions dominated by coarse and fine particles, respectively.     

Cooling flows induced by Compton cooling resulting from luminous quasars in clusters of galaxies

We have studied the effects of Compton cooling on cooling flow by performing numerical hydrodynamic calculations of the time evolution of hot gas in clusters of galaxies with luminous quasars. We assumed various temperatures for the hot intracluster gas. We have shown that the Compton cooling resulting from very luminous quasars is effective in inducing cooling flow, before radiative cooling flow is realized. The mass flux resulting from the cooling flow increases with time, as the Compton-cooled region expands. However, the mass flux of the Compton cooling flow is not large, less than 1 M⊙ yr⁻¹ in our model, because the Compton-cooled region is limited to an inner galactic region around a quasar. Even after the quasar active phase has ceased, the cooling flow will continue for at least 10⁹ yr. The accreted mass is enough to explain X-ray absorption lines in high-redshift quasars, if the Compton-cooled gas is compressed by high-pressure intracluster gas.     

Methane in Izena Cauldron,Okinawa Trough

Methane in the deep water of Izena Cauldron (maximum depth: ca. 1650 m) at the east side of mid-Okinawa Trough was studied by casting a CTD system with 12 Niskin bottles for water sampling at 11 stations inside and outside the cauldron. The water contained much methane up to 706 nmoles/l. The depths of maximum concentration varied widely from station to station, indicating the existence of a considerable number of vents emitting methane and heat. The waters containing less methane formed a straight line in theT-S diagram, while those containing more methane were more largely deviated from the line. The temperature anomaly was virtually proportional to the methane concentration, suggesting that the oxidation rate of methane inside the cauldron is negligibly small and methane can be used as a tracer of the cauldron water. The relation and the estimated vertical diffusivity gave the following fluxes. The emissions of methane and heat out of the bottom below 1450 m turn out to be 1400 moles/day and 7×10¹⁰ cal/day, respectively. The total emission rates inside the cauldron are presumed to be about twice the above values. The turnover time of methane has been estimated to be 240 days, which is also that of heat generated from the bottom and probably that of the bottom water.     

Phreatomagmatic eruptions associated with the caldera collapse during the Miyakejima 2000 eruption,Japan

The 2000 AD eruption of Miyakejima was characterized by a series of phreatomagmatic eruptions from the subsiding caldera. Six major eruptive events occurred, and they can be divided into the first and second periods separated by a 25-day hiatus. The phreatomagmatic eruptions produced a total of ~ 2 × 10¹⁰ kg of tephra, which mainly comprised fine-grained volcanic ash. The tephra layers could be divided into six fall units corresponding to the six major eruptive events.     

Lessons Learned from the 2011 Great East Japan Tsunami: Performance of Tsunami Countermeasures, Coastal Buildings, and Tsunami Evacuation in Japan

In 2011, Japan was hit by a tsunami that was generated by the greatest earthquake in its history. The first tsunami warning was announced 3 min after the earthquake, as is normal, but failed to estimate the actual tsunami height. Most of the structural countermeasures were not designed for the huge tsunami that was generated by the magnitude M = 9.0 earthquake; as a result, many were destroyed and did not stop the tsunami. These structures included breakwaters, seawalls, water gates, and control forests. In this paper we discuss the performance of these countermeasures, and the mechanisms by which they were damaged; we also discuss damage to residential houses, commercial and public buildings, and evacuation buildings. Some topics regarding tsunami awareness and mitigation are discussed. The failures of structural defenses are a reminder that structural (hard) measures alone were not sufficient to protect people and buildings from a major disaster such as this. These defenses might be able to reduce the impact but should be designed so that they can survive even if the tsunami flows over them. Coastal residents should also understand the function and limit of the hard measures. For this purpose, non-structural (soft) measures, for example experience and awareness, are very important for promoting rapid evacuation in the event of a tsunami. An adequate communication system for tsunami warning messages and more evacuation shelters with evacuation routes in good condition might support a safe evacuation process. The combination of both hard and soft measures is very important for reducing the loss caused by a major tsunami. This tsunami has taught us that natural disasters can occur repeatedly and that their scale is sometimes larger than expected.     

Mineralogical and textural variation of silica minerals in hydrothermal flow-through experiments: Implications for quartz vein formation

We conducted hydrothermal flow-through experiments at 430 °C and 31 MPa to investigate the mechanism of silica precipitation on granite under crustal conditions. Two experiments were performed using different input solutions: a single-component Si solution, and a multi-component solution with minor Al, Na, and K. The degree of supersaturation with respect to quartz, Ω = C_Si/C_Si,Qtz,eq, where C_Si and C_Si,Qtz,eq indicate Si concentration in solutions and the solubility of quartz within water, respectively, decreased from 3-3.5 to <1.1 along the flow path. A variety of silica minerals formed during the experiments (opal-A, opal-C, chalcedony, and quartz), and their occurrences and modal abundances changed in response to Ω and the presence of additives in the solution.For near-equilibrium solutions (Ω < ∼1.2), silica precipitation occurred in a simple way in both experiments, being restricted to overgrowths on pre-existing quartz surfaces in the granite. At higher saturation levels (Ω > ∼1.2), silica minerals were deposited on other surfaces in addition to quartz. In the single-component experiment, the dominant silica minerals changed in the order of opal-A → opal-C → quartz with decreasing Si concentration along the flow path. In contrast, in the multi-component experiment, quartz and minor chalcedony formed throughout the entire reaction vessel. This finding indicates that impurities (Na, K, and Al) in the solutions inhibited the precipitation of opal and enhanced the direct nucleation of quartz. The systematic appearance of metastable silica minerals were examined by nucleation processes and macroscopic precipitation kinetics. Our experimental results indicate that different precipitation mechanisms yield contrasting textures, which in turn suggests that vein textures can be used as indicators of solution chemistry within the fracture.     

Fine-grained aggregates in L3 chondrites

The textures and chemical compositions of the constituent minerals of the fine-grained aggregates (FGA's) of L3 chondrites were studied by the backscattered electron image technique, electron probe microanalysis, and transmission electron microscopy. Plagioclase and glass in the interstices between fine grains of olivine and pyroxene indicate that the FGA's once partly melted. Compositional zoning and decomposition texture of pyroxenes are similar to those observed in chondrules, indicating a common cooling history of the FGA's and chondrules. Therefore, the mechanism that caused melting of the FGA's is considered to be the same as for chondrules. Bulk compositions of the FGA's are within the range of those of chondrules, so some chondrules probably were produced by complete melting of the same precursor materials as those of the FGA's. The precursor materials must have included fine olivine and other grains that probably are condensates.