Iron isotopic analyses of geological reference materials on MC-ICP-MS with instrumental mass bias corrected by three independent methods

Here we report iron (Fe) isotopic data of three pure Fe solution standards (IRMM-014, GSB Fe, and NIST 3126a) and five widely used geological reference materials (RMs) from the United States Geological Survey and Geological Survey of Japan obtained on a Neptune Plus multi-collector–inductively coupled plasma–mass spectrometer (MC-ICP-MS) in our laboratory over the past 3 years. The instrumental mass bias was corrected by three independent methods: sample-standard bracketing (SSB), Ni doping?+?SSB, and ⁵⁷Fe–⁵⁸Fe double spike?+?SSB. Measurements reveal that both the Ni doping and double spike methods helped calibrate short-term fluctuations in mass bias. Collectively, almost all measurements of RMs yielded δ⁵⁶Fe within?±?0.05 of recommended values, provided that each sample was measured four times on MC-ICP-MS. For the first time, new recommended values for NIST SRM3126a are reported (δ⁵⁶Fe?=?0.363?±?0.006, 2SE, 95% CI; and δ⁵⁷Fe?=?0.534?±?0.010, 2SE).     

山东某地羟-氟磷灰石的研究

羟-氟磷灰石是介于氟磷灰石与羟磷灰石之间的变种。这次在山东枣庄发现的羟氟-磷灰石产在沙沟杂岩体内的同化混染作用形成的岩石中。本文研究了它的产状、物理化学特征及稀土元素模式等,讨论了它的地质意义。     

The effect of annealing on the luminescence decay-time of synthetic calcite:Mn

Calcite was synthesized by four methods, and the luminescence decay-time was measured for nine samples before and after heating hydrothermally in the temperature range 200–400°C. Decay-time data were collected between room temperature and approximately 15 K. The decay time at room temperature is approximately 50 ms, with little difference between a given calcite before and after hydrothermal treatment. The decay time at 15 K is always greater than at room temperature as the effect of thermal quenching diminishes. Differences in decay time before and after heating are more apparent at low temperature owing to this reduction in thermal quenching. The decay time decreased significantly in two samples, and an increase in decay time was observed in the remaining seven samples following heating. Among the latter group, the change in decay time was insignificant in three samples. The results are compared with previous data in which it was shown that the effect of heating is to increase the intensity of luminescence.     

水溶液中草酸漂白高岭土细尾矿的研究

研究了用草酸在不同溶液中漂白高土细尾矿的反应动力学。考察了ＰＨ值,温度、浸出液初始浓度等因素对反应的影响。结果表明,ＰＨ值的降低、反应温度和浸出液浓度的提高有利于高岭土中氧化铁的浸出,该反应是草酸根与铁的摩尔比为３：１的络合反应,在草酸溶液中铁的溶出符合一级反应动力学。     

Flow Characteristics of Cemented Paste Backfill

Cemented paste backfill (CPB) is primarily used for backfilling underground voids at George Fisher Mine (Mount Isa, Australia). The objective of this paper is to summarise the geotechnical characterisation of the tailings and the rheological properties of the CPB as determined from a laboratory testing program undertaken at James Cook University. Two binders were examined [a General Purpose cement and a slag blend cement] over a range of dosages from 0 to 6% and CPB mix solids content in the range of 72–78%. The slump tests were carried out using the standard cone (ASTM C 143) used for concrete and a cylinder with 110 mm (diameter) × 110 mm (height), whereas the yield stress was measured using a shear vane (Brookfield vane spindle V-73). The index characteristics of the tailings including the grain size distribution, liquid limit, plastic limit, specific gravity were determined as per ASTM standards. This paper will then discuss the interrelationships among the solid content, slump, saturated density and the yield stress of the CPB. It is shown that there is strong correlation between the two different slump test devices used in this study. The smaller cylindrical device appears to have good potential for slurries like mine tailings or dredged mud that have high water content for slump test. There is also strong inter-relationship among solid content, slump, yield stress, and bulk density. Increasing the solid content increases the bulk density and yield stress, but reduces the slump. While there is hardly any difference between the two binder types used in this study in terms of flow parameters, namely the yield stress and slump, the binder dosage has an effect. At any specific solid content, higher binder dosages lead to a drop in the slump and increase in the yield stress. The difference is more pronounced in dense slurries. It is also strongly believed that the trends and relationships developed in this study may be valuable for the other mining operations using CPB.     

The early Miocene (~25 Ma) volcanism in the northern Kyushu-Palau Ridge,enriched mantle source injection during rifting prior to the Shikoku backarc basin opening

The northern Kyushu-Palau Ridge (KPR), remnant conjugate arc of the Izu-Ogasawara (Bonin)-Mariana (IBM) active arc, is dominated by basalt-andesite except for the Komahashi-Daini Seamount where acidic plutonic rocks of 38 Ma were recovered. These mafic to intermediate volcanics are produced by the rifting volcanism in the proto-IBM arc associated with spreading of the Shikoku Basin. The HFSE and HREE contents and ratios of these volcanics indicate enriched source mantle composition compared to recent volcanic front. The LILE ratios exhibit similar characteristics to reararc volcanism of the recent Izu arc, and some enriched volcanics exhibit high abundance of sediment melt inputs. Based on these observations and compilations of the published data set, the replacement event of the wedge mantle under the IBM arc occurred two times. The first event occurred between 45 and 38 Ma, with Pacific type mantle being replaced by depleted Indian type mantle. The second event occurred between 36 and 25 Ma, enriched mantle flowed from reararc side. The slab component during the proto-IBM arc rifting was a similar characteristic to recent reararc volcanism of the Izu arc, and sediment melt added in a local area.     

Mineralogy and chemical composition of the clay fraction of Neogene shales from the Surma Group in the Bengal basin,Bangladesh

Mineralogical and chemical investigations (<2μm clay separates) of shale samples from the Neogene-age Surma Group obtained from four wells (Habiganj-11, Shahbazpur-1, Titas-11, Titas-15) in the Bengal basin, Bangladesh, were carried out in order to reveal the clay mineral composition as reservoir exploration and exploitation requires a good understanding of the clay minerals. The samples were analyzed by X-ray diffraction (XRD), scanning electron microscope (SEM) and X-Ray fluorescence spectrometry (XRF). Mineralogically, the sub-surface Surma Group shales comprise predominantly quartz, plagioclase, illite, chlorite, kaolinite, with lesser amounts of K-feldspar, dolomite and smectite, and minor to trace amounts of calcite, siderite and pyrite. The chemical composition of the <2 μm clay separates also suggests an illite and chlorite-rich composition. With increasing burial depth, the Surma Group shales are enriched in illite. The gradual decreasing of the smectite clays with depth and ultimate disappearance at greater depths (≥ 3000 m) may have been responsible for the presence of the diagenetic illite. Based on the mineralogical composition it is most likely that the illite-chlorite associations together with quartz and feldspar were predominantly detrital in origin and thus reflect the presence of a rapidly-rising source terrain not subjected to intense weathering.     

Citizens as sensors: the world of volunteered geography

In recent months there has been an explosion of interest in using the Web to create, assemble, and disseminate geographic information provided voluntarily by individuals. Sites such as Wikimapia and OpenStreetMap are empowering citizens to create a global patchwork of geographic information, while Google Earth and other virtual globes are encouraging volunteers to develop interesting applications using their own data. I review this phenomenon, and examine associated issues: what drives people to do this, how accurate are the results, will they threaten individual privacy, and how can they augment more conventional sources? I compare this new phenomenon to more traditional citizen science and the role of the amateur in geographic observation.     

湘黔地区震旦纪菌藻硅质岩特征及形成机理探讨

湘黔地区震旦纪菌藻硅质岩化学成分纯净,硅质矿物含量95%以上,几乎都为泥晶—微晶石英,石英结晶度平均为6.35。岩石具菌藻生物结构,以纹层状构造为主。其中丰富的菌藻生物化石,按形态可划分为三种类型。岩石属原生沉积成因,二氧化硅的聚沉一方面通过菌藻有机体的硅化作用,另一方面是菌藻生物化学作用引起微环境变化而导致二氧化硅的聚沉。     

Chromium speciation in oxide-type compounds: application to minerals,gems, aqueous solutions and silicate glasses

Cr K-edge XANES spectra were obtained for a variety of Cr-bearing model compounds containing Cr(II), Cr(III), Cr(IV), Cr(V) and Cr(VI), in which the Cr-site symmetry is D4h, Oh and Td. The centroid position of the pre-edge feature is a better indicator of the Cr valence than the edge position. In Cr-rich oxides, higher-energy transitions must be excluded in order to refine a robust valence for Cr. The pre-edge for chromates is not unique and varies as a function of the CrO₄ ^2? moiety distortion, which is often related to Cr-polymerization (monochromate vs. dichromate). Both the analogy with the Mn K-pre-edge information and ab initio FEFF calculations of the pre-edge feature for Cr(III) and Cr(VI) confirm the experimental trends. This methodology is applied to the Cr K-edge pre-edge feature collected in gems (emerald, spinel and ruby), the layered minerals fuchsite and kämmererite, two Cr-bearing aqueous solutions and a set of sodo-calcic silicate glasses used for bottling sparkling white wine. In emerald and fuchsite, the Cr-site is differently distorted than its ruby or spinel counterpart. In a Cr(III)-bearing aqueous solution and sodo-calcic glass, no evidence for Cr(III) with Td and C3v symmetry is detected. However, minor amounts of chromate moieties (most likely monomeric) are detected in a glass synthesized in air. Preliminary spectra for the wine bottle glass suggest that only trace amounts of chromates might possibly be present in these glasses.