Dynamics of willow tree (Salix matsudana) water use and its response to environmental factors in the semi-arid Hailiutu River catchment,Northwest China

Sap flow (SF)of a willow tree, meteorological variables, soil water content, and water table depth were measured during the growing period from mid-April to October, 2011 in the semi-arid Hailiutu River catchment, Northwest China. The measurements of SF showed diurnal fluctuations in sunny days and seasonal changes from 1.65 l/h in mid-April to 33 l/h in July. At hourly scale, SF is significantly correlated with net radiation, followed by air temperature, relative humidity, and wind speed. At daily scale, air temperature affects the dynamics of SF significantly. Daily SF correlates positively with net radiation and negatively with relative humidity. There is no correlation observed between daily SF and wind speed. The measurements of SF do not indicate water stress although the experimental period is dry. Correlation analysis shows that SF is strongly correlated with soil moisture and water table depth, indicating the willow tree uses both soil water and groundwater for transpiration.     

Boundary layer and aerosol evolution during the 3rd Lagrangian experiment of ACE‐2

Aircraft measurements are presented of the Lagrangian evolution of a marine boundary layer over a 30‐h period during the ACE‐2 field campaign. At the start of the observational period, a 500‐m deep polluted marine internal boundary layer (MIBL) was overlain by the remnants of a polluted continental boundary layer extending to around 2 km below a clean, dry free troposphere. The MIBL grew rapidly to a thickness of 900–1000 m in response to increasing sea surface temperatures. No significant aerosol spectral evolution was observed in the boundary layer. Low concentrations of SO₂ were observed in the MIBL suggesting that the air mass contained relatively aged aerosol. Aerosol spectra show a broad mode with a modal diameter of around 0.1μm. The polluted layer between the MIBL and the unpolluted free troposphere was only weakly and intermittently turbulent which prevented significant entrainment of clean air into the polluted layer from aloft. The polluted layer depth was thus controlled mainly by subsidence which as a result becomes shallower, decreasing from over 2000 m to around 1200 m during the observational period. The aerosol characteristics of the polluted layer were similar to those in the MIBL and so although the MIBL entrained considerable amounts of air from above the MIBL the aerosol characteristics underwent no significant change. This has important implications for the rate at which a polluted continental air mass is converted to a clean marine one. The dataset should prove useful in the validation of the modelling of continental pollution outbreaks.     

The FORS Deep Field: the photometric catalog

The FORS Deep Field project is a multi-colour, multi-object spectroscopical investigation of a ∼ 7′ × ′' region near the south galactic pole based mostly on observations carried out with the FORS instruments attached to the VLT telescopes. It includes the QSO Q 0103-260 (z = 3.36). The goal of this study is to improve our understanding of the formation and evolution of galaxies in the young Universe. In this contribution, the photometric observations are presented. In particular, a combined B and I selected UBgRIJKs photometric catalog of 8753 objects in the FDF is presented and its content is briefly described. The formal 50% completeness limits for point sources, derived from the coadded images, are 25.64, 27.69, 26.86, 26.68, 26.37, 23.60 and 21.57in U, B, g, R, I, J and Ks, respectively. This revised version was published online in August 2006 with corrections to the Cover Date.     

Experimental evidence of fast groundwater responses in a hillslope/floodplain area in the Black Forest Mountains,Germany

Analysis of water flow pathways from hillslopes to streams is essential for the optimal protection of water resources as well as for ecohydrological studies. This study addresses runoff generation processes at a hillslope and near‐stream shallow groundwater system in the Black Forest Mountains, southwestern Germany. The changing spatial and temporal flow patterns during differing hydrological situations were examined using a combined hydraulic and hydrochemical approach. Groundwater levels at 10 wells, discharge at a near‐stream saturated area, and several natural tracers (deuterium, dissolved silica, and major anions and cations) were observed at different locations during high and low flows. The importance of the groundwater component during flood formation was clearly demonstrated: its contribution was about 80% during a double peak flood event at the saturated area. In addition, a rapid change of the shallow groundwater levels was observed along two transects of groundwater wells in the floodplain. This led to an enhanced groundwater discharge into the saturated area located at the end of one study transect. The amount of groundwater additionally activated during the event was about 30% of total discharge recorded at the outlet of the saturated area. Two alternative hypotheses are discussed to explain this phenomenon: the establishment of locally confined conditions and the development of a pressure wave (hypothesis A), or the significant change of the three‐dimensional groundwater flow lines that caused a large increase of the groundwater catchment at the saturated area during the investigated event (hypothesis B). Even if the exact flow paths and mechanisms could not be clearly identified, the importance of rapid responding hillslope groundwater was undoubtedly demonstrated by a combination of tracer and hydrometric methods. Copyright © 2004 John Wiley & Sons, Ltd.     

Marine ice-rafted debris records constrain maximum extent of Saalian and Weichselian ice-sheets along the northern Eurasian margin

Ice-rafted debris (IRD) (>2 mm), input in eight sediment cores along the Eurasian continental margin (Arctic Ocean), have been studied over the last two glacial/interglacial cycles. Together with the revised chronologies and new micropaleontological data of two cores from the northern Barents Sea (PS2138) and northeastern Kara Sea (PS2741) spanning Marine Isotope Stages (MIS) 6 to 1, the IRD data give new insights into the glacial history of northern Eurasian ice-sheets over the last 150 ka. The chronologies of the cores are based on stable isotope records, AMS ¹⁴C datings, paleomagnetic and biostratigraphic data.Extensive episodes of northern Barents Sea ice-sheet growth, probably to the shelf edge, occurred during the late Weichselian (MIS 2) and the Saalian (MIS 6). Major IRD discharge at the MIS 4/3-transition hints to another severe glaciation, probably onto the outer shelf, during MIS 4. IRD-based instabilities of the marine-based ice margin along the northern Barents Sea between MIS 4 and 2 are similar in timing with North Atlantic Heinrich events and Nordic Seas IRD events, suggesting similar atmospheric cooling over a broad region or linkage of ice-sheet fluctuations through small sea-level events.In the relatively low-precipitation areas of eastern Eurasia, IRD peak values during Termination II and MIS 4/3-transition suggest a Kara Sea ice-sheet advance onto the outer shelf, probably to the shelf edge, during glacial MIS 6 and 4. This suggests that during the initial cooling following the interglacials MIS 5, and possibly MIS 7, the combined effect of sustained inflow of Atlantic water into the Arctic Ocean and penetration of moisture-bearing cyclones into easterly direction supported major ice build-up during Saalian (MIS 6) and Mid-Weichselian (MIS 4) glaciation. IRD peak values in MIS 5 indicate at least two advances of the Severnaya Semlya ice-sheet to the coast line during the Early Weichselian. In contrast, a distinct Kara Sea ice advance during the Late Weichselian (MIS 2) is not documented by the IRD records along the northeastern Kara Sea margin.     

The geography of global urban greenhouse gas emissions: an exploratory analysis

The purpose of this paper is to describe global urban greenhouse gas emissions by region and sector, examine the distribution of emissions through the urban-to-rural gradient, and identify covariates of emission levels for our baseline year, 2000. We use multiple existing spatial databases to identify urban extent, greenhouse gas emissions (CO₂, N₂O, CH₄ and SF₆) and covariates of emissions in a “top-down” analysis. The results indicate that urban activities are significant sources of total greenhouse gas emissions (36.8 and 48.6 % of total). The urban energy sector accounts for between 41.5 and 66.3 % of total energy emissions. Significant differences exist in the urban share of greenhouse gas emissions between developed and developing countries as well as among source sectors for geographic regions. The 50 largest urban emitting areas account for 38.8 % of all urban greenhouse gas emissions. We find that greenhouse gas emissions are significantly associated with population size, density, growth rates, and per capita income. Finally, comparison of our results to “bottom-up” estimates suggest that this research’s data and techniques are best used at the regional and global scales.     

A generalized zero-lag cross-correlation approach for Rapid Earthquake Localization (REL): the example of the Istanbul Megacity Rapid Response System

A seismic antenna approach based on the generalized zero-lag cross-correlation method for rapid earthquake localization is proposed. This method is intended to be applied primarily for early warning, whenever the epicentre-to-target distances guarantee enough lead-time, rapid response purposes, and for those circumstances when a seismogenic area is not directly accessible with seismic stations or/and a network of instruments is concentrated within the area to be warned. The procedure we propose aims to provide useful information for magnitude determination and shake-maps generation. Indeed, it relies only on the first P-wave triggered arrivals from seismic stations, and is designed to work in real-time for the localization of events occurring outside of the network, that is, under conditions that might be detrimental to standard localization approaches. The procedure can by summarized by a few preliminary pre-seismic and real-time co-seismic steps. In the pre-seismic time-frame, for the cases where a large and dense network exists, waiting for all stations to trigger could dramatically reduce the available lead-time for the warning. Therefore, in such cases, the network could profitably be divided into sub-arrays, while also taking advantage of available earthquake recordings or simulated data sets. During the co-seismic time-frame, the main operations are: (1) individual on-site triggering by the P-wave of the seismic stations (e.g. by a STA/LTA algorithm); (2) real-time communication of key parameters (e.g. P-wave arrival time, and signal quality) to a main centre by SMS/WLAN; (3) setup of a pseudo data set, composed by a Gaussian function centred at the P-time, and with a bell width that can be set up proportional to the trigger signal-to-noise ratio (SNR); (4) calculation of a coherency map for the sub-array with triggered stations (preliminary sub-array location); and (5) stacking of coherency maps from the different sub-arrays (final location). By the stack of coherency maps estimated by the different sub-arrays in the last step of the procedure, the epicentral area’s location may be better constrained. This innovative approach for rapid localization was applied to both synthetic data, and real observations of two small earthquakes that occurred in the Marmara Sea, Turkey, which were recorded by the Istanbul Earthquake Rapid Response System.     

Improved dynamic testing by impedance control

In this paper, the issue of actuator-structure interaction in dynamic testing of structures is considered. The problem is approached from the novel standpoint of impedance control. It is shown that an effective strategy to design controls for dynamic testing is by designing the test system impedance. It is also shown that this can be achieved using feedforward compensation. The analysis is carried out in the context of displacement controlled dynamic testing, when the tested structure has a high and nonlinear stiffness. It is demonstrated that stable and accurate dynamic testing can be achieved using the proposed strategy, when this is not possible using traditional feedback control techniques. Furthermore, the impedance control and feedforward strategies are applied in the context of hybrid simulation, a technique of coupling computational and physical substructures applied in earthquake engineering. Here, a delay compensation scheme is necessary in addition to feedforward. Experimental results are presented that demonstrate both improved dynamic testing performance when impedance control is employed, and its applicability in hybrid simulation.