The 1-Centimeter Orbit: Jason-1 Precision Orbit Determination Using GPS, SLR, DORIS, and Altimeter Data

The Jason-1 radar altimeter satellite, launched on December 7, 2001 is the follow on to the highly successful TOPEX/Poseidon (T/P) mission and will continue the time series of centimeter level ocean topography measurements. Orbit error is a major component in the overall error budget of all altimeter satellite missions. Jason-1 is no exception and has set a 1-cm radial orbit accuracy goal, which represents a factor of two improvement over what is currently being achieved for T/P. The challenge to precision orbit determination (POD) is both achieving the 1-cm radial orbit accuracy and evaluating the performance of the 1-cm orbit. There is reason to hope such an improvement is possible. The early years of T/P showed that GPS tracking data collected by an on-board receiver holds great promise for precise orbit determination. In the years following the T/P launch there have been several enhancements to GPS, improving its POD capability. In addition, Jason-1 carries aboard an enhanced GPS receiver and significantly improved SLR and DORIS tracking systems along with the altimeter itself. In this article we demonstrate the 1-cm radial orbit accuracy goal has been achieved using GPS data alone in a reduced dynamic solution. It is also shown that adding SLR data to the GPS-based solutions improves the orbits even further. In order to assess the performance of these orbits it is necessary to process all of the available tracking data (GPS, SLR, DORIS, and altimeter crossover differences) as either dependent or independent of the orbit solutions. It was also necessary to compute orbit solutions using various combinations of the four available tracking data in order to independently assess the orbit performance. Towards this end, we have greatly improved orbits determined solely from SLR+DORIS data by applying the reduced dynamic solution strategy. In addition, we have computed reduced dynamic orbits based on SLR, DORIS, and crossover data that are a significant improvement over the SLR- and DORIS-based dynamic solutions. These solutions provide the best performing orbits for independent validation of the GPS-based reduced dynamic orbits. The application of the 1-cm orbit will significantly improve the resolution of the altimeter measurement, making possible further strides in radar altimeter remote sensing.     

Preliminary results about the stability of an intermediate water current

Experiments were run on a 14 m diameter rotating platform to study the stability conditions for a constant volume flow rate current of intermediate water. The flow was introduced in a two-layer system initially at rest in solid body rotation, along the sidewall of the tank, and allowed freely to evolve. A sink collected the intermediate water and thus ensured that the free surface height was constant. Thus the upstream conditions were the rotation rate, the volume flow rate, the density and the initial width of the intermediate current, which was in geostrophic equilibrium when it left the source; i.e. its thickness along the wall at the source was fixed by this condition. The relevant parameters appear to be the Ekman and the Burger numbers. The data collected from the experiments are very consistent, and it appears that there were five typical flow regimes: (1) a stable current along the whole basin; (2) a series of cyclonic vortices attached to the outer edge of the current, with an upstream stable current; (3) a large cyclonic vortex attached to an anticyclonic instability; (4) dipoles shed from the current into the interior fluid; and (5) generation of lenses of intermediate water, similar to meddies. This last result shows that no topographical effect is required to generate such long-lived lenses, which then drift slowly upstream as the dipoles do.     

Comparison of wind and wave measurements and models in the Western Mediterranean Sea

We have hindcast the wind and wave conditions in the Mediterranean Sea for two one month periods. Four different meteorological models and three different wave models have been used. The results have been compared with satellite and buoy wind and wave observations.Several conclusions concerning both the instruments and the models have been derived. The quality of both wind and wave results has been assessed. Close to the coasts high resolution, nested wave models are required for sufficient reliability.A wave threshold analysis suggests a sufficient reliability only off the coast, with a substantial decrease for low wave heights.     

0422−476: a shell galaxy with azimuthally distributed shells

A morphological and two-colour charge-coupled device photometry study of the shell galaxy 0422−476, one of the richest known azimuthally distributed shell galaxies, is presented. Taking this galaxy as a prototype, a general method for reducing observational data of these objects is defined and quantitative parameters for use in further theoretical studies are derived.
According to some recent models (e.g. that of Thomson and Wright in 1990), the shells in such a galaxy could be density waves induced in a thick disc population of dynamically cold stars by a weak interaction with another galaxy. In 0422−476 there is no evidence of either a conventional exponential disc or a thick disc. Although it is not possible to rule out the weak interaction model, the observations continue to favour the merger model (e.g. that of Quinn from 1984).     

Dispersion Statistics and Sample Size Estimates for Three Fish Species (Symphodus ocellatus,Serranus scriba and Diplodus annularis) in the Lavezzi Islands Marine Reserve (South Corsica,Mediterranean Sea)

For the correct management of the future International Marine Park of Bonifacio, a sampling strategy must be adopted to follow the population fluctuations of certain species of fish. This sampling will be carried out by SCUBA visual census using the fixed point method. The information to be gleaned using this method will include estimates of biomass. These data will subsequently be used to perform both spatial comparisons between sites and temporal comparisons over periods of several years. In order to reveal the existence of statistically significant differences, the sampling strategy adopted must allow accurate means to be obtained which possess relatively low coefficients of variability. The calculation of this optimum sampling depends on the spatial distribution of the species examined. The Taylor law (s² = a ×x ^b), which represents a much utilized mean-variance relationship, will be used to compare the aggregation of three species of fish (Symphodus ocellatus,Serranus scriba and Diplodus annularis) on two different substrate types (Posidonia oceanica meadows and rocks) and for four sites in the Lavezzi Islands. The goodness of fit of this law to the biomass data will allow an optimum sampling strategy to be determined for each species with coefficients of variability of 10 and 25%.     

A SEM-based method to determine the mineralogical composition and the particle size distribution of suspended sediment

A robust method for characterizing the mineralogy of suspended sediment in continental rivers is introduced. It encompasses 3 steps: the filtration of a few milliliters of water, measurements of X-ray energy dispersive spectra using Scanning Electron Microscopy (SEM), and robust machine learning tools of classification. The method is applied to suspended particles collected from various Amazonian rivers. A total of more than 204,000 particles were analyzed by SEM-EDXS (Energy Dispersive X-ray Spectroscopy), i.e. about 15,700 particles per sampling station, which lead to the identification of 15 distinct groups of mineralogical phases. The size distribution of particles collected on the filters was derived from the SEM micrographs taken in the backscattered electron imaging mode and analyzed with ImageJ freeware. The determination of the main mineralogical groups composing the bulk sediment associated with physical parameters such as particle size distribution or aspect ratio allows a precise characterization of the load of the terrigenous particles in rivers or lakes. In the case of the Amazonian rivers investigated, the results show that the identified mineralogies are consistent with previous studies as well as between the different samples collected. The method enabled the evolution of grain size distribution from fine to coarse material to be described in the water column. Implications about hydrodynamic sorting of mineral particles in the water column are also briefly discussed. The proposed method appears well suited for intensive routine monitoring of suspended sediment in river systems.     

Integrated Hydrological Modeling of Climate Change Impacts in a Snow-Influenced Catchment

The potential impact of climate change on water resources has been intensively studied for different regions and climates across the world. In regions where winter processes such as snowfall and melting play a significant role, anticipated changes in temperature might significantly affect hydrological systems. To address this impact, modifications have been made to the fully integrated surface-subsurface flow model HydroGeoSphere (HGS) to allow the simulation of snow accumulation and melting. The modified HGS model was used to assess the potential impact of climate change on surface and subsurface flow in the Saint-Charles River catchment, Quebec (Canada) for the period 2070 to 2100. The model was first developed and calibrated to reproduce observed streamflow and hydraulic heads for current climate conditions. The calibrated model was then used with three different climate scenarios to simulate surface flow and groundwater dynamics for the 2070 to 2100 period. Winter stream discharges are predicted to increase by about 80, 120, and 150% for the three scenarios due to warmer winters, leading to more liquid precipitation and more snowmelt. Conversely, the summer stream discharges are predicted to fall by about 10, 15, and 20% due to an increase in evapotranspiration. However, the annual mean stream discharge should remain stable (±0.1 m³/s). The predicted increase in hydraulic heads in winter may reach 15 m and the maximum decrease in summer may reach 3 m. Simulations show that winter processes play a key role in the seasonal modifications anticipated for surface and subsurface flow dynamics.     

Quantifying FES2004 S<Subscript>2</Subscript> tidal model from multiple space-geodesy techniques,GPS and GRACE,over North West Australia

Unmodeled sub-daily ocean S₂ tide signals that alias into lower frequencies have been detected in the analysis of gravity recovery and climate experiment (GRACE) space gravity fields of GRGS. The most significant global S₂ aliased signal occurs off the northwest coast of Australia in a shallow continental shelf zone, a region with high tidal amplitudes at a period of 161 days. The GRACE S₂ aliased equivalent water height grids are convolved with Green’s functions to produce GRACE aliased tidal loading (GATL) vertical displacements. The analysis of hourly global positioning system (GPS) vertical coordinate estimates at permanent sites in the region confirms the presence of spectral power at the S₂ frequency when the same ocean tide model (FES2004) was used. Thus, deficiencies in the FES2004 ocean tide model are detected both directly and indirectly by the two independent space geodetic techniques. Through simulation, the admittance (ratio of amplitude of spurious long-wavelength output signal in the GRACE time-series to amplitude of unmodeled periodic signals) of the GRACE unmodeled S₂ tidal signals, aliased to a 161-day period, is found to have a global average close to 100%, although with substantial spatial variation. Comparing GATL with unmodeled S₂ tidal sub-daily signals in the vertical GPS time-series in the region of Broome in NW Australia suggests an admittance of 110–130%.