Identification of aquifer-recharge zones and sources in an urban development area (Delhi, India), by correlating isotopic tracers with hydrological features

Recharge zones and sources in an urban setup (NCT of Delhi, India) were identified using environmental isotopes (²H, ³H, ¹⁸O); they were then correlated with hydrogeological conditions. The isotopic results showed that groundwater is being recharged by surface water during the dry season, while recharge associated with local precipitation becomes prominent during the monsoon. The effect of source-water evaporation and altitude on the isotopic characteristics of groundwater was clearly noted. A gradual increase in groundwater age, i.e. decrease in tritium content, while moving away from the river/canals/drains, suggests a degree of mixing of old-aged groundwater with relatively young recharging water. Further, to substantiate the findings of isotopic investigations, surface recharge conditions were differentiated into potential pervious (recharge prone) and impervious (recharge resistant) surfaces through mapping of potential recharge areas based on soil type and water-table depth, to depict a three-dimensional illustration of hydrogeologically mediated recharge zones of the area. The hydrogeological evidence thus obtained about the spatial distribution of permeable zones, slope and boundary conditions, aptly substantiates the isotopic findings. The study seeks its impact by correlation of the isotopic findings with the regional groundwater flow regime which has been altered by the urban development.     

A study of arsenic,iron and other dissolved ion variations in the groundwater of Bishnupur District,Manipur, India

The presence of arsenic (As) in groundwater and its effect on human health has become an issue of serious concern in recent years. The present study assessed the groundwater quality of the Bishnupur District, Manipur, with respect to drinking water standards. Higher concentrations of pH, iron and phosphate were observed at several locations. Phosphate and iron levels were highest in the pre-monsoon, followed by monsoon and post-monsoon seasons. The arsenic concentrations were highest during post-monsoon (1–200 μg L⁻¹) as compared to pre-monsoon (1–108 μg L⁻¹) and monsoon (2–99 μg L⁻¹). Kwakta and Ngakhalawai show higher levels of arsenic concentration as compared to the prescribed World Health Organization (WHO) and Bureau of Indian Standards (BIS) norms. Arsenic showed a strong positive correlation with phosphate and negative correlation with sulphate, suggesting a partial influence of anthropogenic sources. The study suggests that the Bishnupur area has an arsenic contamination problem, which is expected to increase in the near future.     

Geophysical Finite-Element Simulation Tool (GeoFEST): Algorithms and Validation for Quasistatic Regional Faulted Crust Problems

GeoFEST (Geophysical Finite Element Simulation Tool) is a two- and three-dimensional finite element software package for the modeling of solid stress and strain in geophysical and other continuum domain applications. It is one of the featured high-performance applications of the NASA QuakeSim project. The program is targeted to be compiled and run on UNIX systems, and is running on diverse systems including sequential and message-passing parallel systems. Solution to the elliptical partial differential equations is obtained by finite element basis sampling, resulting in a sparse linear system primarily solved by conjugate gradient iteration to a tolerance level; on sequential systems a Crout factorization for the direct inversion of the linear system is also supported. The physics models supported include isotropic linear elasticity and both Newtonian and power-law viscoelasticity, via implicit quasi-static time stepping. In addition to triangular, quadrilateral, tetrahedral and hexahedral continuum elements, GeoFEST supports split-node faulting, body forces, and surface tractions. This software and related mesh refinement strategies have been validated on a variety of test cases with rigorous comparison to analytical solutions. These include a box-shaped domain with imposed motion on one surface, a pair of strike slip faults in stepover arrangement, and two community-agreed benchmark cases: a strike slip fault in an enclosing box, and a quarter-domain circular fault problem. Scientific applications of the code include the modeling of static and transient co- and post-seismic earth deformation, Earth response to glacial, atmospheric and hydrological loading, and other scenarios involving the bulk deformation of geologic media.     

Dynamic characteristics and horizontal transports of internal solitons generated at the Columbia River plume front

River plume front-generated internal solitons play an important role in the interaction between the plume and coastal waters. The internal solitons drive a non-harmonic velocity field, resulting in a horizontal transport that carries plume water seaward and redistributes nutrients and sediments. In this study, we present observations of internal solitons generated at the Columbia River plume front that separates the new, tidal plume, older plume and coastal waters. Scale analyses suggest that the plume front-generated internal solitons are highly non-linear waves, and their dynamic properties do not conform to any weakly non-linear theory. Thus, a high-order Korteweg–de Vries (KdV) theory is used to analyze the internal solitons. The comparison between theoretical values and cruise data shows that the high-order KdV model is much better than the weakly non-linear theories for prediction of the soliton dynamic parameters. Based on the model, we develop theoretical and numerical solutions of the soliton-induced upper layer horizontal transport and Lagrangian water parcel transport distance, which shows that the water particle drift, during the internal soliton passage, is as far as 1 km, and demonstrates the role of the internal solitons on the exchange between the plume and ambient coastal water. Energy fluxes caused by the internal solitons are estimated using the high-order KdV theory. The leading soliton fluxes 2.0×10³ W m⁻¹ per unit crest length, and carries energy of 4.2×10⁵ J m⁻¹. The total energy carried by the eight internal solitons is 1.6×10⁶ J m⁻¹, about 70% of the total frontal energy.     

Geochemistry,chronology and stratigraphy of Neogene tuffs of the Central Andean region

Tuff layers are vital stratigraphic tools that allow correlations to be made between widely dispersed exposures. Despite their widespread occurrence in the central Andes, tuffs from both natural exposures and sedimentary cores extracted from the region's extensive salars (salt pans) are relatively unstudied. Here we lay the foundation for a tephrostratigraphic framework in the central Andes (14–28°S) by chemically and morphologically characterizing ash shards, and in some cases dating 36 Neogene distal tuffs. These tuffs occur in lacustrine and alluvial deposits from the southern Bolivian Altiplano and adjacent Atacama Desert. All tuffs are calc-akaline rhyolites, consistent with their setting in the Central Andean Volcanic Zone. Five of the older tuffs were ⁴⁰Ar/³⁹Ar dated and yield an age range of 6.63–0.75 Ma. Organic material associated with tuffs deposited into paleolake sediments, paleowetland deposits, or urine-encrusted rodent middens provide constraints on the age of several Late Pleistocene and Holocene tuffs.These tuffs provide key stratigraphic markers and ages for lake cycles and archeological sites on the Bolivian Altiplano and for assessing rates of surficial processes and archeology in both the Atacama and Altiplano. While modern climate, and consequently questions about geomorphic processes and climate change, differs in the hyperarid Atacama and the semi-arid Altiplano, the most extensive air-fall tuffs covered both regions, placing the Atacama and the Bolivian Altiplano in the same tephrostratigraphic province. For example, the Escara B tuff (～1.85 Ma), can be securely identified in both the Altiplano and Atacama. On the Altiplano, dates from the Escara B and E tuffs securely establish the age of the Escara Formation—representing the oldest expansive lake documented on the Bolivian Altiplano. By contrast, the presence of the Escara B tuff below ～6 m of alluvial sediment at the Blanco Encalado site in the Atacama desert yields information about sedimentation rates in this hyperarid region. Indeed, most tuffs from the Atacama Desert are older than 600,000 years, even though they occur within fluvial terraces immediately adjacent to the alluvial fans that are still active. Most of these geomorphic surfaces in the Atacama also possess well-developed saline soils that, when combined with the radiometric ages of the distal tuffs, suggest slow rates of geomorphic change and exceptional landscape stability for this area during the Quaternary.In contrast, younger tuffs are more abundant in the more recent lake records of the Altiplano. The Chita tuff was deposited at ～15,650 cal yr B.P., during the regressive phase of the region's deepest late Quaternary lake cycle—the “Tauca lake cycle”—which spanned 18.1–14.1 cal yr B.P. Two Holocene tuffs, the Sajsi tuff and the Cruzani Cocha tuff, are widespread. The Sajsi tuff was deposited just before 1700 cal yr B.P., whereas the Cruzani Cocha tuff appears to be mid-Holocene in age and shows some chemical affinities to a Holocene tuff (202B) deposited between 4420 and 5460 cal yr B.P. in a urine-encased rodent midden in the Atacama Desert.     

Effects of soil layering on the characteristics of basin-edge induced surface waves

This paper presents the effects of soil layering on the characteristics of basin-edge induced surface waves and associated strain and aggravation factor. The simulated results revealed surface wave generation near the basin-edge. The first mode of induced Love wave was obtained in models having increasing velocity with depth and a large impedance contrast between the soil layers. Amplitude amplification or de-amplification of body waves was proportional to the impedance contrast between the soil layers. The average aggravation factor was inversely proportional to the impedance contrast between the soil layers in case of increasingvelocity models and proportional in case of decreasing-velocity basinedge models. On the other hand, the maximum strain was inversely proportional to the impedance contrast between the soil layers in both cases. On the average, strain was greater in case of increasing-velocity models but the average aggravation factor was greater in case of decreasingvelocity models.     

Degradation of wetlands on the Qinghai-Tibet Plateau: A comparison of the effectiveness of three indicators

The Qinghai-Tibet Plateau encompasses a large quantity of wetlands, some of which have been degraded to varying severity levels. In the literature, a number of degradation indicators have been proposed to evaluate ecological health of wetlands, but their effectiveness in the plateau environment remains unknown. In this study, we assessed the effectiveness of three degradation indicators, soil moisture content at 10 cm deep, vegetative cover, and density of pika burrows. The degradation severity of wetlands in Maduo County on the Qinghai-Tibet Plateau is enumerated at four levels, intact, slight, moderate and severe. Analysis of 106 samples collected in the field demonstrates that the density of pika burrows is the least reliable indicator. By comparison, vegetative cover and underlying soil moisture content are more reliable, even though neither is a perfect indicator as the difference among adjacent levels of severity as revealed by t-test is not always statistically significant. The imperfection of vegetative cover as an indicator is due to its variation among different types of wetlands. The limitation of moisture content is attributed to its non-linear relationship with wetland degradation. Above the threshold of about 50% in moisture content wetlands are unlikely to be degraded. It is recommended that moisture be measured at the point near the surface and vegetative cover be further differentiated by species in order to improve their effectiveness.     

Lacustrine basin hydrocarbon exploration – current thoughts

Although much of the world's petroleum resource-base is associated with marine systems, regionally lacustrine petroleum systems are important. Individual accumulations may exceed several billion barrels. In each of these cases the oil is derived from a lacustrine source rock and may be produced from either nonmarine or marine reservoir rocks. The purpose of this paper is to describe the factors that control lacustrine source rock development and the nature of lacustrine reservoirs. Lacustrine oils display different physical and chemical characteristics than their marine counterparts. These differences can be related to the nature of their precursor material. Although the nature of the products are different, the geochemical threshold criteria for defining source rocks in both settings are the same because of common expulsion requirements. Commercially significant lacustrine systems require the presence of large, long-lived lakes. Such lake settings are tectonic in origin and restricted to climatic settings where precipitation exceeds evaporation. Within these large lake systems three primary factors determine source rock potential and quality. These factors are primary productivity level, organic preservation potential, and matrix sedimentation rate, which controls the dilution of preserved organic matter. Source rock potential is maximized where both productivity and preservation potential are maximized and sedimentation rate is minimized. To some degree these factors can compensate for each other. Hydrocarbon reservoir potential within lacustrine basins is partially impacted by overall tectonic setting. Within extensional settings, transport distances tend to be limited, with much of the sediment being transported away from the basin. The sediments delivered to the lake are poorly sorted and sedimentologically immature, commonly resulting in poor reservoirs due to both primary properties and their susceptibility to diagenesis. Within rifts better reservoirs tend to develop along platform or flexural margins. Stacking of reservoirs is important in lacustrine systems but baffles and barriers are often present between individual sand units. These barriers form as a result of lake level fluctuations. In compressional settings transport distances tend to be longer, resulting in more mature, better sorted sediments leading to higher quality reservoirs. These reservoirs typically develop in fluvial-deltaic and wave-dominated shoreline settings. Lacustrine carbonate reservoirs are locally important. These carbonates tend to develop during lake level lowstands and are dependent on diagenesis (dissolution and karstification) for porosity and permeability development. Lacustrine reservoirs are often stratigraphically and areally limited and display low individual well production rates. Within pure lacustrine systems exploration opportunities appear to be often restricted by either reservoir presence or quality (i.e., production rates). The best exploration opportunities in lacustrine basins appear to be associated with hybrid systems where a lacustrine source and marine reservoir exist.     

东北地区农业结构转型时期土地利用变化的成因与效应

During the last decade of the 20th century, extensive conversion in agricultural land use took place in Northeast China. The goal of this study is to ascertain its spatial distribution and regional differentiation, determine its causes, and analyze its environmental impact, Especially we attempt to elucidate how institutional constraints have facilitated the change at a time of agrarian restructuring when newly emerging free market was hybridized with the former planned economy. Information on six categories of land use was mapped from interpretation of Landsat TM images recorded in 1990,1995 and 2000. Most of land use changes took place during the first half of the decade, coinciding with abrupt and chaotic changes in government directives. Farmland was changed mainly to woodland,water body and built-up areas while woodland and grassland were converted chiefly to farmland.Spatially, the change from farmland to woodland was restricted to the west of the study area. The change from grassland to farmland took place in the grazing and farming interlocked west. These chaotic and occasionally conflicting changes were largely caused by lack of stability and consistency in agricultural land use policies promulgated. They have exerted adverse impacts on the local environment, including land degradation, increased flooding, and modified climate regime.