Onshore and offshore seismic and lithostratigraphic analysis of a deeply incised Quaternary buried valley system in the Northern Netherlands

High-resolution seismic data (onshore and offshore), geophysical borehole data as well as detailed lithofacies from airlift boreholes were acquired in northern Netherlands on and around the island of Ameland. Marine and land seismic data combined with information from land boreholes have been explored with the objective of providing a sedimentary model. Qualitative seismic facies analysis of the valley fill commonly shows a thin unit with high amplitude reflectors at the base. Thick units of variable seismic facies (transparent to high amplitude) occur higher up in the sequence. Onlap is common at mid–upper levels within the sandy valley fill (with clay in mm layering), and a transparent seismic facies, corresponding to firm clays, is common at the top. Almost all lithological unit boundaries recognised within core parameters correspond with seismic unconformities within error margins. Subunits contain multiple cyclical trends in gamma ray and grain size. Cyclical trends show lower order fluctuations in gamma radiation on a scale of less than 1 m. Gamma-ray pattern variability between units, e.g. in general coarsening-up or fining-up units, suggests migration of subaqueous outwash fans or ice margin fluctuations. Seismic results could support a headward excavation and backfilling process suggested by Praeg [Morphology, stratigraphy and genesis of buried Elsterian tunnel valleys in the southern North Sea basin [PhD thesis]: University of Edinburgh, 207 pp.; Journal of Applied Geophysics, (this volume)] as being responsible for the formation of buried valleys. On a lithological scale, a more complicated, detailed and cyclical pattern arises. Catastrophic processes are considered unlikely as being responsible for the infill sequence because of the observed small-scale facies variability and because of the presence of diamicton layers. Diamicton layers at the base of basal unconformities as well as higher in sequence could suggest subglacial deformation by grounded ice before and during the valley-fill process.     

Seismic evidence for deep low-velocity anomalies in the transition zone beneath West Antarctica

We present a three-dimensional (3D) SV-wave velocity model of the upper mantle beneath the Antarctic plate constrained by fundamental and higher mode Rayleigh waves recorded at regional distances. The good agreement between our results and previous surface wave studies in the uppermost 200 km of the mantle confirms that despite strong differences in data processing, modern surface wave tomographic techniques allow to produce consistent velocity models, even at regional scale. At greater depths the higher mode information present in our data set allows us to improve the resolution compared to previous regional surface wave studies in Antarctica that were all restricted to the analysis of the fundamental mode. This paper is therefore mostly devoted to the discussion of the deeper part of the model. Our seismic model displays broad domains of anomalously low seismic velocities in the asthenosphere. Moreover, we show that some of these broad, low-velocity regions can be more deeply rooted. The most remarkable new features of our model are vertical low-velocity structures extending from the asthenosphere down to the transition zone beneath the volcanic region of Marie Byrd Land, West Antarctica and a portion of the Pacific-Antarctic Ridge close to the Balleny Islands hotspot. A deep low-velocity anomaly may also exist beneath the Ross Sea hotspot. These vertical structures cannot be explained by vertical smearing of shallow seismic anomalies and synthetic tests show that they are compatible with a structure narrower than 200 km which would have been horizontally smoothed by the tomographic inversion. These deep low-velocity anomalies may favor the existence of several distinct mantle plumes, instead of a large single one, as the origin of volcanism in and around West Antarctica. These hypothetical deep plumes could feed large regions of low seismic velocities in the asthenosphere.     

Data Assimilation (4D-VAR) for Shallow-Water Flow: The Case of the Chicoutimi River

This is a web presentation of the work presented at the 10th Annual Conference of the CFD Society of Canada, “CFD 2002”, at the University of Windsor on June 9-11, 2002. This discussion paper presents the four-dimensional variational data assimilation (4D-VAR) technique as a tool to forecast floods. This discussion will be limited to hydrological forecast. We assume that the weather, here a large rainstorm, had already been forecasted by the meteorological services. In the 4D-VAR technique, we need to minimize, in the sense of Lagrange, a cost function which measures the difference between the forecast and the observations. The physical equations acts as a set of constraints. Here, the model is the shallow-water equations modified to include sediment transport. The minimum was found by using the steepest descent algorithm. This is made possible because the gradient of the cost function can be calculated analytically by using the adjoint equations of the model. To illustrate the 4D-VAR technique, the bypass of a simple theoretical dam as well as the more complex overflowing of the Chicoutimi River at the Chute-Garneau dam (during the 1996 flood) are investigated.     

Evidence for fullerenes in solid bitumen from pillow lavas of Proterozoic age from Mítov (Bohemian Massif, Czech Republic)

Andesitic pillow lavas containing biogenic, solid bitumen (SB) are a constituent of a Neoproterozoic volcanosedimentary sequence (Teplá-Barrandian unit, Bohemian Massif) in the Mítov area of the Czech Republic. A black shale formation that is crosscut by these andesitic basalts is 565 Ma old. Carbon disulfide extracts of two powdered samples of SB contain 0.2 and 0.3 ppm of C₆₀, respectively, as determined by high-pressure liquid chromatography. The peak assignment based on retention time is fully supported by high-resolution electron ionization mass spectrometry (EI-MS). No C₇₀ was detected, nor was C₆₀ found in two other SB samples from this locality. Other investigated carbonaceous samples from Bohemia (coals and anthracites of Upper Paleozoic age and anthraxolite, graphitoids, and graphite of Upper Proterozoic age) did not contain fullerenes at concentrations above the detection limit of 0.01 ppm. The absence of C₆₀ in these samples was confirmed by EI-MS. The proposed mechanism of fullerene formation involves a primary algal phase, generation of a hydrocarbonaceous mixture in the course of thermal evolution of the sedimentary series, and their high-temperature transformation related to the extrusion of basalt. An important feature for fullerene conservation was the enclosure of fullerenes in SB with a structure similar to glasslike carbon, where the fullerene was protected against oxidation.     

Use of phytoplankton species indicators to track the origin of phytoplankton blooms in Willapa Bay, Washington

We focus on the question of whether high phytoplankton production events observed in a United States Pacific Northwest estuary consist of estuarine species blooms fueled by oceanic nutrient input or reflect offshore oceanic blooms that have advected into the estuary. Our approach is to use certain phytoplankton species as indicators associated with water mass origin, either estuarine or oceanic, to help resolve this question in Willapa Bay, Washington. We used species analysis and primary production data from 10 selected dates in May–September of 1998 and 1999, representing periods of high through low productivity. Out of 108 phytoplankton species identified from Willapa Bay, nine were selected and tested as indicators of oceanic species, six as estuarine, and two as surf zone. Our test results demonstrated the oceanic and estuarine species to be satifactory indicators of source waters. The prevalence of these species indicators in our samples revealed that the highest primary production and the appearance ofPseudo-nitzschia spp. were associated with oceanic intrusions of phytoplankton biomass into Willapa Bay. While the largest blooms were oceanic in origin, numerous medium-sized production events were from either oceanic, surf zone, or estuarine sources, indicating a complex situation.     

Understanding Climatic Impacts, Vulnerabilities, and Adaptation in the United States: Building a Capacity for Assessment

Based on the experience of the U.S. National Assessment, we propose a program of research and analysis to advance capability for assessment of climate impacts, vulnerabilities, and adaptation options. We identify specific priorities for scientific research on the responses of ecological and socioeconomic systems to climate and other stresses; for improvement in the climatic inputs to impact assessments; and for further development of assessment methods to improve their practical utility to decision-makers. Finally, we propose a new institutional model for assessment, based principally on regional efforts that integrate observations, research, data, applications, and assessment on climate and linked environmental-change issues. The proposed program will require effective collaboration between scientists, resource managers, and other stakeholders, all of whose expertise is needed to define and prioritize key regional issues, characterize relevant uncertainties, and assess potential responses. While both scientifically and organizationally challenging, such an integrated program holds the best promise of advancing our capacity to manage resources and the economy adaptively under a changing climate.     

Erosion rates of alpine bedrock summit surfaces deduced from in situ Be and Al

We have measured the concentration of in situ produced cosmogenic ¹⁰Be and ²⁶Al from bare bedrock surfaces on summit flats in four western U.S. mountain ranges. The maximum mean bare-bedrock erosion rate from these alpine environments is 7.6 ± 3.9 m My⁻¹. Individual measurements vary between 2 and 19 m My⁻¹. These erosion rates are similar to previous cosmogenic radionuclide (CRN) erosion rates measured in other environments, except for those from extremely arid regions. This indicates that bare bedrock is not weathered into transportable material more rapidly in alpine environments than in other environments, even though frost weathering should be intense in these areas. Our CRN-deduced point measurements of bedrock erosion are slower than typical basin-averaged denudation rates ( 50 m My⁻¹). If our measured CRN erosion rates are accurate indicators of the rate at which summit flats are lowered by erosion, then relief in the mountain ranges examined here is probably increasing.

We develop a model of outcrop erosion to investigate the magnitude of errors associated with applying the steady-state erosion model to episodically eroding outcrops. Our simulations show that interpreting measurements with the steady-state erosion model can yield erosion rates which are either greater or less than the actual long-term mean erosion rate. While errors resulting from episodic erosion are potentially greater than both measurement and production rate errors for single samples, the mean value of many steady-state erosion rate measurements provides a much better estimate of the long-term erosion rate.     

Detecting lateral resistivity inhomogeneities with the Schlumberger array

A method of detecting lateral resistivity inhomogeneities with a multi-electrode cable for the Schlumberger array is presented. Using such a cable system, two dipole-dipole soundings are gathered in addition to the Schlumberger sounding at each point. Offset differences calculated from the dipole-dipole data give qualitative information about lateral resistivity inhomogeneities. Results from 1D modelling can give quantitative information about the 2D resistivity distribution since the dipole-dipole soundings are made to either side of the Schlumberger sounding point. Examples from two different locations in Norway are shown. At Reinøya, northern Norway, a dipping layer, confirmed by refraction seismic data, was identified. In a sedimentary basin with a contamination plume at Haslemoen, southern Norway, the method has revealed lateral variations in resistivity. In both cases, the Schlumberger soundings could be fitted with a 1D resistivity model.     

Petrogenesis of orthopyroxene- and amphibole-bearing andesites, Mustique, Grenadine Islands, Lesser Antilles Arc: Isotope, trace element and physical constraints

Abstract On the island of Mustique, fresh and propylitized olivine–plagioclase–clinopyroxene basalt, plagioclase–clinopyroxene–orthopyroxene and plagioclase–clinopyroxene–amphibole andesite lavas and minor intrusions are interbedded with Oligocene pyroclastic and epiclastic rocks. Chemical data show that two isotopically identical, but chemically different, suites of lava are present: (i) the OPXS (⁸⁷Sr/⁸⁶Sr 0.70403–0.70454; ¹⁴³Nd/¹⁴⁴Nd 0.512952–0.512986; δ¹⁸O_cpx 5.49 and 5.61), comprising basalts and orthopyroxene‐bearing andesites; and (ii) the AMPHS (⁸⁷Sr/⁸⁶Sr 0.70401–0.70457; ¹⁴³Nd/¹⁴⁴Nd 0.512981–0.513037; δ¹⁸O_cpx 5.54), made up of basalts and amphibole‐bearing andesites. The OPXS has higher contents of TiO₂, P₂O₅, light rare earth elements, Sm, Pb, Th, U, Zr, Y and Nb, and higher La/Yb ratios than the AMPHS. The isotopic data suggest that both suites formed from melts derived from the same subduction‐modified depleted mantle source as the volcanic rocks of nearby St Vincent and Bequia, and the northern islands of the Lesser Antilles Arc. The immobile trace element contents, and La/Yb ratios, of the OPXS are indicative of ～10% partial melting of the source, whereas those of the AMPHS are indicative of ～25% partial melting. The within‐suite chemical variation of the OPXS is consistent with ～45% fractional crystallization of its intratelluric mineral assemblages, and that of the AMPHS is consistent with the removal of ～65% of its intratelluric assemblages. Experimental evidence suggests that both suites of basalt crystallized at pressures <8 kbar from melts containing 1–2 wt% water. After extensive fractional crystallization, the andesites crystallized at pressures between approximately 5 and 2 kbar. The OPXS magmas appear to have lost more of their water content than the AMPHS magmas. Thus, the OPXS andesites formed from melts with an estimated water content of 2–3 wt%, whereas the AMPHS andesites formed from melts containing at least 4.5 wt% water.