用交叉点数据计算中国近海海平面变化

讨论了由测高卫星升、降弧段海面高在交叉点上的约束监测海平面变化的方法；用TOPEX／POSIDON测高数据计算了中国黄海、东海、南海海域的海平面变化，其中黄海、东海海域受两个月周期分量的振荡信号影响，而南海海域以年周期变化为主要表现特征；分析了3个海区海平面变化的相关性，扣除两个月的周期分量振荡信号后，其海平面变化的相关性达到90％以上；分析了海水面积随纬度带的变化对不同纬度分布的海区海平面变化量的影响。     

Establishing the Database of Inundation Potential in Taiwan

The structural measure was the major solution for flood defense in Taiwan. However, the measure is always limited to the design standard and cannot prevent the damages when floods exceed certain scale. Therefore, non-structural measures for flood mitigation are the indispensable complements to structural solutions. The study introduces the establishment of inundation potential database that provides required information for the non-structural measures in Taiwan. The database was built by numerical simulations, based on different rainfall scenarios, and has been applied by the local governments of Taiwan for land use managements, flood warning systems, emergency responses, and flood insurance programs to reduce the flood damages and impacts.     

Using ADV backscatter strength for measuring suspended cohesive sediment concentration

Laboratory experiments were conducted at two institutes to reveal the relationship between acoustic backscatter strength and suspended sediment concentration (SSC). In total, three acoustic Doppler velocimeters (ADVs) with different frequencies (5, 10 and 16 MHz) were tested. Two different commercial clays and one natural sediment from Clay Bank site in the York River were checked for acoustic responses. The SSCs of selected sediments were artificially changed between a selected low and a high value in tap or de-ion water. Each ADV showed quite different backscatter responses depending on the sediment type and SSC. Not all devices had a good linear relationship between backscatter strength and SSC. Within a limited range of SSC, however, the backscatter strength can be well correlated with the SSC. Compared with optical backscattering sensor (OBS), the fluctuation of ADV backscatter signals was too noisy to be directly converted to the instantaneous changes of SSC due to high amplification ratio and small sampling volume. For the more accurate signal conversion for finding the fluctuation of SSC, the ensemble average should be applied to increase the signal-to-noise ratio. There are unexpected responses for the averaged backscatter wave strength: (1) high signals from small particles but low signals from large particles; and (2) two linear segments in calibration slope. These phenomena would be most likely caused by the different gain setting built in ADVs. The different acoustic responses to flocculation might also contribute somewhat if flocs are tightly packed. This study suggests that an ADV could be a useful instrument to estimate suspended cohesive sediment concentration and its fluctuation if the above concerns are clarified.     

The Principle of the Drilling by Impregnated Diamond Bits and the Classification of Rocks

Recently impregnated diamond bits have been widely applied in drilling hard and me-dium-hard formations in the world.It is quite necessary to study the fracturing mecha-nism of the impregnated diamond bit and the classification of rocks,which can realizeoptimum drilling.Using multi-parameter rotary test stand can monitor and print nineparameters.The diamond size and concentration for experiment are various and there arenearly200 types of samples,numbering over1000 pieces.The results of laboratory arethe same as those in the field.Besides,this paper expresses that the diamond concentra-tion of impregnated diamond bits effect the bonding strength of diamond imbedded in ma-trix.During drilling by impregnated diamond bits three ways are used to cool the bits.The contact area between impregnated diamond layer and flow,and the drilling flowthrough annulus carrying away heat with conduction form can be shown by equations.Itis impossible to classify the rock drillability only by using single factor.The best met     

泡沫钻进流体压力损失的研究

为了研究泡沫钻进中泡沫流休压力损失的变化规律，建立室内模拟试验台，通过大量实验，得出结论。     

An application of Boussinesq equations to Bragg reflection of irregular waves

A numerical model based on the second-order fully nonlinear Boussinesq equations of Wei et al. [1995. Journal of Waterway, Port, Coastal and Ocean Engineering 121 (5), 251-263] is developed to simulate the Bragg reflection of both regular and irregular surface waves scattered by submerged bars. Particularly for incident regular waves, the computed results are observed to agree very well with the existing experimental data as presented by Davies and Heathershaw [1984. Journal of Fluid Mechanics 144, 419-446] and Kirby and Anton [1990. Proceedings of the 22nd International Conference on Coastal Engineering, ASCE, New York, pp. 757–768). In the case of incident irregular waves, the simulated results reveal that the distribution of Bragg reflection from irregular waves becomes more flat than that of regular waves. Due to lack of experimental data, the numerical results for incident irregular waves are compared with those of the evolution equation of the mild-slope equation [Hsu et al., 2002 Proceedings of the 24th Ocean Engineering Conference in Taiwan, pp. 70–77 (in Chinese)]. In addition, several parameters such as the number of bars, the relative height of bars and the spacing of bars affecting Bragg reflection are also discussed.     

Modelling of hydrodynamics and cohesive sediment transport in Tanshui River estuarine system,Taiwan

A laterally averaged two-dimensional numerical model is used to simulate hydrodynamics and cohesive sediment transport in the Tanshui River estuarine system. The model handles tributaries as well as the main stem of the estuarine system. Observed time series of salinity data and tidally averaged salinity distributions have been compared with model results to calibrate the turbulent diffusion coefficients. The overall model verification is achieved with comparisons of residual currents and salinity distribution. The model reproduces the prototype water surface elevation, currents and salinity distributions. Comparisons of the suspended cohesive sediment concentrations calculated by the numerical model and the field data at various stations show good agreement. The validated model is applied to investigate the tidally averaged salinity distributions, residual circulation and suspended sediment concentration under low flow conditions in the Tanshui River estuarine system. The model results show that the limit of salt intrusion in the mainstem estuary is located at Hsin-Hai bridge in Tahan Stream, 26 km from the River mouth under Q75 flow. The null point is located at the head of salt intrusion, using 1 ppt isohaline as an indicator. The tidally averaged sediment concentration distribution exhibits a local maximum around the null point.     

Numerical simulation on a tremendous debris flow caused by Typhoon Morakot in the Jiaopu Stream,Taiwan

In August 2009,Typhoon Morakot brought a large amount of rainfall with both high intensity and long duration to a vast area of Taiwan.Unfortunately,this resulted in a catastrophic landslide in Hsiaolin Village,Taiwan.Meanwhile,large amounts of landslides were formed in the Jiaopu Stream watershed near the southeast part of the Hsiaolin Village.The Hsiaolin Village access road（Provincial Highway No.21 and Bridge No.8） was completely destroyed by the landslide and consequent debris flow.The major scope of this study is to apply a debris flow model to simulate the disaster caused by the debris flow that occurred in the Jiaopu Stream during Typhoon Morakot.According to the interviews with local residents,this study applied the destruction time of Bridge No.8 and Chen＇s house to verify the numerical debris flow model.By the spatial rainfall distributions information,the numerical simulations of the debris flow are conducted in two stages.In the first stage（before the landslide-dam failure）,the elevation of the debris flow and the corresponding potential damages toward residential properties were investigated.In the second stage（after the landslidedam failure）,comparisons of simulation results between the longitudinal and cross profiles of the Jiaopu Stream were performed using topographic maps and satellite imagery.In summary,applications of the adopted numerical debris flow model have shown positive impact on supporting better understanding of the occurrence and movement of debris flow processes.