Proper motions and variability of the H2 knots in the HH 111 and 121 protostellar outflows

We discuss the formation of spectral features in the decelerating ejecta of gamma-ray bursts, including the possible effect of inhomogeneities. These should lead to blueshifted and broadened absorption edges and resonant features, especially from H and He. An external neutral ISM could produce detectable H and He, as well as Fe X-ray absorption edges and lines. Hypernova scenarios may be diagnosed by Fe Kα and H Lyα emission lines.     

Intercomparison of NO column measurements during MAP/GLOBUS 1985

Column measurements of nitric oxide were made using several techniques during the MAP/GLOBUS campaign in France in September 1985. The data sets are nearly co-located and simultaneous, therefore allowing a valid intercomparison of the various measurement methods. The range of altitudes sampled differs from instrument to instrument. This complicates the comparison because the data sets are to some extent complementary. The NO distributions apparently vary significantly from day to day, and possibly over shorter timescales. Changes in dynamics may be responsible for these variations. The results from the instruments which measure in the infrared and the ultraviolet are self-consistent, and show good agreement with photochemical predictions. On 19 September, when the intercomparison was made, the profile measured by the in-situ chemiluminescent instrument differed significantly from the predicted profile, and the measured columns were generally higher.     

Determination of surface layer parameters at the edge of a suburban area

Vertical wind and air temperature profile related parameters in the surface layer at the edge of suburban area of Zagreb (Croatia) have been considered. For that purpose, adopted Monin–Obukhov similarity theory and a set of observations of wind and air temperature at 2 and 10?m above ground, recorded in 2005, have been used. The root mean square differences (errors) principle has been used as a tool to estimate the effective roughness length as well as standard deviations of wind speed and wind gusts. The results of estimation are effective roughness lengths dependent on eight wind direction sectors unknown before. Gratefully to that achievement, representativeness of wind data at standard 10-m height can be clarified more deeply for an area of at least about 1?km in upwind direction from the observation site. Extrapolation of wind data for lower or higher levels from standard 10-m height are thus properly representative for a wider inhomogeneous suburban area and can be used as such in numerical models, flux and wind energy estimation, civil engineering, air pollution and climatological applications.     

The Dammam aquifer in Bahrain – Hydrochemical characterization and alternatives for management of groundwater quality

 Over-abstraction of the Dammam aquifer, the principal aquifer in Bahrain, by the agricultural and domestic sectors, has led to its salinization by adjacent brackish and saline water bodies. A hydrochemical study identified the locations of the sources of aquifer salinization and delineated their areas of influence. The investigation indicates that the aquifer water quality is significantly modified as groundwater flows from the northwestern parts of Bahrain, where the aquifer receives its water by lateral underflow from eastern Saudi Arabia, to the southern and southeastern parts. Four types of salinization of the aquifer are identified: brackish-water up-flow from the underlying brackish-water zones in north-central, western, and eastern regions; seawater intrusion in the eastern region; intrusion of sabkha water in the southwestern region; and irrigation return flow in a local area in the western region. Four alternatives for the management of groundwater quality that are available to the water authorities in Bahrain are discussed and their priority areas are proposed, based on the type and extent of each salinization source, in addition to groundwater use in that area. The effectiveness of the proposed management options in controlling the degradation of water quality in the Dammam aquifer should be evaluated using simulation modeling. Received: June 1998 Revised: November 1998 Accepted: December 1998     

STATISTICAL EVALUATION OF MT AND AMT METHODS APPLIED TO A BASALT-COVERED AREA IN SOUTHEASTERN ANATOLIA,TURKEY*

The efficacy of the magnetotelluric and audiomagnetotelluric (MT/AMT) methods for detailing the structure of a hypothetical geological section is investigated by using the singular value decomposition (SVD) technique. The section is representative of southeastern Turkey, which is mostly covered by basalt and is a prime area for oil exploration. One of the geological units, the Germav shale at a depth of 600 m, is a problem layer for electromagnetic surveys because of its very low resistivity (on average 3 Ωm) and highly variable thickness across the area (200–900 m). In the MT frequency range (0.0004–40 Hz) its total conductance—or, since its resistivity is known from resistivity log information, its thickness—is the best resolved model parameter. The total depth to the Germav shale and the resistivity of the Cambrian/Precambrian basement are the marginally resolved parameters. In the AMT frequency range (4–10000 Hz) the resistivity of the surface basalt layer strongly affects the resolution of the other, less important, model parameters which are the total depth to the Germav shale and the total conductance of the Germav shale. The errors in the measurements determine the number of model parameters resolvable, and are also important for interpretation of the geological model parameters to within a desired accuracy. It is shown that statistical evaluation of the MT and/or AMT interpretations by using an SVD factorization of the sensitivity matrix can be helpful to define the importance of some particular stage of the interpretation, and also provides a priori knowledge to plan a proposed survey. Arrangements of MT and AMT observations, together with some Schlumberger resistivity soundings, on a large grid will certainly provide three-dimensional detailed information of the deep geoelectric structure of the area.     

Splash detachment of sand particles under varying contact stress field of wind-driven raindrop impact

The effects of wind-driven rain (WDR) on sand detachment were studied under various raindrop obliquities. Results suggested a significant reduction in compressive stress on sand surfaces for a two-dimensional experimental set-up in a wind tunnel. During experiments, sand particles in splash cups were exposed to both wind-free rain (WFR) and WDR driven by horizontal winds of 6.4, 8.9 and 12.8 m s⁻¹ and rainfall intensities of 50, 60, 75 and 90-mm h⁻¹ to assess the sand detachment rate (D, in g m⁻² s⁻¹). The effects of sand moisture state (dry and wet) on the detachment of different-sized particles (0.20–0.50 and 0.50–2.00 mm, respectively) were also tested. Factorial analysis of variance showed that shear and compressive stress components evaluated by horizontal and vertical kinetic energy flux terms (KE_x and KE_y, respectively, in J m⁻² s⁻¹) along with their vector sum (KE_r, in J m⁻² s⁻¹) explained the variation in D. Neither sand size nor sand moisture was statistically significant alone although binary interactions of KE_r, KE_x and KE_y with the sand size and three-way interaction of KE_x, sand size and moisture were statistically significant. These results can be explained by size-dependent variation in sand compressibility and surface friction related to the total stress field developed by a given partition of shear and compressive stresses of wind-driven oblique raindrops (KE_x/KE_y). Further analysis of the variation of the unit sand detachment rate (D_u = D/KE_r = g J⁻¹) with rain inclination (α, in degrees) better revealed the effect of WDR obliquity on D_u that further changed with sand size class and moisture state. Finally, the difference in the resulting stress field differentiable by the oblique raindrop trajectories of the experiment over sand surface significantly affected the non-cohesive particle detachment rates, to some extent interacted with size-dependent compressibility and interface shear strength of sand grains.     

Gladstone, Australia Field Studies: Weathering and Degradation of Hydrocarbons in Oiled Mangrove and Salt Marsh Sediments With and Without the Application of an Experimental Bioremediation Protocol

This field study was a combined chemical and biological investigation of the relative rates of weathering and biodegradation of oil spilled in sediments and testing the influence of a bioremediation protocol. The aim of the chemistry work presented here was to determine whether the bioremediation protocol affected the rate of penetration, dissipation or long-term retention of a medium range crude oil (Gippsland) and a Bunker C oil stranded in tropical Rhizophora sp. mangrove and Halosarcia sp. salt marsh environments. Permission for the planned oil spills was granted in the Port Authority area of Gladstone, Queensland (Australia). Sediment cores from three replicate plots of each treatment for mangroves and four replicate plots for the salt marsh (oil only and oil plus bioremediation) were analysed for total hydrocarbons (THC) and for individual alkane markers using gas chromatography with flame ionization detection (GC–FID). Sediments were collected at day 2, then 1, 2, 5 or 6 and 12 or 13 months post-spill for mangroves and day 2, 1, 3 and 9 months post-spill for salt marshes. Over this time, hydrocarbons in all of the oil treated plots decreased exponentially. There was no statistical difference in initial oil concentrations, penetration of oil to depth, or in the rates of oil dissipation between untreated oil and bioremediated oil in the mangrove plots. The salt marsh plots treated with the waxy Gippsland oil showed a faster rate of biodegradation of the oil in the bioremediated plots. In this case only, the degradation rate significantly impacted the mass balance of remaining oil. The Bunker C oil contained only minor amounts of highly degradable n-alkanes and bioremediation did not significantly impact its rate of loss in the salt marsh sediments. At the end of each experiment, there were still n-alkanes visible in the gas chromatograms of residual oils. Thus it was concluded that there was unlikely to be any change in the stable internal biomarkers of the oils over this time period. The predominant removal processes in both habitats were evaporation and dissolution, with a lag-phase of 1–2 months before the start of microbial degradation.     

A climate change simulation starting from 1935

Due to restrictions in the available computing resources and a lack of suitable observational data, transient climate change experiments with global coupled ocean-atmosphere models have been started from an initial state at equilibrium with the present day forcing. The historical development of greenhouse gas forcing from the onset of industrialization until the present has therefore been neglected. Studies with simplified models have shown that this cold start error leads to a serious underestimation of the anthropogenic global warming. In the present study, a 150-year integration has been carried out with a global coupled ocean-atmosphere model starting from the greenhouse gas concentration observed in 1935, i.e., at an early time of industrialization. The model was forced with observed greenhouse gas concentrations up to 1985, and with the equivalent C0₂ concentrations stipulated in Scenario A (Business as Usual) of the Intergovernmental Panel on Climate Change from 1985 to 2085. The early starting date alleviates some of the cold start problems. The global mean near surface temperature change in 2085 is about 0.3 K (ca. 10%) higher in the early industrialization experiment than in an integration with the same model and identical Scenario A greenhouse gas forcing, but with a start date in 1985. Comparisons between the experiments with early and late start dates show considerable differences in the amplitude of the regional climate change patterns, particularly for sea level. The early industrialization experiment can be used to obtain a first estimate of the detection time for a greenhouse-gas-induced near-surface temperature signal. Detection time estimates are obtained using globally and zonally averaged data from the experiment and a long control run, as well as principal component time series describing the evolution of the dominant signal and noise modes. The latter approach yields the earliest detection time (in the decade 1990–2000) for the time-evolving near-surface temperature signal. For global-mean temperatures or for temperatures averaged between 45°N and 45°S, the signal detection times are in the decades 2015–2025 and 2005–2015, respectively. The reduction of the cold start error in the early industrialization experiment makes it possible to separate the near-surface temperature signal from the noise about one decade earlier than in the experiment starting in 1985. We stress that these detection times are only valid in the context of the coupled model's internally-generated natural variability, which possibly underestimates low frequency fluctuations and does not incorporate the variance associated with changes in external forcing factors, such as anthropogenic sulfate aerosols, solar variability or volcanic dust.     

Possible climatic changes of hydrological regime of valley reservoirs

The paper presents the simulation outputs of changes of hydrological characteristics of reservoirs of different kind (changes in residence time and in water column stratification) in case of forecast warming according to the most adverse scenario for Moscow water supply, when annual flow and springflood flow depth decrease.