Harmonic Analysis of Sedimentary Cyclic Sequences in Kansas, Midcontinent, USA

Several stratigraphic sequences in the Upper Carboniferous (Pennsylvanian) in Kansas (Midcontinent, USA) were analyzed quantitatively for periodic repetitions. The sequences were coded by lithologic type into strings of datasets. The strings then were analyzed by an adaptation of a one-dimensional Fourier transform analysis and examined for evidence of periodicity. The method was tested using different states in coding to determine the robustness of the method and data. The most persistent response is in multiples of 8–10 ft (2.5–3.0 m) and probably is dependent on the depositional thickness of the original lithologic units. Other cyclicities occurred in multiples of the basic frequency of 8–10 with persistent ones at 22 and 30 feet (6.5–9.0 m) and large ones at 80 and 160 feet (25–50 m). These levels of thickness relate well to the basic cyclothem and megacyclothem as measured on outcrop. We propose that this approach is a suitable one for analyzing cyclic events in the stratigraphic record.     

Seismic Ground Motion Expected for the Eastern District of Naples

The seismic ground motion of a test area in the eastern district of Naples is computed with a hybrid technique based on the mode summation and the finite difference methods. This technique allows us the realistic modelling of source and propagation effects, including local soil conditions. In the modelling, we consider the 1980 Irpinia earthquake, a good example of strong shaking for the area of Naples, which is located about 90 km from the epicenter.The detailed geological setting is reconstructed from a large number of drillings. The sub-soil is mainly formed by alluvial (ash, stratified sand and peat) and pyroclastic materials overlying a pyroclastic rock (yellow neapolitan tuff), representing the neapolitan bedrock. The detailed information available on mechanical properties of the sub-soil and its geometry warrants the application of the sophisticated hybrid technique.As expected, the sedimentary cover causes an increase of the signal's amplitudes and duration. If thin peat layers are present, the amplification effects are reduced, and the peak ground accelerations are similar to those observed for the bedrock model. This can be explained by the backscattering of wave energy at such layers, that tend to seismically decouple the upper from the lower part of the structure.For SH-waves, the influence of the variations of the S-wave velocities on the spectral amplification is studied, by considering locally measured velocities and values determined from near-by down-hole measurements. The comparison between the computed spectral amplifications confirms the key role of an accurate determination of the seismic velocities of the different layers.The comparison performed between a realistic 2-D seismic response and a standard 1-D response, based on the vertical propagation of waves in a plane layered structure, shows considerable difference, from which it is evident that serious caution must be taken in the modelling of expected ground motion at a specific site.     

Accretion and exhumation at a Variscan active margin, recorded in the Saxothuringian flysch

The Saxothuringian flysch basin, on the north flank of the Central European Variscides, was fed and eventually overthrust by the northwestern, active margin of the Tepla-Barrandian terrane. Clast spectra, mineral composition and isotopic ages of detrital mica and zircon have been analyzed in order to constrain accretion and exhumation of rocks in the orogenic wedge. The earliest clastic sediments preserved are of early Famennian age (ca. 370?Ma). They are exposed immediately to the NW of the suture, and belong to the par-autochthon of the foreland. Besides ultramafic (?ophiolite) material, these rocks contain clasts derived from Early Paleozoic continental slope sediments, originally deposited at the NW margin of the Saxothuringian basin. These findings, together with the paleogeographic position of the Famennian clastics debris on the northwestern passive margin, indicate that the Saxothuringian narrow ocean had been closed by that time. Microprobe analyses of detrital hornblendes suggest derivation from the “Randamphibolit” unit, now present in the middle part of the Saxothuringian allochthon (Münchberg nappes). Detrital zircons of metamorphic rocks formed a little earlier (ca. 380?Ma) indicate rapid recycling at the tectonic front. The middle part of the flysch sequence (ca. early to middle Viséan), both in the par-autochthon and in the allochthon, contains abundant clasts of Paleozoic rocks derived from the northwestern slope and rise, together with debris of Cadomian basement, 500-Ma granitoids and 380?Ma (early Variscan) crystalline rocks. All of these source rocks were still available in the youngest part of the flysch (c. middle to late Viséan), but some clasts record, in addition, accretion of the northwestern shelf. Our findings permit deduction of minimum rates of tectonic shortening well in excess of 10–30?mm per year, and rates of exhumation of ca. 3?mm/a, and possibly more.     

Argillite debris converted to bauxite during karst weathering: evidence from immobile element geochemistry at the Olmedo Deposit, Sardinia

The Olmedo bauxite deposit occurs in the Nurra district of northwest Sardinia. It forms a stratiform horizon in Cretaceous limestone and marl. Uplift in mid-Cretaceous had exposed recently deposited limestone to karst weathering, and a layer of argillaceous debris accumulated on its surface and was partly converted to bauxite. Intermediate products were desiccated marl, bauxitic argillite and argillaceous bauxite. Subsidence followed, and the bauxite was preserved by the deposition of late Cretaceous limestone and other sediments. Uplift in Oligocene-Miocene time, with ensuing erosion, exposed the bauxite horizon to its present configuration. Concentrations of normative minerals illustrate chemical processes and the build-up of Al in the bauxite horizon. Plots of chemical data and correlation coefficients show that Al, Ti, Zr, Nb, Th, Cr and V were immobile during the bauxitization process. Mass changes point to large net removal of Si, Mg and K from the system, although some of this material and slightly mobile Al were reprecipitated in the underlying argillite and altered marl. Immobile element ratios trace the source of the bauxite to the underlying argillaceous limestone. Al in the bauxite was accumulated from the degradation of 25 to 50 m of the argillaceous limestone. Received: 10 June 1996 / Accepted: 15 April 1997     

Attenuation differences in layer 2A in intermediate- and slow-spreading oceanic crust

In situ seismic attenuationQ⁻¹logs are derived from borehole velocity profiles and reveal sharp boundaries between morphologies of the extrusive volcanic layers in intermediate- and slow-spreading oceanic crust.Q⁻¹logs are calculated from the scattering attenuation associated with vertical velocity heterogeneity in Ocean Drilling Program Holes 504B and 896A and in Hole 395A, located in 5.9–7.3 Ma crust on the Pacific and Atlantic plates, respectively. Our results strongly tie crustal properties to seismic measurables and observed geological structures: we find that the scattering attenuation can be used to identify the extrusive volcanic sequence because it is closely related to changes in the degree of vertical heterogeneity. We interpret a distinct decrease in the Q⁻¹log at the transition below the extrusive volcanic layer to correspond with the seismic layer 2A/2B boundary. The boundary is located at 465 m depth below the sea floor in both Hole 395A and 504B, although this is likely to be a coincidence of the sediment thickness at these sites. Layer 2A is estimated to be approximately 150 m thick in Hole 504B and > 300 m thick in Hole 395A. Cyclic sequences of high-porosity pillows and low-porosity massive units in the uppermost 100 m of volcanics in Hole 395A result in large velocity heterogeneities which cause > 5 times more attenuation in this layer than in Hole 504B. In Hole 896A, by contrast, fewer pillows, more massive flows, and a greater volume of carbonate veins decrease the velocity heterogeneity and attenuation significantly over only 1 km distance from Hole 504B. We conclude that the attenuation in the extrusive volcanics of the ocean crust is largely controlled by variation in local heterogeneity and morphology as well as by subsequent hydrothermal alteration. The observed differences inQ⁻¹profiles and layer 2A thickness at these sites may be attributed to variations in the volume and duration of volcanic activity at mid-ocean spreading centers for these Pacific and Atlantic ridge segments.     

Estimation of groundwater evaporation and salt flux from Owens Lake, California, USA

Groundwater evaporation and subsequent precipitation of soluble salts at Owens Lake in eastern California have created one of the single largest sources of airborne dust in the USA, yet the evaporation and salt flux have not been fully quantified. In this study, we compare eddy correlation, microlysimeters and solute profiling methods to determine their validity and sensitivity in playa environments. These techniques are often used to estimate evaporative losses, yet have not been critically compared at one field site to judge their relative effectiveness and accuracy. Results suggest that eddy correlation methods are the most widely applicable for the variety of conditions found on large playa lakes. Chloride profiling is shown to be highly sensitive to thermal and density-driven fluxes in the near surface and, as a result, appears to underestimate yearly groundwater evaporation. Yearly mean groundwater evaporation from the playa surface estimated from the three study areas was found to range from 88 to 104 mm year⁻¹, whereas mean evaporation from the brine-covered areas was 872 mm year⁻¹. Uncertainties on these mean rates were estimated to be ±25%, based on comparisons between eddy correlation and lysimeter estimates. On a yearly basis, evaporation accounts for approximately 47 × 10⁶ m³ of water loss from the playa surface and open-water areas of the lake. Over the playa area, as much as 7.5 × 10⁸ kg (7.5 × 10⁵ t) of salt are annually concentrated by evaporation at or near the playa surface, much of which appears to be lost during dust storms in area.     

The identifiability of parameters in a water quality model of the Biebrza River, Poland

The identifiability of model parameters of a steady state water quality model of the Biebrza River and the resulting variation in model results was examined by applying the Monte Carlo method which combines calibration, identifiability analysis, uncertainty analysis, and sensitivity analysis. The water quality model simulates the steady state concentration profiles of chloride, phosphate, ammonium, and nitrate as a function of distance along a river. The water quality model with the best combination of parameter values simulates the observed concentrations very well. However, the range of possible modelled concentrations obtained for other more or less equally eligible combinations of parameter values is rather wide. This range in model outcomes reflects possible errors in the model parameters. Discrepancies between the range in model outcomes and the validation data set are only caused by errors in model structure, or (measurement) errors in boundary conditions or input variables. In this sense the validation procedure is a test of model capability, where the effects of calibration errors are filtered out. It is concluded that, despite some slight deviations between model outcome and observations, the model is successful in simulating the spatial pattern of nutrient concentrations in the Biebrza River.     

The separation of the influence of nutrients and climate on the varve time-series of baldeggersee, Switzerland

The varve data-set from a freeze-core taken in the deepest part of Baldeggersee was subjected to different multivariate statistical analyses in order to estimate the amount of variance in the varve thickness measures explicable by past climate and by the trophic state of the lake. A comparison of two different time-periods (1902 to1992 versus 1920 to 1980) revealed that the lake restoration programme since 1982 has had a significant impact on the formation of the seasonal layers. Results of the partitioning of the variance in the varve thickness measures showed that about two thirds of the variance are unexplained by a climate and trophic state model and that trophic state explains 6%, whereas climate accounts for about 28% of the variance before the effect of lake restoration had a strong impact on the varves. Among the climate parameters the amount of annual precipitation is a strong predictor for explaining the thickness of both dark layer and total couplet thickness, whereas summer precipitation is important for the thickness of the light layer.