Some characteristics of ozone profiles above Hong Kong

Summary Analysis of ozonesonde data shows that in the lower troposphere above Hong Kong, there is a relative maximum with respect to height in all seasons except winter. In the upper troposphere, there is with respect to height a relative minimum in the seasonally averaged ozone mixing ratio in winter. Ozone mixing ratios in the upper troposphere in winter and spring can be significantly enhanced by stratospheric intrusions associated with the passage of cold fronts and upper cut-off lows.For Hong Kong, the seasonally averaged total ozone has the highest value in spring, and the lowest in winter. The seasonally averaged total tropospheric ozone also has the highest value in spring, but the lowest in summer. In a relative sense, total tropospheric ozone contributes most to the total ozone in spring and the least in summer.The phase of the total ozone anomaly above Hong Kong is influenced by the Quasi-Biennial Oscillation (QBO), with the positive anomaly associated with the easterly phase of QBO, and the negative anomaly the westerly phase.     

Estimating hydraulic conductivity using grain-size analyses, aquifer tests, and numerical modeling in a riverside alluvial system in South Korea

Hydraulic conductivity (K) for an alluvial system in a riverbank filtration area in Changwon City, South Korea, has been studied using grain-size distribution, pumping and slug tests, and numerical modeling. The alluvial system is composed of layers: upper fine sand, medium sand, lower fine sand, and a highly conductive sand/gravel layer at the base. The geometric mean of K for the sand/gravel layer (9.89?×?10^?4 m s^?1), as determined by grain-size analyses, was 3.33 times greater than the geometric mean obtained from pumping tests (2.97?×?10^?4 m s^?1). The geometric mean of K estimates obtained from slug tests (3.08?×?10^?6 m s^?1) was one to two orders of magnitude lower than that from pumping tests and grain-size analyses. K estimates derived from a numerical model were compared to those derived from the grain-size methods, slug tests and pumping tests in order to determine the degree of deviation from the numerical model. It is considered that the K estimates determined by the slug tests resemble the uppermost part of the alluvial deposit, whereas the K estimates obtained by grain-size analyses and pumping tests are similar to those from the numerical model for the sand/gravel layer of the riverside alluvial system.     

浙江省及邻区中强地震潜在震源区的判定与地震危险特征的讨论

本文利用模式识别方法,判定浙江省及其邻区的5.0级和5.5级地震的潜在震源区,并研究了它们的发震背景特征,同时与强震区的地震进行了对比。研究表明,两种地区的发震背景在地质构造和深部构造上存在一定的差异。本文还指出了未来有可能发生5.0级地震的地区。     

Source identification of PM2.5 particles measured in Gwangju, Korea

The UNMIX and Chemical Mass Balance (CMB) receptor models were used to investigate sources of PM_2.5 aerosols measured between March 2001 and February 2002 in Gwangju, Korea. Measurements of PM_2.5 particles were used for the analysis of carbonaceous species (organic (OC) and elemental carbon (EC)) using the thermal manganese dioxide oxidation (TMO) method, the investigation of seven ionic species using ion chromatography (IC), and the analysis of twenty-four metal species using Inductively Coupled Plasma (ICP)-Atomic Emission Spectrometry (AES)/ICP-Mass Spectrometry (MS). According to annual average PM_2.5 source apportionment results obtained from CMB calculations, diesel vehicle exhaust was the major contributor, accounting for 33.4% of the measured PM_2.5 mass (21.5 μg m^− 3), followed by secondary sulfate (14.6%), meat cooking (11.7%), secondary organic carbon (8.9%), secondary nitrate (7.6%), urban dust (5.5%), Asian dust (4.4%), biomass burning (2.8%), sea salt (2.7%), residual oil combustion (2.6%), gasoline vehicle exhaust (1.9%), automobile lead (0.5%), and components of unknown sources (3.4%). Seven PM_2.5 sources including diesel vehicles (29.6%), secondary sulfate (17.4%), biomass burning (14.7%), secondary nitrate (12.6%), gasoline vehicles (12.4%), secondary organic carbon (5.8%) and Asian dust (1.9%) were identified from the UNMIX analysis. The annual average source apportionment results from the two models are compared and the reasons for differences are qualitatively discussed for better understanding of PM_2.5 sources.Additionally, the impact of air mass pathways on the PM_2.5 mass was evaluated using air mass trajectories calculated with the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) backward trajectory model. Source contributions to PM_2.5 collected during the four air mass patterns and two event periods were calculated with the CMB model and analyzed. Results of source apportionment revealed that the contribution of diesel traffic exhaust (47.0%) in stagnant conditions (S) was much higher than the average contribution of diesel vehicle exhaust (33.4%) during the sampling period. During Asian dust (AD) periods when the air mass passed over the Korean peninsula, Asian dust and secondary organic carbon accounted for 25.2 and 23.0% of the PM_2.5 mass, respectively, whereas Asian dust contributed only 10.8% to the PM_2.5 mass during the AD event when the air mass passed over the Yellow Sea. The contribution of biomass burning to the PM_2.5 mass during the biomass burning (BB) event equaled 63.8%.     

水库地震主震发生时间的预测

水利工程对水库地震的抗震设防要求事先对水为地震进行预测。预测内容包括蓄水后诱发地震的危险性（可能性、）最大震级、最大震的地占紧及不库地震对场址地震动参数的影响。除主震时间的预测外，本文第一作者都曾提出过初步的预测方法。本文认为，水库地震前震波速比异常、非线性灰色模型以及前震系列回归等方法，是预测主震时间的有前途的方法。     

汶川地震强地面运动模拟

基于确定性震源模型的方法主要用于计算低频(＜1 Hz)地震波,难以计算高频地震波;高频(＞1 Hz)地震动常用经验格林函数法或随机方法,对低频地震动模拟不够准确.本文在确定性震源模型方法基础上,尝试采用分解给定的震源模型的方法来模拟宽频带(0.1-10 Hz)强地面运动,即采用分级离散断层面和分解断层面破裂单元上升时间的方法,增加震源时间函数中的高频信号,从而避免了对地震记录丰富程度和准确性的依赖.文中模拟计算了汶川M8.0地震在8个地震观测台的地震动,将模拟结果和观测记录进行了加速度时程曲线和傅里叶振幅谱的对比分析.对比结果显示,模拟估计的地震动峰值加速度和持续时间与观测记录的数据基本在±50％的精度范围内相同,傅里叶振幅谱显示模拟结果有得到10 Hz左右的高频成分.四川盆地中的台站模拟结果高频衰减比观测记录要快,原因是模拟过程没有考虑场地效应.对强地震动模拟还是要综合考虑震源、传播路径和场地的影响.研究结果表明,此改变震源输入的确定性方法可应用于模拟近断层宽频强地面运动.     

Particle shape effect on thermal conductivity and shear wave velocity in sands

This study presents the correlations between quantified shape parameters and geotechnical properties for nine sand specimens. Four shape parameters, sphericity, convexity, elongation and slenderness, were quantified with two-dimensional microscopic images with the aid of image processing techniques. An instrumented oedometer cell is used to measure compressibility, thermal conductivity and shear wave velocity during loading, unloading and reloading stages. As the particle shape inherently determines the initial loose packing condition, initial void ratio and shape parameters are well correlated with compressibility. The applied stress in soils increases the interparticle contact area and contact quality; round particles tend to achieve higher thermal conductivity and shear wave velocity during stress-induced volume change. Multiple linear regression is implemented to capture the relative contributions of involved variables, revealing that the thermal evolution is governed by the initial packing density and particle shape. The experimental observations underscore the predominant effect that particle shape has on the geomechanical and physical properties upon stress-induced soil behavior.     

Internal generation of waves: Delta source function method and source term addition method

In this study, we investigate two internal wave generation methods in numerical modeling of time-dependent equations for water wave propagation, i.e., delta source function method and source term addition method, the latter of which has been called the line source method in literatures. We derive delta source functions for the Boussinesq-type equations and extended mild-slope equations. By applying the fractional step splitting method, we show that the delta source function method is equivalent to the source term addition method employing the energy velocity. This suggests that the energy velocity should be used rather than the phase velocity for the transport of incident wave energy in the source term addition method. Finally, the performance of the delta source function method is verified by accurately generating nonlinear cnoidal waves as well as linear waves for horizontally one-dimensional cases.     

Experimental studies on the slowly varying drift motion of a berthed container ship model

The effects of free-surface waves on the floating structures are of great importance in the offshore industry. Among the six degrees of motions of a surface ship the absence of restoring forces in surge, sway and yaw led to critical situations for moored ships in the recent times. The order of forces in horizontal plane and their exciting frequencies are matters of interest. The resonance with the presence of moored chains led to many accidents in the recent past. The lines in dry conditions may not give good damping and in wet condition they may trigger the system to chaotic motions and jumps. Two different loading conditions of a container ship model are tested with waves in laboratory conditions in two different drafts. The mooring lines are chosen as per scale law and the energy under the response spectrum is determined from the plots. The results give new insights into the movement of a berthed ships subjected to waves. Response of the moored ship to different loading conditions in different water depths are discussed in this paper. The paper gives the order of energy due to first-order and slowly varying movement of a berthed container model in a towing tank.     

辽宁北票中侏罗世海房沟组水生生物群落

辽宁北票盆地中侏罗世海房沟组含丰富的生物化石，其中的水生昆虫、水生植物、叶肢介、水生软体动物和鱼类共同构成一个复杂的水生生物群落。根据其营养水平划分为生产者、消费者和分解者。这些生物通过捕食关系构成一个复杂的食物链