Aerosol mass loading over the marine environment of Arabian Sea during ICARB: Sea-salt and non-sea-salt components

Mass loading and chemical composition of atmospheric aerosols over the Arabian Sea during the pre-monsoon months of April and May have been studied as a part of the Integrated Campaign for Aerosols, gases and Radiation Budget (ICARB). These investigations show large spatial variabilities in total aerosol mass loading as well as that of individual chemical species. The mass loading is found to vary between 3.5 and 69.2 μg m^?3, with higher loadings near the eastern and northern parts of Arabian Sea, which decreases steadily to reach its minimum value in the mid Arabian Sea. The decrease in mass loading from the coast of India towards west is estimated to have a linear gradient of 1.53 μg m^?3/° longitude and an e^?1 scale distance of ～2300 km. SO ₄ ^2? , Cl^? and Na⁺ are found to be the major ionic species present. Apart from these, other dominating watersoluble components of aerosols are NO ₃ ^? (17%) and Ca²⁺ (6%). Over the marine environment of Arabian Sea, the non-sea-salt component dominates accounting to ～76% of the total aerosol mass. The spatial variations of the various ions are examined in the light of prevailing meteorological conditions and airmass back trajectories.     

A technical note on seismic microzonation in the central United States

Microzonation is an effort to evaluate and map potential hazards found in an area, urban area in particular, that could be induced by strong ground shaking during an earthquake. These hazards include: ground motion amplification, liquefaction, and slope failure. The microzonation maps, depicting ground-motion amplification, liquefaction, and landslide potentials, can be produced if the ground motion on bedrock (input) and the site conditions are known. These maps, in combination with ground-motion hazard maps (on bedrock), can be used to develop a variety of hazard mitigation strategies such as seismic risk assessment, emergency response and preparedness, and land-use planning. However, these maps have certain limitations that result from the nature of regional mapping, data limitations, generalization, and computer modeling. These microzonations show that when strong ground shaking occurs, damage is more likely to occur, or be more severe, in the higher hazard areas. The zones shown on the hazard maps should not serve as a substitute for site-specific evaluations.     

Preliminary results for a semi-automated quantification of site effects using geomorphometry and ASTER satellite data for Mozambique,Pakistan and Turkey

Estimation of the degree of local seismic wave amplification (site effects) requires precise information about the local site conditions. In many regions of the world, local geologic information is either sparse or is not readily available. Because of this, seismic hazard maps for countries such as Mozambique, Pakistan and Turkey are developed without consideration of site factors and, therefore, do not provide a complete assessment of future hazards. Where local geologic information is available, details on the traditional maps often lack the precision (better than 1:10,000 scale) or the level of information required for modern seismic microzonation requirements. We use high-resolution (1:50,000) satellite imagery and newly developed image analysis methods to begin addressing this problem. Our imagery, consisting of optical data and digital elevation models (DEMs), is recorded from the ASTER (Advanced Spaceborne Thermal Emission and Reflection Radiometer) sensor system. We apply a semi-automated, object-oriented, multi-resolution feature segmentation method to identify and extract local terrain features. Then we classify the terrain types into mountain, piedmont and basin units using geomorphometry (topographic slope) as our parameter. Next, on the basis of the site classification schemes from the Wills and Silva (1998) study and the Wills et al (2000) and Wills and Clahan (2006) maps of California, we assign the local terrain units with V _s 30 (the average seismic shear-wave velocity through the upper 30m of the subsurface) ranges for selected regions in Mozambique, Pakistan and Turkey. We find that the applicability of our site class assignments in each region is a good first-approximation for quantifying local site conditions and that additional work, such as the verification of the terrain’s compositional rigidity, is needed.     

Evaluation of coal bed methane potential of coal seams of Sawang Colliery,Jharkhand, India

The coal seams of Sawang Colliery, East Bokaro Coalfields are bituminous to sub-bituminous in nature and categorized as high gaseous seams (degree II to degree III level). These seams have the potential for coal bed methane (CBM) and their maturity increases with increasing depth, as a result of enhanced pressure-temperature conditions in the underground. The vitrinite maceral group composition of the investigated coal seams ranges from 62.50–83.15%, whereas the inertinite content varies from 14.93–36.81%. The liptinite content varies from 0.66% to 3.09%. The maximum micro-pores are confined within the vitrinite group of macerals. The coal seams exhibit vitrinite reflectance values (Ro% calculated) from 0.94% (sample CG-97) to 1.21% (sample CG-119). Proximate analyses of the investigated coal samples reveal that the moisture content (M%) ranges from 1.28% to 2.98%, whereas, volatile matter (VM%) content is placed in the range of 27.01% to 33.86%. The ash content (A%) ranges from 10.92% to 30.01%. Fixed carbon (FC%) content varies from 41.53% to 55.93%. Fuel ratio variation shows a restricted range from 1.53 to 1.97. All the coal samples were found to be strongly caking and forming coke buttons. The present study is based on the adsorption isotherm experiments carried out under controlled P-T conditions for determination of actual gas adsorption capacity of the coal seams. This analysis shows that the maximum methane gas adsorbed in the coal sample CG-81 is 17 m³/t (Std. daf), at maximum pressure of 5.92 MPa and experimental temperature of 30°C. The calculated Langmuir regression parameters P_L and V_L range from 2.49 to 3.75 MPa and 22.94 to 26.88 m³/t (Std. daf), respectively.     

Comments on ‘A comparative study of ANN and neuro-fuzzy for the prediction of dynamic constant of rockmass’

Singh et al (2005) examined the potential of the ANN and neuro-fuzzy systems application for the prediction of dynamic constant of rockmass. However, the model proposed by them has some drawbacks according to fuzzy logic principles. This discussion will focus on the main fuzzy logic principles which authors and potential readers should take into consideration.     

Proposed seismic hazard maps of Sumatra and Java islands and microzonation study of Jakarta city,Indonesia

This paper presents the development of spectral hazard maps for Sumatra and Java islands, Indonesia and microzonation study for Jakarta city. The purpose of this study is to propose a revision of the seismic hazard map in Indonesian Seismic Code SNI 03-1726-2002. Some improvements in seismic hazard analysis were implemented in the analysis by considering the recent seismic activities around Java and Sumatra. The seismic hazard analysis was carried out using 3-dimension (3-D) seismic source models (fault source model) using the latest research works regarding the tectonic setting of Sumatra and Java. Two hazard levels were analysed for representing 10% and 2% probability of exceedance (PE) in 50 years ground motions for Sumatra and Java. Peak ground acceleration contour maps for those two hazard levels and two additional macrozonation maps for 10% PE in 50 years were produced during this research. These two additional maps represent short period (0.2 s) and long-period (1.0 s) spectra values at the bedrock. Microzonation study is performed in order to obtain ground motion parameters such as acceleration, amplification factor and response spectra at the surface of Jakarta. The analyses were carried out using nonlinear approach. The results were used to develop contour of acceleration at the surface of Jakarta. Finally, the design response spectra for structural design purposes are proposed in this study.     

火试金法测定铜精矿中金含量结果的不确定度评定

对火试金法测定铜精矿中金含量的结果进行不确定度评定。分析了铜精矿样品称量、铜精矿样品的不均匀性和配料处理,以及金粒称量等因素对金含量测量结果不确定度的影响,并得出火试金法测量铜精矿中金含量的扩展不确定度。     

多接收器电感耦合等离子体质谱法测定镉标准溶液中镉的同位素组成

建立了多接收器电感耦合等离子体质谱仪对Cd标准溶液同位素组成进行分析的实验方法。仪器的质量分馏校正采用Standard-Sample Bracketing法。实验结果用δ114/110Cd来表达。在此研究基础上,以SPEX Cd标准溶液为参考标准,对国外4种Cd标准溶液进行了测定。结果表明,实验测定的精度在0.07‰~0.13‰(δ114/110Cd),与目前文献报道的结果具有相似的精度。以最新SPEX Cd标准样品(δ114/110Cd=0)为基准,计算的δ114/110CdJMC、δ114/110CdSPEX-1、δ114/110CdBAM1012和δ114/110CdM櫣nster的值分别为0.55‰、0.56‰、-0.65‰和5.14‰,说明不同批次SPEX标准溶液的Cd同位素组成是明显不同的,最新的SPEX Cd标准溶液与SPEX-1 Cd的δ114/110Cd值存在着0.56‰的差别。将以SPEX Cd为参考标准的δ114/110CdBAM1012和δ114/110CdM櫣nster转化为以SPEX-1或JMC为参考标准后,得到的结果与文献报道的结果在误差范围内一致。     

高、低煤阶煤层气藏地质特征及控气作用差异性研究

高、低煤阶煤层气地质特征及控气作用差异性是研究煤层气富集成藏的重要组成部分,是煤层气勘探开发理论研究过程中重要的基础性研究领域之一。本文以中国沁水、阜新盆地和美国粉河盆地等典型的含气盆地为例,探讨了高、低煤阶煤层气的储层物性差异,分析了构造控气和水文地质控气作用的差异性。研究表明,高煤阶气藏含气量高,CH4百分含量高,δ13C1值大于-38.75‰,储层渗透率变化小,储层改造难,构造热事件对煤层气的生成、富集贡献大,持续的水动力使气藏遭到破坏,且破坏幅度大,现今地下水格局对气藏的形成具有一定的影响;低煤阶气藏含气量低,CH4百分含量低,δ13C1值大于-49.11‰,储层渗透率变化大,储层易改造,煤热演化史及煤阶影响着煤层气的生成、富集,在煤层气生成过程中活跃的水动力是甲烷生成的主要的水文地质条件之一,但持续的水动力使气藏遭到破坏,且破坏幅度小,而合适的地层水矿化度则是低煤阶煤层气生成的重要条件,地下水格局对气藏的调整和改造起到决定性的影响。     

Using ALSM to map sinkholes in the urbanized covered karst of Pinellas County,Florida—1, methodological considerations

Comparison of a database of interpreted sinkholes made using airborne laser swath mapping (ALSM) with databases of sinkholes made from interpretation of aerial photographs reveals substantial disagreement. The discrepancies involve the location, number, areas, and circularity of interpreted sinkholes. Methodological factors that contribute to the discrepancies include blockage of ALSM laser returns in thick vegetation, multi-path reflections, and misrepresentation of the true extent of sinkholes. Comparison of two ALSM-derived databases made (1) independently from versus (2) in combination with earlier air photo analysis in undeveloped regions had the following result: one-fourth of the sinkholes interpreted by using the composite method were missed by the independent analysis, and one-third of the sinkholes that were interpreted from the independent analysis were not interpreted as sinkholes using the composite method. Subjective interpretation leads to a high level of uncertainty such that the results of the remote sensing studies are suspect, if not invalid.