生物炭对磷石膏中磷的固化作用

磷石膏中的磷在雨水淋滤作用下浸出,将污染堆场附近水体。本研究采用生物炭固化磷石膏中的磷,以减少其对周遭水体的污染。主要通过模拟固化实验和对照浸出实验,分析生物炭用量、反应时间和温度、初始pH值对固化效果的影响,通过XRD、SEM-EDS分析固化后的生成物。实验结果显示,在生物炭用量为25 mg时,单位固化量达到最大值13.20 mg/g;在反应温度T=293 K、初始pH=7条件下,反应平衡时间72 h时浸出液的磷平衡浓度C_e= 1.40 mg/L;温度提升有助于提高生物炭的固化效果,当T=308 K时,浸出液的磷平衡浓度C_e=0.167 mg/L;碱性条件有利于固化反应持续进行,在pH=11条件下,浸出液的磷平衡浓度C_e=0.153 mg/L。实验结果表明生物炭对磷石膏中的磷具有明显的固化效果。磷石膏中的二水硫酸钙溶解后,Ca²⁺与表面带负电的生物炭结合,在生物炭显微结构的凹陷处,化学吸附溶液中的磷酸根生成了絮状、团簇状的羟基磷灰石(HAP)沉淀,从而使浸出磷得到有效控制。     

特高压输电线路通道三维可视化系统的实现

智能巡检技术的飞速发展可有效提高直升机、无人机、机器人及各类智能终端巡检高压输电线路的运维水平、提高工作效率、减小劳动强度.本文利用智能终端平台搭载的激光雷达扫描系统获取特高压输电线路上的激光雷达点云和光学影像数据,在激光扫描技术、三维可视化术及大数据分析等技术融合的基础上,在三维全景平台上融合航检数据,建立输电线路通道管控系统,全面提升输电通道的管理水平.     

雄安新区地热地质模型探究：来自地球物理的证据

雄安新区内地热资源丰富，区内有牛驼镇地热田、容城地热田和高阳地热田，地热资源开发利用较早，但是对其深部热源机制仍未形成统一观点。为了研究雄安新区内地热田深部热源机制，在新区及外围进行了深反射地震和长周期大地电磁探测，对取得的同剖面的深反射地震和大地电磁数据进行处理和综合解释，探明了研究区从地表至莫霍面范围内地质构造和电性结构。下地壳结构在深反射地震剖面与大地电磁剖面上有很好的对应关系。电阻率低值区对应着在深反射地震剖面上存在一系列反射同相轴，且同相轴可以延续到莫霍面，电阻率高值区对应着在深反射地震剖面上无明显连续反射同相轴，尤其是在莫霍面之上呈现地震反射近似"空白区"。结合区域地热资料构建了研究区深部地热地质模型，对新区内深部地热机制进行了解释。该模型为"二元"生热模型，其热源包含两个部分，深部地幔热源和地壳放射性元素衰变生热。放射性元素衰变生热占地表热流的接近30%，而幔源热流在地表热流中的占比可达约70%。在牛驼镇下方，莫霍面以上，由于地幔热物质上涌造成下地壳上隆，幔源岩浆底侵作用于下地壳形成了局部热异常，该热异常具有低速高导的地球物理特征，认为是牛驼镇地热田和容城地热田的深部热源；以区域断裂为热通道，大地热流由深部向上传导、扩散到牛驼镇凸起和容城凸起顶部，对碳酸盐岩储水层进行加热，形成地热储层；上覆新近系沉积地层是良好的热盖层。     

船式支护在基坑中的应用

在深厚软土地区的基坑,对基坑底软土进行搅拌加固形成强度较高的底板而保证坑底稳定,侧壁采用支护桩支护保证侧壁的稳定使其不倾倒,支护桩与加固底板两者共同作用形成的船状结构支护体系类似轮船的船侧壁及船底板,以保证基坑的稳定。结合具体的工程实例,介绍了船式支护的侧壁及底板的设计方法。工程案例成功实施,监测结果表明,船式支护既可避免支护桩嵌固深度过长,又利于软土的土方施工及工程桩的保护,是安全可靠的,对类似工程有一定的参考意义。     

Slip-weakening constitutive relation and the structure in the vicinity of a shear crack tip

Shear-crack model with a cohesive zone (or breakdown zone) is appropriate for the analysis of a fault surface in which slip distribution is strongly nonuniform. As the slipped portion advances, slip-weakening occurs over the so-called cohesive zone, a distance behind the fault tip. For a prescribed strength vs. displacement constitutive relation, however, the zone structure is difficult to determine by an analytical method except for some simple cases, thus it often requires a certain numerical procedure. This work proposes a numerical procedure to obtain approximated solutions of the problem by combining a series of elastic solutions derived bySmith (1974). The series is linearly combined and the unknown coefficients are determined by a nonlinear least square method. This method can fit a wide range of prescribed strength vs. displacement relations which may be simple algebraic relations or curves obtained by laboratory tests. By examining the residual errors and in comparison with a derived result in which linear stress is assumed within the zone, it could be concluded that the results provide good accuracy. Moreover, because the results are written in formulae, they can be easily referred to or used. By fitting constitutive curves in many different shapes, it is found that the stress distribution within the zone is more sensitive to the constitutive curve shape than the displacement. The most interesting fact is that the zone size is not sensitive to the curve shape, i.e., the zone size can be estimated by $$R = 3\mu \zeta \upsilon _c /\{ 2(1 - \upsilon )(\tau _c - \tau _f )\}$$ with ζ=1±0.11 for most cases.     

Strength and stability of frictional sliding of gabbro gouge at elevated temperatures

To investigate the strength of frictional sliding and stability of mafic lower crust, we conducted experiments on oven-dried gabbro gouge of 1 mm thick sandwiched between country rock pieces (with gouge inclined 35° to the sample axis) at slip rates of 1.22 × 10^− 3 mm/s and 1.22 × 10^− 4 mm/s and elevated temperatures up to 615 °C. Special attention has been paid to whether transition from velocity weakening to velocity strengthening occurs due to the elevation of temperature.Two series of experiments were conducted with normal stresses of 200 MPa and 300 MPa, respectively. For both normal stresses, the friction strengths are comparable at least up to 510 °C, with no significant weakening effect of increasing temperature. Comparison of our results with Byerlee's rule on a strike slip fault with a specific temperature profile in the Zhangbei region of North China shows that the strength given by experiments are around that given by Byerlee's rule and a little greater in the high temperature range.At 200 MPa normal stress, the steady-state rate dependence a − b shows only positive values, probably still in the “run-in” process where velocity strengthening is a common feature. With a normal stress of 300 MPa, the values of steady-state rate dependence decreases systematically with increasing temperature, and stick-slip occurred at 615 °C. Considering the limited displacement, limited normal stress applied and the effect of normal stress for the temperatures above 420 °C, it is inferred here that velocity weakening may be the typical behaviour at higher normal stress for temperature above 420 °C and at least up to 615 °C, which covers most of the temperature range in the lower crust of geologically stable continental interior. For a dry mafic lower crust in cool continental interiors where frictional sliding prevails over plastic flow, unstable slip nucleation may occur to generate earthquakes.     

松溪县域城镇体系发展研究

城镇体系建设是当今加快城市化进程的重要组成部分。本文通过对松溪县域城镇现状的调查,从城镇体系的等级规模结构、空间布局结构、职能结构3个方面剖析其发展中存在的一些问题。从建设社会主义新农村、改善人居环境的角度出发,提出相应的发展思路和建议,为松溪县“十一五”期间制定城镇发展战略提供一定的参考。     

Vertical distribution and water solubility of phosphorus and heavy metals in sediments of the St. Lucie Estuary, South Florida, USA

Accumulation and distribution of heavy metals and phosphorus in sediments impact water quality. There has been an increasing concern regarding fish health in the St. Lucie Estuary, which is related to increased inputs of nutrients and metals in recent decades. To investigate vertical changes of contaminants (P, Cd, Cr, Co, Cu, Ni, Pb, Zn, and Mn) in sediments of the St. Lucie Estuary in South Florida, 117 layer samples from six of the 210 to 420 cm depth cores were analyzed for their total and water-soluble P and heavy metals, clay, total Fe, Al, K, Ca, Mg, Na, and pH. Principal component analysis (PCA) was used in two sets of analytical data (total and water-soluble contaminant concentrations) to document changes of contaminants in each core of sediments. The PCA of total contaminants and minerals resulted in two factors (principal components). The first and second factors accounted for 61.7 and 17.2 % of the total variation in all variables, and contrast indicators associated with contaminants of P, Cd, Co, Cr, Ni, Pb, Zn, and Mn and accumulation of Fe and Al oxides, respectively. The first factor could be used for overall assessment of P and heavy metal contamination, and was higher in the upper 45–90 cm than the lower depths of each core. The concentrations of P and heavy metals in the surface layers of sediments significantly increased, as compared with those in the sediments deeper than 45–90 cm. The PCA of water-soluble contaminants developed two factors. The second factor (Cu–P) was higher in the upper than the lower depths of the sediment, whereas the highest score of the first factor (Cd–Co–Cr–Ni–Pb–Zn–Mn) occurred below 100 cm. The water-soluble Cu and P concentrations were mainly dependent on their total concentrations in the sediments, whereas the water-soluble Cd, Co, Cr, Ni, Pb, Zn, and Mn concentrations were mainly controlled by pH.     

吉林伊通盆地莫里青断陷古近系双阳组储集层成岩作用研究

古近系双阳组是在吉林省伊通盆地莫里青断陷中，油气赋存的主要层位,储层主要为湖底扇和扇三角洲的砂体。依据双阳组储层的大量薄片、扫描电镜、粘土矿物分析的资料研究了该储集层的成岩作用。研究结果表明双阳组储集层：成岩作用经历了压实、压溶、胶结、交代和溶解6方面的作用。双储集层中的自生粘土矿物蒙皂石向伊利石转化具有明显的特征：主要演化过程经历了蒙皂石渐变带，第一迅速转化带和第二迅速转化带，相应的成岩作用阶段可划分为早成岩阶段B期、晚成岩阶段A1期和晚成岩阶段A2期。依据在垂向上的成岩变化,建立了莫里青断陷双阳组储集层的成岩作用演化序列。在垂向上成岩作用的类型和强度均存在明显的差异，造成了储层物性的垂向分带。     

黄河拉西瓦水电站坝区天然高边坡特征及其治理

拉西瓦水电站为黄河上游最大水电枢纽工程。两岸边坡谷底至岸顶相对高差为600~700m。正常蓄水位以上边坡高度约450m。坝址两岸2400m高程以上天然高边坡变形破裂体、松动体、危岩体、危石等发育广泛且小型不稳定体随机分布。高边坡稳定性构成本电站重大工程地质问题之一。且因峡谷深切、边坡高陡,对其处理难度很大。论文首先总结了电站坝址两岸天然高边坡地质特征,对高边坡进行了稳定性分区与总体评价。在此基础上提出边坡处理原则与方案设计。最后列举了2个边坡处理典型实例,一为基于现代设计理念和新型材料的SNS柔性边坡防护系统在拉西瓦高边坡不稳定体处理中的广泛应用;另一为坝址大型变形破裂体———Ⅱ#变形体的综合治理。根据高边坡不稳定体各自不同地质特征,采用科学且针对性强的流通量措施能够达到稳定要求的。