Evaluation of drift current parameters using an analytical model

The paper is concerned with the evaluation of the drift current parameters derived through the use of an analytical model. In this model, effective when stratification is stable and indifferent, the vertical turbulence coefficient profile is prescribed by the power function, and hydrodynamic quantities are prescribed using the external parameters of the problem (wind stress, the Coriolis parameter, and the dimensionless stratification parameter). Model data are compared with the observations of the upper mixed layer in the vicinity of the oceanic Station C, conducted during one year. It is shown that, under the spring-summer-time warming conditions, the model at issue is capable of adequately simulating the upper ocean layer dynamics. Translated by Vladimir A. Puchkin.     

Seasonal course of theT,S-characteristics in the north-eastern Tropical Atlantic

The problem of the seasonal variations of temperature and salinity in the intermediate zone located between the West African and the Gulf of Guinea upwellings is considered. The vertical distribution of the phase-amplitude characteristics of the annual and semi-annual variations is examined in good detail and their parameters are defined from the monthly means using the least-squares fit technique. The contribution of isopycnic advection to the formation of seasonal thermohaline variations is studied.Translated by Vladimir A. Puchkin.     

Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.     

The effects of oil exploration and production in the northern North Sea: Part 2—microbial biodegradation of hydrocarbons in water and sediments, 1978–1981

The potential of heterotrophs to degrade aromatic hydrocarbons derived from oil in water and sediments in the northern North Sea around the Brent, Beryl, Forties and Murchison oilfields and at a number of stations, from the Forties field to the Firth of Forth, was estimated using 1-¹⁴C naphthalene and 7, 10-¹⁴C benzo(a)pyrene. The degradation of uniformly labelled ¹⁴C mixed 1-amino acids was used as a measure of total heterotrophic activity. Results showed that microorganisms have the potential to degrade the smaller aromatic hydrocarbon molecules rapidly in the water column and in surface sediments. Close to the Beryl platform, where diesel-washed drill cuttings have been continuously dumped, the rate of input of hydrocarbons to the sediment has exceeded the rate of degradation. Mineralization of benzo(a)pyrene, estimated in the sediments only, was minimal. Close to production platforms the biodegradation rate of mixed 1-amino acids showed no increase comparable with that found for naphthalene, suggesting that existing microbial populations had not increased but adapted to degrade oil in water and sediments.     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Phytoplankton biomass and size fractions in surface waters of the Australian sector of the southern ocean

We collected surface water along the 142nd E meridian from Tasmania to Antarctica in December 1999. We measured temperature, salinity and total chlorophyll a; additionally, we collected suspended particle size fractions and used fluorometric analysis to determine the quantity of chlorophyll a in each of four cell size classes: picoplankton (<3 μm), two nanoplankton fractions (3–10 μm and 10–20 μm) and microplankton (> 20 μm). Changes in temperature and salinity show that we crossed 6 water masses separated by 5 fronts. We found low abundance (<0.2 mg m⁻³) of chlorophyll in all size classes, with the exception of higher values near the continent (0.2 to 0.4 mg m⁻³). Lowest chlorophyll values (<0.1 mg m⁻³) were found in the Polar Frontal Zone (51° to 54°S). Microplankton made up the largest portion of total chlorophyll throughout most of the region. We conclude that biomass of all phytoplankton fractions, especially pico-and nanoplankton, was constrained by limiting factors, most probably iron, throughout the region and that ecosystem dynamics within a zone are not circumpolar but are regionalized within sectors.