Evolution of the Radio Luminosities of the Tycho and Kepler Supernovae Remnants

Radio emission of the historical supernovae remnants Tycho (SNR1572) and Kepler (SNR1604) and evolution of their luminosity are considered. Measurement data of secular luminosity decrease rate, obtained earlier by the authors, were corrected with account of variation in time of the flux density of the reference sources. As a result, it is found that the SNR1604 luminosity at 1667 MHz is weakening with an annual mean rate equal to (0.2 ± 0.07)%. The corresponding rate for SNR1572 is (0.47 ± 0.05)%. Since the radio luminosity evolution, as well as energy densities of magnetic field and relativistic electrons inside SNR1604 and SNR1572 are essentially different, these remnants should be considered as different types of supernovae. Bandiera classified SN1604 as type SNIb or SNII.     

Computer Simulation of Sputtering of Lunar Regolith by Solar Wind Protons: Contribution to Change of Surface Composition and to Hydrogen Flux at the Lunar Poles

A computer simulation of the sputtering of lunar soil by solar wind protons was performed with the TRIM program. The rate of the sputtering-induced erosion of regolith particles was shown to be less than 0.2 Å per year. A preferential sputtering of Ca, Mg, and O was found along with a less intense sputtering of Fe, Si, and Ti. However, with no other selection mechanisms, surface concentrations of the atoms would differ from the volume ones by no more than 6 %. The enrichment of rims of regolith particles with iron occurs as a result of selective removal of lighter atoms from the lunar surface because of different energies of escape from the Moon's gravity. The energy distributions proved to be the same for all sorts of the sputtered atoms, except for implanted hydrogen; thus, a greater fraction of the atoms left on the lunar surface corresponds to heavier elements. According to simulation results, the concentration of reduced iron observed in the mature regolith could be attained during the time of regolith particle exposure to the present flux of solar wind (10⁵ years). Thus, sputtering can provide the concentration of Fe₀ observed in regolith. On periphery of a cloud of impact vapor the temperature is too low for an irreversible selective removal of evaporation products; thus, a meteoritic bombardment contributes to the formation of composition of the rims of regolith particles mainly through enrichment of the rims with elements from the bulk of the particles. The estimates of fluxes of backscattered solar wind protons and of sputtered protons, earlier implanted to the regolith, demonstrated that their contribution to the proton flux near the poles is only 10⁴ cm^–2 s^–1. This is by two orders of magnitude smaller than the proton flux from the Earth's magnetosphere which is, therefore, the main source of protons for permanently shaded polar craters of the Moon.     

A Method for the Determination of an Intermediate Orbit from Three Positions of the Small Body on the Celestial Sphere

A new method is suggested for finding the preliminary orbit from three complete measurements of the angular coordinates of a celestial body developed by analogy with the classic Lagrange–Gauss method. The proposed method uses the intermediate orbit that we had constructed in an earlier paper based on two position vectors and the corresponding time interval. This intermediate orbit allows for most of the perturbations in the motion of the body. Using the orbital motion of asteroid 1566 Icarus as an example, we compare the results obtained by applying the classic and the new method. The comparison shows the new method to be highly efficient for studying perturbed motion. It is especially efficient if applied to high-precision observational data covering short orbital arcs.     

Late Cretaceous-Paleogene Palynostratigraphy from the Arkhara-Boguchan Brown Coal Mine of Zeya-Bureya Depression, Russia

1IntroductionThe Arkhara-Boguchan brown coal mine is lo-cated in the western Arkhara depression,southeast-ern part of the Zea-Bureya Basin (Fig.1). Late Creta-ceous-Paleogene coal-bearing strata are well out-cropped at the Arkhara-Boguchan quarry. It contains four coal-bearing beds (in descending order): “Ve-likan”, “Promezhutochny”,“Dvoinoy”and “Nyzhny”, and composed of three sedimentary cycles (Fig.2). The lower cycle can be divided into two sub-cycles:the lowest sub-cycle is …     

Contribution of storms to groundwater recharge in the semi‐arid region of Karnataka,India

This paper describes the application of environmental isotopes and injected tracer techniques in estimating the contribution of storms as well as annual precipitation to groundwater recharge and its circulation, in the semi‐arid region of Bagepalli, Kolar district, Karnataka. Environmental isotopes ²H, ¹⁸O and ³H were used to study the effect of storms on the hydrological system, and an isotope balance was used to compute the contribution of a storm component to the groundwater. Some of the groundwater samples collected during the post‐storm periods were highly depleted in stable isotope content with higher deuterium excess relative to groundwater from the pre‐storm periods. Significant variation in deuterium excess in groundwater from the same area, collected in two different periods, indicates the different origin of air masses. The estimated recharge component of a storm event of 600 mm to the groundwater was found to be in the range of 117–165 mm. There was no significant variation in environmental tritium content of post‐storm and pre‐storm groundwater, indicating the fast circulation of groundwater in the system. After completion of the environmental isotope work, an injected radiotracer ³H technique was applied to estimate the direct recharge of total precipitation to the groundwater. The estimated recharge to the groundwater is 33 mm of the 550 mm annual precipitation during 1992. Copyright © 2003 John Wiley & Sons, Ltd.     

APPLICATION OF GEOGRAPHICAL PARAMETER DATABASE TO ESTABLISHMENT OF UNIT POPULATION DATABASE

Now GIS is turning into a good tool in handling geographical, economical, and population data, so we can obtain more and more information from these data. On the other hand, in some cases, for a calamity, such as hurricane, earthquake, flood, drought etc., or a decision-making, such as setting up a broadcasting transmitter, building a chemical plant etc., we have to evaluate the total population in the region influenced by a calamity or a project. In this paper, a method is put forward to evaluate the population in such special region. Through exploring the correlation of geographical parameters and the distribution of people in the same region by means of quantitative analysis and qualitative analysis, unit population database (1km× 1km) is established. In this way, estimating the number of people in a special region is capable by adding up the population in every grid involved in this region boundary. The geographical parameters are obtained from topographic database and DEM database on the scale of     

Helicity as a Component of Filament Formation

In this paper we seek the origin of the axial component of the magnetic field in filaments by adapting theory to observations. A previous paper (Mackay, Gaizauskas, and van Ballegooijen, 2000) showed that surface flows acting on potential magnetic fields for 27 days – the maximum time between the emergence of magnetic flux and the formation of large filaments between the resulting activity complexes – cannot explain the chirality or inverse polarity nature of the observed filaments. We show that the inclusion of initial helicity, for which there is observational evidence, in the flux transport model results in sufficiently strong dextral fields of inverse polarity to account for the existence and length of an observed filament within the allotted time. The simulations even produce a large length of dextral chirality when just small amounts of helicity are included in the initial configuration. The modeling suggests that the axial field component in filaments can result from a combination of surface (flux transport) and sub-surface (helicity) effects acting together. Here surface effects convert the large-scale helicity emerging in active regions into a smaller-scale magnetic-field component parallel to the polarity inversion line so as to form a magnetic configuration suitable for a filament.     

Polar Ring Currents on the sun During a Polar Magnetic Field Reversal

We have studied the variations of the height of polar crown prominences according to daily observations of the Sun at the Kodaikanal Observatory (India) during 1905–1975. Polar ring filaments at latitudes 60°–80° are related to the polar magnetic field reversal. A double decrease of the height of polar ring filaments was found in the course of their migration from 40°to the poles. We estimated the limiting height of the equilibrium of polar ring filaments from the stability condition of a strong electric current. We found that the transition from large-scale to small-scale ring filaments reduces the critical height of the stability for the prominences. A model of an inverse-polarity filament was used.