Determining effective wellbore permeability from a field pressure test: a numerical analysis of detection limits

We propose a simple pressure test that can be used in the field to determine the effective permeability of existing wellbores. Such tests are motivated by the need to understand and quantify leakage risks associated with geological storage of CO₂ in mature sedimentary basins. If CO₂ is injected into a deep geological formation, and the resulting CO₂ plume encounters a wellbore, leakage may occur through various pathways in the “disturbed zone” surrounding the well casing. The effective permeability of this composite zone, on the outside of the well casing, is an important parameter for models of leakage. However, the data that exist on this key parameter do not exist in the open literature, and therefore specific field tests need to be done in order to reduce the uncertainty inherent in the leakage estimates. The test designed and analyzed herein is designed to measure effective wellbore permeability within a low-permeability caprock, bounded above and below by permeable reservoirs, by pressurizing the reservoir below and measuring the response in the reservoir above. Alternatively, a modified test can be performed within the caprock without directly contacting the reservoirs above and below. We use numerical simulation to relate pressure response to effective well permeability and then evaluate the range of detection of the effective permeability based on instrument measurement error and limits on fracture pressure. These results can guide field experiments associated with site characterization and leakage analysis.     

Space–time distribution of ancient and active alluvial karst subsidence: examples from the central Ebro Basin,Spain

Space and time variations of alluvial karst subsidence in the central Ebro Basin are analysed in trenches (paleodolines), aerial photographs (historical dolines) and field surveys (present-day active dolines). The measured subsidence rates, as well as a comparison between densities of paleodolines computed in randomly selected scan-lines and density of active dolines computed in maps, suggest that present-day subsidence in favourable areas is more intense than that of Pleistocene times. According to diachronic maps drawn from (a) different aerial photographs taken after 1946 and (b) field surveys on deformations in urbanized areas, subsidence behaved as a nearly steady process while the whole area was used for agriculture. In contrast, rapid changes (through periods of several tens of years) have occurred in urbanized areas, in which dolines expand their boundaries through small marginal collapses, shifting sharply their sinking centres to neighbouring sites. These rapid changes do not have an equivalent in observed paleodolines.     

Suitability analysis for sand and gravel extraction site location in the context of a sustainable development in the surroundings of Zaragoza (Spain)

Zaragoza city is located in the central Ebro Basin, in the Iberian Peninsula. The fluvial terraces formed by the Ebro River present a valuable resource of sand and gravel deposits. However, taking advantage of these available resources implies conflicts with other land use interests like urban and industrial development as well as agricultural use, which has also traditionally occupied the alluvial terraces. These deposits represent a substantial groundwater resource that should be preserved for future generations. The development of spatial decision support systems (SDSS) has greatly assisted efforts for solving land-use conflicts. These systems combine the benefits of geographic information systems (GIS) and decision support methodologies and are therefore suitable to manage sustainable development of urban areas. In this contribution, an extraction suitability map taking into consideration a variety of environmental criteria is created with the help of a SDSS. The method used is the analytical hierarchy process which is integrated in ArcGIS. Areas most suitable to sand and gravel extraction are located in the high terraces, and in those terraces covered by pediments where the thickness of resource is relatively high. These areas are far from valuable natural areas, outside areas most vulnerable to groundwater contamination, and beneath soils with poor irrigation characteristics.     

Quick-look assessments to identify optimal CO2 EOR storage sites

A newly developed, multistage quick-look methodology allows for the efficient screening of an unmanageably large number of reservoirs to generate a workable set of sites that closely match the requirements for optimal CO₂ enhanced oil recovery (EOR) storage. The objective of the study is to quickly identify miscible CO₂ EOR candidates in areas that contain thousands of reservoirs and to estimate additional oil recovery and sequestration capacities of selected top options through dimensionless modeling and reservoir characterization. Quick-look assessments indicate that the CO₂ EOR resource potential along the US Gulf Coast is 4.7 billion barrels, and CO₂ sequestration capacity is 2.6 billion metric tons. In the first stage, oil reservoirs are screened and ranked in terms of technical and practical feasibility for miscible CO₂ EOR. The second stage provides quick estimates of CO₂ EOR potential and sequestration capacities. In the third stage, a dimensionless group model is applied to a selected set of sites to improve the estimates of oil recovery and storage potential using appropriate inputs for rock and fluid properties, disregarding reservoir architecture and sweep design. The fourth stage validates and refines the results by simulating flow in a model that describes the internal architecture and fluid distribution in the reservoir. The stated approach both saves time and allows more resources to be applied to the best candidate sites.     

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.     

Problems of soil and groundwater pollution in the disposal of “marble” slurries in NW Sicily

This work deals with disposal of slurries generated during the cutting and polishing processes of slabs of decorative sedimentary carbonate rocks in the north western Sicily. At present, they are used as fillers of dismantled quarries near the sawmills and, as a final step of reclamation, are covered with earth layers. In spite of such inexpensive solution, there is lack of knowledge about the composition of the waste. In order to assess if there is any threat for the environment and to suggest indications for alternative solutions, such as recycling or inactivation processes, the slurries were analysed by XR diffraction, simultaneous thermal analysis, ICP/MS, ionic chromatography, FTIR, UV-Vis, COD and TOC measurements, grain size analysis. Results indicate that the slurries can threaten the groundwater, because of the high chemical oxygen demand; furthermore they can modify the mechanism of groundwater recharge, because of their grain size distribution. Some laboratory tests show that, even in very aggressive conditions, the solid pollutants persist in the waste and slowly release into water the products of their degradation. The slurry therefore should be subjected to inactivation treatment before disposal or, alternatively, recycled as secondary raw material for a suitable process.     

Anthropogenic influence on trace element geochemistry of healing mud (peloid) from Makirina Cove (Croatia)

Due to their balneotherapeutic features, the organic-rich sediments in Makirina Cove are an important source of healing mud. An environmental geochemistry approach using normalization techniques was applied to evaluate the anthropogenic contribution of trace metals to sediments used as healing mud. Sediment geochemistry was found to be associated with land-use change and storm events, as well as with proximity of a road with heavy traffic in the summer months. Local valley topography preferentially channels lithogenic and pollutant transport to the cove. Concentrations and distribution of trace metals indicate lithogenic (Ni, Cr, Co) and anthropogenic (Pb, Cu, Zn and Se) contributions to the sediments. The calculation of enrichment factors indicates a moderate (EFs between 2–3.5) input of anthropogenic Cu and Pb in surficial sediments to a depth of 10 cm. Patients using the Makirina Cove sediments as healing mud could be to some extent exposed to enhanced uptake of metals from anthropogenic sources via dermal contact.     

Mineralogy and geochemistry of the Texeo Cu–Co mine site (NW Spain): screening tools for environmental assessment

The Cu–Co–Ni Texeo mine has been the most important source of Cu in NW Spain since Roman times and now, approximately 40,000 m³ of wastes from mine and metallurgical operations, containing average concentrations of 9,263 mg kg⁻¹ Cu, 1,100 mg kg⁻¹ As, 549 mg kg⁻¹ Co, and 840 mg kg⁻¹ Ni, remain on-site. Since the cessation of the activity, the abandoned works, facilities and waste piles have been posing a threat to the environment, derived from the release of toxic elements. In order to assess the potential environmental pollution caused by the mining operations, a sequential sampling strategy was undertaken in wastes, soil, surface and groundwater, and sediments. First, screening field tools were used to identify hotspots, before defining formal sampling strategies; so, in the areas where anomalies were detected in a first sampling stage, a second detailed sampling campaign was undertaken. Metal concentrations in the soils are highly above the local background, reaching up to 9,921 mg kg⁻¹ Cu, 1,373 mg kg⁻¹ As, 685 mg kg⁻¹ Co, and 1,040 mg kg⁻¹ Ni, among others. Copper concentrations downstream of the mine works reach values up to 1,869 μg l⁻¹ and 240 mg kg⁻¹ in surface water and stream sediments, respectively. Computer-based risk assessment for the site gives a carcinogenic risk associated with the presence of As in surface waters and soils, and a health risk for long exposures; so, trigger levels of these elements are high enough to warrant further investigation.     

Regional distribution pattern of groundwater heavy metals resulting from agricultural activities

Contaminations of groundwater by heavy metals due to agricultural activities are growing recently. The objective of this study was to evaluate and map regional patterns of heavy metals (Cd, Zn and Cu) in groundwater on a plain with high agricultural activities. The study was conducted to investigate the concentration of heavy metals and distribution in groundwater in regions of Shush Danial and Andimeshk aquifers in the southern part of Iran. Presently, groundwater is the only appropriate and widely used source of drinking water for rural and urban communities in this region. The region covers an area of 1,100 km² between the Dez and Karkhe rivers, which lead to the Persian Gulf. For this study, the region was divided into four sub-regions A, B, C and D. Additionally, 168 groundwater samples were collected from 42 water wells during the earlier months of 2004. The flame atomic absorption spectrometry (AAS-Flame) was used to measure the concentration of heavy metals in water samples and the Surfer software was used for determination of the contour map of metal distribution. The results demonstrated that in all of the samples, Cd and Zn concentrations were below the EPA MCLG and EPA secondary standard, respectively. However, the Cu contents of 4.8 % of all samples were higher than EPA MCL. It is also indicated that the concentrations of metals were more pronounced at the southern part of the studied region than at the others. The analysis of fertilizers applied for agricultural activities at this region also indicated that a great majority of the above-mentioned heavy metals were discharged into the environment. Absence of confining layers, proximity to land surface, excess agricultural activities in the southern part and groundwater flow direction that is generally from the north to the southern parts in this area make the southern region of the Shush plain especially vulnerable to pollution by heavy metals than by other contaminants.