Environmental issues with Australian ports

Ports and shipping operations are under increased environmental scrutiny in Australia, particularly as so many of Australia's ports and shipping routes are located in or near major environmentally sensitive areas. The environmental risks involved have been highlighted by the publicity given to shipping accidents. Environmental regulations over aspects of port operations, including ballast water management, dredge spoil and waste reception, are also becoming stricter. While port authorities have adopted stringent environmental guidelines, they remain concerned that the full impact of proposed new environmental regulations on maritime industry may not be fully understood. This paper discusses some of the issues involved with achieving a balance between environmental protection and the need to recognise the importance of seaborne trade to Australia and to maintain Australia's competitiveness in international trade.     

Determination of palladium and platinum in seaweed

Palladium and platinum concentrations were determined for twenty two species of seaweed from the California coast, U.S.A.. A new sensitive analytical technique using atomic absorption spectrometry was developed for palladium in seaweed. For the first time, palladium contents in seaweed were obtained. The contents of palladium and platinum varied from 0.09 to 0.61 ng g^–1 and 0.25 to 1.75 ng g^–1 in dried material, respectively.The average ratio of Pt/Pd found in seaweed was 3.5, while the ratio of Pt/Pd was 4.5 in seawater. Therefore, it is postulated that there is no discrimination for seaweed to accumulate palladium and platinum from the ambient seawater due to the chemical similarity of the metals.     

Capturing strain localization in reinforced soils

Lade’s single hardening soil model with Cosserat rotation embodied in the finite element method is employed to investigate the behavior of geosynthetic reinforced soils with special attention to the development of shear banding. The ability of the finite element model to detect shear banding in a reinforced soil is examined against three high quality small-scale laboratory plane strain tests on Toyoura sand with and without reinforcement. These three tests were chosen because of the clear failure surfaces that developed in the soil during loading. The FEM analyses were able to reasonably simulate the plane strain laboratory tests including both unreinforced and reinforced cases. The FEM analyses gave reasonably good agreement with the experimental results in terms of global stress–strain relationships and shear band occurrences. Furthermore, and based on FE analyses of a hypothetical geosynthetic reinforced soil (GRS) retaining wall, it is shown that the geosynthetic reinforcements are very effective in hindering the formation of shear bands in GRS retaining walls when small spacing between the reinforcement layers was used. When used properly, the geosynthetic reinforcements made the soil behave as a truly reinforced mass of considerable stiffness and strength.     

Geochronological constraints on the Legs Lake shear zone with implications for regional exhumation of lower continental crust, western Churchill Province, Canadian Shield

The Legs Lake shear zone marks the southeastern boundary of an extensive region (>20,000 km²) of high-pressure (0.8–1.5+ GPa) granulite-facies rocks in the western Churchill Province, Canada. The shear zone is one of the largest exhumation-related structures in the Canadian Shield and coincides with the central segment of the ∼2,800 km long Snowbird tectonic zone. The movement history of this shear zone is critical for the development of models for the exhumation history of the high-pressure region. We used electron microprobe U–Th–Pb dating of monazite with supplemental ID-TIMS U–Pb geochronology to place constraints on the timing of shear zone activity. Combining these and other data, we suggest that regional exhumation occurred during at least three distinct phases over an ∼150 million year period. The first phase involved high temperature decompression from ∼1.0 to 0.8–0.7 GPa shortly following 1.9 Ga peak metamorphism, possibly under an extensional regime. The second phase involved rock uplift and decompression of the hanging wall to 0.5–0.4 GPa during east-vergent thrusting across the Legs Lake shear zone at ca. 1.85 Ga. This phase was likely driven by early collision-related convergence in the Trans-Hudson orogen. The final phase of regional exhumation, involving the removal of 15–20 km of overburden from both footwall and hanging wall, likely occurred after ∼1.78 Ga and may have been related to regional extensional faulting.Electronic Supplementary Material Supplementary material is available to authorised users in the online version of this article at .     

Timescales and significance of high-pressure, high-temperature metamorphism and mafic dike anatexis, Snowbird tectonic zone, Canada

New geochronological, isotopic and geochemical data for a spectacular swarm of deep crustal migmatitic mafic dikes offer important insight into processes operative during 1.9 Ga high pressure, high temperature metamorphism along the Snowbird tectonic zone in northern Saskatchewan. High-precision U–Pb zircon dates reveal anatexis of Chipman mafic dikes at 1,896.2 ± 0.3 Ma during syntectonic and synmetamorphic intrusion at conditions of 1.0–1.2 GPa, >750°C. U–Pb zircon dates of 1,894–1,891 Ma for cross-cutting pegmatites place a lower bound on major metamorphism and deformation at the currently exposed crustal levels. The persistence of elevated temperatures for ~14 m.y. following peak conditions is implied by younger U–Pb titanite dates, and by Sm–Nd whole rock isotopic data that suggest the derivation of the pegmatites by melting of a mafic source. Limited melting of the host felsic gneiss at 1.9 Ga despite high temperature is consistent with evidence for their previous dehydration by granulite facies metamorphism in the Archean. Spatial heterogeneity in patterns of mafic dike and tonalitic gneiss anatexis can be attributed to lateral peak temperature and compositional variability. We correlate 1,896 Ma Chipman mafic dike emplacement and metamorphism with substantial 1.9 Ga mafic magmatism over a minimum along-strike extent of 1,200 km of the Snowbird tectonic zone. This suggests a significant, continent-wide period of asthenospheric upwelling that induced incipient continental rifting. Extension was subsequently terminated by hinterland contraction associated with Trans-Hudson accretion and orogenesis. Little activity in the lower crust for ca. 650 m.y. prior to Proterozoic metamorphism and mafic magmatism implies an extended interval of cratonic stability that was disrupted at 1.9 Ga. This episode of destabilization contrasts with the record of long-term stability in most preserved cratons, and is important for understanding the lithospheric characteristics and tectonic circumstances that control the destruction or survival of continents.     

Simulation of marine boundary layer characteristics using a 1-D PBL model over the Bay of Bengal during BOBMEX-99

The characteristic features of the marine boundary layer (MBL) over the Bay of Bengal during the southwest monsoon and the factors influencing it are investigated. The Bay of Bengal and Monsoon Experiment (BOBMEX) carried out during July–August 1999 is the first observational experiment under the Indian Climate Research Programme (ICRP). A very high-resolution data in the vertical was obtained during this experiment, which was used to study the MBL characteristics off the east coast of India in the north and south Bay of Bengal. Spells of active and suppressed convection over the Bay were observed, of which, three representative convective episodes were considered for the study. For this purpose a one-dimensional multi-level PBL model with a TKE-ε closure scheme was used. The soundings, viz., the vertical profiles of temperature, humidity, zonal and meridional component of wind, obtained onboard ORV Sagar Kanya and from coastal stations along the east coast are used for the study. The temporal evolution of turbulent kinetic energy, marine boundary layer height (MBLH), sensible and latent heat fluxes and drag coefficient of momentum are simulated for different epochs of monsoon and monsoon depressions during BOBMEX-99.The model also generates the vertical profiles of potential temperature, specific humidity, zonal and meridional wind. These simulated values compared reasonably well with the observations available from BOBMEX.     

Constraints on the thermal evolution of continental lithosphere from U-Pb accessory mineral thermochronometry of lower crustal xenoliths,southern Africa

U-Pb isotopic thermochronometry of rutile, apatite and titanite from kimberlite-borne lower crustal granulite xenoliths has been used to constrain the thermal evolution of Archean cratonic and Proterozoic off-craton continental lithosphere beneath southern Africa. The relatively low closure temperature of the U-Pb rutile thermochronometer (~400-450 °C) allows its use as a particularly sensitive recorder of the establishment of "cratonic" lithospheric geotherms, as well as subsequent thermal perturbations to the lithosphere. Contrasting lower crustal thermal histories are revealed between intracratonic and craton margin regions. Discordant Proterozoic (1.8 to 1.0 Ga) rutile ages in Archean (2.9 to 2.7 Ga) granulites from within the craton are indicative of isotopic resetting by marginal orogenic thermal perturbations influencing the deep crust of the cratonic nucleus. In Proterozoic (1.1 to 1.0 Ga) granulite xenoliths from the craton-bounding orogenic belts, rutiles define discordia arrays with Neoproterozoic (0.8 to 0.6 Ga) upper intercepts and lower intercepts equivalent to Mesozoic exhumation upon kimberlite entrainment. In combination with coexisting titanite and apatite dates, these results are interpreted as a record of postorogenic cooling at an integrated rate of approximately 1 °C/Ma, and subsequent variable Pb loss in the apatite and rutile systems during a Mesozoic thermal perturbation to the deep lithosphere. Closure of the rutile thermochronometer signals temperatures of 𙠂 °C in the lower crust during attainment of cratonic lithospheric conductive geotherms, and such closure in the examined portions of the "off-craton" Proterozoic domains of southern Africa indicates that their lithospheric thermal profiles were essentially cratonic from the Neoproterozoic through to the Late Jurassic. These results suggest similar lithospheric thickness and potential for diamond stability beneath both Proterozoic and Archean domains of southern Africa. Subsequent partial resetting of U-Pb rutile and apatite systematics in the cratonic margin lower crust records a transient Mesozoic thermal modification of the lithosphere, and modeling of the diffusive Pb loss from lower crustal rutile constrains the temperature and duration of Mesozoic heating to 𙡦 °C for ₞ ka. This result indicates that the thermal perturbation is not simply a kimberlite-related magmatic phenomenon, but is rather a more protracted manifestation of lithospheric heating, likely related to mantle upwelling and rifting of Gondwana during the Late Jurassic to Cretaceous. The manifestation of this thermal pulse in the lower crust is spatially and temporally correlated with anomalously elevated and/or kinked Cretaceous mantle paleogeotherms, and evidence for metasomatic modification in cratonic mantle peridotite suites. It is argued that most of the geographic differences in lithospheric thermal structure inferred from mantle xenolith thermobarometry are likewise due to the heterogeneous propagation of this broad upper mantle thermal anomaly. The differential manifestation of heating between cratonic margin and cratonic interior indicates the importance of advective heat transport along pre-existing lithosphere-scale discontinuities. Within this model, kimberlite magmatism was a similarly complex, space- and time-dependent response to Late Mesozoic lithospheric thermal perturbation.     

Alteration of hydrological processes and streamflow with juniper (Juniperus virginiana) encroachment in a mesic grassland catchment

To understand the effect of woody plant encroachment on hydrological processes of mesic grasslands, we quantified infiltration capacity in situ, the temporal changes in soil water storage, and streamflow of a grassland catchment and a catchment heavily encroached by juniper (Juniperus virginiana, eastern redcedar) in previously cultivated, non‐karst substrate grasslands in north‐central Oklahoma for 3 years. The initial and steady‐state infiltration rates under the juniper canopy were nearly triple to that of the grassland catchment and were intermediate in the intercanopy spaces within the encroached catchment. Soil water content and soil water storage on the encroached catchment were generally lower than on the grassland catchment, especially when preceding the seasons of peak rainfall in spring and fall. Frequency and magnitude of streamflow events were reduced in the encroached catchment. Annual runoff coefficients for the encroached catchment averaged 2.1%, in contrast to 10.6% for the grassland catchment. Annual streamflow duration ranged from 80 to 250 h for the encroached catchment compared with 600 to 800 h for the grassland catchment. Our results showed that the encroachment of juniper into previously cultivated mesic grasslands fundamentally alters catchment hydrological function. Rapid transformation of mesic grassland to a woodland state with juniper encroachment, if not confined, has the potential to drastically reduce soil water, streamflow and flow duration of ephemeral streams in the Southern Great Plains. Copyright © 2013 John Wiley & Sons, Ltd.