唐山地震震源区构造应力场强度的初步分析

利用唐山地区丰富的震源机制解资料反演构造应力场，并结合构造物理研究手段，对唐山地震震源区现代构造应力场的3个主应力绝对量值进行了估算，给出了地壳介质参数取理论平均值的情况下，唐山地震震源区构造应力场３个主应力量值随深度的变化趋势．研究分析了摩擦系数c、孔隙压力P0和应力形因子 等参数与应力值的关系，发现最大主应力1的垂向增长率与摩擦系数c成正比，与孔隙压力P0和应力形因子成反比；而最小应力值3的垂向增长率与孔隙压力P0成正比，与摩擦系数c和应力形因子成反比．本文对应用震源机制解资料反演完整的应力张量进行了一次有意义的尝试．      

吉林省南部下元古界集安群地质特征与沉积期古环境分析

根据集安群地质特征,岩石化学,稳定同位素特征分析认为:蚂蚁河组沉积期古环境为强氧化泻湖相;荒岔沟组沉积期为强还原的泻湖相、大东岔组沉积期为开阔正常浅海潮坪相。集安群从发生发展到结束古环境演化规律是:构造上,由优地槽向冒地槽演化,气候上由炎热向温湿演化;古地理环境从有障壁的局限海变为无障壁的开阔海;从咸化海向正常海,从泻湖相向潮坪相转化。     

利用震源机制解对中国西南及邻区进行应力分区的初步研究.

将滑动方向拟合法引入应力分区的研究中,以地震震源机制解反演出的断层面上剪应力的方向和相对大小作为判定条件,对一地区的地震震源机制解进行逐一筛选,确定受各个不同构造应力场控制的地震,然后再根据地震的震中分布划分应力分区,我们称之为逐次收敛法．通过对297个地震震源机制解的反演分析,认为中国西南及邻区可分为5个应力分区,并计算出5个应力分区相应的3个主应力的方向和应力形因子的大小．      

沂水县杏山官庄铁矿地质特征

在汞丹山凸起中分布的基性一超基性岩体,其磁铁矿含量高者可构成矿体。利用高精度磁测、钻探等方法开展了沂水县杏山官庄铁矿的普查工作,大致查明了该矿体的规模、形态和产状,认为该矿床具有低品位、工程地质条件简单的特点,综合分析矿床成因属岩浆分异型磁铁矿矿床。     

Mercury indicating inflow zones and ruptures along the Wenchuan Ms 8.0 earthquake fault

Acta Geochimica - During the Wenchuan Fault Scientific Drilling Project, we determined the values of total mercury (HgT) and gaseous elemental mercury (GEM) from drilled cores and drilling mud,...     

The 20 April 2013 Lushan,Sichuan, mainshock,and its aftershock sequence: tectonic implications

Using the double-difference relocation algorithm, we relocated the 20 April 2013 Lushan, Sichuan, earthquake (M _S 7.0), and its 4,567 aftershocks recorded during the period between 20 April and May 3, 2013. Our results showed that most aftershocks are relocated between 10 and 20 km depths, but some large aftershocks were relocated around 30 km depth and small events extended upward near the surface. Vertical cross sections illustrate a shovel-shaped fault plane with a variable dip angle from the southwest to northeast along the fault. Furthermore, the dip angle of the fault plane is smaller around the mainshock than that in the surrounding areas along the fault. These results suggest that it may be easy to generate the strong earthquake in the place having a small dip angle of the fault, which is somewhat similar to the genesis of the 2008 Wenchuan earthquake. The Lushan mainshock is underlain by the seismically anomalous layers with low-V_P, low-V_S, and high-Poisson’s ratio anomalies, possibly suggesting that the fluid-filled fractured rock matrices might significantly reduce the effective normal stress on the fault plane to bring the brittle failure. The seismic gap between Lushan and Wenchuan aftershocks is suspected to be vulnerable to future seismic risks at greater depths, if any.     

福建沿海边缘陆域的原地应力测量研究

通过在福建沿海边缘陆域地区活动断裂带附近进行水压致裂原地应力测量, 得到了地表浅部构造应力的大小、方向和分布特征. 根据实测的地应力资料,用库仑摩擦滑动准则分析研究了断裂带的性质和活动性. 结果表明:① 沿海岸线边缘自北向南,其最大水平主压应力方向为北西向,与测区北西向断裂带走向近于平行,与地质构造、跨断层形变测量等方法反映的主压应力方向大体一致,与震源机制解反映的主压应力方向夹角20deg;左右; ② 水平主应力值随深度增加而增大,与垂直应力值的关系为SHSVSh和SHasymp;SV Sh, 应力状态有利于走滑断层和正断层活动;③ 利用库仑摩擦滑动准则,摩擦强度取0.6～1.0分析, 断层附近的现今地应力状态达到或超过产生正断层摩擦滑动的临界值,表明测区现今构造活动以正断层为主; ④ 反映出本区现今构造应力场的力源主要来自太平洋板块向西和菲律宾板块向北西对欧亚板块的水平挤压作用.      

发展钻孔应变观测的战略构想

钻孔应变观测正在成为一种与测震和GPS相提并论的地壳形变观测。曾经处于领先地位的我国钻孔应力一应变观测的发展需要回顾历史,面对现实,借鉴国外,放眼长远。建立比测基地、实验场和完善国家前兆监测网,三位一体,应该成为发展我国钻孔应变观测的基本方针。     

龙陵-瑞丽断裂北段晚第四纪活动性特征及强震复发间隔

野外地质地貌调查表明,龙陵-瑞丽断裂(南支)北段是以左旋走滑为主兼具一定正断分量的区域性活动断裂.断裂晚更新世以来的平均水平滑动速率为2.2mm/a,平均垂直滑动速率为0.6mm/a;全新世以来的平均水平滑动速率为1.8-3.0mm/a,平均垂直滑动速率为0.5mm/a.断裂在晚更新世以来的滑动速率在不同的时间尺度上变化不大,反映出该断裂晚更新世以来的活动强度比较稳定.利用Poisson模型、Lognormal模型、BPT模型三种概率模型计算获得未来50a强震发震概率分别是:6.32％、0.08％、0.05％;三种模型分别取权重0.28、0.36、0.36,获得龙陵-瑞丽断裂北段未来50a特征地震发震概率为1.82％.     

Deformation of the Most Recent Co-seismic Surface Ruptures Along the Garzê–Yushu Fault Zone (Dangjiang Segment) and Tectonic Implications For the Tibetan Plateau

The Garzê–Yushu strike-slip fault in central Tibet is the locus of strong earthquakes(M 7). The deformation and geometry of the co-seismic surface ruptures are reflected in the surface morphology of the fault and depend on the structure of the upper crust as well as the pre-existing tectonics. Therefore, the most recent co-seismic surface ruptures along the Garzê–Yushu fault zone(Dangjiang segment) reveal the surface deformation of the central Tibetan Plateau. Remote sensing images and field investigations suggest a 85 km long surface rupture zone(striking NW-NWW), less than 50 m wide, defined by discontinuous fault scarps, right-stepping en echelon tensional cracks and left-stepping mole tracks that point to a left-lateral strike-slip fault. The gullies that cross fault scarps record systematic left-lateral offsets of 1.8 m to 5.0 m owing to the most recent earthquake, with moment magnitude of about M 7.5, in the Dangjiang segment. Geological and geomorphological features suggest that the spatial distribution of the 1738 co-seismic surface rupture zone was controlled by the pre-existing active Garzê–Yushu fault zone(Dangjiang segment). We confirm that the Garzê–Yushu fault zone, a boundary between the Bayan Har Block to the north and the Qiangtang Block to the south, accommodates the eastward extrusion of the Tibetan Plateau and generates strong earthquakes that release the strain energy owing to the relative motion between the Bayan Har and Qiangtang Blocks.