γ射线暴的logN(>P)～logP分布

本文用简单的宇宙学模型 ,在标准烛光和均匀分布的假设下计算了γ射线暴的logN(>P)～logP分布 (大小谱 ) .在考虑了探测效率修正和死时间修正后 ,由宇宙学模型计算的理论结果和BATSE实测的大小谱没有显著的偏离     

CygX—1硬态高能光子的时延

硬X射线和软射线光子的时延时研究主能辐射的一个重要方面，傅里叶交叉谱常常被用于教育处硬软光子之间的时延，但是交叉说示能在高于30Hz的傅里叶频率上从CygX-1测量到有统计意义的快速光变，由李惕培在时域上发展的交叉相关函方法能有效测量不同时间尺度上的时延，利用此交叉相关分析方法，讨论了不同观测时期CygX-1硬态高能光子时延 的性质，分析结果表明，CygX-1硬态在短的尺度（＜0．1秒）上存存在有意义的时间延迟，并将短时间尺度上的观测结果和各种CygX-1硬态模型进行了比较讨论。     

西藏冈底斯矿带成矿作用及远景分析

冈底斯带矿床众多,类型复杂,主要有斑岩型铜（金钼）矿床、矽卡岩型铁铜-铅-锌（银）矿床、层控铅-锌-银矿床、火山岩型金-银矿床及雄村式铜-金矿床。矿床地质特征和同位素年龄表明,冈底斯带南部的矿床与新特提斯洋壳向北俯冲-陆陆碰撞及碰撞期后的构造岩浆事件有关;冈底斯带北部的矿床与班公湖-怒江洋壳向南俯冲-陆陆碰撞及碰撞期后构造岩浆事件有关。冈底斯带与洋壳的俯冲-碰撞有关的岩浆活动强烈,成矿条件优越。西藏高原在碰撞后发生了快速抬升剥蚀,部分矿床顶部出现低温组合矿化,多数矿床保存良好。     

广州流溪河河水主要化学组成时空分布特征及控制因素

本次研究报道了位于广州市典型热带-亚热带河流流溪河上游、中游和下游3个站点(东星、乌石和江高)河水的主要化学成分在近1年的持续变化时间序列.结果显示,3个站点河水的阳离子均主要来自硅酸盐的化学风化输出,但贡献率略有差异,其中在上游的东星站贡献率最大,下游的江高站次之,中游的乌石站相对较少.相较之下,阴离子的来源更为多样...     

An introduction to ultrahigh-pressure metamorphism

Abstract Ultrahigh-pressure (UHP) metamorphism refers to mineralogical and structural readjustment of supracrustal protoliths and associated mafic-ultramafic rocks at mantle pressures greater than ∼ 25 kbar (80-90 km). Typical products include metapelite, quartzite, marble, granulite, eclogite, paragneiss and orthogneiss; minor mafic and ultramafic rocks occur as eclogitic-ultramafic layers or blocks of various dimensions within the supracrustal rocks. For appropriate bulk compositions, metamorphism at great depths produces coesite, microdiamond and other characteristic UHP minerals with unusual compositions. Thus far, at least seven coesite-bearing eclogitic terranes and three diamond-bearing UHP regions have been documented. All lie within major continental collision belts in Eurasia, have similar supracrustal protoliths and metamorphic assemblages, occur in long, discontinuous belts that may extend several hundred kilometers or more, and typically are associated with contemporaneous high-P blueschist belts. This paper defines the P-T regimes of UHP metamorphism and describes mineralogical, petrological and tectonic characteristics for a few representative UHP terranes including the western gneiss region of Norway, the Dora Maira massif of the western Alps, the Dabie Mountains and the Su-Lu region of east-central China, and the Kokchetav massif of the former USSR. Prograde P-T paths for coesite-bearing eclogites require abnormally low geothermal gradients (approximately 7°C/km) that can be accomplished only by subduction of cold, oceanic crust-capped lithosphere ± pelagic sediments or an old, cold continent. The preservation of coesite inclusions in garnet, zircon, omphacite, kyanite and epidote, and microdiamond inclusions in garnet and zircon during exhumation of an UHP terrane requires either an extraordinarily fast rate of denudation (up to 10 cm/year) or continuous refrigeration in an extensional regime (retreating subduction zone).     

Tectonic evolution of the ultrahigh-pressure (UHP) and high-pressure (HP) metamorphic belts from central China

Abstract In the Triassic suture between the Sino-Korean and Yangtze cratons, the Dabie metamorphic Complex in central China includes three tectonic units: the northern Dabie migmatitic terrane, the central ultrahigh-P coesite- and diamond-bearing eclogite belt, and the southern high-P blueschist-eclogite belt. This complex is bounded to the north by a north-dipping normal fault with a Paleozoic accretionary complex and to the south by a north-dipping reverse fault with Yangtze basement plus its foreland fold-and-thrust sequence. Great differences in metamorphic pressure suggests that these units reached different depths during metamorphism and their juxtaposition occurred by wedge extrusion of subducted old continental fragments. These units were subsequently subjected to (i) Barrovian type regional metamorphism and deformation at shallow depths; (ii) intrusion of Cretaceous granitic plutons; and (iii) doming and segmentation into several blocks by normal and strike-slip faults. A new speculative model of tectonic exhumation of UHP rocks is proposed.     

Ultra-high pressure metamorphic rocks in the Dabie-Su-Lu region, China: Their formation and exhumation

Abstract Based on petrological, structural, geological and geochronological research, the authors summarize the progress of ultra-high pressure (UHP) metamorphic rock study since 1989 by Chinese geoscientists and foreign geoscientists in the Dabie-Su-Lu region. The authors introduce and discuss a two-stage exhumation process for the UHP metamorphic rocks that have various lithologies; eclogite, ultramafics, jadeitic quartzite, gneiss, schist and marble. The metamorphic history of UHP metamorphic rocks is divided into three stages, that is, the pre-eclogite stage, coesite eclogite stage, and retrograde stage. Prior to UHP metamorphism, the ultramafics had a high temperature environment assemblage of mantle and others had blueschist facies assemblages. The granulite facies assemblages, which have recorded a temperature increase event with decompression, have developed locally in the Weihai basaltic rocks. Isotopic ages show a long range from > 700 Ma to 200 Ma. The diversity in protoliths of UHP metamorphic rocks may be related to the variation of isotopic ages older than 400 Ma. The Sm-Nd dating of ~ 220 Ma could reflect the initial exhumation stage after the peak UHP metamorphism in relation to the collision between the Sino-Korean and Yangtze blocks and subsequent events. Petrological and structural evidence imply a two-stage exhumation process. During the initial exhumation, the UHP metamorphic rocks were sheared and squeezed up in a high P/T regime. In the second exhumation stage the UHP metamorphic rocks were uplifted and eventually exposed with middle crustal rocks.     

金伯利岩及有关岩类中的石榴石

镁铝榴石是金刚石的常见伴生矿物,由于经常在自然重砂中出现,因此利用重砂法来寻找金刚石原生矿是一种有效的方法。但是镁铝榴石不仅在金伯利岩中,而且往往在某些基性、超基性、以及某些高级变质岩中出现,使找矿工作复杂化。为此,探寻与金刚石有成因联系的镁铝榴石和其他镁铝榴石之区别是很必要的。     

悬链线法在水平定向钻轨迹设计中的应用探究

铝孔轨迹设计是非开挖水平定向钻施工中一项重要内容。其最优化设计在国内已较成熟,但多数优化设计未从力学方面进行优化设计。针对这一情况,引入悬链线法来优化水平定向钻轨迹设计。通过悬链线法的计算可知,优化后的轨迹不仅有利于降低钻杆回转阻力和扭矩消耗,提高机械钻速,增长管道使用年限,同时与传统设计方法相比较,其计算出的轨迹长度也比传统圆弧轨迹长度略短,表明了悬链线法在水平定向钻轨迹设计上具有一定的优势。     

新型扇形盘式消能器减震性能参数分析

提出了一种新型扇形盘式效能器(fanshaped disc-type energy dissipator,FDED),阐明了其原理、特点,导出其设计要点和设计理论,采用数值方法分析了FDED的减震性能,研究不同设计参数对FDED减震性能的影响。结果表明:FDED设计原理可行,减震机理明确,其转盘式的构造可起到有效的位移放大效果,使得消能器在小激励位移下发挥耗能作用;FDED具有明显的双线性恢复力特性和稳定的耗能性能,等效黏滞阻尼系数可达50%以上;阻尼件中橡胶硬度的改变对FDED初始刚度的影响不敏感,但对FDED屈服后刚度和等效黏滞阻尼系数的影响较为明显。随着橡胶硬度的增大,FDEDE的屈服后刚度上升,等效黏滞阻尼系数降低;保持阻尼层中橡胶层的总厚度不变,通过增减叠层钢板改变单层橡胶层的厚度对于调整FDED的减震性能影响不大;调整铅芯直径的大小主要影响FDED的屈服力和耗能性能。随着铅芯直径的增大,FDED的屈服力也增大,耗能能力逐渐提高。